Jeanne Malet
Research Subjects
Research Interests
Jeanne Malet has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- C. Perrotin
Institute for Radioprotection and Nuclear Safety, DSU/SERAC/LEMAC, BP68 - 91192 Gif-sur-Yvette cedex, France
1 shared publication D. Costa
1 shared publication- Delphine Costa
Institut de Radioprotection et de Sûreté Nucléaire (IRSN), PSN-RES, SCA, LEMAC, Gif-sur-Yvette, 91192, France
1 shared publication E. Gehin
1 shared publicationEvelyne Géhin
Univ Paris Est Creteil, CERTES, F-94010 Creteil, France
1 shared publicationJ. Travis
KIT, Karlsruhe, Germany
1 shared publication
Latest Publications
- 6 June 2022
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 33 (9) , 094001
An experimental protocol for measuring aerosol deposition in industrial-sized ventilation ducts
In the literature, studies on aerosol deposition in ventilation ducts mainly focus on ventilation ducts with a hydraulic diameter ( D h ) of around 15–25 cm and with circular or square cross-sections. However, to the best of our knowledge, common industrial-sized ventilation ducts ( D h ∼ 50 cm) with rectangular cross-sections have not been studied. As a result, experimental aerosol deposition measurement protocols relative to smaller ventilation ducts are not suitable for measurements in industrial-sized ducts. Therefore, a new experimental protocol is proposed here, which can be used without destruction of the surface or addition of a substrate onto the duct surface and which could be applied in industrial ventilation networks if certain conditions are met. In this paper, we present an experimental protocol developed to measure aerosol deposition in large-scale ventilation ducts. First, the collection and measurement technique, the type of aerosol and the injection method are chosen. Second, an experimental protocol relative to the collection of aerosols deposited on duct surfaces is developed, based on a so-called ‘wiping’ technique. Many verifications are presented to ensure repeatable and reproducible measurements. Third, a repeatability study is conducted as well as a validation process. In the last section of this paper, we present some results on aerosol deposition obtained at a test facility compared to two other studies.
- 6 June 2022
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 33 (9) , 094001
An experimental protocol for measuring aerosol deposition in industrial-sized ventilation ducts
In the literature, studies on aerosol deposition in ventilation ducts mainly focus on ventilation ducts with a hydraulic diameter ( D h ) of around 15–25 cm and with circular or square cross-sections. However, to the best of our knowledge, common industrial-sized ventilation ducts ( D h ∼ 50 cm) with rectangular cross-sections have not been studied. As a result, experimental aerosol deposition measurement protocols relative to smaller ventilation ducts are not suitable for measurements in industrial-sized ducts. Therefore, a new experimental protocol is proposed here, which can be used without destruction of the surface or addition of a substrate onto the duct surface and which could be applied in industrial ventilation networks if certain conditions are met. In this paper, we present an experimental protocol developed to measure aerosol deposition in large-scale ventilation ducts. First, the collection and measurement technique, the type of aerosol and the injection method are chosen. Second, an experimental protocol relative to the collection of aerosols deposited on duct surfaces is developed, based on a so-called ‘wiping’ technique. Many verifications are presented to ensure repeatable and reproducible measurements. Third, a repeatability study is conducted as well as a validation process. In the last section of this paper, we present some results on aerosol deposition obtained at a test facility compared to two other studies.
- 2 June 2022
- Published by Elsevier in Building and Environment
- Vol. 222
Flow characterization of various singularities in a real-scale ventilation network with rectangular ducts
- 2 June 2022
- Published by Elsevier in Building and Environment
- Vol. 222
Flow characterization of various singularities in a real-scale ventilation network with rectangular ducts
- Open Access
Statistics of a Sharp GP2Y Low-Cost Aerosol PM Sensor Output Signals
In this work, we characterise the performance of a Sharp optical aerosol sensor model GP2Y1010AU0F. The sensor was exposed to different environments: to a clean room, to a controlled atmosphere with known aerosol size distribution and to the ambient atmosphere on a busy city street. During the exposure, the output waveforms of the sensor pulses were digitised, saved and a following offline analysis enabled us to study the behaviour of the sensor pulse-by-pulse. A linear response of the sensor on number concentration of the monosized dispersed PSL particles was shown together with an almost linear dependence on particle diameters in the 0.4 to 4 micrometer range. The gathered data about the sensor were used to predict its response to an ambient atmosphere, which was observed simultaneously with a calibrated optical particle counter.
Open AccessStatistics of a Sharp GP2Y Low-Cost Aerosol PM Sensor Output Signals
In this work, we characterise the performance of a Sharp optical aerosol sensor model GP2Y1010AU0F. The sensor was exposed to different environments: to a clean room, to a controlled atmosphere with known aerosol size distribution and to the ambient atmosphere on a busy city street. During the exposure, the output waveforms of the sensor pulses were digitised, saved and a following offline analysis enabled us to study the behaviour of the sensor pulse-by-pulse. A linear response of the sensor on number concentration of the monosized dispersed PSL particles was shown together with an almost linear dependence on particle diameters in the 0.4 to 4 micrometer range. The gathered data about the sensor were used to predict its response to an ambient atmosphere, which was observed simultaneously with a calibrated optical particle counter.
- 21 July 2014
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 74, 134-142
Achievements of spray activities in nuclear reactor containments during the last decade
- 21 July 2014
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 74, 134-142
Achievements of spray activities in nuclear reactor containments during the last decade
- 27 July 2013
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 263, 395-405
Water evaporation over sump surface in nuclear containment studies: CFD and LP codes validation on TOSQAN tests
- 27 July 2013
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 263, 395-405
Water evaporation over sump surface in nuclear containment studies: CFD and LP codes validation on TOSQAN tests
- 2 April 2011
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 241 (5) , 1726-1735
Modelling of water sump evaporation in a CFD code for nuclear containment studies
- 2 April 2011
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 241 (5) , 1726-1735
Modelling of water sump evaporation in a CFD code for nuclear containment studies