Alexei A. Lapkin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Alexei A. Lapkin has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Pawel Plucinski
Department of Chemical Engineering, University of Bath, Bath, UK
2 shared publications - Adam J. Walker
TWI Ltd., Great Abington, UK
1 shared publication Barry Crittenden
Department of Chemical Engineering, University of Bath, Bath BA2 7AY, U.K.
1 shared publicationBenhilda Mlambo
1 shared publicationBhupinder Khambay
1 shared publicationClaire Savill-Jowitt
Catalysis and Reaction Engineering Group, Department of Chemical Engineering, University of Bath, Bath BA2 7AY, U.K., Department of Chemical and Biological Sciences, University of Huddersfield, Huddersfield HD1 3DH, U.K., and Department of Chemistry, University of Bath, Bath BA2 7AY, U.K.
1 shared publication
Latest Publications
- 1 May 2009
- Published by Elsevier in Journal of Pharmaceutical and Biomedical Analysis
- Vol. 49 (4) , 908-915
Development of HPLC analytical protocols for quantification of artemisinin in biomass and extracts
- 1 May 2009
- Published by Elsevier in Journal of Pharmaceutical and Biomedical Analysis
- Vol. 49 (4) , 908-915
Development of HPLC analytical protocols for quantification of artemisinin in biomass and extracts
- 1 April 2008
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 10 (6) , 670-677
Potential of ‘nanofluids’ to further intensify microreactors
Recent discovery of high enhancement of heat transfer in nanofluids may be applicable to the area of process intensification of chemical reactors through integration of the functionalities of reaction and heat transfer in compact multifunctional reactors. This may lead to the reduction in the processes footprint and energy intensity over the process life cycle, allow easier implementation of highly exothermic and endothermic reactions, and enable rapid quenching of reactions. A nanofluid based on benign TiO2 material dispersed in ethylene glycol has been studied in an integrated reactor–heat exchanger. An up to 35% increase in the overall heat transfer coefficient was measured in the steady state continuous experiments. This resulted in a closer temperature control in the reaction of selective reduction of an aromatic aldehyde by molecular hydrogen and very rapid change in the temperature of reaction under dynamic reaction control.
- 1 April 2008
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 10 (6) , 670-677
Potential of ‘nanofluids’ to further intensify microreactors
Recent discovery of high enhancement of heat transfer in nanofluids may be applicable to the area of process intensification of chemical reactors through integration of the functionalities of reaction and heat transfer in compact multifunctional reactors. This may lead to the reduction in the processes footprint and energy intensity over the process life cycle, allow easier implementation of highly exothermic and endothermic reactions, and enable rapid quenching of reactions. A nanofluid based on benign TiO2 material dispersed in ethylene glycol has been studied in an integrated reactor–heat exchanger. An up to 35% increase in the overall heat transfer coefficient was measured in the steady state continuous experiments. This resulted in a closer temperature control in the reaction of selective reduction of an aromatic aldehyde by molecular hydrogen and very rapid change in the temperature of reaction under dynamic reaction control.
- 25 January 2007
- Published by Elsevier in Journal of Catalysis
- Vol. 245 (2) , 272-278
Highly selective Pd/titanate nanotube catalysts for the double-bond migration reaction
- 25 January 2007
- Published by Elsevier in Journal of Catalysis
- Vol. 245 (2) , 272-278
Highly selective Pd/titanate nanotube catalysts for the double-bond migration reaction
- 1 November 2006
- Published by American Chemical Society (ACS) in Journal of Natural Products
- Vol. 69 (11) , 1653-1664
Comparative Assessment of Technologies for Extraction of Artemisinin
This paper describes results of a multiobjective comparative assessment of several established and emerging technologies for extraction of a natural antimalarial substance, artemisinin. Extractions by hexane, supercritical carbon dioxide, hydrofluorocarbon HFC-134a, ionic liquids, and ethanol were considered. Hexane extraction is an established technology and appears to be the most cost-effective. However, it is characterized by lower rates and efficiency of extraction than all other considered techniques and is also worse in terms of safety and environmental impact. Similarly, EtOH extraction was found to be worse than hexane in all assessment parameters. The new technologies (scCO2, HFC, and ILs) are based on nonflammable solvents and are characterized by faster extraction cycles and more complete extraction of the useful substances and enable continuous extraction processes with reduced solvent inventory. Ionic liquid and HFC-134a technologies show considerable promise and should be able to compete with hexane extraction in terms of cost-effectiveness following due process optimization. New technologies are also considerably safer (no risk of explosions, low toxicity) and greener (having a lower environmental impact in use, potential for biodegradability after use). The methodology of comparative assessment of established and emerging technologies is discussed.
- 1 November 2006
- Published by American Chemical Society (ACS) in Journal of Natural Products
- Vol. 69 (11) , 1653-1664
Comparative Assessment of Technologies for Extraction of Artemisinin
This paper describes results of a multiobjective comparative assessment of several established and emerging technologies for extraction of a natural antimalarial substance, artemisinin. Extractions by hexane, supercritical carbon dioxide, hydrofluorocarbon HFC-134a, ionic liquids, and ethanol were considered. Hexane extraction is an established technology and appears to be the most cost-effective. However, it is characterized by lower rates and efficiency of extraction than all other considered techniques and is also worse in terms of safety and environmental impact. Similarly, EtOH extraction was found to be worse than hexane in all assessment parameters. The new technologies (scCO2, HFC, and ILs) are based on nonflammable solvents and are characterized by faster extraction cycles and more complete extraction of the useful substances and enable continuous extraction processes with reduced solvent inventory. Ionic liquid and HFC-134a technologies show considerable promise and should be able to compete with hexane extraction in terms of cost-effectiveness following due process optimization. New technologies are also considerably safer (no risk of explosions, low toxicity) and greener (having a lower environmental impact in use, potential for biodegradability after use). The methodology of comparative assessment of established and emerging technologies is discussed.
