E. K. Mann
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
E. K. Mann has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- J.-C. Voegel
Institut National de la Santé et de la Recherche Médicale. Unité 424, Fédération de Recherches “Odontologie,” Université Louis Pasteur, 11, rue Humann, 67085 Strasbourg Cedex, France
3 shared publications L. Heinrich
Institut Charles Sadron
3 shared publications- Pierre Schaaf
INSERM/Université De Strasbourg, UMR_S1121, France
3 shared publications - Bernard Senger
Institut National de la Santé et de la Recherche Médicale, UMR_S 1121, Strasbourg, France
1 shared publication J. C. Voegel
Institut National de la Santé et de la Recherche Médicale
1 shared publicationM. Semmler
Federal Institute of Technology-Zurich (ITÖ-ETH), Grabenstrasse 3, CH-8952 Schlieren, Switzerland
1 shared publication
Latest Publications
- 13 January 2008
- Published by Springer Nature
- p. 296-299
How much can you learn about thin adsorbed layers with optical techniques?
- 13 January 2008
- Published by Springer Nature
- p. 296-299
How much can you learn about thin adsorbed layers with optical techniques?
- 20 December 1999
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 83 (25) , 5397-5400
Stability of Two-Dimensional Foams in Langmuir Monolayers
Two-dimensional foams within a polymer Langmuir monolayer show markedly different stability on two different substrates. This contrast is used to explore foam stability in Langmuir layers. The relaxation of 2D isolated droplets allows both the measurement of the line tension and the assessment of hydrodynamics. Surface potential measurements assess long-range electrostatic repulsion due to alignment of molecular dipoles at the surface. The surface potential difference between gaseous and liquid polymer domains is larger, by more than a factor of 7, where foams are stable than where they are not.
- 20 December 1999
- Published by American Physical Society (APS) in Physical Review Letters
- Vol. 83 (25) , 5397-5400
Stability of Two-Dimensional Foams in Langmuir Monolayers
Two-dimensional foams within a polymer Langmuir monolayer show markedly different stability on two different substrates. This contrast is used to explore foam stability in Langmuir layers. The relaxation of 2D isolated droplets allows both the measurement of the line tension and the assessment of hydrodynamics. Surface potential measurements assess long-range electrostatic repulsion due to alignment of molecular dipoles at the surface. The surface potential difference between gaseous and liquid polymer domains is larger, by more than a factor of 7, where foams are stable than where they are not.
- 1 May 1998
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 108 (17) , 7416-7425
Sensitivity of optical methods to the homogeneity of particulate layers
For stratified layers, it was recently demonstrated that information about the structure of thin dielectric layers could be determined from scanning angle reflectometry measurements independent of any model of the interface. A measure of the deviation of the film from uniform was defined and demonstrated to be measurable. This analysis is extended here to the case of particulate layers, where we show that the same uniformity parameter can give information about the deviation of the distribution of particles on the surface from a uniform one. Preliminary optical data on moderately sized polystyrene particles, 116 nm in diameter, suggest that the closest approach of two particles on the surface is considerably greater than their diameter. This is in agreement with direct measurements of the radial distribution functions of these particles adsorbed on surfaces under similar conditions.
- 1 May 1998
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 108 (17) , 7416-7425
Sensitivity of optical methods to the homogeneity of particulate layers
For stratified layers, it was recently demonstrated that information about the structure of thin dielectric layers could be determined from scanning angle reflectometry measurements independent of any model of the interface. A measure of the deviation of the film from uniform was defined and demonstrated to be measurable. This analysis is extended here to the case of particulate layers, where we show that the same uniformity parameter can give information about the deviation of the distribution of particles on the surface from a uniform one. Preliminary optical data on moderately sized polystyrene particles, 116 nm in diameter, suggest that the closest approach of two particles on the surface is considerably greater than their diameter. This is in agreement with direct measurements of the radial distribution functions of these particles adsorbed on surfaces under similar conditions.
- 8 October 1996
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 105 (14) , 6082-6085
Optical characterization of thin films: Beyond the uniform layer model
Scanning angle reflectometry (SAR) is used to investigate the structure of antigen/antibody layers deposited on a silica surface. The reflectivity curves are analyzed by the means of the optical invariants, which permits the determination of three structural characteristic parameters for the layer. A new invariant is constructed that yields information about the repartition of mass in the layer and thus goes beyond the usual uniform layer model. In our case, this model does not hold: the layer appears to be denser away from the adsorbing silica surface than near that surface.
- 8 October 1996
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 105 (14) , 6082-6085
Optical characterization of thin films: Beyond the uniform layer model
Scanning angle reflectometry (SAR) is used to investigate the structure of antigen/antibody layers deposited on a silica surface. The reflectivity curves are analyzed by the means of the optical invariants, which permits the determination of three structural characteristic parameters for the layer. A new invariant is constructed that yields information about the repartition of mass in the layer and thus goes beyond the usual uniform layer model. In our case, this model does not hold: the layer appears to be denser away from the adsorbing silica surface than near that surface.
- 8 November 1995
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 103 (18) , 8285-8295
Statistical properties of surfaces covered by deposited particles
- 8 November 1995
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 103 (18) , 8285-8295
Statistical properties of surfaces covered by deposited particles