Kentaro Fukuda
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kentaro Fukuda has a total of 85 co-authors. Here are the top co-authors by number of shared publications:
- Akira Yoshikawa
Institute for Materials Research, Tohoku University, 2-1-1 Katahira, Aoba-ku, Sendai 980-8577, Miyagi, Japan
11 shared publications - Yuui Yokota
Institute for Materials Research, Tohoku University, 2‐1‐1 Katahira, Aoba‐ku, Sendai, Miyagi 980‐8577, Japan
8 shared publications - Noriaki Kawaguchi
Institute for Materials Research, Tohoku University, 2-1-1 Katahira, Aoba-ku, Sendai, Miyagi 980-8577, Japan
7 shared publications - Takayuki Yanagida
Kyushu Institute of Technology
7 shared publications - Kohei Yamanoi
Institute of Laser Engineering, The University of Osaka
5 shared publications - Nobuhiko Sarukura
Institute of Laser Engineering, Osaka University 2 , 2-6 Yamadaoka, Suita, Osaka 565-0871, Japan
5 shared publications
Latest Publications
- 1 August 2016
- Published by Elsevier in Optical Materials
- Vol. 58, 5-8
Temperature-dependent evaluation of Nd:LiCAF optical properties as potential vacuum ultraviolet laser material
- 1 August 2016
- Published by Elsevier in Optical Materials
- Vol. 58, 5-8
Temperature-dependent evaluation of Nd:LiCAF optical properties as potential vacuum ultraviolet laser material
- Open Access
Aluminum Nitride Ceramic as an Optically Stimulable Luminescence Dosimeter Plate
Photostimulable storage phosphors have been used in a wide range of applications including radiation measurements in one- and two-dimensional spaces, called point dosimetry and radiography. In this work, we report that an aluminum nitride (AlN) ceramic plate, which is practically used as a heat sink (SHAPAL®, Tokuyama Corp., Yamaguchi, Japan), shows good optically-stimulated luminescence (OSL) properties with sufficiently large signal and capability for imaging applications, and we have characterized the AlN plate for OSL applications. Upon interaction with X-rays, the sample color turns yellowish, due to a radiation-induced photoabsorption band in the UV-blue range below ~500 nm. After irradiating the sample with X-rays, an intense OSL emission can be observed in the UV (360 nm) spectral region during stimulation by red light. Although our measurement setup is not optimized, dose detection was confirmed as low as ~3 mGy to over 20 Gy. Furthermore, we have successfully demonstrated that the SHAPAL® AlN ceramic plate has great potential to be used as an imaging plate in radiography.
Open AccessAluminum Nitride Ceramic as an Optically Stimulable Luminescence Dosimeter Plate
Photostimulable storage phosphors have been used in a wide range of applications including radiation measurements in one- and two-dimensional spaces, called point dosimetry and radiography. In this work, we report that an aluminum nitride (AlN) ceramic plate, which is practically used as a heat sink (SHAPAL®, Tokuyama Corp., Yamaguchi, Japan), shows good optically-stimulated luminescence (OSL) properties with sufficiently large signal and capability for imaging applications, and we have characterized the AlN plate for OSL applications. Upon interaction with X-rays, the sample color turns yellowish, due to a radiation-induced photoabsorption band in the UV-blue range below ~500 nm. After irradiating the sample with X-rays, an intense OSL emission can be observed in the UV (360 nm) spectral region during stimulation by red light. Although our measurement setup is not optimized, dose detection was confirmed as low as ~3 mGy to over 20 Gy. Furthermore, we have successfully demonstrated that the SHAPAL® AlN ceramic plate has great potential to be used as an imaging plate in radiography.
