Ryuichi Ishizaki
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Ryuichi Ishizaki has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Noriyoshi Nakajima
National Institute for Fusion Science
2 shared publicationsK. Nishihara
Institute of Laser Engineering, Osaka University, 2-6 Yamada-oka, Suita, Osaka 565-0871, Japan
1 shared publicationMasao Okamoto
National Institute for Fusion Science, 322-6 Oroshi-cho, Toki, Gifu 509-5292, Japan
1 shared publicationPaul B. Parks
General Atomics, San Diego, CA 92121, USA
1 shared publication
Latest Publications
- Open Access
- 1 January 2014
- Published by Japan Society of Plasma Science and Nuclear Fusion Research in Plasma and Fusion Research
- Vol. 9, 3403130
MHD Simulations of Pellet Injection in the LHD
To clarify motions of a plasmoid induced by pellet ablation in the Large Helical Device (LHD), MHD simulations have been conducted. When a plasmoid is located on the inboard side of the mid-plane in the LHD, it drifts in the negative direction of the major radius not only on the horizontally elongated poloidal cross section but also on the vertically elongated poloidal cross section. This means that the plasmoid drifts to the lower field side in the former and to the higher field side in the latter. Our simulations show that these motions are determined by the direction of the curvature vector and the magnetic pressure distribution along the field line at the location of the plasmoid
- 1 January 2014
- Published by Japan Society of Plasma Science and Nuclear Fusion Research in Plasma and Fusion Research
- Vol. 9, 3403130
Open AccessMHD Simulations of Pellet Injection in the LHD
To clarify motions of a plasmoid induced by pellet ablation in the Large Helical Device (LHD), MHD simulations have been conducted. When a plasmoid is located on the inboard side of the mid-plane in the LHD, it drifts in the negative direction of the major radius not only on the horizontally elongated poloidal cross section but also on the vertically elongated poloidal cross section. This means that the plasmoid drifts to the lower field side in the former and to the higher field side in the latter. Our simulations show that these motions are determined by the direction of the curvature vector and the magnetic pressure distribution along the field line at the location of the plasmoid
- Open Access
- 1 March 2003
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 313-316, 579-583
Fluid simulation on pellet ablation with atomic process
- 1 March 2003
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 313-316, 579-583
Open AccessFluid simulation on pellet ablation with atomic process
- 1 September 1998
- Published by American Physical Society (APS) in Physical Review E
- Vol. 58 (3) , 3744-3767
Model of hydrodynamic perturbation growth in the start-up phase of laser implosion
A simple analytical model is presented to study hydrodynamic perturbation growths driven by nonuniform laser ablation in the start-up phase in laser fusion. Propagation of a rippled shock and deformation of an ablation surface are studied for cases of initial target roughness and nonuniform laser irradiation. The study of the perturbation growth in the start-up phase is very important because it seeds the Rayleigh-Taylor instability in the subsequent acceleration and stagnation phases. Analytical solutions are obtained for temporal evolutions of the shock front ripple and the ablation surface deformation. As a result, it is seen that the shock front ripples oscillate and decay in both cases. On the other hand, there is an asymptotic amplitude of the ablation surface deformation in the case of uniform laser irradiation on a target with a rippled surface, and an asymptotic growth rate of the ablation surface ripple in the case of nonuniform laser irradiation on a smooth target. In both cases, it can be shown that a high intensity of laser irradiation causes the ablation surface to distort, and a short wavelength laser inhibits its deformation. Approximate formulas expressing the temporal behaviors of the shock front and the ablation surface are obtained in the weak shock limit. Those formulas are also applicable to a relatively strong shock. Analytical results agree quite well with recent experimental data for the shock front ripple and the areal mass density perturbation in the initial target roughness case. The behaviors of the shock front ripple and the ablation surface deformation are also investigated in the case where the nonuniformity of the laser irradiation oscillates with time. It can be seen that the deformation of the ablation surface is inhibited for a high oscillation frequency of the laser nonuniformity.
- 1 September 1998
- Published by American Physical Society (APS) in Physical Review E
- Vol. 58 (3) , 3744-3767
Model of hydrodynamic perturbation growth in the start-up phase of laser implosion
A simple analytical model is presented to study hydrodynamic perturbation growths driven by nonuniform laser ablation in the start-up phase in laser fusion. Propagation of a rippled shock and deformation of an ablation surface are studied for cases of initial target roughness and nonuniform laser irradiation. The study of the perturbation growth in the start-up phase is very important because it seeds the Rayleigh-Taylor instability in the subsequent acceleration and stagnation phases. Analytical solutions are obtained for temporal evolutions of the shock front ripple and the ablation surface deformation. As a result, it is seen that the shock front ripples oscillate and decay in both cases. On the other hand, there is an asymptotic amplitude of the ablation surface deformation in the case of uniform laser irradiation on a target with a rippled surface, and an asymptotic growth rate of the ablation surface ripple in the case of nonuniform laser irradiation on a smooth target. In both cases, it can be shown that a high intensity of laser irradiation causes the ablation surface to distort, and a short wavelength laser inhibits its deformation. Approximate formulas expressing the temporal behaviors of the shock front and the ablation surface are obtained in the weak shock limit. Those formulas are also applicable to a relatively strong shock. Analytical results agree quite well with recent experimental data for the shock front ripple and the areal mass density perturbation in the initial target roughness case. The behaviors of the shock front ripple and the ablation surface deformation are also investigated in the case where the nonuniformity of the laser irradiation oscillates with time. It can be seen that the deformation of the ablation surface is inhibited for a high oscillation frequency of the laser nonuniformity.