Tommi Kaplas
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Tommi Kaplas has a total of 65 co-authors. Here are the top co-authors by number of shared publications:
Yuri Svirko
Univ Eastern Finland, Inst Photon, Yliopistokatu 7, FI-80101 Joensuu, Finland
7 shared publications- Yuri Svirko
University of Eastern Finland
6 shared publications - Polina Kuzhir
Department of Physics and Mathematics, Center for Photonics Sciences, University of Eastern Finland, Yliopistokatu 2, 80101 Joensuu, Finland
5 shared publications Lasse Karvonen
Department of Micro and Nanosciences, Aalto University, Espoo, P.O. Box 13500, FI-00076, Finland
3 shared publications- Alesia Paddubskaya
Institute for Nuclear Problems, Belarusian State University
2 shared publications - Galina Ivanivna Dovbeshko
Department of Physics of Biological Systems, Institute of Physics, Natl. Acad. of Sci. of Ukraine, Prospect Nauky, 46, UA-03028, Kyiv, Ukraine, Ukraine
2 shared publications
Latest Publications
- Open Access
- 19 October 2020
- Published by AIP Publishing in Applied Physics Letters
- Vol. 117 (16) , 162101
Experimental evidence of temperature dependent effective mass in AlGaN/GaN heterostructures observed via THz spectroscopy of 2D plasmons
Temperature-dependent effective mass in AlGaN/GaN heterostructures was experimentally observed via THz time domain spectroscopy of 2D plasmons in the range of 80–300 K. Grating couplers with different periods and filling factors were developed in order to monitor the behavior of plasma resonances in transmission spectra in the frequency range of 0.5–3.5 THz. For the grating with a 50% filling factor, the fundamental modes were excited and observed at temperatures below 225 K. The change of the filling factor to 80% led to the excitation of the fundamental and second order plasma harmonics observable up to 300 K and 220 K, respectively. Moreover, with an increase in temperature, the 2D plasmons experienced the red-shift in transmission power and phase spectra of all samples. This phenomenon was explained by the renormalization of effective mass, which started distinctly to deviate at 134 K temperature and at 295 K increased up to 55% of its nominal value. The THz spectroscopy of 2D plasmons further confirms a temperature-dependent effective mass in AlGaN/GaN heterostructures as reported previously in optical Hall effect studies.
- 19 October 2020
- Published by AIP Publishing in Applied Physics Letters
- Vol. 117 (16) , 162101
Open AccessExperimental evidence of temperature dependent effective mass in AlGaN/GaN heterostructures observed via THz spectroscopy of 2D plasmons
Temperature-dependent effective mass in AlGaN/GaN heterostructures was experimentally observed via THz time domain spectroscopy of 2D plasmons in the range of 80–300 K. Grating couplers with different periods and filling factors were developed in order to monitor the behavior of plasma resonances in transmission spectra in the frequency range of 0.5–3.5 THz. For the grating with a 50% filling factor, the fundamental modes were excited and observed at temperatures below 225 K. The change of the filling factor to 80% led to the excitation of the fundamental and second order plasma harmonics observable up to 300 K and 220 K, respectively. Moreover, with an increase in temperature, the 2D plasmons experienced the red-shift in transmission power and phase spectra of all samples. This phenomenon was explained by the renormalization of effective mass, which started distinctly to deviate at 134 K temperature and at 295 K increased up to 55% of its nominal value. The THz spectroscopy of 2D plasmons further confirms a temperature-dependent effective mass in AlGaN/GaN heterostructures as reported previously in optical Hall effect studies.
- Open Access
- 1 December 2019
- Published by Elsevier in Applied Surface Science
- Vol. 497
Strong optical nonlinearity of ultrathin graphitic films synthesized on dielectric substrates
- 1 December 2019
- Published by Elsevier in Applied Surface Science
- Vol. 497
Open AccessStrong optical nonlinearity of ultrathin graphitic films synthesized on dielectric substrates
- 22 May 2019
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 6 (7) , 1780-1788
Coherent Detection of Terahertz Radiation with Graphene
- 22 May 2019
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 6 (7) , 1780-1788
Coherent Detection of Terahertz Radiation with Graphene
- Open Access
Tunable Perfect THz Absorber Based on a Stretchable Ultrathin Carbon-Polymer Bilayer
By exploring the Salisbury screen approach, we propose and demonstrate a thin film absorber of terahertz (THz) radiation. The absorber is comprised of a less than 100 nm thick layer of pyrolytic carbon deposited on a stretchable polydimethylsiloxane (PDMS) film followed by the metal film. We demonstrate that being overall less than 200 microns thick, such a sandwich structure absorbs resonantly up to 99.9%of the incident THz radiation, and that the absorption resonance is determined by the polymer thickness, which can be adjusted by stretching.
