Luis Sainz
Research Subjects
Luis Sainz has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Joaquín Pedra3 shared publications
- Juan José Mesas
Department of Electrical Engineering (DEE), Escola d’Enginyeria de Barcelona Est (EEBE), Universitat Politècnica de Catalunya—BarcelonaTech (UPC), Av. d’Eduard Maristany 16, 08019 Barcelona, Spain
2 shared publications - O. Boix2 shared publications
- Albert Ferrer
Tech Univ Catalonia, Dept Appl Math, Barcelona, Spain
1 shared publication - Felipe Córcoles
Department of Electrical Engineering, Universitat Politècnica de Catalunya (UPC), C. Colom 1, 08222 Terrassa, Spain
1 shared publication - J. Clua1 shared publication
Latest Publications
- 5 August 2015
- Published by Taylor & Francis in Electric Power Components and Systems
- Vol. 43 (15) , 1771-1780
Study of Resonances in 1 × 25 kV AC Traction Systems
- 5 August 2015
- Published by Taylor & Francis in Electric Power Components and Systems
- Vol. 43 (15) , 1771-1780
Study of Resonances in 1 × 25 kV AC Traction Systems
- 28 February 2013
- Published by Elsevier in Electric Power Systems Research
- Vol. 95, 112-120
Model of discharge lamps with magnetic ballast
- 28 February 2013
- Published by Elsevier in Electric Power Systems Research
- Vol. 95, 112-120
Model of discharge lamps with magnetic ballast
- 1 January 2011
- Published by Elsevier in Electric Power Systems Research
- Vol. 81 (1) , 10-18
Deterministic and stochastic assessment of the harmonic currents consumed by discharge lamps
- 1 January 2011
- Published by Elsevier in Electric Power Systems Research
- Vol. 81 (1) , 10-18
Deterministic and stochastic assessment of the harmonic currents consumed by discharge lamps
- 1 January 2009
- Published by Elsevier in Electric Power Systems Research
- Vol. 79 (1) , 161-169
Background voltage distortion influence on power electric systems in the presence of the Steinmetz circuit
- 1 January 2009
- Published by Elsevier in Electric Power Systems Research
- Vol. 79 (1) , 161-169
Background voltage distortion influence on power electric systems in the presence of the Steinmetz circuit
- 7 September 2007
- Published by Wiley in European Transactions on Electrical Power
- Vol. 10 (2) , 93-97
Harmonic interaction in capacitor rectifier loads
- 7 September 2007
- Published by Wiley in European Transactions on Electrical Power
- Vol. 10 (2) , 93-97
Harmonic interaction in capacitor rectifier loads
- 2 April 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 22 (2) , 986-995
Theoretical Calculation of Inrush Currents in Three- and Five-Legged Core Transformers
In this paper, a theoretical study of the three-phase transformer behavior in the presence of a sag is presented by considering that the fault clearing is produced simultaneously in all phases. Analytical expressions of the magnetic flux and the inrush current after voltage recovery are obtained, and the results presented in the literature are analytically justified. The influence of depth, duration, and the initial point-on-wave on the peak value of the inrush current are studied for all sag types. Simple expressions to obtain the value of the current peaks are presented
- 2 April 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 22 (2) , 986-995
Theoretical Calculation of Inrush Currents in Three- and Five-Legged Core Transformers
In this paper, a theoretical study of the three-phase transformer behavior in the presence of a sag is presented by considering that the fault clearing is produced simultaneously in all phases. Analytical expressions of the magnetic flux and the inrush current after voltage recovery are obtained, and the results presented in the literature are analytically justified. The influence of depth, duration, and the initial point-on-wave on the peak value of the inrush current are studied for all sag types. Simple expressions to obtain the value of the current peaks are presented
- 1 May 2003
- Published by Wiley in European Transactions on Electrical Power
- Vol. 13 (3) , 185-192
Behaviour of single‐phase full‐wave rectifier
This paper describes the line side behaviour of single‐phase uncontrolled rectifiers with AC‐side reactance and capacitive load, depending on the short‐circuit ratio at the valve side of the rectifier. The influence of both finite DC link capacitance and AC ohmic resistance is considered in the analysis too. As a result of the study, a set of graphics was generated. This allows a user‐friendly estimation of the line current consumed by the device (fundamental and harmonic currents).
