André B. de Haan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
André B. de Haan has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Antonius T. M. Marcelis
Laboratory of Organic Chemistry, Wageningen University, Dreijenplein 8, 6703 HB Wageningen, The Netherlands, Department of DelftChemTech, Delft University of Technology, Julianalaan 136, 2628 BL Delft, The Netherlands, and Chemical Engineering and Chemistry Process Systems Engineering, Eindhoven University of Technology, P.O. Box 513, 5600 MB Eindhoven, The Netherlands
1 shared publicationB. Schuur
Eindhoven University of Technology, Department of Chemical Engineering and Chemistry/SPS, P.O. Box 513, NL‐5600 MB Eindhoven, The Netherlands
1 shared publicationBernhard Burghoff
Laboratory of Organic Chemistry, Wageningen University, Dreijenplein 8, 6703 HB Wageningen, The Netherlands, Department of DelftChemTech, Delft University of Technology, Julianalaan 136, 2628 BL Delft, The Netherlands, and Chemical Engineering and Chemistry Process Systems Engineering, Eindhoven University of Technology, P.O. Box 513, 5600 MB Eindhoven, The Netherlands
1 shared publicationE. Quijada-Maldonado
Eindhoven University of Technology, Department of Chemical Engineering and Chemistry/SPS, P.O. Box 513, NL‐5600 MB Eindhoven, The Netherlands
1 shared publicationErnst J. R. Sudhölter
Laboratory of Organic Chemistry, Wageningen University, Dreijenplein 8, 6703 HB Wageningen, The Netherlands, Department of DelftChemTech, Delft University of Technology, Julianalaan 136, 2628 BL Delft, The Netherlands, and Chemical Engineering and Chemistry Process Systems Engineering, Eindhoven University of Technology, P.O. Box 513, 5600 MB Eindhoven, The Netherlands
1 shared publicationG. W. Meindersma
Eindhoven University of Technology, Department of Chemical Engineering and Chemistry/SPS, P.O. Box 513, NL‐5600 MB Eindhoven, The Netherlands
1 shared publication
Latest Publications
- Open Access
- 23 August 2013
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 85 (9) , 1358
Ionic Liquids in Extractive Distillation Solvent Selection, Conceptual Process Design, and Pilot Plant Validation
- 23 August 2013
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 85 (9) , 1358
Open AccessIonic Liquids in Extractive Distillation Solvent Selection, Conceptual Process Design, and Pilot Plant Validation
- 27 August 2010
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 82 (9) , 1356-1357
Ionic Liquids as Alternative Solvents in Petrochemicals Extraction
- 27 August 2010
- Published by Wiley in Chemie Ingenieur Technik
- Vol. 82 (9) , 1356-1357
Ionic Liquids as Alternative Solvents in Petrochemicals Extraction
- 5 August 2009
- Published by Elsevier in Separation and Purification Technology
- Vol. 68 (2) , 199-207
Kinetic analysis of anionic surfactant adsorption from aqueous solution onto activated carbon and layered double hydroxide with the zero length column method
- 5 August 2009
- Published by Elsevier in Separation and Purification Technology
- Vol. 68 (2) , 199-207
Kinetic analysis of anionic surfactant adsorption from aqueous solution onto activated carbon and layered double hydroxide with the zero length column method
- 29 October 2008
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 112 (46) , 11714-11723
Complexation of Phenols and Thiophenol by Phosphine Oxides and Phosphates. Extraction, Isothermal Titration Calorimetry, and ab Initio Calculations
To develop a new solvent-impregnated resin system for the removal of phenols from water the complex formation of triisobutylphosphine sulfide (TIBPS), tributylphosphate (TBP), and tri-n-octylphosphine oxide (TOPO) with a series of phenols (phenol, thiophenol, 3-chlorophenol, 3,5-dichlorophenol, 4-cyanophenol, and pentachlorophenol) was studied. The investigation of complex formation between the extractants and the phenols in the solvent toluene was carried out using liquid−liquid extraction, isothermal titration calorimetry (ITC), and quantum chemical modeling (B3LYP/6-311+G(d,p)//B3LYP/6-311G(d,p) and MP2/6-311++G(2d,2p)//B3LYP/6-311G(d,p)). The equilibrium constant (binding affinity, Kchem), enthalpy of complex formation (ΔH), and stoichiometry (N) were directly measured with ITC, and the entropy of complexation (ΔS) was derived from these results. A first screening of Kchem toward phenol revealed a very high binding affinity for TOPO, and very low binding affinities for the other extractants. Modeling results showed that although 1:1 complexes were formed, the TIBPS and TBP do not form strong hydrogen bonds. Therefore, in the remainder of the research only TOPO was considered. Kchem of TOPO for the phenols in toluene increased from 1 000 to 10 000 M−1 in the order phenol < pentachlorophenol < 3-chlorophenol < 4-cyanophenol ≈ 3,5-dichlorophenol (in line with their pKa values, except for pentachlorophenol) in the absence of water, while the stoichiometric ratio remained 1:1. In water-saturated toluene, the binding affinities are lower due to co-complexation of water with the active site of the extractant. The increase in binding affinity for TOPO in the phenol series was confirmed by a detailed ab initio study, in which ΔH was calculated to range from −10.7 kcal/mol for phenol to −13.4 kcal/mol for 4-cyanophenol. Pentachlorophenol was found to behave quite differently, showing a ΔH value of −10.5 kcal/mol. In addition, these calculations confirm the formation of 1:1 H-bonded complexes.