- 1 August 2006
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 22 (18) , 7664-7671
Microcalorimetric Study of Ammonia Chemisorption on H3PW12O40 Supported onto Mesoporous Synthetic Carbons and SBA-15
Keggin tungstophosphoric acid supported onto mesoporous and meso-microporous materials was studied by ammonia microcalorimetry. Experiments were performed at high and low temperatures to separate the contributions of chemisorption and physisorption, low-temperature data being potentially important for the ambient temperature purification processes. Analysis of thermokinetic data obtained from heat output curves at an elevated temperature allows one to distinguish the transition between reaction of ammonia with the acid sites and the onset of physical sorption. Thermokinetic data are also sensitive to the pore structure of the support materials, with faster sorption registered in the case of materials with the open mesoporous structure. The SBA-15 supported acid shows the maximum ammonia uptake and the strongest acid sites among the three materials studied. The dynamics of sorption, characterized by the thermokinetic parameter, appears to be better in the two materials possessing open pore structure, mesoporous carbon Novacarb and especially the mesoporous silica SBA-15.
- 1 August 2006
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 22 (18) , 7664-7671
Microcalorimetric Study of Ammonia Chemisorption on H3PW12O40 Supported onto Mesoporous Synthetic Carbons and SBA-15
Keggin tungstophosphoric acid supported onto mesoporous and meso-microporous materials was studied by ammonia microcalorimetry. Experiments were performed at high and low temperatures to separate the contributions of chemisorption and physisorption, low-temperature data being potentially important for the ambient temperature purification processes. Analysis of thermokinetic data obtained from heat output curves at an elevated temperature allows one to distinguish the transition between reaction of ammonia with the acid sites and the onset of physical sorption. Thermokinetic data are also sensitive to the pore structure of the support materials, with faster sorption registered in the case of materials with the open mesoporous structure. The SBA-15 supported acid shows the maximum ammonia uptake and the strongest acid sites among the three materials studied. The dynamics of sorption, characterized by the thermokinetic parameter, appears to be better in the two materials possessing open pore structure, mesoporous carbon Novacarb and especially the mesoporous silica SBA-15.
- 29 September 2004
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 38 (21) , 5815-5823
Framework for Evaluating the “Greenness” of Chemical Processes: Case Studies for a Novel VOC Recovery Technology
A system of metrics is proposed for a rough-guide evaluation of the greenness of new and existing chemical technologies as well as for the analysis of flow sheets of new processes. The proposed methodology is based on a hierarchical approach. The main feature of the proposed system is the reflection of the stakeholder relevance of various aspects of green chemistry at different levels of the hierarchy and the corresponding system boundaries. Therefore, the developed methodology provides a basis for the multiobjective comparison of alternative technologies in terms of their greenness. A novel technology for recovery of volatile organic chemicals (VOCs) using monolithic adsorbents has been evaluated in terms of its environmental efficiency using a small set of indicators assembled into a hierarchical metric. A comparison between incineration and recovery of VOCs via adsorption has been performed using the proposed methodology. The comparison highlights considerable environmental advantages of the recovery technology. Flow sheet analysis points out which stages of the adsorption process could be further improved. Indicators have been evaluated within defined system boundaries.
- 29 September 2004
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 38 (21) , 5815-5823
Framework for Evaluating the “Greenness” of Chemical Processes: Case Studies for a Novel VOC Recovery Technology
A system of metrics is proposed for a rough-guide evaluation of the greenness of new and existing chemical technologies as well as for the analysis of flow sheets of new processes. The proposed methodology is based on a hierarchical approach. The main feature of the proposed system is the reflection of the stakeholder relevance of various aspects of green chemistry at different levels of the hierarchy and the corresponding system boundaries. Therefore, the developed methodology provides a basis for the multiobjective comparison of alternative technologies in terms of their greenness. A novel technology for recovery of volatile organic chemicals (VOCs) using monolithic adsorbents has been evaluated in terms of its environmental efficiency using a small set of indicators assembled into a hierarchical metric. A comparison between incineration and recovery of VOCs via adsorption has been performed using the proposed methodology. The comparison highlights considerable environmental advantages of the recovery technology. Flow sheet analysis points out which stages of the adsorption process could be further improved. Indicators have been evaluated within defined system boundaries.
- 1 July 2003
- Published by Elsevier in Catalysis Today
- Vol. 81 (4) , 529
Preface
- 14 May 2002
- Published by Elsevier in Chemical Engineering Science
- Vol. 57 (13) , 2357-2369
A porous carbon membrane reactor for the homogeneous catalytic hydration of propene
- 14 May 2002
- Published by Elsevier in Chemical Engineering Science
- Vol. 57 (13) , 2357-2369
A porous carbon membrane reactor for the homogeneous catalytic hydration of propene