Open AccessTunable Perfect THz Absorber Based on a Stretchable Ultrathin Carbon-Polymer Bilayer
By exploring the Salisbury screen approach, we propose and demonstrate a thin film absorber of terahertz (THz) radiation. The absorber is comprised of a less than 100 nm thick layer of pyrolytic carbon deposited on a stretchable polydimethylsiloxane (PDMS) film followed by the metal film. We demonstrate that being overall less than 200 microns thick, such a sandwich structure absorbs resonantly up to 99.9%of the incident THz radiation, and that the absorption resonance is determined by the polymer thickness, which can be adjusted by stretching.
- Open Access
- 17 August 2017
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , 1-6
Scalable fabrication of the graphitic substrates for graphene-enhanced Raman spectroscopy
We propose direct synthesis of ultra-thin graphitic films on a dielectric substrate using sacrificial Ni catalyst layer, which significantly increases the crystallinity of the photoresist pyrolyzed at the temperature of 800 °C and above. A considerable amount of multilayer graphene in the photoresist film pyrolyzed in the presence of the Ni catalyst gives rise to an enhancement of the Raman signal of dye Sudan III molecules deposited on the substrate. We demonstrate comparable enhancement of the Raman signal from Sudan III molecules deposited on the fabricated graphitic substrate and those deposited on graphene, which was conventionally transferred to the silica substrate.
- 17 August 2017
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , 1-6
Open AccessScalable fabrication of the graphitic substrates for graphene-enhanced Raman spectroscopy
We propose direct synthesis of ultra-thin graphitic films on a dielectric substrate using sacrificial Ni catalyst layer, which significantly increases the crystallinity of the photoresist pyrolyzed at the temperature of 800 °C and above. A considerable amount of multilayer graphene in the photoresist film pyrolyzed in the presence of the Ni catalyst gives rise to an enhancement of the Raman signal of dye Sudan III molecules deposited on the substrate. We demonstrate comparable enhancement of the Raman signal from Sudan III molecules deposited on the fabricated graphitic substrate and those deposited on graphene, which was conventionally transferred to the silica substrate.
- Open Access
- 16 February 2017
- Published by Springer Nature in Discover Nano
- Vol. 12 (1) , 121
Ultra-Thin Pyrocarbon Films as a Versatile Coating Material
The properties and synthesis procedures of the nanometrically thin pyrolyzed photoresist films (PPF) and the pyrolytic carbon films (PCF) were compared, and a number of similarities were found. Closer examination showed that the optical properties of these films are almost identical; however, the DC resistance of PPF is about three times higher than that of PCF. Moreover, we observed that the wettability of amorphous PPF and PCF was almost comparable to crystalline graphite. Potential applications executed by utilizing the small difference in the synthesis procedure of these two materials are suggested.
- 16 February 2017
- Published by Springer Nature in Discover Nano
- Vol. 12 (1) , 121
Open AccessUltra-Thin Pyrocarbon Films as a Versatile Coating Material
The properties and synthesis procedures of the nanometrically thin pyrolyzed photoresist films (PPF) and the pyrolytic carbon films (PCF) were compared, and a number of similarities were found. Closer examination showed that the optical properties of these films are almost identical; however, the DC resistance of PPF is about three times higher than that of PCF. Moreover, we observed that the wettability of amorphous PPF and PCF was almost comparable to crystalline graphite. Potential applications executed by utilizing the small difference in the synthesis procedure of these two materials are suggested.
- Open Access
- 13 May 2016
- Published by Springer Nature in Scientific Reports
- Vol. 6 (1) , 25922
Pyrolytic carbon coated black silicon
Carbon is the most well-known black material in the history of man. Throughout the centuries, carbon has been used as a black material for paintings, camouflage and optics. Although, the techniques to make other black surfaces have evolved and become more sophisticated with time, carbon still remains one of the best black materials. Another well-known black surface is black silicon, reflecting less than 0.5% of incident light in visible spectral range but becomes a highly reflecting surface in wavelengths above 1000 nm. On the other hand, carbon absorbs at those and longer wavelengths. Thus, it is possible to combine black silicon with carbon to create an artificial material with very low reflectivity over a wide spectral range. Here we report our results on coating conformally black silicon substrate with amorphous pyrolytic carbon. We present a superior black surface with reflectance of light less than 0.5% in the spectral range of 350 nm to 2000 nm.
