A. E. Gorodetskii
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
A. E. Gorodetskii has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
- A. P. Zakharov
Institute of Physical Chemistry, Russian Academy of Sciences, Leninsky pr. 31, 117915 Moscow, Russian Federation
11 shared publications R.Kh. Zalavutdinov
5 shared publicationsV.L. Bukhovets
4 shared publicationsA. P. Zakharov
Russian Academy of Sciences
3 shared publicationsA.P. Zakharov
Institute of Physical Chemistry, Russian Academy of Sciences, Leninsky pr., 31, Moscow, 119991, Russian Federation
3 shared publicationsR. Kh. Zalavutdinov
Russian Academy of Sciences
3 shared publications
Latest Publications
- 1 August 2015
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 463, 255-257
Sputtering of W and Al in D2/O2 plasma cleaning discharge
- 1 August 2015
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 463, 255-257
Sputtering of W and Al in D2/O2 plasma cleaning discharge
- 1 August 2011
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 415 (1) , S129-S132
Erosion of a-C:H films deposited on W, Mo, and stainless steel under interaction with air glow discharge
- 1 August 2011
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 415 (1) , S129-S132
Erosion of a-C:H films deposited on W, Mo, and stainless steel under interaction with air glow discharge
- 1 November 2010
- Published by Pleiades Publishing Ltd in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
- Vol. 4 (6) , 928-934
Transformations of hydrocarbon radicals moving along a stainless steel tube
Transport of exhausted thermonuclear fuel in the ITER divertor and pumping duct was modeled on a specially designed dc glow discharge setup using mass spectrometry, optical and electron microscopy, and electron probe microanalysis. Transport and deposition of hydrocarbon radicals transferred in an H2/C x H yx mixture through a hollow stainless steel anode at a total mixture pressure of 8–212 Pa and a methane content to 15 mol % were considered. It was shown that deposition of radicals and ions (CH3, C2H3, C2H5) with kinetic energies of 0.03–3 eV on the anode inner surface at 600 K was suppressed to a large extent. In the temperature range of 600–800 K, deposition of ions and radicals with kinetic energy of ~3 eV was partially restored with the formation of soft a-C:H films, while thermalized radicals were not condensed.
- 1 November 2010
- Published by Pleiades Publishing Ltd in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
- Vol. 4 (6) , 928-934
Transformations of hydrocarbon radicals moving along a stainless steel tube
Transport of exhausted thermonuclear fuel in the ITER divertor and pumping duct was modeled on a specially designed dc glow discharge setup using mass spectrometry, optical and electron microscopy, and electron probe microanalysis. Transport and deposition of hydrocarbon radicals transferred in an H2/C x H yx mixture through a hollow stainless steel anode at a total mixture pressure of 8–212 Pa and a methane content to 15 mol % were considered. It was shown that deposition of radicals and ions (CH3, C2H3, C2H5) with kinetic energies of 0.03–3 eV on the anode inner surface at 600 K was suppressed to a large extent. In the temperature range of 600–800 K, deposition of ions and radicals with kinetic energy of ~3 eV was partially restored with the formation of soft a-C:H films, while thermalized radicals were not condensed.
- 26 November 2008
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry A
- Vol. 82 (13) , 2340-2345
The hydrogenation of methyl on metallic surfaces
The stream technique was used to comparatively analyze the characteristics of the deposition of a-C:H films from methyl radicals transferred by a carrier gas CH4/C2H y /H2 (y = 2, 4, 6) in a quartz tube with cylindrical insets made of Cu, Ni, Fe, W, Si, and stainless steel (SS), initial and coated with thin Pd or Rh films, over the temperature range 300–1000 K. The deposition of methyl was fully suppressed in a tube section heated to 380–800 K with all the insets specified. During further mixture movement outside this section in the tube with a decreasing wall temperature, carbon deposition resumed. The most effective catalyst of the hydrogenation reaction was stainless steel. Radicals and unsaturated hydrocarbons capable of polymerization at 300–400 K were fully removed from the carrier gas flow (CH4/C2H y /H2) after several hundreds of collisions with the surface of SS heated to 420–470 K. The possibility of creating an SS recombination filter for hydrocarbon radicals (the performance of radical hydrogenation reactions) transferred by a CH4/C2H y /H2 laminar flow was demonstrated. The deposition of a thin Pd film (∼10 nm) on steel did not increase the effectiveness of the surface with respect to radical recombination reactions. At the same time, Rh films increased the catalytic effectiveness of the surface of SS with respect to the hydrogenation of methyl and unsaturated hydrocarbons (380–420 K). The data obtained were used to select temperature conditions and mutual arrangement for the construction elements of an ITER diverter made of tungsten and stainless steel.