- 19 March 2014
- Published by Physical Society of Japan
Basic Properties of Eu2+5d-4f Luminescence in SiO2Glass Matrix
- 19 March 2014
- Published by Physical Society of Japan
Basic Properties of Eu2+5d-4f Luminescence in SiO2Glass Matrix
- 8 November 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 61 (1) , 419-423
Growth and Scintillation Properties of Ce: Li(Ca,Ba)AlF$_{{6}}$ Scintillator Crystals
Ba co-doped Ce:LiCaAlF6 [Ce:Li(Ca,Ba)AlF6] and LiCaAlF6 [Li(Ca,Ba)AlF6] crystals with various Ba concentrations were grown and their structures, optical and scintillation properties were investigated. As-grown Ce2%Ba1% and Ce2%Ba2%:Li(Ca,Ba)AlF6 crystals were high transparency in all parts while an end part of as-grown Ce2%Ba5%:Li(Ca,Ba)AlF6 crystal and all parts of as-grown Ba5%:Li(Ca,Ba)AlF6 crystal included milky parts which decreased transmittance. Ce:Li(Ca,Ba)AlF6 crystals indicated the emission peaks at 288 and 308 nm from which was attributable to the 5d-4f transition of Ce3+ ion in the radioluminescence spectra under α-ray irradiation. In the case of Ce1%Ba2%:Li(Ca,Ba)AlF6 crystal, light yield under thermal neutron irradiation were improved. Decay times of Ce:Ce:Li(Ca,Ba)AlF6 under thermal neutron irradiation systematically increased with an increase of Ba concentration.
- 8 November 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 61 (1) , 419-423
Growth and Scintillation Properties of Ce: Li(Ca,Ba)AlF$_{{6}}$ Scintillator Crystals
Ba co-doped Ce:LiCaAlF6 [Ce:Li(Ca,Ba)AlF6] and LiCaAlF6 [Li(Ca,Ba)AlF6] crystals with various Ba concentrations were grown and their structures, optical and scintillation properties were investigated. As-grown Ce2%Ba1% and Ce2%Ba2%:Li(Ca,Ba)AlF6 crystals were high transparency in all parts while an end part of as-grown Ce2%Ba5%:Li(Ca,Ba)AlF6 crystal and all parts of as-grown Ba5%:Li(Ca,Ba)AlF6 crystal included milky parts which decreased transmittance. Ce:Li(Ca,Ba)AlF6 crystals indicated the emission peaks at 288 and 308 nm from which was attributable to the 5d-4f transition of Ce3+ ion in the radioluminescence spectra under α-ray irradiation. In the case of Ce1%Ba2%:Li(Ca,Ba)AlF6 crystal, light yield under thermal neutron irradiation were improved. Decay times of Ce:Ce:Li(Ca,Ba)AlF6 under thermal neutron irradiation systematically increased with an increase of Ba concentration.
- 17 October 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 61 (1) , 411-418
Luminescence and Scintillation Properties of Scintillators Based on Orthorhombic and Monoclinic BaLu$_{2}$F$_{8}$ Single Crystals
The rare-earth-doped orthorhombic BaLu2F8 vacuum-ultra-violet scintillator crystals have been studied. The fast emission around 185 nm with a decay time of several nanoseconds was due to the allowed 5d-4f transition of the Nd3+ ion. The high temperature phase BaLu2F8 orthorhombic crystals have been prepared by micro-pulling-down method. Unfortunately, no 5d-4f emission (neither from Nd3+ nor from Tm3+) was observed in the crystals under excitation by ionizing radiation at all. This was explained by preferential energy transfer from the host to the lattice defect states. Further improvement of the scintillation efficiency by facilitating the energy transfer from the host matrix to the Nd3+ luminescence center by Tm3+-codoping was attempted. The energy transfer from the Tm3+ ions to the Nd3+ ones has been proved, however, no improvement of the overall scintillation efficiency was observed.
- 17 October 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 61 (1) , 411-418
Luminescence and Scintillation Properties of Scintillators Based on Orthorhombic and Monoclinic BaLu$_{2}$F$_{8}$ Single Crystals
The rare-earth-doped orthorhombic BaLu2F8 vacuum-ultra-violet scintillator crystals have been studied. The fast emission around 185 nm with a decay time of several nanoseconds was due to the allowed 5d-4f transition of the Nd3+ ion. The high temperature phase BaLu2F8 orthorhombic crystals have been prepared by micro-pulling-down method. Unfortunately, no 5d-4f emission (neither from Nd3+ nor from Tm3+) was observed in the crystals under excitation by ionizing radiation at all. This was explained by preferential energy transfer from the host to the lattice defect states. Further improvement of the scintillation efficiency by facilitating the energy transfer from the host matrix to the Nd3+ luminescence center by Tm3+-codoping was attempted. The energy transfer from the Tm3+ ions to the Nd3+ ones has been proved, however, no improvement of the overall scintillation efficiency was observed.
