Ryoichi Monzen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ryoichi Monzen has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Chihiro Watanabe
Faculty of Mechanical Engineering, Institute of Science and Engineering, Kanazawa University
11 shared publications T. Hasegawa
Division of Mechanical Science and Engineering, Kanazawa University
3 shared publicationsD. Watanabe
Kanazawa University
1 shared publicationDaizen Watanabe
Division of Innovative Technology and Science, Kanazawa University, Kanazawa, Japan
1 shared publicationH. Miura
Toyohashi University of Technology
1 shared publicationH. Nagayoshi
Division of Mechanical Science and Engineering , Kanazawa University , Kakuma-machi, Kanazawa 920-1192, Japan
1 shared publication
Latest Publications
- Open Access
- 28 August 2017
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 48 (11) , 5368-5375
Strain-Rate and Temperature Dependences of Deformation Behavior of AZ61Mg Alloy Processed by Multi-directional Forging Under Decreasing Temperature Conditions
- 28 August 2017
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 48 (11) , 5368-5375
Open AccessStrain-Rate and Temperature Dependences of Deformation Behavior of AZ61Mg Alloy Processed by Multi-directional Forging Under Decreasing Temperature Conditions
- Open Access
- 7 March 2012
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 92 (14) , 1826-1843
Stress-assisted nucleation and growth of γ″ and γ′ precipitates in a Cu–1.2 wt%Be–0.1 wt%Co alloy aged at 320°C
An investigation by high-resolution transmission electron microscopy of the precipitation process during ageing a Cu–1.2 wt%Be–0.1 wt%Co alloy at 320°C has revealed that the transition phases follow a γ″→ γ″ + γ′ → γ sequence. The γ′ phase heterogeneously precipitates on the γ″ phase. The effects of an external stress on the nucleation and growth of disc-shaped γ″ and plate-shaped γ′ precipitates have been examined for the alloy aged at 320°C. A compressive stress applied in the [001] direction during ageing preferentially accelerates the nucleation and growth of the γ″ variant normal to the [001] axis among three crystallographically equivalent variants and the specific four γ′ variants formed on the γ″ variant normal to the [001] axis. A tensile stress does not significantly affect those of γ″ and γ′ precipitates. The critical diameter of the disc-shaped γ″ nucleus is estimated as about 1 nm from evaluation of the interaction energy between the applied stress and the misfit strains of γ″ precipitates. It is proposed that applied external stress does not affect the diffusion rate but the interphase boundary velocity.
- 7 March 2012
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 92 (14) , 1826-1843
Open AccessStress-assisted nucleation and growth of γ″ and γ′ precipitates in a Cu–1.2 wt%Be–0.1 wt%Co alloy aged at 320°C
An investigation by high-resolution transmission electron microscopy of the precipitation process during ageing a Cu–1.2 wt%Be–0.1 wt%Co alloy at 320°C has revealed that the transition phases follow a γ″→ γ″ + γ′ → γ sequence. The γ′ phase heterogeneously precipitates on the γ″ phase. The effects of an external stress on the nucleation and growth of disc-shaped γ″ and plate-shaped γ′ precipitates have been examined for the alloy aged at 320°C. A compressive stress applied in the [001] direction during ageing preferentially accelerates the nucleation and growth of the γ″ variant normal to the [001] axis among three crystallographically equivalent variants and the specific four γ′ variants formed on the γ″ variant normal to the [001] axis. A tensile stress does not significantly affect those of γ″ and γ′ precipitates. The critical diameter of the disc-shaped γ″ nucleus is estimated as about 1 nm from evaluation of the interaction energy between the applied stress and the misfit strains of γ″ precipitates. It is proposed that applied external stress does not affect the diffusion rate but the interphase boundary velocity.
