Jae-Keun Lee

Ethylene glycol (EG)-based zinc oxide (ZnO) nanofluids containing no surfactant have been manufactured by one-step pulsed wire evaporation (PWE) method. Round-robin tests on thermal conductivity measurements of three samples of EG-based ZnO nanofluids have been conducted by five participating labs, four using accurate measurement apparatuses developed in house and one using a commercial device. The results have been compared with several theoretical bounds on the effective thermal conductivity of heterogeneous systems. This study convincingly demonstrates that the large enhancements in the thermal conductivities of EG-based ZnO nanofluids tested are beyond the lower and upper bounds calculated using the models of the Maxwell and Nan et al. with and without the interfacial thermal resistance.

In case of engine room of ship, it uses type 2 ventilation system which supplies outside air forcibly by engine room ventilation fan, and naturally discharges air to outlet through low-pressed casing. The advantage of type 2 ventilation is that it makes inside with bi-pressure status to discharge contaminated materials to outside naturally. However, there is a phenomenon that pressure is greatly different between outside and inside due to huge amount of air supply by engine room ventilation fan. Therefore, we went aboard a container vessel which is on test run to analyze differential pressure with micronanometer by engine load and by combustion air supply method of engine. As a result, as engine load decreases (50, 75, 100%), the differential pressure between outside and inside tends to increase by 35% average, and the difference of pressure was 6.5 times maximum by combustion air supply method of engine.

Summary: Polyethylene glycol substituted titanyl phthalocyanine was prepared in two steps starting from phthalonitrile and characterized by FT‐IR, UV‐vis spectrophotometry, and fluorescence spectrophotometry. The titanyl phthocyanine derivatives (TiOPcs) showed high solubility in common organic solvents, such as, CH₃Cl and DMF. These compounds decreased in absorbance intensity with increase of molecular weight of polyethylene glycol at maxima wavelength of visible range. The fluorescence spectra showed a fluorescence emission near 690 nm with a quantum yield of 0.05–0.32 (λ_ex = 625 nm).