Thomas H. Myers
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Thomas H. Myers has a total of 139 co-authors. Here are the top co-authors by number of shared publications:
A. J. Ptak
Department of Physics, West Virginia University, Morgantown, West Virginia 26506
6 shared publicationsN. C. Giles
West Virginia University Department of Physics Morgantown, West Virginia 26506
5 shared publicationsB. L. VanMil
West Virginia University Department of Physics Morgantown, West Virginia 26506
4 shared publicationsL. S. Hirsch
West Virginia University
4 shared publications- Nancy C. Giles
West Virginia University Physics Department Morgantown, West Virginia 26506
3 shared publications A.J. Ptak
Department of Physics
2 shared publications
Latest Publications
- 10 February 2014
- Published by American Physical Society (APS) in Physical Review B
- Vol. 89 (7) , 075305
Method for the simultaneous determination of vertical and horizontal mobilities in superlattices
A magnetoresistance method is proposed which extracts both the growth direction mobility and the planar mobility of an anisotropic thin film, such as a superlattice. A magnetic field which varies in magnitude and orientation is employed. Errors appearing in previous magnetotransport studies on superlattices are resolved. In particular, it is shown that the contact layers used to send currents through an active region do not have a negligible resistance, even if they are much more conductive than the active region. The technique is demonstrated on an InAs/GaSb-based structure where the growth axis to planar mobility anisotropy ratio is found to drop rapidly with increasing temperature.
- 10 February 2014
- Published by American Physical Society (APS) in Physical Review B
- Vol. 89 (7) , 075305
Method for the simultaneous determination of vertical and horizontal mobilities in superlattices
A magnetoresistance method is proposed which extracts both the growth direction mobility and the planar mobility of an anisotropic thin film, such as a superlattice. A magnetic field which varies in magnitude and orientation is employed. Errors appearing in previous magnetotransport studies on superlattices are resolved. In particular, it is shown that the contact layers used to send currents through an active region do not have a negligible resistance, even if they are much more conductive than the active region. The technique is demonstrated on an InAs/GaSb-based structure where the growth axis to planar mobility anisotropy ratio is found to drop rapidly with increasing temperature.
- 28 August 2008
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7056, 70560J
Optofluidic photonic crystals for biomolecular fluorescence enhancement: a bottom-up approach for fabricating GaN-based biosensors
The application of photonic crystals in biosensor applications has lead to the development of highly sensitive and selective sensor elements. The research efforts undertaken by this group have led to the development of a photonic crystal transducer that acts as a waveguide, nanofluidic flow channel, and resonant defect cavity. This sensor architecture shows promise for greatly enhancing the emission of naturally fluorescent or fluorescently-labeled biomolecules. Due to its transparency in the visible regime, GaN is a viable candidate for this photonic crystal biosensor application. This paper provides an overview of the sensor architecture as well as a discussion of one particular bottom-up approach to its fabrication. Molecular Beam Epitaxy (MBE) growth of heavily Mg doped GaN can result in inversion of the surface polarity from Ga-polar to N-polar GaN. This bottom-up approach includes patterning and etching of the Mg inversion layer, followed by re-growth of the opposite polarity to produce periodically poled GaN. Subsequent wet etching of N-polar regions then produces a GaN based photonic crystal structure. This process shows promise for achieving high aspect ratio, highly anisotropic nanostructures.
- 28 August 2008
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7056, 70560J
Optofluidic photonic crystals for biomolecular fluorescence enhancement: a bottom-up approach for fabricating GaN-based biosensors
The application of photonic crystals in biosensor applications has lead to the development of highly sensitive and selective sensor elements. The research efforts undertaken by this group have led to the development of a photonic crystal transducer that acts as a waveguide, nanofluidic flow channel, and resonant defect cavity. This sensor architecture shows promise for greatly enhancing the emission of naturally fluorescent or fluorescently-labeled biomolecules. Due to its transparency in the visible regime, GaN is a viable candidate for this photonic crystal biosensor application. This paper provides an overview of the sensor architecture as well as a discussion of one particular bottom-up approach to its fabrication. Molecular Beam Epitaxy (MBE) growth of heavily Mg doped GaN can result in inversion of the surface polarity from Ga-polar to N-polar GaN. This bottom-up approach includes patterning and etching of the Mg inversion layer, followed by re-growth of the opposite polarity to produce periodically poled GaN. Subsequent wet etching of N-polar regions then produces a GaN based photonic crystal structure. This process shows promise for achieving high aspect ratio, highly anisotropic nanostructures.
