Arleen Hill
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Arleen Hill has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
A. Vicini
ImageCat, Ltd., Communications House, 63 Woodfield Lane, Ashtead, Surrey, KT21 2BT, United Kingdom
1 shared publication- Beverley J. Adams
ImageCat, Ltd., Communications House, 63 Woodfield Lane, Ashtead, Surrey, KT21 2BT, United Kingdom
1 shared publication - Brian Waldron
Center for Applied Earth Science and Engineering Research (CAESER), University of Memphis, Memphis, TN 38152, USA
1 shared publication - Dan Clark
Geoscience Australia, Canberra 2609, Australia
1 shared publication - David N. Lumsden
Department of Earth Sciences, University of Memphis, Memphis, TN 38152, USA
1 shared publication - Farid Javadnejad
Formerly, Graduate Research Assistant, School of Civil and Construction Engineering, Oregon State Univ., 101 Kearney Hall, Corvallis, OR 97331. ORCID:
1 shared publication
Latest Publications
- 1 August 2017
- Published by American Society of Civil Engineers (ASCE) in Natural Hazards Review
- Vol. 18 (3)
LITE Flood: Simple GIS-Based Mapping Approach for Real-Time Redelineation of Multifrequency Floods
Flood zones with 1 and 0.02% of annual flooding chance are projected in FEMA’s digital flood insurance rate maps (DFIRMs) and are suited for identifying flood risk at the largest impacts. However, less severe floods, which are not mapped in DFIRMs, still cause significant damage and occur on a more frequent basis. This article uses a simplified rapid geographic information system (GIS)-based solution for on-the-fly inundation mapping of small flood events. The linear interpolation technique (LITE Flood) was developed to approximate the prone flood zones based on river stage without performing additional hydraulic simulations. The approach was evaluated by comparing the results to the corresponding storm scenarios simulated in a standard river hydraulics simulator. The case study is a portion of Wolf River and its two main tributaries in Shelby County, which is located in the southwest corner of Tennessee. The stream channelization of the lower portion of Wolf River has mitigated large flood events, while causing frequent flooding from less severe storms. LITE Flood produced results with good to acceptable accuracy. LITE Flood can be used for rapid, cost-effective, and real-time mapping of multifrequency floods at a large scale, thereby aiding local community emergency response agencies who often do not have the expertise to perform more sophisticated hydraulic modeling but do have a GIS capacity.
- 1 August 2017
- Published by American Society of Civil Engineers (ASCE) in Natural Hazards Review
- Vol. 18 (3)
LITE Flood: Simple GIS-Based Mapping Approach for Real-Time Redelineation of Multifrequency Floods
Flood zones with 1 and 0.02% of annual flooding chance are projected in FEMA’s digital flood insurance rate maps (DFIRMs) and are suited for identifying flood risk at the largest impacts. However, less severe floods, which are not mapped in DFIRMs, still cause significant damage and occur on a more frequent basis. This article uses a simplified rapid geographic information system (GIS)-based solution for on-the-fly inundation mapping of small flood events. The linear interpolation technique (LITE Flood) was developed to approximate the prone flood zones based on river stage without performing additional hydraulic simulations. The approach was evaluated by comparing the results to the corresponding storm scenarios simulated in a standard river hydraulics simulator. The case study is a portion of Wolf River and its two main tributaries in Shelby County, which is located in the southwest corner of Tennessee. The stream channelization of the lower portion of Wolf River has mitigated large flood events, while causing frequent flooding from less severe storms. LITE Flood produced results with good to acceptable accuracy. LITE Flood can be used for rapid, cost-effective, and real-time mapping of multifrequency floods at a large scale, thereby aiding local community emergency response agencies who often do not have the expertise to perform more sophisticated hydraulic modeling but do have a GIS capacity.
