H. Kawashima
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
H. Kawashima has a total of 105 co-authors. Here are the top co-authors by number of shared publications:
Y. Miura
Naka Fusion Research Establishment, Naka-shi, Ibaraki-ken 311-0193, Japan
11 shared publicationsH. Ogawa
Naka Fusion Research Establishment, Naka-shi, Ibaraki-ken 311-0193, Japan
10 shared publicationsK. Hoshino
9 shared publicationsM. Mori
9 shared publicationsN. Suzuki
9 shared publicationsS. Sengoku
Naka Fusion Research Establishment, Naka-shi, Ibaraki-ken 311-0193, Japan
9 shared publications
Latest Publications
- 11 February 2011
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 415 (1) , S948-S951
Evaluation of heat and particle controllability on the JT-60SA divertor
- 11 February 2011
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 415 (1) , S948-S951
Evaluation of heat and particle controllability on the JT-60SA divertor
- 6 May 2009
- Published by IOP Publishing in Nuclear Fusion
- Vol. 49 (6)
Simulation study for divertor design to handle huge exhaust power in the SlimCS DEMO reactor
- 6 May 2009
- Published by IOP Publishing in Nuclear Fusion
- Vol. 49 (6)
Simulation study for divertor design to handle huge exhaust power in the SlimCS DEMO reactor
- 23 August 2008
- Published by Elsevier in Fusion Engineering and Design
- Vol. 83 (10-12) , 1643-1647
Design study of JT-60SA divertor for high heat and particle controllability
- 23 August 2008
- Published by Elsevier in Fusion Engineering and Design
- Vol. 83 (10-12) , 1643-1647
Design study of JT-60SA divertor for high heat and particle controllability
- 18 March 2008
- Published by Wiley in Contributions to Plasma Physics
- Vol. 48 (1-3) , 158-163
Analysis of Particle Pumping Using SOLDOR/NEUT2D Code in the JT‐60U Tokamak
In order to understand the particle pumping on JT‐60U, we analyze the roles of atomic and molecular processes using SOLDOR/NEUT2D code. A case of short strike point distance shows that most of neutrals produced on the targets go toward the exhaust slot directly. Whereas, neutrals are scattered in the spherically at random for the long distance case by collision processes and a few of them go toward the slot. It is clarified that the incident neutrals to the slot at low ne /high Te divertor plasma condition are dominated by atoms. Those at high ne /low Te condition are dominated by molecules due to elastic collision.
- 18 March 2008
- Published by Wiley in Contributions to Plasma Physics
- Vol. 48 (1-3) , 158-163
Analysis of Particle Pumping Using SOLDOR/NEUT2D Code in the JT‐60U Tokamak
In order to understand the particle pumping on JT‐60U, we analyze the roles of atomic and molecular processes using SOLDOR/NEUT2D code. A case of short strike point distance shows that most of neutrals produced on the targets go toward the exhaust slot directly. Whereas, neutrals are scattered in the spherically at random for the long distance case by collision processes and a few of them go toward the slot. It is clarified that the incident neutrals to the slot at low ne /high Te divertor plasma condition are dominated by atoms. Those at high ne /low Te condition are dominated by molecules due to elastic collision.
- 30 January 2007
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 363-365, 786-790
Simulation of divertor pumping in JT-60U with SOLDOR/NEUT2D code
- 30 January 2007
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 363-365, 786-790
Simulation of divertor pumping in JT-60U with SOLDOR/NEUT2D code
- 1 February 2006
- Published by Taylor & Francis in Fusion Science and Technology
- Vol. 49 (2) , 168-186
Study of SOL/Divertor Plasmas in JFT-2M
Experimental efforts on JFT-2M have been devoted to understanding the scrape-off-layer (SOL)/divertor plasmas and to investigating power and particle control by boundary plasma modification. Starting in 1985, an open divertor configuration was adopted for the first decade of the JFT-2M experiments. The characteristics of SOL/divertor plasmas such as in/out asymmetry for divertor plasmas, heat and particle diffusivities, and SOL current during an edge-localized-mode event were identified. The power and particle flux was successfully handled by active control methods such as local pumping, boundary plasma ergodization, divertor biasing, electron cyclotron wave edge heating, and fueling optimization. In 1995, to improve the power and particle control capability of the divertor, the JFT-2M divertor was modified to have a closed configuration, which demonstrated the baffling effects with its narrower divertor throat. A dense and cold divertor state (nediv = 4 × 1019 m-3 and Tediv = 4 eV), compatible with improved confinement modes (e.g., H-mode), was realized with strong gas puffing in a closed configuration. Edge plasma fluctuations related to the H-mode physics were identified by an electrostatic probe and magnetic measurements. These are reviewed in this paper.
- 1 February 2006
- Published by Taylor & Francis in Fusion Science and Technology
- Vol. 49 (2) , 168-186
Study of SOL/Divertor Plasmas in JFT-2M
Experimental efforts on JFT-2M have been devoted to understanding the scrape-off-layer (SOL)/divertor plasmas and to investigating power and particle control by boundary plasma modification. Starting in 1985, an open divertor configuration was adopted for the first decade of the JFT-2M experiments. The characteristics of SOL/divertor plasmas such as in/out asymmetry for divertor plasmas, heat and particle diffusivities, and SOL current during an edge-localized-mode event were identified. The power and particle flux was successfully handled by active control methods such as local pumping, boundary plasma ergodization, divertor biasing, electron cyclotron wave edge heating, and fueling optimization. In 1995, to improve the power and particle control capability of the divertor, the JFT-2M divertor was modified to have a closed configuration, which demonstrated the baffling effects with its narrower divertor throat. A dense and cold divertor state (nediv = 4 × 1019 m-3 and Tediv = 4 eV), compatible with improved confinement modes (e.g., H-mode), was realized with strong gas puffing in a closed configuration. Edge plasma fluctuations related to the H-mode physics were identified by an electrostatic probe and magnetic measurements. These are reviewed in this paper.