- 13 May 2016
- Published by Springer Nature in Scientific Reports
- Vol. 6 (1) , 25922
Open AccessPyrolytic carbon coated black silicon
Carbon is the most well-known black material in the history of man. Throughout the centuries, carbon has been used as a black material for paintings, camouflage and optics. Although, the techniques to make other black surfaces have evolved and become more sophisticated with time, carbon still remains one of the best black materials. Another well-known black surface is black silicon, reflecting less than 0.5% of incident light in visible spectral range but becomes a highly reflecting surface in wavelengths above 1000 nm. On the other hand, carbon absorbs at those and longer wavelengths. Thus, it is possible to combine black silicon with carbon to create an artificial material with very low reflectivity over a wide spectral range. Here we report our results on coating conformally black silicon substrate with amorphous pyrolytic carbon. We present a superior black surface with reflectance of light less than 0.5% in the spectral range of 350 nm to 2000 nm.
- Open Access
- 4 February 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (3) , 2965-2970
Optical characterization of directly deposited graphene on a dielectric substrate
By using scanning multiphoton microscopy we compare the nonlinear optical properties of the directly deposited and transferred to the dielectric substrate graphene. The direct deposition of graphene on oxidized silicon wafer was done by utilizing sacrificial copper catalyst film. We demonstrate that the directly deposited graphene and bi-layered transferred graphene produce comparable third harmonic signals and have almost the same damage thresholds. Therefore, we believe directly deposited graphene is suitable for the use of e.g. nanofabricated optical setups.
- 4 February 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (3) , 2965-2970
Open AccessOptical characterization of directly deposited graphene on a dielectric substrate
By using scanning multiphoton microscopy we compare the nonlinear optical properties of the directly deposited and transferred to the dielectric substrate graphene. The direct deposition of graphene on oxidized silicon wafer was done by utilizing sacrificial copper catalyst film. We demonstrate that the directly deposited graphene and bi-layered transferred graphene produce comparable third harmonic signals and have almost the same damage thresholds. Therefore, we believe directly deposited graphene is suitable for the use of e.g. nanofabricated optical setups.
- 1 January 2016
- Published by Springer Nature
- p. 227-238
Synthesis of Pyrolytic Carbon Films on Dielectric Substrates
- 1 January 2016
- Published by Springer Nature
- p. 227-238
Synthesis of Pyrolytic Carbon Films on Dielectric Substrates
- Open Access
- 27 May 2015
- Published by Springer Nature in Discover Nano
- Vol. 10 (1) , 1-6
Optical Properties of Pyrolytic Carbon Films Versus Graphite and Graphene
We report a comparative study of optical properties of 5–20 nm thick pyrolytic carbon (PyC) films, graphite, and graphene. The complex dielectric permittivity of PyC is obtained by measuring polarization-sensitive reflectance and transmittance spectra of the PyC films deposited on silica substrate. The Lorentz-Drude model describes well the general features of the optical properties of PyC from 360 to 1100 nm. By comparing the obtained results with literature data for graphene and highly ordered pyrolytic graphite, we found that in the visible spectral range, the effective dielectric permittivity of the ultrathin PyC films are comparable with those of graphite and graphene.
- 27 May 2015
- Published by Springer Nature in Discover Nano
- Vol. 10 (1) , 1-6
Open AccessOptical Properties of Pyrolytic Carbon Films Versus Graphite and Graphene
We report a comparative study of optical properties of 5–20 nm thick pyrolytic carbon (PyC) films, graphite, and graphene. The complex dielectric permittivity of PyC is obtained by measuring polarization-sensitive reflectance and transmittance spectra of the PyC films deposited on silica substrate. The Lorentz-Drude model describes well the general features of the optical properties of PyC from 360 to 1100 nm. By comparing the obtained results with literature data for graphene and highly ordered pyrolytic graphite, we found that in the visible spectral range, the effective dielectric permittivity of the ultrathin PyC films are comparable with those of graphite and graphene.