- 26 November 2008
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry A
- Vol. 82 (13) , 2340-2345
The hydrogenation of methyl on metallic surfaces
The stream technique was used to comparatively analyze the characteristics of the deposition of a-C:H films from methyl radicals transferred by a carrier gas CH4/C2H y /H2 (y = 2, 4, 6) in a quartz tube with cylindrical insets made of Cu, Ni, Fe, W, Si, and stainless steel (SS), initial and coated with thin Pd or Rh films, over the temperature range 300–1000 K. The deposition of methyl was fully suppressed in a tube section heated to 380–800 K with all the insets specified. During further mixture movement outside this section in the tube with a decreasing wall temperature, carbon deposition resumed. The most effective catalyst of the hydrogenation reaction was stainless steel. Radicals and unsaturated hydrocarbons capable of polymerization at 300–400 K were fully removed from the carrier gas flow (CH4/C2H y /H2) after several hundreds of collisions with the surface of SS heated to 420–470 K. The possibility of creating an SS recombination filter for hydrocarbon radicals (the performance of radical hydrogenation reactions) transferred by a CH4/C2H y /H2 laminar flow was demonstrated. The deposition of a thin Pd film (∼10 nm) on steel did not increase the effectiveness of the surface with respect to radical recombination reactions. At the same time, Rh films increased the catalytic effectiveness of the surface of SS with respect to the hydrogenation of methyl and unsaturated hydrocarbons (380–420 K). The data obtained were used to select temperature conditions and mutual arrangement for the construction elements of an ITER diverter made of tungsten and stainless steel.
- 9 November 2008
- Published by Pleiades Publishing Ltd in Protection of Metals
- Vol. 44 (6) , 542-547
Transfer and deposition of carbon-and nitrogen-containing radicals and ions produced by glow discharge in hydrogen/methane/nitrogen mixtures
Transfer and deposition of the decomposition products of a dc glow discharge with hollow cathode in a hydrogen/methane flow are discussed. Hydrocarbon (a-C:H) films were deposited at inner surfaces of the hollow cathode and quartz tube bounded the discharge. The carbon deposition rate in the hollow cathode was 3–10 times higher than in the positive column and in afterglow range. Acetylene, ethylene, and ethane prevailed in the plasma-reaction gaseous products. When molecular nitrogen was introduced to the near-cathode plasma at a flow rate equal to or higher than that of methane, the carbon deposition rate at the cathode inner surfaces dropped down by 1.5 to 2 orders of magnitude. The carbon that has been consumed in the a-C:H films formation in the cathode is now transformed mainly to hydrogen cyanide (HCN). The carbon deposition rate in the positive column and in afterglow range (T = 300 K) were comparable with those in the H2/CH4 mixture. In the a-C/N:H deposits, the nitrogen concentration was 15 to 25 at %. The experiments showed that nitrogen can be used as a component of the gas flow specially introduced near the mirror in protecting the optical surfaces in diagnostic channels of the ITER tokamak against a-C:H film deposition.
- 9 November 2008
- Published by Pleiades Publishing Ltd in Protection of Metals
- Vol. 44 (6) , 542-547
Transfer and deposition of carbon-and nitrogen-containing radicals and ions produced by glow discharge in hydrogen/methane/nitrogen mixtures
Transfer and deposition of the decomposition products of a dc glow discharge with hollow cathode in a hydrogen/methane flow are discussed. Hydrocarbon (a-C:H) films were deposited at inner surfaces of the hollow cathode and quartz tube bounded the discharge. The carbon deposition rate in the hollow cathode was 3–10 times higher than in the positive column and in afterglow range. Acetylene, ethylene, and ethane prevailed in the plasma-reaction gaseous products. When molecular nitrogen was introduced to the near-cathode plasma at a flow rate equal to or higher than that of methane, the carbon deposition rate at the cathode inner surfaces dropped down by 1.5 to 2 orders of magnitude. The carbon that has been consumed in the a-C:H films formation in the cathode is now transformed mainly to hydrogen cyanide (HCN). The carbon deposition rate in the positive column and in afterglow range (T = 300 K) were comparable with those in the H2/CH4 mixture. In the a-C/N:H deposits, the nitrogen concentration was 15 to 25 at %. The experiments showed that nitrogen can be used as a component of the gas flow specially introduced near the mirror in protecting the optical surfaces in diagnostic channels of the ITER tokamak against a-C:H film deposition.
- 1 March 2005
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 337-339, 892-896
Increased recombination of CH3 radicals on stainless steel
- 1 March 2005
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 337-339, 892-896
Increased recombination of CH3 radicals on stainless steel
- 31 March 2003
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 313-316, 460-464
Transport and condensation of soft a-C:H film thermal decomposition products
- 31 March 2003
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 313-316, 460-464
Transport and condensation of soft a-C:H film thermal decomposition products
- 1 January 2003
- Published by IOP Publishing in Physica Scripta
- Vol. T103 (1)
Deuterium Retention in the Near-Surface Layer of W Single Crystal Irradiated with 6 keV Deuterium Ions
- 1 January 2003
- Published by IOP Publishing in Physica Scripta
- Vol. T103 (1)
Deuterium Retention in the Near-Surface Layer of W Single Crystal Irradiated with 6 keV Deuterium Ions
- 1 March 2001
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 290-293, 271-275
Transport of and deposition from hydrocarbon radicals in a flow tube downstream from a CH4 RF discharge
- 1 March 2001
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 290-293, 271-275
Transport of and deposition from hydrocarbon radicals in a flow tube downstream from a CH4 RF discharge
- 1 January 2001
- Published by IOP Publishing in Physica Scripta
- Vol. T94 (1)
Behavior of Deuterium Implanted into W, Be and BeO
- 1 January 2001
- Published by IOP Publishing in Physica Scripta
- Vol. T94 (1)
Behavior of Deuterium Implanted into W, Be and BeO