Taher Alizadeh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Taher Alizadeh has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Mashaalah Zarejousheghani
UFZ-Helmholtz Centre for Environmental Research, Department Monitoring and Exploration Technologies, Permoserstrasse 15, D-04318 Leipzig, Germany
3 shared publications - Mohammad Reza Ganjali
Center of Excellence in Electrochemistry, School of Chemistry, College of Science, University of Tehran, Tehran, Iran
3 shared publications Aezam Akbari
1 shared publicationBabak Tavana
1 shared publicationFariba Jamshidi
University of Mohaghegh Ardabili
1 shared publicationFatema Rezaloo
Department of Chemistry, Faculty of Science , University of Mohaghegh Ardabili , P.O. Box 179, Ardabil , Iran
1 shared publication
Latest Publications
- 27 December 2014
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 19 (4) , 1053-1062
Synthesis of nanosized sulfate-modified α-Fe2O3 and its use for the fabrication of all-solid-state carbon paste pH sensor
- 27 December 2014
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 19 (4) , 1053-1062
Synthesis of nanosized sulfate-modified α-Fe2O3 and its use for the fabrication of all-solid-state carbon paste pH sensor
- 1 November 2014
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 61, 532-540
Preparation of magnetic TNT-imprinted polymer nanoparticles and their accumulation onto magnetic carbon paste electrode for TNT determination
- 1 November 2014
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 61, 532-540
Preparation of magnetic TNT-imprinted polymer nanoparticles and their accumulation onto magnetic carbon paste electrode for TNT determination
- 1 September 2014
- Published by Elsevier in Analytica Chimica Acta
- Vol. 843, 7-17
Synthesis of nano-sized arsenic-imprinted polymer and its use as As3+ selective ionophore in a potentiometric membrane electrode: Part 1
- 1 September 2014
- Published by Elsevier in Analytica Chimica Acta
- Vol. 843, 7-17
Synthesis of nano-sized arsenic-imprinted polymer and its use as As3+ selective ionophore in a potentiometric membrane electrode: Part 1
- 1 July 2013
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 93 (8) , 919-934
Toluene chemiresistor sensor based on nano-porous toluene-imprinted polymer
In this work, the application of molecularly imprinted polymer (MIP) as the recognition element of a chemiresistor sensor was introduced. Toluene-imprinted polymer and non-imprinted polymer (NIP) were synthesized and then mixed with carbon black powder in the presence of melted n-eicosane as the binder agent. The obtained composites were applied for the construction of chemiresistor sensors. The sensor, fabricated with toluene-imprinted polymer, showed a significant response towards toluene. Moreover, the response of the NIP-based (polymer synthesized without solvent) chemiresistor sensor was very small and negligible. The components of the MIP-based sensing composite were found to strongly influence the sensor sensitivity. Response surface experimental design methodology was applied to optimize the important parameters of the proposed sensor. Cross-sensitivity of the MIP-based chemiresistor sensor for different vapours was investigated and a satisfactory result was found for toluene vapour recognition. It was shown that the sensor response to toluene concentration in air was linear in the concentration range of 3.8 to 46.4 ppm. The detection limit and relative standard deviation (for five separate determinations) of the designed sensor were calculated equal to 0.8 ppm and 5.6%, respectively.
- 1 July 2013
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 93 (8) , 919-934
Toluene chemiresistor sensor based on nano-porous toluene-imprinted polymer
In this work, the application of molecularly imprinted polymer (MIP) as the recognition element of a chemiresistor sensor was introduced. Toluene-imprinted polymer and non-imprinted polymer (NIP) were synthesized and then mixed with carbon black powder in the presence of melted n-eicosane as the binder agent. The obtained composites were applied for the construction of chemiresistor sensors. The sensor, fabricated with toluene-imprinted polymer, showed a significant response towards toluene. Moreover, the response of the NIP-based (polymer synthesized without solvent) chemiresistor sensor was very small and negligible. The components of the MIP-based sensing composite were found to strongly influence the sensor sensitivity. Response surface experimental design methodology was applied to optimize the important parameters of the proposed sensor. Cross-sensitivity of the MIP-based chemiresistor sensor for different vapours was investigated and a satisfactory result was found for toluene vapour recognition. It was shown that the sensor response to toluene concentration in air was linear in the concentration range of 3.8 to 46.4 ppm. The detection limit and relative standard deviation (for five separate determinations) of the designed sensor were calculated equal to 0.8 ppm and 5.6%, respectively.
- 1 March 2013
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 248-249, 401-406
Graphene/poly(methyl methacrylate) chemiresistor sensor for formaldehyde odor sensing
- 1 March 2013
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 248-249, 401-406
Graphene/poly(methyl methacrylate) chemiresistor sensor for formaldehyde odor sensing
- 1 March 2013
- Published by Elsevier in Analytica Chimica Acta
- Vol. 769, 100-107
Synthesis of Cu2+-mediated nano-sized salbutamol-imprinted polymer and its use for indirect recognition of ultra-trace levels of salbutamol
- 1 March 2013
- Published by Elsevier in Analytica Chimica Acta
- Vol. 769, 100-107
Synthesis of Cu2+-mediated nano-sized salbutamol-imprinted polymer and its use for indirect recognition of ultra-trace levels of salbutamol
- Open Access
- 21 September 2011
- Published by Springer Nature in Chinese Journal of Polymer Science
- Vol. 29 (6) , 658-669
An imprinted polymer for removal of Cd2+ from water samples: Optimization of adsorption and recovery steps by experimental design
- 21 September 2011
- Published by Springer Nature in Chinese Journal of Polymer Science
- Vol. 29 (6) , 658-669
Open AccessAn imprinted polymer for removal of Cd2+ from water samples: Optimization of adsorption and recovery steps by experimental design