- 1 January 2013
- Published by Elsevier in Journal of Crystal Growth
- Vol. 362, 167-169
Micro-pulling down method-grown Er3+:LiCaAlF6 as prospective vacuum ultraviolet laser material
- 1 January 2013
- Published by Elsevier in Journal of Crystal Growth
- Vol. 362, 167-169
Micro-pulling down method-grown Er3+:LiCaAlF6 as prospective vacuum ultraviolet laser material
- 10 October 2012
- Published by Wiley in physica status solidi (c)
- Vol. 9 (12) , 2235-2238
Crystal growth and evaluation of scintillation properties of Eu and alkali-metal co-doped LiSrAlF6single crystals for thermal neutron detector
- 10 October 2012
- Published by Wiley in physica status solidi (c)
- Vol. 9 (12) , 2235-2238
Crystal growth and evaluation of scintillation properties of Eu and alkali-metal co-doped LiSrAlF6single crystals for thermal neutron detector
- 1 February 2012
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 51 (2) , 22603
Optical Characteristic Improvement of Neodymium-Doped Lanthanum Fluoride Thin Films Grown by Pulsed Laser Deposition for Vacuum Ultraviolet Application
- 1 February 2012
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 51 (2) , 22603
Optical Characteristic Improvement of Neodymium-Doped Lanthanum Fluoride Thin Films Grown by Pulsed Laser Deposition for Vacuum Ultraviolet Application
- 1 October 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1594-1597
6LiF-SrxCa1xF2 doped with Ce and Eu eutectic scintillator for neutron detection
Eu 2+ 0.05, 0.1, and 0.2% activated LiF-SrF 2 eutectic scintillators were fabricated by the Bridgman method using 6 Li enriched (95%) raw material. In α-ray induced radio luminescence spectra, Eu 2+ doped eutectic scintillators showed intense emission peak at 430 nm due to an emission from Eu 2+ 5d-4f transition of Eu:SrF 2 layers. When 252 Cf neutrons were irradiated, they exhibited almost the same light yields of 5000-7000 ph/n with a typical decay times of several hundreds ns.
- 1 October 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1594-1597
6LiF-SrxCa1xF2 doped with Ce and Eu eutectic scintillator for neutron detection
Eu 2+ 0.05, 0.1, and 0.2% activated LiF-SrF 2 eutectic scintillators were fabricated by the Bridgman method using 6 Li enriched (95%) raw material. In α-ray induced radio luminescence spectra, Eu 2+ doped eutectic scintillators showed intense emission peak at 430 nm due to an emission from Eu 2+ 5d-4f transition of Eu:SrF 2 layers. When 252 Cf neutrons were irradiated, they exhibited almost the same light yields of 5000-7000 ph/n with a typical decay times of several hundreds ns.
- 1 October 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10823654,p. 4869-4871
Light output uniformity of czochralski grown rare-earth-ion doped 6LiCaAlF6 single crystal for thermal neutron detection
Light output uniformity of Ce doped 6 LiCaAlF 6 single crystal was researched. Ce doped 6 LiCaAlF 6 single crystal was grown by Czochralski technique and several parts of the crystal were cut from grown crystal and polished. Position dependence of radioluminescence spectra and pulse height spectra were investigated.
- 1 October 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10823654,p. 4869-4871
Light output uniformity of czochralski grown rare-earth-ion doped 6LiCaAlF6 single crystal for thermal neutron detection
Light output uniformity of Ce doped 6 LiCaAlF 6 single crystal was researched. Ce doped 6 LiCaAlF 6 single crystal was grown by Czochralski technique and several parts of the crystal were cut from grown crystal and polished. Position dependence of radioluminescence spectra and pulse height spectra were investigated.