Bernhard Wett
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Bernhard Wett has a total of 58 co-authors. Here are the top co-authors by number of shared publications:
- Imre Takacs
Dynamita, Nyons, France
7 shared publications - Sudhir Murthy
NEWhub Water Corporation Herndon Virginia USA
7 shared publications - A. Eladawy
Institute of Environmental Engineering, University of Innsbruck,Technikerstr.13, A-6020 Innsbruck, Austria
2 shared publications - Charles Bott
Hampton Roads Sanitation District Virginia Beach Virginia USA
2 shared publications - Haydée De Clippeleir
DC Water and Sewer Authority Washington District of Columbia USA
2 shared publications - Heribert Insam
Leopold-Franzens-Universität Innsbruck
2 shared publications
Latest Publications
- 1 January 2018
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2018 (5) , 185-191
Enhancing the decoupling of solids retention times in full-scale deammonification processes using screens
- 1 January 2018
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2018 (5) , 185-191
Enhancing the decoupling of solids retention times in full-scale deammonification processes using screens
- 1 January 2017
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2017 (4) , 5431-5435
Experimental metrics to predict the flocculent settling coefficient in a 1D settler model
- 1 January 2017
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2017 (4) , 5431-5435
Experimental metrics to predict the flocculent settling coefficient in a 1D settler model
- 1 October 2014
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2014 (16) , 913-926
Mathematical Modeling Of The High Rate Activated Sludge System: Optimizing The Cod:N Ratio In The Process Effluent
- 1 October 2014
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2014 (16) , 913-926
Mathematical Modeling Of The High Rate Activated Sludge System: Optimizing The Cod:N Ratio In The Process Effluent
- 1 October 2014
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2014 (2) , 1-4
Modeling Thermally Pretreated Mesophilic Anaerobic Digestion
- 1 October 2014
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2014 (2) , 1-4
Modeling Thermally Pretreated Mesophilic Anaerobic Digestion
- 1 January 2013
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2013 (4) , 555-562
All you need is air – alternating activated sludge system BIOCOS without electro-mechanical equipment
- 1 January 2013
- Published by Water Environment Federation in Proceedings of the Water Environment Federation
- Vol. 2013 (4) , 555-562
All you need is air – alternating activated sludge system BIOCOS without electro-mechanical equipment
- 1 April 2010
- Published by IWA Publishing in Water Science & Technology
- Vol. 61 (8) , 1915-1922
Syntrophy of aerobic and anaerobic ammonia oxidisers
Deammonification is known as an efficient and resource saving sidestream process option to remove the nitrogen load from sludge liquors. The transfer of the intermediate product nitrite between both syntrophic groups of organisms – aerobic and anaerobic ammonia oxidizers (AOB) – appears very sensitive to process conditions such as temperature, dissolved oxygen (DO) and operating nitrite level. Growth kinetics for aerobic and anaerobic AOBs differ by one order of magnitude and require an adequate selection of sludge retention time. This paper provides measurement- and model-based results on how selected sludge wasting impacts population dynamics in a suspended growth deammonification system. Anammox enrichment up to a doubled portion in mixed liquor solids can substantially improve process stability in difficult conditions. A case-study on low temperature operations outlines two possible strategies to balance syntrophic consumption of ammonium and nitrite.
- 1 April 2010
- Published by IWA Publishing in Water Science & Technology
- Vol. 61 (8) , 1915-1922
Syntrophy of aerobic and anaerobic ammonia oxidisers
Deammonification is known as an efficient and resource saving sidestream process option to remove the nitrogen load from sludge liquors. The transfer of the intermediate product nitrite between both syntrophic groups of organisms – aerobic and anaerobic ammonia oxidizers (AOB) – appears very sensitive to process conditions such as temperature, dissolved oxygen (DO) and operating nitrite level. Growth kinetics for aerobic and anaerobic AOBs differ by one order of magnitude and require an adequate selection of sludge retention time. This paper provides measurement- and model-based results on how selected sludge wasting impacts population dynamics in a suspended growth deammonification system. Anammox enrichment up to a doubled portion in mixed liquor solids can substantially improve process stability in difficult conditions. A case-study on low temperature operations outlines two possible strategies to balance syntrophic consumption of ammonium and nitrite.
- 1 February 2010
- Published by IWA Publishing in Water Science & Technology
- Vol. 61 (4) , 1003-1009
Quantitative and qualitative effects of bioaugmentation on ammonia oxidisers at a two-step WWTP
Large waste water treatment plants (WWTP) often operate nitrification in two different process environments: the cold-dilute sewage is treated in the mainstream nitrification/denitrification system, while the high strength ammonia liquors from sludge dewatering are treated in a separate high temperature reactor (SBR). This study investigates transfer from nitrifier biomass into a two-stage WWTP, commonly referred to as bioaugmentation. Besides the quantitation of ammonia oxidising bacteria (AOB), community differences were analysed with two techniques, denaturing gradient gel electrophoresis and real-time PCR melt curve analysis. It was shown that, without bioaugmentation, two distinct AOB communities establish in the mainstream and in the SBR, respectively. A gradual shift of the two AOB communities with increasing pump rates between the systems could be demonstrated. These molecular findings support process engineering experience, that cycling of waste activated sludge improves the ability of AOB to adapt to different process environments.
