Margot Deruyck
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Margot Deruyck has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Wout Joseph
Ghent University/IMEC
5 shared publications Luc Martens
Department of Information Technology Ghent University/iMinds Ghent Belgium
4 shared publicationsEmmeric Tanghe
Department of Information Technology Ghent University/iMinds Ghent Belgium
2 shared publicationsBart Lannoo
Department of Information Technology (INTEC) Ghent University/IBBT Gaston Crommenlaan 8 9050 Ghent Belgium
1 shared publicationDaan Pareit
Department of Information Technology (INTEC) Ghent University/IBBT Gaston Crommenlaan 8 9050 Ghent Belgium
1 shared publicationErik Vanhauwaert
Department of Information Technology (INTEC) Ghent University/IBBT Gaston Crommenlaan 8 9050 Ghent Belgium
1 shared publication
Latest Publications
- Open Access
- 29 August 2014
- Published by American Geophysical Union (AGU) in Radio Science
- Vol. 49 (9) , 777-787
Reducing the power consumption in LTE‐Advanced wireless access networks by a capacity based deployment tool
As both the bit rate required by applications on mobile devices and the number of those mobile devices are steadily growing, wireless access networks need to be expanded. As wireless networks also consume a lot of energy, it is important to develop energy‐efficient wireless access networks in the near future. In this study, a capacity‐based deployment tool for the design of energy‐efficient wireless access networks is proposed. Capacity‐based means that the network responds to the instantaneous bit rate requirements of the users active in the selected area. To the best of our knowledge, such a deployment tool for energy‐efficient wireless access networks has never been presented before. This deployment tool is applied to a realistic case in Ghent, Belgium, to investigate three main functionalities incorporated in LTE‐Advanced: carrier aggregation, heterogeneous deployments, and Multiple‐Input Multiple‐Output (MIMO). The results show that it is recommended to introduce femtocell base stations, supporting both MIMO and carrier aggregation, into the network (heterogeneous deployment) to reduce the network's power consumption. For the selected area and the assumptions made, this results in a power consumption reduction up to 70%. Introducing femtocell base stations without MIMO and carrier aggregation can already result in a significant power consumption reduction of 38%.
- 29 August 2014
- Published by American Geophysical Union (AGU) in Radio Science
- Vol. 49 (9) , 777-787
Open AccessReducing the power consumption in LTE‐Advanced wireless access networks by a capacity based deployment tool
As both the bit rate required by applications on mobile devices and the number of those mobile devices are steadily growing, wireless access networks need to be expanded. As wireless networks also consume a lot of energy, it is important to develop energy‐efficient wireless access networks in the near future. In this study, a capacity‐based deployment tool for the design of energy‐efficient wireless access networks is proposed. Capacity‐based means that the network responds to the instantaneous bit rate requirements of the users active in the selected area. To the best of our knowledge, such a deployment tool for energy‐efficient wireless access networks has never been presented before. This deployment tool is applied to a realistic case in Ghent, Belgium, to investigate three main functionalities incorporated in LTE‐Advanced: carrier aggregation, heterogeneous deployments, and Multiple‐Input Multiple‐Output (MIMO). The results show that it is recommended to introduce femtocell base stations, supporting both MIMO and carrier aggregation, into the network (heterogeneous deployment) to reduce the network's power consumption. For the selected area and the assumptions made, this results in a power consumption reduction up to 70%. Introducing femtocell base stations without MIMO and carrier aggregation can already result in a significant power consumption reduction of 38%.
- 7 January 2013
- Published by Elsevier in Computer Networks
- Vol. 57 (5) , 1217-1233
Energy efficiency of femtocell deployment in combined wireless/optical access networks
- 7 January 2013
- Published by Elsevier in Computer Networks
- Vol. 57 (5) , 1217-1233
Energy efficiency of femtocell deployment in combined wireless/optical access networks
- 28 August 2012
- Published by Wiley in Transactions on Emerging Telecommunications Technologies
- Vol. 25 (3) , 343-353
WiMAX‐based monitoring network for a utility company: a case study
As the network of a power distribution company can be very large, maintaining such a network is not only very time‐consuming but also very costly, especially when failures occur. A huge amount of effort could be saved by monitoring the substations remotely, which allows, amongst others, to trace failures more efficiently. In this study, such a monitoring network is designed based on WiMAX in ‘Flanders’, Belgium. To the best of the authors' knowledge, this study differs from previous studies by combining both coverage and cost calculations. Firstly, the number of base stations needed to cover the considered area is determined. Therefore, link budget calculations are performed to obtain the ranges of the base stations. Secondly, the cost to install and maintain the network is determined using the results of the first step.A cost of approximately 6.5 EUR was found per km2that needs to be covered. This result is very sensitive to possible changes of the technical parameters, which can lead to cost fluctuations between 33.5% and 3007%. Changes in the cost parameters have, however, less impact on the total cost than the technical parameters. Copyright © 2012 John Wiley & Sons, Ltd.