- 1 May 2003
- Published by Wiley in European Transactions on Electrical Power
- Vol. 13 (3) , 185-192
Behaviour of single‐phase full‐wave rectifier
This paper describes the line side behaviour of single‐phase uncontrolled rectifiers with AC‐side reactance and capacitive load, depending on the short‐circuit ratio at the valve side of the rectifier. The influence of both finite DC link capacitance and AC ohmic resistance is considered in the analysis too. As a result of the study, a set of graphics was generated. This allows a user‐friendly estimation of the line current consumed by the device (fundamental and harmonic currents).
- 1 July 2002
- Published by Wiley in European Transactions on Electrical Power
- Vol. 12 (4) , 283-290
Steinmetz system design under unbalanced conditions
This paper studies and develops general analytical expressions to obtain three‐phase current symmetrization under unbalanced voltage conditions. It proposes two procedures for this symmetrization: the application of the traditional expressions assuming symmetry conditions and the use of optimization methods based in the general analytical equations. Specifically, the paper applies and evaluates these methods to analyze the Steinmetz system design. Several graphics evaluating the error introduced by assumption of balanced voltage in the design are plotted and an example is studied to compare both procedures. In the example the necessity to apply the optimization techniques in highly unbalanced conditions is demonstrated.
- 1 July 2002
- Published by Wiley in European Transactions on Electrical Power
- Vol. 12 (4) , 283-290
Steinmetz system design under unbalanced conditions
This paper studies and develops general analytical expressions to obtain three‐phase current symmetrization under unbalanced voltage conditions. It proposes two procedures for this symmetrization: the application of the traditional expressions assuming symmetry conditions and the use of optimization methods based in the general analytical equations. Specifically, the paper applies and evaluates these methods to analyze the Steinmetz system design. Several graphics evaluating the error introduced by assumption of balanced voltage in the design are plotted and an example is studied to compare both procedures. In the example the necessity to apply the optimization techniques in highly unbalanced conditions is demonstrated.
- 1 January 2001
- Published by Wiley in European Transactions on Electrical Power
- Vol. 11 (1) , 49-56
Load modelling for analysis of power‐system harmonics under unbalanced conditions
This paper analyses the load‐harmonic modelling under unbalanced conditions. It presents a harmonic characterization of linear three‐phase loads (three‐phase P‐Q consumptions) for different impedance configurations and analytical models for an ideal six‐ and twelve‐pulse converter supplied by unbalanced voltages, too. The models of these linear and non‐linear loads are incorporated to the three‐phase harmonic load‐flow formulation. A 15‐bus network is presented to study the different load behaviour.
- 1 January 2001
- Published by Wiley in European Transactions on Electrical Power
- Vol. 11 (1) , 49-56
Load modelling for analysis of power‐system harmonics under unbalanced conditions
This paper analyses the load‐harmonic modelling under unbalanced conditions. It presents a harmonic characterization of linear three‐phase loads (three‐phase P‐Q consumptions) for different impedance configurations and analytical models for an ideal six‐ and twelve‐pulse converter supplied by unbalanced voltages, too. The models of these linear and non‐linear loads are incorporated to the three‐phase harmonic load‐flow formulation. A 15‐bus network is presented to study the different load behaviour.
- 1 September 1999
- Published by Wiley in European Transactions on Electrical Power
- Vol. 9 (5) , 317-326
Non-divergent numerical method for the harmonic load-flow resolution
- 1 September 1999
- Published by Wiley in European Transactions on Electrical Power
- Vol. 9 (5) , 317-326
Non-divergent numerical method for the harmonic load-flow resolution