- 1 February 2010
- Published by IWA Publishing in Water Science & Technology
- Vol. 61 (4) , 1003-1009
Quantitative and qualitative effects of bioaugmentation on ammonia oxidisers at a two-step WWTP
Large waste water treatment plants (WWTP) often operate nitrification in two different process environments: the cold-dilute sewage is treated in the mainstream nitrification/denitrification system, while the high strength ammonia liquors from sludge dewatering are treated in a separate high temperature reactor (SBR). This study investigates transfer from nitrifier biomass into a two-stage WWTP, commonly referred to as bioaugmentation. Besides the quantitation of ammonia oxidising bacteria (AOB), community differences were analysed with two techniques, denaturing gradient gel electrophoresis and real-time PCR melt curve analysis. It was shown that, without bioaugmentation, two distinct AOB communities establish in the mainstream and in the SBR, respectively. A gradual shift of the two AOB communities with increasing pump rates between the systems could be demonstrated. These molecular findings support process engineering experience, that cycling of waste activated sludge improves the ability of AOB to adapt to different process environments.
- 8 January 2010
- Published by Elsevier in Waste Management
- Vol. 30 (6) , 1057-1062
Systematic comparison of mechanical and thermal sludge disintegration technologies
- 8 January 2010
- Published by Elsevier in Waste Management
- Vol. 30 (6) , 1057-1062
Systematic comparison of mechanical and thermal sludge disintegration technologies
- 1 October 2008
- Published by IWA Publishing in Water Science & Technology
- Vol. 58 (6) , 1155-1171
Modelling nitrite in wastewater treatment systems: a discussion of different modelling concepts
Originally presented at the 1st IWA/WEF Wastewater Treatment Modelling Seminar (WWTmod 2008), this contribution has been updated to also include the valuable feedback that was received during the Modelling Seminar. This paper addresses a number of basic issues concerning the modelling of nitrite in key processes involved in biological wastewater water treatment. To this end, we review different model concepts (together with model structures and corresponding parameter sets) proposed for processes such as two-step nitrification/denitrification, anaerobic ammonium oxidation and phosphorus uptake processes. After critically discussing these models with respect to their assumptions and parameter sets, common points of agreement as well as disagreement were elucidated. From this discussion a general picture of the state-of-the-art in the modelling of nitrite is provided. Taking this into account, a number of recommendations are provided to focus further research and development on nitrite modelling in biological wastewater treatment.
- 1 October 2008
- Published by IWA Publishing in Water Science & Technology
- Vol. 58 (6) , 1155-1171
Modelling nitrite in wastewater treatment systems: a discussion of different modelling concepts
Originally presented at the 1st IWA/WEF Wastewater Treatment Modelling Seminar (WWTmod 2008), this contribution has been updated to also include the valuable feedback that was received during the Modelling Seminar. This paper addresses a number of basic issues concerning the modelling of nitrite in key processes involved in biological wastewater water treatment. To this end, we review different model concepts (together with model structures and corresponding parameter sets) proposed for processes such as two-step nitrification/denitrification, anaerobic ammonium oxidation and phosphorus uptake processes. After critically discussing these models with respect to their assumptions and parameter sets, common points of agreement as well as disagreement were elucidated. From this discussion a general picture of the state-of-the-art in the modelling of nitrite is provided. Taking this into account, a number of recommendations are provided to focus further research and development on nitrite modelling in biological wastewater treatment.
- 1 November 2007
- Published by IWA Publishing in Water Science & Technology
- Vol. 56 (9) , 37-41
Elemental balance based methodology to establish reaction stoichiometry in environmental modeling
Kinetic models in activated sludge, anaerobic digestion and other environmental modeling fields rely on the proper formulation of stoichiometric coefficients. Elemental balancing provides a simple and rigorous way to establish the stoichiometric coefficients of reactions represented in the Gujer matrix. The deduction of these coefficients is frequently trivial, from basic mass balancing considerations. In more complex cases, such as the Anammox growth reaction, rigorous elemental balancing is required to establish the proper formulation. This paper demonstrates the methodology based on a simple aerobic heterotrophic growth reaction where stoichiometry coefficients (such as the (1-YH)/YH term for oxygen) are well known. In the second step the methodology is applied for the Anammox growth reaction. The fraction of N2 gas in current models originates from the NH4+ and the NO2− electron donor/acceptor pair in equal proportion. This paper demonstrates that this stoichiometry is a simplification leading to elemental balance errors. The proper stoichiometric coefficients are derived.
- 1 November 2007
- Published by IWA Publishing in Water Science & Technology
- Vol. 56 (9) , 37-41
Elemental balance based methodology to establish reaction stoichiometry in environmental modeling
Kinetic models in activated sludge, anaerobic digestion and other environmental modeling fields rely on the proper formulation of stoichiometric coefficients. Elemental balancing provides a simple and rigorous way to establish the stoichiometric coefficients of reactions represented in the Gujer matrix. The deduction of these coefficients is frequently trivial, from basic mass balancing considerations. In more complex cases, such as the Anammox growth reaction, rigorous elemental balancing is required to establish the proper formulation. This paper demonstrates the methodology based on a simple aerobic heterotrophic growth reaction where stoichiometry coefficients (such as the (1-YH)/YH term for oxygen) are well known. In the second step the methodology is applied for the Anammox growth reaction. The fraction of N2 gas in current models originates from the NH4+ and the NO2− electron donor/acceptor pair in equal proportion. This paper demonstrates that this stoichiometry is a simplification leading to elemental balance errors. The proper stoichiometric coefficients are derived.