Shakeeba Shaheen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Shakeeba Shaheen has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Asif Ali Khan
Analytical and Polymer Research Laboratory, Department of Applied Chemistry, F/O Engineering and Technology, Aligarh Muslim University, Aligarh 202002, India
4 shared publications Asif Ali Khan
Analytical and Polymer Research Laboratory, Department of Applied Chemistry, Faculty of Engineering and Technology, Aligarh Muslim University, Aligarh 202002, India
1 shared publication- Asif Ali Khan
Analytical and Polymer Research Laboratory
1 shared publication Mohd. Zeeshan
Analytical and Polymer Research Laboratory, Department of Applied Chemistry, F/O Engineering and Technology, Aligarh Muslim University, Aligarh 202002, India
1 shared publication- Mohmmad Khalid
Hydrogen Research Institute/Institut d’Innovations en Écomatériaux, Écoproduits et Écoénergies, Université du Québec à Trois-Rivières, 3351 boul. des forges, Trois-Rivières (Québec) G8Z 4M3, Canada
1 shared publication Rais Ahmad
Analytical and Polymer Research Laboratory, Department of Applied Chemistry, F/O Engineering and Technology, Aligarh Muslim University, Aligarh 202002, India
1 shared publication
Latest Publications
- 1 September 2016
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 221, 999-1007
Synthesis, characterization, electrical and dielectrical studies of Polypyrrole-Sn(IV)arsenotungstate nanocomposite ion-exchange membrane: Its selectivity as Ba(II)
- 1 September 2016
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 221, 999-1007
Synthesis, characterization, electrical and dielectrical studies of Polypyrrole-Sn(IV)arsenotungstate nanocomposite ion-exchange membrane: Its selectivity as Ba(II)
- 21 January 2015
- Published by Royal Society of Chemistry (RSC) in Analytical Methods
- Vol. 7 (5) , 2077-2086
Electrical conductivity, isothermal stability and amine sensing studies of a synthetic poly-o-toluidine/multiwalled carbon nanotube/Sn(iv) tungstate composite ion exchanger doped with p-toluene sulfonic acid
An electrically conductive poly-o-toluidine (POT) composite doped with p-toluene sulfonic acid (pTSA) was prepared using multiwalled carbon nanotubes (MWCNTs) and Sn(IV) tungstate (ST) by in situ oxidative polymerization. The pTSA-doped POT, POT/MWCNT and POT/MWCNT/ST composites were characterized by Fourier-transform infrared spectrometry, X-ray diffraction, scanning electron microscopy, transmission electron microscopy, UV-visible spectrometry and thermogravimetric analysis. The thermogravimetric analysis studies showed that the POT/MWCNT/ST composite was thermally more stable than the pure polymer and the POT/MWCNT composite. The electrical conductivity behaviour of the POT/MWCNT composite was better than that of pure POT and the POT/MWCNT/ST composite. Ammonia and amine vapour sensing studies of the POT/MWCNT/ST composite ion exchangers showed an improved performance.
- 21 January 2015
- Published by Royal Society of Chemistry (RSC) in Analytical Methods
- Vol. 7 (5) , 2077-2086
Electrical conductivity, isothermal stability and amine sensing studies of a synthetic poly-o-toluidine/multiwalled carbon nanotube/Sn(iv) tungstate composite ion exchanger doped with p-toluene sulfonic acid
An electrically conductive poly-o-toluidine (POT) composite doped with p-toluene sulfonic acid (pTSA) was prepared using multiwalled carbon nanotubes (MWCNTs) and Sn(IV) tungstate (ST) by in situ oxidative polymerization. The pTSA-doped POT, POT/MWCNT and POT/MWCNT/ST composites were characterized by Fourier-transform infrared spectrometry, X-ray diffraction, scanning electron microscopy, transmission electron microscopy, UV-visible spectrometry and thermogravimetric analysis. The thermogravimetric analysis studies showed that the POT/MWCNT/ST composite was thermally more stable than the pure polymer and the POT/MWCNT composite. The electrical conductivity behaviour of the POT/MWCNT composite was better than that of pure POT and the POT/MWCNT/ST composite. Ammonia and amine vapour sensing studies of the POT/MWCNT/ST composite ion exchangers showed an improved performance.