- 28 August 2012
- Published by Wiley in Transactions on Emerging Telecommunications Technologies
- Vol. 25 (3) , 343-353
WiMAX‐based monitoring network for a utility company: a case study
As the network of a power distribution company can be very large, maintaining such a network is not only very time‐consuming but also very costly, especially when failures occur. A huge amount of effort could be saved by monitoring the substations remotely, which allows, amongst others, to trace failures more efficiently. In this study, such a monitoring network is designed based on WiMAX in ‘Flanders’, Belgium. To the best of the authors' knowledge, this study differs from previous studies by combining both coverage and cost calculations. Firstly, the number of base stations needed to cover the considered area is determined. Therefore, link budget calculations are performed to obtain the ranges of the base stations. Secondly, the cost to install and maintain the network is determined using the results of the first step.A cost of approximately 6.5 EUR was found per km2that needs to be covered. This result is very sensitive to possible changes of the technical parameters, which can lead to cost fluctuations between 33.5% and 3007%. Changes in the cost parameters have, however, less impact on the total cost than the technical parameters. Copyright © 2012 John Wiley & Sons, Ltd.
- 28 August 2012
- Published by Wiley in Transactions on Emerging Telecommunications Technologies
- Vol. 25 (3) , 320-333
Power consumption model for macrocell and microcell base stations
In this paper, a power consumption model for both macrocell and microcell base stations is proposed. This model is validated by temporal power measurements on actual base stations, and an excellent agreement is obtained. Furthermore, the power consumption's evolution during the day is investigated by means of these measurements. The energy efficiency of three different wireless technologies is compared namely mobile Worldwide Interoperability for Microwave Access, Long Term Evolution and High Speed Packet Access. With the model proposed, the deployment tool Green Radio Access Network Design is implemented, which allows to design an energy‐efficient access network for a predefined area. In general and with the assumptions made, a macrocell base station consumes about 4.4 times more than a microcell base station. However, a microcell base station is less energy efficient than a macrocell base station because of its lower coverage range. Despite this, it is still useful to introduce them in the network as the same coverage can be obtained with a lower total power consumption than with a network where only macrocell base stations are used. Copyright © 2012 John Wiley & Sons, Ltd.
- 28 August 2012
- Published by Wiley in Transactions on Emerging Telecommunications Technologies
- Vol. 25 (3) , 320-333
Power consumption model for macrocell and microcell base stations
In this paper, a power consumption model for both macrocell and microcell base stations is proposed. This model is validated by temporal power measurements on actual base stations, and an excellent agreement is obtained. Furthermore, the power consumption's evolution during the day is investigated by means of these measurements. The energy efficiency of three different wireless technologies is compared namely mobile Worldwide Interoperability for Microwave Access, Long Term Evolution and High Speed Packet Access. With the model proposed, the deployment tool Green Radio Access Network Design is implemented, which allows to design an energy‐efficient access network for a predefined area. In general and with the assumptions made, a macrocell base station consumes about 4.4 times more than a microcell base station. However, a microcell base station is less energy efficient than a macrocell base station because of its lower coverage range. Despite this, it is still useful to introduce them in the network as the same coverage can be obtained with a lower total power consumption than with a network where only macrocell base stations are used. Copyright © 2012 John Wiley & Sons, Ltd.
- Open Access
- 8 August 2012
- Published by Springer Nature in EURASIP Journal on Wireless Communications and Networking
- Vol. 2012 (1) , 248
Characterization and optimization of the power consumption in wireless access networks by taking daily traffic variations into account
- 8 August 2012
- Published by Springer Nature in EURASIP Journal on Wireless Communications and Networking
- Vol. 2012 (1) , 248
Open AccessCharacterization and optimization of the power consumption in wireless access networks by taking daily traffic variations into account