- Open Access
- 14 January 2011
- Published by Springer Nature in Journal of Materials Science
- Vol. 46 (12) , 4284-4289
Bend formability and strength of Cu–Be–Co alloys
- 14 January 2011
- Published by Springer Nature in Journal of Materials Science
- Vol. 46 (12) , 4284-4289
Open AccessBend formability and strength of Cu–Be–Co alloys
- Open Access
- 1 January 2011
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 52 (8) , 1685-1688
Deformation of Cu-Be-Co Alloys by Aging at 593 K
Japan's largest platform for academic e-journals: J-STAGE is a full text database for reviewed academic papers published by Japanese societies
- 1 January 2011
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 52 (8) , 1685-1688
Open AccessDeformation of Cu-Be-Co Alloys by Aging at 593 K
Japan's largest platform for academic e-journals: J-STAGE is a full text database for reviewed academic papers published by Japanese societies
- Open Access
- 5 June 2010
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 41 (8) , 1936-1941
Influence of External Stress on Discontinuous Precipitation Behavior in a Cu-Ag Alloy
- 5 June 2010
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 41 (8) , 1936-1941
Open AccessInfluence of External Stress on Discontinuous Precipitation Behavior in a Cu-Ag Alloy
- 28 March 2010
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 90 (10) , 1347-1358
Effect of external stress on discontinuous precipitation in a Cu–2.1 wt % Be alloy
The influence of an applied stress on discontinuous precipitation (DP) in a Cu–2.1 wt % Be alloy aged at 300°C was examined. A compressive stress accelerates the growth of DP cells, which consist of lamellae of the precipitated γ phase and the solute-depleted α phase, but a tensile stress does not essentially change it. The cell growth rates along the loading direction under the compressive and tensile stress are identical to those along the direction perpendicular to the loading direction under the same stress. Both the compressive and tensile stresses have no influence on the incubation time to initiate DP. From measurements of the specimen length change and investigations of the distribution of γ variants in cells in a particular case, specific γ variants among crystallographically equivalent ones are found to be formed, depending on the sense of the applied stress. This result, together with the dependence of the cell growth rate on the sense of the applied stress, can be well understood through the interaction energy between the external stress and the misfit strains of discontinuous γ precipitates.
- 28 March 2010
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 90 (10) , 1347-1358
Effect of external stress on discontinuous precipitation in a Cu–2.1 wt % Be alloy
The influence of an applied stress on discontinuous precipitation (DP) in a Cu–2.1 wt % Be alloy aged at 300°C was examined. A compressive stress accelerates the growth of DP cells, which consist of lamellae of the precipitated γ phase and the solute-depleted α phase, but a tensile stress does not essentially change it. The cell growth rates along the loading direction under the compressive and tensile stress are identical to those along the direction perpendicular to the loading direction under the same stress. Both the compressive and tensile stresses have no influence on the incubation time to initiate DP. From measurements of the specimen length change and investigations of the distribution of γ variants in cells in a particular case, specific γ variants among crystallographically equivalent ones are found to be formed, depending on the sense of the applied stress. This result, together with the dependence of the cell growth rate on the sense of the applied stress, can be well understood through the interaction energy between the external stress and the misfit strains of discontinuous γ precipitates.
- 17 February 2009
- Published by Taylor & Francis in Philosophical Magazine Letters
- Vol. 89 (2) , 75-85
Effect of prior deformation on dimensional change and precipitation process in a Cu-1.8wt%Be-0.2wt%Co alloy aged at 320°C
The influence of prior cold work (90% reduction) on the length change and precipitation behaviour of a Cu-1.8wt%Be-0.2wt%Co alloy aged at 320°C up to 350 h has been investigated. The alloy gradually expands to a maximum and then contracts during ageing. The maximum expansion is attributable to both the expansion due to the loss of Be solute atoms and the contraction due to precipitation of the , γ I, γ m and γ′ phases. The subsequent contraction results from the decrease in amounts of the and γ m phases and the increase in amount of the γ′ phase. The new-found γ m phase, consisting of alternate Be and Cu matrix layers parallel to the matrix {001}α, is body-centred monoclinic with a = b = 0.263 nm and c = 0.279 nm and α = 83°, and aligns with the matrix according to the Bain orientation relationship. The Guinier–Preston (GP) zone transforms continuously to the γ m or γ I phase via γ″ and . The transformation from the GP zone to γ′ via γ″, and γ I is retarded in comparison with that for the un-deformed alloy.