- 1 March 2013
- Published by Seismological Society of America (SSA) in Seismological Research Letters
- Vol. 84 (2) , 402-408
A Revised Paleo-Earthquake Chronology on the Southeast Reelfoot Rift Margin near Memphis, Tennessee
A trench was excavated across the southeastern Reelfoot rift margin for paleoseismic research purposes and for the 2011 Seismological Society of America national meeting field trip. The trench was parallel to and 6 m southwest of the Oldham trench described in 2006. In this 2011 trench, faulted alluvial fan stratigraphy and liquefaction deposits less than 4000 yr old were exposed. The trench revealed three tectonic deformation events. The first event (graben formation) and the second event (sand blow, minor faulting, and injection of sand dikes) both post‐date a paleosol circa 4000 yr B.P. and pre‐date a surficial colluvial soil deposit circa 2000 yr B.P. The third event (minor shallow liquefaction and surface deformation) post‐dates a 2000‐year‐old surface colluvial soil. These age constraints allow this third event to be attributed to the 1811–1812 New Madrid earthquakes or a remotely triggered earthquake related to the 1811–1812 earthquake sequence. Although we cannot rule out that the deformation revealed in this trench was caused by earthquakes on other faults in the New Madrid seismic zone, our favored interpretation is that the deformation was caused by rupture on an underlying fault at the base of the Mississippi River bluff that was previously imaged in a shallow reflection profile near this site.
- 1 March 2013
- Published by Seismological Society of America (SSA) in Seismological Research Letters
- Vol. 84 (2) , 402-408
A Revised Paleo-Earthquake Chronology on the Southeast Reelfoot Rift Margin near Memphis, Tennessee
A trench was excavated across the southeastern Reelfoot rift margin for paleoseismic research purposes and for the 2011 Seismological Society of America national meeting field trip. The trench was parallel to and 6 m southwest of the Oldham trench described in 2006. In this 2011 trench, faulted alluvial fan stratigraphy and liquefaction deposits less than 4000 yr old were exposed. The trench revealed three tectonic deformation events. The first event (graben formation) and the second event (sand blow, minor faulting, and injection of sand dikes) both post‐date a paleosol circa 4000 yr B.P. and pre‐date a surficial colluvial soil deposit circa 2000 yr B.P. The third event (minor shallow liquefaction and surface deformation) post‐dates a 2000‐year‐old surface colluvial soil. These age constraints allow this third event to be attributed to the 1811–1812 New Madrid earthquakes or a remotely triggered earthquake related to the 1811–1812 earthquake sequence. Although we cannot rule out that the deformation revealed in this trench was caused by earthquakes on other faults in the New Madrid seismic zone, our favored interpretation is that the deformation was caused by rupture on an underlying fault at the base of the Mississippi River bluff that was previously imaged in a shallow reflection profile near this site.
- 13 April 2011
- Published by American Society of Civil Engineers (ASCE)
- p. 2033-2043
Measuring, Monitoring, and Evaluating Post-Disaster Recovery: A Key Element in Understanding Community Resilience
The process of community recovery in the aftermath of a disaster is complex, long lasting, resource intensive, and poorly understood. Insights described here result from an ongoing project that aims to monitor, quantify, and evaluate the process of post-disaster recovery for two events, Hurricane Charley (2004, Charlotte County and Punta Gorda, Florida) and Hurricane Katrina (2005, Harrison County and Biloxi, Mississippi). A mixed-methods approach using statistical data, interviews, and remote sensing-derived data is applied in an effort to understand as well as monitor, measure and evaluate the recovery process and its outcomes. Observations associated with the post-disaster course of moving residents from temporary to transitional, and ultimately permanent housing serves as the focus for this paper. This work represents a discrete portion of a multi-sector project where Economic, Environmental, Housing/Infrastructure, and Social elements of community recovery are explored. Understanding community recovery can inform community resilience-building strategies.
- 13 April 2011
- Published by American Society of Civil Engineers (ASCE)
- p. 2033-2043
Measuring, Monitoring, and Evaluating Post-Disaster Recovery: A Key Element in Understanding Community Resilience
The process of community recovery in the aftermath of a disaster is complex, long lasting, resource intensive, and poorly understood. Insights described here result from an ongoing project that aims to monitor, quantify, and evaluate the process of post-disaster recovery for two events, Hurricane Charley (2004, Charlotte County and Punta Gorda, Florida) and Hurricane Katrina (2005, Harrison County and Biloxi, Mississippi). A mixed-methods approach using statistical data, interviews, and remote sensing-derived data is applied in an effort to understand as well as monitor, measure and evaluate the recovery process and its outcomes. Observations associated with the post-disaster course of moving residents from temporary to transitional, and ultimately permanent housing serves as the focus for this paper. This work represents a discrete portion of a multi-sector project where Economic, Environmental, Housing/Infrastructure, and Social elements of community recovery are explored. Understanding community recovery can inform community resilience-building strategies.