Binay K. Dutta
Research Subjects
Binay K. Dutta has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Masita Mohammod
Chemical Engineering Department, Universiti Teknologi Petronas, Petronas, Malaysia
2 shared publicationsSaikat Maitra
Chemical Engineering Department, Universiti Teknologi Petronas, Petronas, Malaysia
2 shared publicationsTushar Kanti Sen
Department of Chemical Engineering, Curtin University of Technology, Perth, Australia
2 shared publicationsDavide Vione
Università di Torino
1 shared publicationHilmi Mukhtar
Dept. of Chemical Engineering, Universiti Teknologi Petronas, Bandar Seri Iskandar, 31750 Tronoh, Perak, Malaysia
1 shared publicationIdzham Fauzi B. M. Ariff
Universiti Teknologi PETRONAS
1 shared publication
Latest Publications
- 24 August 2010
- Published by Wiley in CLEAN – Soil, Air, Water
- Vol. 38 (9) , 850-858
Removal of Cadmium from Aqueous Solution Using Castor Seed Hull: A Kinetic and Equilibrium Study
- 24 August 2010
- Published by Wiley in CLEAN – Soil, Air, Water
- Vol. 38 (9) , 850-858
Removal of Cadmium from Aqueous Solution Using Castor Seed Hull: A Kinetic and Equilibrium Study
- 15 June 2010
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 215 (1-4) , 609-620
Removal of Zn2+ from Aqueous Solution using Castor Seed Hull
- 15 June 2010
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 215 (1-4) , 609-620
Removal of Zn2+ from Aqueous Solution using Castor Seed Hull
- 23 December 2009
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 211 (1-4) , 273-286
Degradation of Monoethanolamine in Aqueous Solution by Fenton’s Reagent with Biological Post-treatment
- 23 December 2009
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 211 (1-4) , 273-286
Degradation of Monoethanolamine in Aqueous Solution by Fenton’s Reagent with Biological Post-treatment
- 1 December 2009
- Published by IWA Publishing in Water Science & Technology
- Vol. 60 (12) , 3017-3024
Active manganese oxide: a novel adsorbent for treatment of wastewater containing azo dye
A new variety of active manganese oxide was prepared, characterized, and tested for its potential of adsorbing Congo Red, a dis-azo dye, from aqueous solutions. Both equilibrium and kinetics were investigated over different values of process parameters such as temperature (25–45°C), adsorbent loading (0.4–0.6%), initial dye concentration (50–500 mg/L), presence of salts (sodium sulphate, 500 mg/L) and the oxygen content (MnOx, x = 1.2, 1.33 and 2) of the adsorbent. The equilibrium adsorption data were fitted to Langmuir and Freundlich isotherms. Langmuir adsorption capacity of the sorbent (x = 1.33) for Congo Red was 38.6 mg/g at room temperature which is substantially higher than those for commercial manganese dioxide, red mud, coir pith, activated carbon, and fly ash. The kinetic data were best interpreted using a pseudo-second order model. The results show that the active manganese oxide used in this work removes the dye by reversible adsorption and has the potential for practical use for remediation of textile industry effluents.
- 1 December 2009
- Published by IWA Publishing in Water Science & Technology
- Vol. 60 (12) , 3017-3024
Active manganese oxide: a novel adsorbent for treatment of wastewater containing azo dye
A new variety of active manganese oxide was prepared, characterized, and tested for its potential of adsorbing Congo Red, a dis-azo dye, from aqueous solutions. Both equilibrium and kinetics were investigated over different values of process parameters such as temperature (25–45°C), adsorbent loading (0.4–0.6%), initial dye concentration (50–500 mg/L), presence of salts (sodium sulphate, 500 mg/L) and the oxygen content (MnOx, x = 1.2, 1.33 and 2) of the adsorbent. The equilibrium adsorption data were fitted to Langmuir and Freundlich isotherms. Langmuir adsorption capacity of the sorbent (x = 1.33) for Congo Red was 38.6 mg/g at room temperature which is substantially higher than those for commercial manganese dioxide, red mud, coir pith, activated carbon, and fly ash. The kinetic data were best interpreted using a pseudo-second order model. The results show that the active manganese oxide used in this work removes the dye by reversible adsorption and has the potential for practical use for remediation of textile industry effluents.
- 24 August 2009
- Published by Wiley in AIChE Journal
- Vol. 55 (12) , 3221-3233
Ab initio energy calculations and macroscopic rate modeling of hydroformylation of higher alkenes by Rh‐based catalyst
Ab initio quantum chemical computations have been done to determine the energetics and reaction pathways of hydroformylation of higher alkenes using a rhodium complex homogeneous catalyst. Calculation of fragments of the potential energy surfaces of the HRh(CO)(PPh3)3‐catalyzed hydroformylation of 1‐decene, 1‐dodecene, and styrene were performed by the restricted Hartree‐Fock method at the second‐order MØller‐Plesset (MP2) level of perturbation theory and basis set of 6‐31++G(d,p). Geometrically optimized structures of the intermediates and transition states were identified. Three generalized rate models were developed on the basis of above reaction path analysis as well as experimental findings reported in the literature. The kinetic and equilibrium parameters of the models were estimated by nonlinear least square regression of available literature data. The model based on H2‐oxidative addition fitted the data best; it predicts the conversion of all the alkenes quite satisfactorily with an average deviation of 7.6% and a maximum deviation of 13%. © 2009 American Institute of Chemical Engineers AIChE J, 2009
- 24 August 2009
- Published by Wiley in AIChE Journal
- Vol. 55 (12) , 3221-3233
Ab initio energy calculations and macroscopic rate modeling of hydroformylation of higher alkenes by Rh‐based catalyst
Ab initio quantum chemical computations have been done to determine the energetics and reaction pathways of hydroformylation of higher alkenes using a rhodium complex homogeneous catalyst. Calculation of fragments of the potential energy surfaces of the HRh(CO)(PPh3)3‐catalyzed hydroformylation of 1‐decene, 1‐dodecene, and styrene were performed by the restricted Hartree‐Fock method at the second‐order MØller‐Plesset (MP2) level of perturbation theory and basis set of 6‐31++G(d,p). Geometrically optimized structures of the intermediates and transition states were identified. Three generalized rate models were developed on the basis of above reaction path analysis as well as experimental findings reported in the literature. The kinetic and equilibrium parameters of the models were estimated by nonlinear least square regression of available literature data. The model based on H2‐oxidative addition fitted the data best; it predicts the conversion of all the alkenes quite satisfactorily with an average deviation of 7.6% and a maximum deviation of 13%. © 2009 American Institute of Chemical Engineers AIChE J, 2009