Elisabeth Rodier
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Elisabeth Rodier has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Jacques Fages
Centre RAPSODEE, IMT Mines Albi, CNRS, Université de Toulouse, 81013 Albi, France
3 shared publications A. Rizzo
Laboratoire de Génie des Procédés des Solides Divisés , Campus Jarlard, École des Mines d'Albi, France
1 shared publication- Alain Chamayou
Centre RAPSODEE (Recherche d’Albi en génie des Procédés des SOlides Divisés, de l’Energie et de l’Environnement), IMT Mines Albi, UMR CNRS 5302, Université de Toulouse, Campus Jarlard, Allée des Sciences, CEDEX 09, F-81013 Albi, France
1 shared publication - Antonio Marsaioli Junior
Universidade Estadual de Campinas, Campinas, Brasil
1 shared publication Arezki Bounaceur
Ecole des Mines d’Albi, RAPSODEE Research Center, UMR EMAC-CNRS 2392, 81013 Albi, France
1 shared publicationJean-Jacques Letourneau
École des Mines d’Albi-Carmaux, RAPSODEE Research Centre-UMR CNRS 2392, 81013, Albi, France
1 shared publication
Latest Publications
- 1 September 2007
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 42 (2) , 189-199
Solidification of Precirol® by the expansion of a supercritical fluid saturated melt: From the thermodynamic balance towards the crystallization aspect
- 1 September 2007
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 42 (2) , 189-199
Solidification of Precirol® by the expansion of a supercritical fluid saturated melt: From the thermodynamic balance towards the crystallization aspect
- 1 July 2007
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 41 (3) , 429-439
Maturation of a ketoprofen/β-cyclodextrin mixture with supercritical carbon dioxide
- 1 July 2007
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 41 (3) , 429-439
Maturation of a ketoprofen/β-cyclodextrin mixture with supercritical carbon dioxide
- Open Access
- 1 January 2007
- Published by Hosokawa Powder Technology Foundation in KONA Powder and Particle Journal
- Vol. 25, 217-229
Comparative Study of Two Processes to Improve the Bioavailability of an Active Pharmaceutical Ingredient: Kneading and Supercritical Technology
- 1 January 2007
- Published by Hosokawa Powder Technology Foundation in KONA Powder and Particle Journal
- Vol. 25, 217-229
Open AccessComparative Study of Two Processes to Improve the Bioavailability of an Active Pharmaceutical Ingredient: Kneading and Supercritical Technology
- 1 January 2005
- Published by Taylor & Francis in Journal of Microwave Power and Electromagnetic Energy
- Vol. 40 (4) , 241-250
Study of a Microwave Assisted Vacuum Drying Process Applied to the Granulated Pharmaceutical Drug Hydrochlorthiazide (HCT)
Drying processes have evolved considerably over the years, aiming at the best conditions to shorten the processing time, but maintaining the highest final product quality. The application of vacuums to the microwave drying process might be interesting, especially for thermally sensitive products because the reduced boiling point of the solvent allows a lower temperature processing. The objective of the present work is to study and evaluate the process of drying a granulated product that is the basis of the drug hydrochlorthiazide, with an initial moisture content of 21% in dry basis. This study monitored the drying kinetics, product temperature and power absorbed by the sample using a bench scale vacuum microwave dryer. The equipment consisted of a cylindrical pressure vessel crossed by a wave guide, setting up a system whereby the vacuum pressure, the sample weight and the incident, reflected and residual microwave powers could be measured and evaluated, throughout the entire process. The experimental runs were established with an approximate incident microwave power at 20 W for absolute pressure levels of 50 and 75 mbar, working with samples of about 1.4 g. It was observed that the vacuum microwave process kinetics at both pressure levels showed little difference. The processes were carried out almost entirely in a regime of water evaporation, the product’s temperature remaining below the solvent boiling temperature. The drying times were similar for both processes, whereas the absorbed power was slightly higher at the pressure of 75 mbar.
- 1 January 2005
- Published by Taylor & Francis in Journal of Microwave Power and Electromagnetic Energy
- Vol. 40 (4) , 241-250
Study of a Microwave Assisted Vacuum Drying Process Applied to the Granulated Pharmaceutical Drug Hydrochlorthiazide (HCT)
Drying processes have evolved considerably over the years, aiming at the best conditions to shorten the processing time, but maintaining the highest final product quality. The application of vacuums to the microwave drying process might be interesting, especially for thermally sensitive products because the reduced boiling point of the solvent allows a lower temperature processing. The objective of the present work is to study and evaluate the process of drying a granulated product that is the basis of the drug hydrochlorthiazide, with an initial moisture content of 21% in dry basis. This study monitored the drying kinetics, product temperature and power absorbed by the sample using a bench scale vacuum microwave dryer. The equipment consisted of a cylindrical pressure vessel crossed by a wave guide, setting up a system whereby the vacuum pressure, the sample weight and the incident, reflected and residual microwave powers could be measured and evaluated, throughout the entire process. The experimental runs were established with an approximate incident microwave power at 20 W for absolute pressure levels of 50 and 75 mbar, working with samples of about 1.4 g. It was observed that the vacuum microwave process kinetics at both pressure levels showed little difference. The processes were carried out almost entirely in a regime of water evaporation, the product’s temperature remaining below the solvent boiling temperature. The drying times were similar for both processes, whereas the absorbed power was slightly higher at the pressure of 75 mbar.
- 10 January 2003
- Published by Taylor & Francis in Drying Technology
- Vol. 21 (8) , 1527-1548
Experimental Study on Microwave Vacuum Drying of Two-Porosity Level Media
Microwave vacuum drying experiments were performed on a laboratory scale dryer with a two-level porosity material: a packed bed of porous alumina beads. The incident microwave power and the vacuum pressure level were fixed, the main varying parameters being the beads diameter and porosity, and the mean pore diameter. The drying kinetics and the evolution of the product temperature are presented. The drying kinetics can be divided into two main periods. The first one corresponds to the drying from the bed voids according to evaporation mechanism that we describe with a stagnant film law. The second one corresponds to the drying from the particle pores and we divide it into two parts: we suggest that the former is dominated by capillarity driven moisture transport, and the latter is limited by the desorption kinetics of the few water layers left.
- 10 January 2003
- Published by Taylor & Francis in Drying Technology
- Vol. 21 (8) , 1527-1548
Experimental Study on Microwave Vacuum Drying of Two-Porosity Level Media
Microwave vacuum drying experiments were performed on a laboratory scale dryer with a two-level porosity material: a packed bed of porous alumina beads. The incident microwave power and the vacuum pressure level were fixed, the main varying parameters being the beads diameter and porosity, and the mean pore diameter. The drying kinetics and the evolution of the product temperature are presented. The drying kinetics can be divided into two main periods. The first one corresponds to the drying from the bed voids according to evaporation mechanism that we describe with a stagnant film law. The second one corresponds to the drying from the particle pores and we divide it into two parts: we suggest that the former is dominated by capillarity driven moisture transport, and the latter is limited by the desorption kinetics of the few water layers left.