I. M. Aristova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
I. M. Aristova has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
A.V. Dubovitskii
2 shared publications- Galina Abrosimova
Osipyan Institute of Solid State Physics, Russian Academy of Sciences, Chernogolovka, Russia
2 shared publications I.I. Zverkova
2 shared publicationsV.I. Kulakov
2 shared publicationsV.Sh. Shekhtman
2 shared publicationsA. A. Mazilkin
Russian Academy of Sciences
1 shared publication
Latest Publications
- 1 November 2021
- Published by Pleiades Publishing Ltd in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
- Vol. 15 (6) , 1129-1132
Study of the Formation and Properties of In–CuPcF4 Nanocomposite Materials in the Mode of the Millisecond Recording of Photoelectron Spectra
A study of the formation processes and properties of nanocomposite materials consisting of indium nanoparticles in a thin film of the organic semiconductor copper tetrafluorophthalocyanine (CuPcF4) is presented. The results are obtained by the new setup for dynamic photoelectron spectroscopy, which allows the recording of spectra in a millisecond interval using the ARGUS photoelectron spectrometer and synchrotron radiation (PETRA III/DESY, Germany). The evolution of the core level (CL) spectra: C1s, N1s, and In3d5/2 recorded directly during the deposition of indium onto the CuPcF4 surface under ultrahigh vacuum conditions is traced. The thickness of the indium coating during deposition increased from 0 to 5 nm. In this range of coatings, more than 150 spectra are recorded for each CL with a recording rate of 0.1 s/spectrum. The following is established: the significant diffusion of indium atoms deep into the organic matrix is observed; in fact, no chemical interaction of indium with carbon atoms is found; indium atoms are located in places close to pyrrole nitrogen of the CuPcF4 molecule. Apparently, during the interaction of In atoms and pyrrole nitrogen atoms, a negative charge is transferred from indium to the CuPcF4 molecule. Thus, data on the fast-flowing processes of the formation of organometallic In–CuPcF4 interfaces are obtained.
- 1 November 2021
- Published by Pleiades Publishing Ltd in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
- Vol. 15 (6) , 1129-1132
Study of the Formation and Properties of In–CuPcF4 Nanocomposite Materials in the Mode of the Millisecond Recording of Photoelectron Spectra
A study of the formation processes and properties of nanocomposite materials consisting of indium nanoparticles in a thin film of the organic semiconductor copper tetrafluorophthalocyanine (CuPcF4) is presented. The results are obtained by the new setup for dynamic photoelectron spectroscopy, which allows the recording of spectra in a millisecond interval using the ARGUS photoelectron spectrometer and synchrotron radiation (PETRA III/DESY, Germany). The evolution of the core level (CL) spectra: C1s, N1s, and In3d5/2 recorded directly during the deposition of indium onto the CuPcF4 surface under ultrahigh vacuum conditions is traced. The thickness of the indium coating during deposition increased from 0 to 5 nm. In this range of coatings, more than 150 spectra are recorded for each CL with a recording rate of 0.1 s/spectrum. The following is established: the significant diffusion of indium atoms deep into the organic matrix is observed; in fact, no chemical interaction of indium with carbon atoms is found; indium atoms are located in places close to pyrrole nitrogen of the CuPcF4 molecule. Apparently, during the interaction of In atoms and pyrrole nitrogen atoms, a negative charge is transferred from indium to the CuPcF4 molecule. Thus, data on the fast-flowing processes of the formation of organometallic In–CuPcF4 interfaces are obtained.
- 1 July 2020
- Published by Pleiades Publishing Ltd in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
- Vol. 14 (4) , 668-672
Nanocarbon in the Structure of a Hypereutectic Aluminum-Matrix Composite
The peculiarities of the fine structure of Al–Si–Ni aluminum-matrix composite with a low thermal coefficient of linear expansion, mechanically activated with the addition of nanoscale reduced graphene oxide (RGO), is investigated. The structure is studied by X-ray diffraction analysis, scanning, transmission and high-resolution transmission electron microscopy. The presence of quasi-graphene layers on the surface of aluminum and silicon particles is detected and it is shown that this shell protects them from clumping upon mechanical alloying, which significantly increases the manufacturability of the process of mechanical activation and subsequent compaction. Thus, it is possible to obtain composite materials with a homogeneous structure and higher physical properties (the use of RGO instead of electrode graphite reduces the thermal coefficient of linear expansion (TCLE) of the composite by 10%).