- 17 February 2009
- Published by Taylor & Francis in Philosophical Magazine Letters
- Vol. 89 (2) , 75-85
Effect of prior deformation on dimensional change and precipitation process in a Cu-1.8wt%Be-0.2wt%Co alloy aged at 320°C
The influence of prior cold work (90% reduction) on the length change and precipitation behaviour of a Cu-1.8wt%Be-0.2wt%Co alloy aged at 320°C up to 350 h has been investigated. The alloy gradually expands to a maximum and then contracts during ageing. The maximum expansion is attributable to both the expansion due to the loss of Be solute atoms and the contraction due to precipitation of the , γ I, γ m and γ′ phases. The subsequent contraction results from the decrease in amounts of the and γ m phases and the increase in amount of the γ′ phase. The new-found γ m phase, consisting of alternate Be and Cu matrix layers parallel to the matrix {001}α, is body-centred monoclinic with a = b = 0.263 nm and c = 0.279 nm and α = 83°, and aligns with the matrix according to the Bain orientation relationship. The Guinier–Preston (GP) zone transforms continuously to the γ m or γ I phase via γ″ and . The transformation from the GP zone to γ′ via γ″, and γ I is retarded in comparison with that for the un-deformed alloy.
- 1 June 2008
- Published by Springer Nature in Journal of Materials Science
- Vol. 43 (11) , 3946-3953
Effect of coherency on coarsening of second-phase precipitates in Cu-base alloys
- 1 June 2008
- Published by Springer Nature in Journal of Materials Science
- Vol. 43 (11) , 3946-3953
Effect of coherency on coarsening of second-phase precipitates in Cu-base alloys
- 14 February 2008
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 39 (4) , 725-732
Coarsening Behavior of Co Precipitates in Cu-Co Alloys
- 14 February 2008
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 39 (4) , 725-732
Coarsening Behavior of Co Precipitates in Cu-Co Alloys
- 1 February 2006
- Published by Taylor & Francis in Philosophical Magazine Letters
- Vol. 86 (2) , 65-73
Elastic state of rod-shaped Ag precipitates in a Cu−5.7 wt% Ag single crystal
The elastic state of rod-shaped Ag precipitates in disc-shaped aggregates parallel to {100} planes in Cu−5.7 wt% Ag alloy single crystals has been studied. The rod-shaped precipitates have an elongated shape along a ⟨011⟩ direction and and habit-plane facets. Parallel moiré patterns are produced when the Ag precipitates and Cu matrix, with slight differences in atomic plane spacing, overlap. The elastic strains in the Ag precipitates have been detected by examining the moiré patterns. The measured elastic strains indicate that the misfit strain between the matrix and precipitate in the rod direction is more relaxed than that in the radius direction. A simple analysis using the elastic strains reveals that the elastic state in the semi-coherent Ag precipitates is hydrostatic. Precipitate growth along the ⟨011⟩ direction can be understood through the preferential relaxation of the misfit strain by the array of prismatic loops along the growth direction and the existence of the low-energy {111} habit planes.
- 1 February 2006
- Published by Taylor & Francis in Philosophical Magazine Letters
- Vol. 86 (2) , 65-73
Elastic state of rod-shaped Ag precipitates in a Cu−5.7 wt% Ag single crystal
The elastic state of rod-shaped Ag precipitates in disc-shaped aggregates parallel to {100} planes in Cu−5.7 wt% Ag alloy single crystals has been studied. The rod-shaped precipitates have an elongated shape along a ⟨011⟩ direction and and habit-plane facets. Parallel moiré patterns are produced when the Ag precipitates and Cu matrix, with slight differences in atomic plane spacing, overlap. The elastic strains in the Ag precipitates have been detected by examining the moiré patterns. The measured elastic strains indicate that the misfit strain between the matrix and precipitate in the rod direction is more relaxed than that in the radius direction. A simple analysis using the elastic strains reveals that the elastic state in the semi-coherent Ag precipitates is hydrostatic. Precipitate growth along the ⟨011⟩ direction can be understood through the preferential relaxation of the misfit strain by the array of prismatic loops along the growth direction and the existence of the low-energy {111} habit planes.