- 27 December 2005
- Published by Elsevier in Fusion Engineering and Design
- Vol. 81 (8-14) , 1613-1620
Divertor modeling for the design of the National Centralized Tokamak with high beta steady-state plasmas
- 27 December 2005
- Published by Elsevier in Fusion Engineering and Design
- Vol. 81 (8-14) , 1613-1620
Divertor modeling for the design of the National Centralized Tokamak with high beta steady-state plasmas
- 23 April 2004
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 46 (5A) , A381-A386
Coherent edge fluctuation measurements in H-mode discharges on JFT-2M
- 23 April 2004
- Published by IOP Publishing in Plasma Physics and Controlled Fusion
- Vol. 46 (5A) , A381-A386
Coherent edge fluctuation measurements in H-mode discharges on JFT-2M
- Open Access
- 24 June 2003
- Published by IOP Publishing in Nuclear Fusion
- Vol. 43 (7) , 586-593
Effects of complex magnetic ripple on fast ions in JFT-2M ferritic insert experiments
In JFT-2M, ferritic steel plates (FPs) were installed on almost the whole inner surface of the vacuum vessel. This arrangement is called the ferritic inside wall (FIW), and is the third step of the advanced material tokamak experiment programme. The toroidal field (TF) ripple was reduced by optimizing the thickness of FPs but the total ripple structure has become more complex, with a non-periodic feature in the toroidal direction, because of the existence of ports and other components that limit the periodic installation of FPs. We investigated the effect of this complex ripple on the heat flux onto the first wall due to fast ion loss. The ripple trapped loss was reduced as a result of the reduced magnetic ripple of the FIW. Additional FPs were also installed outside the vacuum vessel to produce a localized larger ripple. A small ripple trapped loss was observed when the shallow ripple well exists in the poloidal cross section, and a large ripple trapped loss was observed when the ripple well extends deep into the plasma region. Experimental results were almost consistent with computation with a newly developed fully three-dimensional magnetic field orbit-following Monte-Carlo code including the three-dimensional complex structure of the TF ripple and the non-axisymmetric first wall geometry.
- 24 June 2003
- Published by IOP Publishing in Nuclear Fusion
- Vol. 43 (7) , 586-593
Open AccessEffects of complex magnetic ripple on fast ions in JFT-2M ferritic insert experiments
In JFT-2M, ferritic steel plates (FPs) were installed on almost the whole inner surface of the vacuum vessel. This arrangement is called the ferritic inside wall (FIW), and is the third step of the advanced material tokamak experiment programme. The toroidal field (TF) ripple was reduced by optimizing the thickness of FPs but the total ripple structure has become more complex, with a non-periodic feature in the toroidal direction, because of the existence of ports and other components that limit the periodic installation of FPs. We investigated the effect of this complex ripple on the heat flux onto the first wall due to fast ion loss. The ripple trapped loss was reduced as a result of the reduced magnetic ripple of the FIW. Additional FPs were also installed outside the vacuum vessel to produce a localized larger ripple. A small ripple trapped loss was observed when the shallow ripple well exists in the poloidal cross section, and a large ripple trapped loss was observed when the ripple well extends deep into the plasma region. Experimental results were almost consistent with computation with a newly developed fully three-dimensional magnetic field orbit-following Monte-Carlo code including the three-dimensional complex structure of the TF ripple and the non-axisymmetric first wall geometry.
- 7 August 2002
- Published by IOP Publishing in Nuclear Fusion
- Vol. 42 (8) , 1008-1013
Investigation on ripple loss reduction by ferritic steel plate insertion in JFT-2M: comparison between experimental and computational data
Ripple loss reduction resulting in reduced losses of fast ions was demonstrated successfully at the JFT-2M tokamak by installing ferritic plates between the vacuum vessel and toroidal field coils. This paper describes the comparison between the experimental results and computation based on the orbit following a Monte Carlo code. They are in qualitatively good agreement in the cases where the toroidal distribution of the toroidal field ripple is almost periodic (e.g. ferritic plate installed resulting in a complex periodic structure of the magnetic ripple), but differ in the case of toroidally small average ripple exhibiting non-periodic large local ones (e.g. ferritic plate installed resulting in a more complex non-periodic structure of the magnetic ripple).
- 7 August 2002
- Published by IOP Publishing in Nuclear Fusion
- Vol. 42 (8) , 1008-1013
Investigation on ripple loss reduction by ferritic steel plate insertion in JFT-2M: comparison between experimental and computational data
Ripple loss reduction resulting in reduced losses of fast ions was demonstrated successfully at the JFT-2M tokamak by installing ferritic plates between the vacuum vessel and toroidal field coils. This paper describes the comparison between the experimental results and computation based on the orbit following a Monte Carlo code. They are in qualitatively good agreement in the cases where the toroidal distribution of the toroidal field ripple is almost periodic (e.g. ferritic plate installed resulting in a complex periodic structure of the magnetic ripple), but differ in the case of toroidally small average ripple exhibiting non-periodic large local ones (e.g. ferritic plate installed resulting in a more complex non-periodic structure of the magnetic ripple).