- 1 July 2020
- Published by Pleiades Publishing Ltd in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
- Vol. 14 (4) , 668-672
Nanocarbon in the Structure of a Hypereutectic Aluminum-Matrix Composite
The peculiarities of the fine structure of Al–Si–Ni aluminum-matrix composite with a low thermal coefficient of linear expansion, mechanically activated with the addition of nanoscale reduced graphene oxide (RGO), is investigated. The structure is studied by X-ray diffraction analysis, scanning, transmission and high-resolution transmission electron microscopy. The presence of quasi-graphene layers on the surface of aluminum and silicon particles is detected and it is shown that this shell protects them from clumping upon mechanical alloying, which significantly increases the manufacturability of the process of mechanical activation and subsequent compaction. Thus, it is possible to obtain composite materials with a homogeneous structure and higher physical properties (the use of RGO instead of electrode graphite reduces the thermal coefficient of linear expansion (TCLE) of the composite by 10%).
- 15 February 2009
- Published by Elsevier in Materials Letters
- Vol. 63 (3-4) , 454-456
Features of nanostructuring in LaMnO3+δ (polydisperse and monodisperse structures)
- 15 February 2009
- Published by Elsevier in Materials Letters
- Vol. 63 (3-4) , 454-456
Features of nanostructuring in LaMnO3+δ (polydisperse and monodisperse structures)
- 15 March 2008
- Published by Elsevier in Materials Letters
- Vol. 62 (6-7) , 1036-1039
Nanostructuring of lanthanum manganite LaMnO3+δ under phase transition
- 15 March 2008
- Published by Elsevier in Materials Letters
- Vol. 62 (6-7) , 1036-1039
Nanostructuring of lanthanum manganite LaMnO3+δ under phase transition
- 1 January 2006
- Published by Pleiades Publishing Ltd in Physics of the Solid State
- Vol. 48 (1) , 10-14
Nitrogen diffusion parameters in ion-implanted tungsten single crystals
Diffusion of nitrogen implanted in single-crystal tungsten was studied in the temperature range 700–820° C. Measurements were carried out using a method of nondestructive determination of diffusivities (developed by the authors) from the dynamics of variation in the surface impurity concentration. The initial distribution and diffusion profiles for various annealing times were determined by secondary ion mass spectrometry. The relative surface concentration of nitrogen was measured by Auger electron spectroscopy. Several fluxes of impurity atoms in the surface region of ion-doped tungsten were experimentally detected to exist. Under the assumption that the fluxes interact with each other, the temperature dependences of the nitrogen diffusivities in the flux associated with dislocations generated by ion implantation and in the flux associated with the bulk diffusion mechanism were determined. Nitrogen diffusion is characterized by a rather low activation energy, namely, 0.15 and 0.75 eV for dislocation and bulk mechanisms, respectively.
- 1 January 2006
- Published by Pleiades Publishing Ltd in Physics of the Solid State
- Vol. 48 (1) , 10-14
Nitrogen diffusion parameters in ion-implanted tungsten single crystals
Diffusion of nitrogen implanted in single-crystal tungsten was studied in the temperature range 700–820° C. Measurements were carried out using a method of nondestructive determination of diffusivities (developed by the authors) from the dynamics of variation in the surface impurity concentration. The initial distribution and diffusion profiles for various annealing times were determined by secondary ion mass spectrometry. The relative surface concentration of nitrogen was measured by Auger electron spectroscopy. Several fluxes of impurity atoms in the surface region of ion-doped tungsten were experimentally detected to exist. Under the assumption that the fluxes interact with each other, the temperature dependences of the nitrogen diffusivities in the flux associated with dislocations generated by ion implantation and in the flux associated with the bulk diffusion mechanism were determined. Nitrogen diffusion is characterized by a rather low activation energy, namely, 0.15 and 0.75 eV for dislocation and bulk mechanisms, respectively.