- 3 June 2014
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 4 (45) , 23456-23463
Preparations and characterizations of poly-o-toluidine/multiwalled carbon nanotubes/Sn( iv ) tungstate composite ion exchange thin films and their application as a Pb( ii ) selective electrode
Poly-o-toluidine (POT), poly-o-toluidine (POT)/multiwalled carbon nanotubes (MWCNTs), and poly-o-toluidine (POT)/multiwalled carbon nanotubes (MWCNTs)/Sn(IV) tungstate (ST) thin films were prepared by a solution casting method using polystyrene as a binder. The ion exchange capacity (IEC) of the POT/MWCNTs/ST thin film was found 1.05 meq g−1, which is better than the IEC of pure POT (0.7 meq g−1) and POT/MWCNTs (0.9 meq g−1). The formation of POT, POT/MWCNTs and POT/MWCNTs/ST ion exchange thin films were characterized by scanning electron microscopy (SEM), Energy-Dispersive X-ray (EDX), Fourier transform infra-red (FTIR), X-ray diffraction (XRD) and thermogravimetric analysis (TGA). On the basis of results obtained from the distribution co-efficient (Kd) values, a Pb(II) selective electrode of POT/MWCNTs/ST thin films was fabricated. A linear response in the concentration range of 1 × 10−9 to 1 × 10−1 M Pb(II) by using the POT/MWCNTs/ST thin film electrode was obtained.
- 3 June 2014
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 4 (45) , 23456-23463
Preparations and characterizations of poly-o-toluidine/multiwalled carbon nanotubes/Sn( iv ) tungstate composite ion exchange thin films and their application as a Pb( ii ) selective electrode
Poly-o-toluidine (POT), poly-o-toluidine (POT)/multiwalled carbon nanotubes (MWCNTs), and poly-o-toluidine (POT)/multiwalled carbon nanotubes (MWCNTs)/Sn(IV) tungstate (ST) thin films were prepared by a solution casting method using polystyrene as a binder. The ion exchange capacity (IEC) of the POT/MWCNTs/ST thin film was found 1.05 meq g−1, which is better than the IEC of pure POT (0.7 meq g−1) and POT/MWCNTs (0.9 meq g−1). The formation of POT, POT/MWCNTs and POT/MWCNTs/ST ion exchange thin films were characterized by scanning electron microscopy (SEM), Energy-Dispersive X-ray (EDX), Fourier transform infra-red (FTIR), X-ray diffraction (XRD) and thermogravimetric analysis (TGA). On the basis of results obtained from the distribution co-efficient (Kd) values, a Pb(II) selective electrode of POT/MWCNTs/ST thin films was fabricated. A linear response in the concentration range of 1 × 10−9 to 1 × 10−1 M Pb(II) by using the POT/MWCNTs/ST thin film electrode was obtained.
- 1 January 2014
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 264, 84-90
Determination of arsenate in water by anion selective membrane electrode using polyurethane–silica gel fibrous anion exchanger composite
- 1 January 2014
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 264, 84-90
Determination of arsenate in water by anion selective membrane electrode using polyurethane–silica gel fibrous anion exchanger composite
- 30 September 2013
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 1 (3) , 310-319
Ion-exchange and humidity sensing properties of poly-o-anisidine Sn(IV) arsenophosphate nano-composite cation-exchanger
- 30 September 2013
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 1 (3) , 310-319
Ion-exchange and humidity sensing properties of poly-o-anisidine Sn(IV) arsenophosphate nano-composite cation-exchanger
- 31 January 2013
- Published by Elsevier in Composites Part B: Engineering
- Vol. 44 (1) , 692-697
Ion-exchange studies of ‘organic–inorganic’ nano-composite cation-exchanger: Poly-o-anisidine Sn(IV) tungstate and its analytical application for the separations of toxic metals
- 31 January 2013
- Published by Elsevier in Composites Part B: Engineering
- Vol. 44 (1) , 692-697
Ion-exchange studies of ‘organic–inorganic’ nano-composite cation-exchanger: Poly-o-anisidine Sn(IV) tungstate and its analytical application for the separations of toxic metals