- 29 October 2008
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 112 (46) , 11714-11723
Complexation of Phenols and Thiophenol by Phosphine Oxides and Phosphates. Extraction, Isothermal Titration Calorimetry, and ab Initio Calculations
To develop a new solvent-impregnated resin system for the removal of phenols from water the complex formation of triisobutylphosphine sulfide (TIBPS), tributylphosphate (TBP), and tri-n-octylphosphine oxide (TOPO) with a series of phenols (phenol, thiophenol, 3-chlorophenol, 3,5-dichlorophenol, 4-cyanophenol, and pentachlorophenol) was studied. The investigation of complex formation between the extractants and the phenols in the solvent toluene was carried out using liquid−liquid extraction, isothermal titration calorimetry (ITC), and quantum chemical modeling (B3LYP/6-311+G(d,p)//B3LYP/6-311G(d,p) and MP2/6-311++G(2d,2p)//B3LYP/6-311G(d,p)). The equilibrium constant (binding affinity, Kchem), enthalpy of complex formation (ΔH), and stoichiometry (N) were directly measured with ITC, and the entropy of complexation (ΔS) was derived from these results. A first screening of Kchem toward phenol revealed a very high binding affinity for TOPO, and very low binding affinities for the other extractants. Modeling results showed that although 1:1 complexes were formed, the TIBPS and TBP do not form strong hydrogen bonds. Therefore, in the remainder of the research only TOPO was considered. Kchem of TOPO for the phenols in toluene increased from 1 000 to 10 000 M−1 in the order phenol < pentachlorophenol < 3-chlorophenol < 4-cyanophenol ≈ 3,5-dichlorophenol (in line with their pKa values, except for pentachlorophenol) in the absence of water, while the stoichiometric ratio remained 1:1. In water-saturated toluene, the binding affinities are lower due to co-complexation of water with the active site of the extractant. The increase in binding affinity for TOPO in the phenol series was confirmed by a detailed ab initio study, in which ΔH was calculated to range from −10.7 kcal/mol for phenol to −13.4 kcal/mol for 4-cyanophenol. Pentachlorophenol was found to behave quite differently, showing a ΔH value of −10.5 kcal/mol. In addition, these calculations confirm the formation of 1:1 H-bonded complexes.
- Open Access
- 13 November 2007
- Published by Wiley in AIChE Journal
- Vol. 54 (1) , 138-142
Recovery of transition metal complex by reverse flow adsorption
Reverse flow adsorption (RFA) is a technique with a definite potential to prevent the leaching of a homogenous catalyst. In this work, we model an RFA‐process for a continuous ideally stirred tank reactor with an adsorption bed upstream and another one downstream from the reactor. The model parameters concerning adsorption equilibrium and kinetics are taken from previous experimental studies on CoCl2 adsorption on polymer‐bound trifenylfosfine. We use this model to study the concentration profiles of CoCl2 in the adsorption beds during consecutive adsorption–desorption cycles. The model calculations show that the concentration profile eventually reaches a fixed position after a number of adsorption–desorption cycles, even though internal mass transfer was a limiting factor. Hence, the transition metal is kept within the system boundaries, which is an essential requirement for the application of RFA. © 2007 American Institute of Chemical Engineers AIChE J, 2008
- 13 November 2007
- Published by Wiley in AIChE Journal
- Vol. 54 (1) , 138-142
Open AccessRecovery of transition metal complex by reverse flow adsorption
Reverse flow adsorption (RFA) is a technique with a definite potential to prevent the leaching of a homogenous catalyst. In this work, we model an RFA‐process for a continuous ideally stirred tank reactor with an adsorption bed upstream and another one downstream from the reactor. The model parameters concerning adsorption equilibrium and kinetics are taken from previous experimental studies on CoCl2 adsorption on polymer‐bound trifenylfosfine. We use this model to study the concentration profiles of CoCl2 in the adsorption beds during consecutive adsorption–desorption cycles. The model calculations show that the concentration profile eventually reaches a fixed position after a number of adsorption–desorption cycles, even though internal mass transfer was a limiting factor. Hence, the transition metal is kept within the system boundaries, which is an essential requirement for the application of RFA. © 2007 American Institute of Chemical Engineers AIChE J, 2008