- 17 January 2007
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 36 (4) , 431-435
The Use of Cathodoluminescence during Molecular Beam Epitaxy Growth of Gallium Nitride to Determine Substrate Temperature
- 17 January 2007
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 36 (4) , 431-435
The Use of Cathodoluminescence during Molecular Beam Epitaxy Growth of Gallium Nitride to Determine Substrate Temperature
- 1 July 2005
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
- Vol. 23 (4) , 1814-1820
Effect of growth conditions, surface orientation, and alloy composition on Cl incorporation and activation in ZnSe and Zn1−xMgxSe grown by molecular beam epitaxy
While chlorine can be incorporated in ZnSe at levels up to about , it is only electrically active at levels up to with almost complete compensation occurring beyond this point. The doping level at which this compensation occurs coincides with a dramatic decrease in growth rate when using as the chlorine source during growth by molecular beam epitaxy. The decrease in growth rate is likely due to competition for Zn atoms between growth and the chlorine. Compensation and degradation of photoluminescence edge emission intensity appear to be directly correlated to the reduced growth rate. Surface chemistry effects on point defect formation and surface reaction kinetics are investigated through comparison of growth and Cl doping of ZnSe on (100) and (211)B oriented substrates, and by dramatically modifying Zn-to-Se ratios during growth. It is shown that growth conditions can be modified to overcome Cl-related growth rate reduction, recovering to some extent the optical and electrical properties. ZnMgSe alloys have a higher Cl solubility than ZnSe, increasing the rate of Cl incorporation by an order of magnitude for the same flux. The growth rate for ZnMgSe was not observed to decrease under high Cl flux. The ZnMgSe alloys were electrically active for roughly an order of magnitude larger Cl concentration than ZnSe. However the increase in band gap with Mg results in a lower net activation of carriers than for equivalently doped ZnSe.- 1 July 2005
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
- Vol. 23 (4) , 1814-1820
Effect of growth conditions, surface orientation, and alloy composition on Cl incorporation and activation in ZnSe and Zn1−xMgxSe grown by molecular beam epitaxy
While chlorine can be incorporated in ZnSe at levels up to about , it is only electrically active at levels up to with almost complete compensation occurring beyond this point. The doping level at which this compensation occurs coincides with a dramatic decrease in growth rate when using as the chlorine source during growth by molecular beam epitaxy. The decrease in growth rate is likely due to competition for Zn atoms between growth and the chlorine. Compensation and degradation of photoluminescence edge emission intensity appear to be directly correlated to the reduced growth rate. Surface chemistry effects on point defect formation and surface reaction kinetics are investigated through comparison of growth and Cl doping of ZnSe on (100) and (211)B oriented substrates, and by dramatically modifying Zn-to-Se ratios during growth. It is shown that growth conditions can be modified to overcome Cl-related growth rate reduction, recovering to some extent the optical and electrical properties. ZnMgSe alloys have a higher Cl solubility than ZnSe, increasing the rate of Cl incorporation by an order of magnitude for the same flux. The growth rate for ZnMgSe was not observed to decrease under high Cl flux. The ZnMgSe alloys were electrically active for roughly an order of magnitude larger Cl concentration than ZnSe. However the increase in band gap with Mg results in a lower net activation of carriers than for equivalently doped ZnSe.- 11 April 2005
- Published by Wiley in physica status solidi (c)
- Vol. 2 (7) , 2250-2253
Demonstration of nearly non‐degenerate electron conduction in InN grown by molecular beam epitaxy
- 11 April 2005
- Published by Wiley in physica status solidi (c)
- Vol. 2 (7) , 2250-2253
Demonstration of nearly non‐degenerate electron conduction in InN grown by molecular beam epitaxy
- 11 April 2005
- Published by Wiley in physica status solidi (c)
- Vol. 2 (7) , 2204-2207
Thermal activation of beryllium‐related photoluminescence by annealing of GaN grown by molecular beam epitaxy
- 11 April 2005
- Published by Wiley in physica status solidi (c)
- Vol. 2 (7) , 2204-2207
Thermal activation of beryllium‐related photoluminescence by annealing of GaN grown by molecular beam epitaxy
- 11 April 2005
- Published by Wiley in physica status solidi (c)
- Vol. 2 (7) , 2174-2177
High temperature limitations for GaN growth by RF‐plasma assisted molecular beam epitaxy: Effects of active nitrogen species, surface polarity, and excess Ga‐overpressure
- 11 April 2005
- Published by Wiley in physica status solidi (c)
- Vol. 2 (7) , 2174-2177
High temperature limitations for GaN growth by RF‐plasma assisted molecular beam epitaxy: Effects of active nitrogen species, surface polarity, and excess Ga‐overpressure
- 15 August 2004
- Published by Elsevier in Journal of Crystal Growth
- Vol. 269 (1) , 29-34
Investigation of multiple carrier effects in InN epilayers using variable magnetic field Hall measurements
- 15 August 2004
- Published by Elsevier in Journal of Crystal Growth
- Vol. 269 (1) , 29-34
Investigation of multiple carrier effects in InN epilayers using variable magnetic field Hall measurements
- 25 May 2004
- Published by AIP Publishing in Applied Physics Letters
- Vol. 84 (24) , 4887-4889
Vacancy defects in O-doped GaN grown by molecular-beam epitaxy: The role of growth polarity and stoichiometry
Positron annihilation spectroscopy is used to study vacancy defects in GaN grown by molecular-beam epitaxy due to different polar directions and varying stoichiometry conditions during oxygen doping. We show that Ga-polar material is free of compensating Ga vacancies up to in Ga stable growth, but high concentrations of are formed in N-stable conditions. We also show that vacancy clusters are formed in N-polar material grown in Ga stable conditions, which may be related to the higher reactivity of the N-polar surface. These clusters have no apparent influence on the electrical properties of the material. We thus infer that their charge state is neutral.- 25 May 2004
- Published by AIP Publishing in Applied Physics Letters
- Vol. 84 (24) , 4887-4889
Vacancy defects in O-doped GaN grown by molecular-beam epitaxy: The role of growth polarity and stoichiometry
Positron annihilation spectroscopy is used to study vacancy defects in GaN grown by molecular-beam epitaxy due to different polar directions and varying stoichiometry conditions during oxygen doping. We show that Ga-polar material is free of compensating Ga vacancies up to in Ga stable growth, but high concentrations of are formed in N-stable conditions. We also show that vacancy clusters are formed in N-polar material grown in Ga stable conditions, which may be related to the higher reactivity of the N-polar surface. These clusters have no apparent influence on the electrical properties of the material. We thus infer that their charge state is neutral.- 1 July 2002
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 31 (7) , 770-775
Heavy Cr doping of ZnSe by molecular beam epitaxy
- 1 July 2002
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 31 (7) , 770-775
Heavy Cr doping of ZnSe by molecular beam epitaxy