Gianni Comini
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Gianni Comini has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
S. Savino
Department of Energy Technologies , University of Udine , Udine, Italy
4 shared publicationsC. Nonino
Department of Energy Technologies , University of Udine , Udine, Italy
3 shared publications- Antonio Barletta
Alma Mater Studiorum Università di Bologna
1 shared publication - Eugenia Rossi di Schio
University of Bologna
1 shared publication - Giovanni Cortella
University of Udine, Via delle Scienze 206,Polytechnic Department of Engineering and Architecture,Udine,Italy,33100
1 shared publication - Giulio Croce
Dipartimento Politecnico di Ingegneria e Architettura, University of Udine, via delle Scienze 206, 33100 Udine, Italy
1 shared publication
Latest Publications
- 7 July 2008
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 48 (4) , 699-707
Wall coupling effect in channel forced convection with streamwise periodic boundary heat flux variation
- 7 July 2008
- Published by Elsevier in International Journal of Thermal Sciences
- Vol. 48 (4) , 699-707
Wall coupling effect in channel forced convection with streamwise periodic boundary heat flux variation
- 1 November 2007
- Published by Taylor & Francis in Numerical Heat Transfer, Part A: Applications
- Vol. 51 (1) , 23-37
Modeling of Coupled Conduction and Convection in Moist Air Cooling
This article deals with the numerical simulation of moist air cooling in compact heat exchangers. The model requires the solution of a coupled problem, since interface temperatures must be calculated at the same time as temperature distributions in adjacent fluid and solid regions. The energy equation is solved in the whole domain, including the solid region, and the latent heat flux on the surfaces where condensation occurs is taken into account by means of an additional internal boundary condition. The approach is completely general, even if the finite-element method is used in the calculations. The accuracy, reliability, and capabilities of the methodology are demonstrated by examples of application concerning heat exchangers of both the plate-fin and the tube-fin types.
- 1 November 2007
- Published by Taylor & Francis in Numerical Heat Transfer, Part A: Applications
- Vol. 51 (1) , 23-37
Modeling of Coupled Conduction and Convection in Moist Air Cooling
This article deals with the numerical simulation of moist air cooling in compact heat exchangers. The model requires the solution of a coupled problem, since interface temperatures must be calculated at the same time as temperature distributions in adjacent fluid and solid regions. The energy equation is solved in the whole domain, including the solid region, and the latent heat flux on the surfaces where condensation occurs is taken into account by means of an additional internal boundary condition. The approach is completely general, even if the finite-element method is used in the calculations. The accuracy, reliability, and capabilities of the methodology are demonstrated by examples of application concerning heat exchangers of both the plate-fin and the tube-fin types.
- 3 August 2007
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 44 (7) , 815-825
Thermal-performance evaluation of coolant passages with staggered arrays of pin fins
- 3 August 2007
- Published by Springer Nature in Heat and Mass Transfer
- Vol. 44 (7) , 815-825
Thermal-performance evaluation of coolant passages with staggered arrays of pin fins
- 28 February 2007
- Published by Elsevier in Applied Thermal Engineering
- Vol. 27 (2-3) , 611-618
Thermal modeling of vacuum web coating
- 28 February 2007
- Published by Elsevier in Applied Thermal Engineering
- Vol. 27 (2-3) , 611-618
Thermal modeling of vacuum web coating
- 13 February 2007
- Published by Wiley in Journal of Heat Transfer
- Vol. 129 (10) , 1395-1402
Numerical Evaluation of Fin Performance Under Dehumidifying Conditions
A numerical model of moist air cooling in compact heat exchangers is presented. The model requires the solution of a coupled problem, since interface temperatures, obtained from the solution of the energy equation in adjacent fluid and solid regions, are used to set the appropriate boundary conditions for the transport equation of water vapor in moist air. The approach is completely general, even if the finite-element method is used for the simulations reported in the paper. The numerical results are favorably compared with the corresponding experimental results concerning the rectangular and wavy fins under dehumidifying conditions.
- 13 February 2007
- Published by Wiley in Journal of Heat Transfer
- Vol. 129 (10) , 1395-1402
Numerical Evaluation of Fin Performance Under Dehumidifying Conditions
A numerical model of moist air cooling in compact heat exchangers is presented. The model requires the solution of a coupled problem, since interface temperatures, obtained from the solution of the energy equation in adjacent fluid and solid regions, are used to set the appropriate boundary conditions for the transport equation of water vapor in moist air. The approach is completely general, even if the finite-element method is used for the simulations reported in the paper. The numerical results are favorably compared with the corresponding experimental results concerning the rectangular and wavy fins under dehumidifying conditions.
- 11 February 2004
- Published by Wiley in International Journal for Numerical Methods in Fluids
- Vol. 44 (8) , 885-903
Effect of corner angle on convection enhancement in wavy ducts with trapezoidal cross‐sections
The effect of corner angle variations on pressure drop and heat transfer characteristics is investigated in the fully developed region of wavy ducts with trapezoidal cross‐sections. The resulting enhancement of convection, with respect to corresponding straight ducts, can be attributed to the formation of longitudinal vortices close to the two parallel surfaces. Numerical simulations show that Nusselt numbers and friction factors increase with the decrease of corner angle from 90 to 60°, before levelling out around 60°. Nusselt numbers and friction factors also increase with the Reynolds number, and the slopes of their representative curves increase above a critical value of the Reynolds number because of the onset of time‐periodic flow oscillations. Copyright © 2004 John Wiley & Sons, Ltd.
- 11 February 2004
- Published by Wiley in International Journal for Numerical Methods in Fluids
- Vol. 44 (8) , 885-903
Effect of corner angle on convection enhancement in wavy ducts with trapezoidal cross‐sections
The effect of corner angle variations on pressure drop and heat transfer characteristics is investigated in the fully developed region of wavy ducts with trapezoidal cross‐sections. The resulting enhancement of convection, with respect to corresponding straight ducts, can be attributed to the formation of longitudinal vortices close to the two parallel surfaces. Numerical simulations show that Nusselt numbers and friction factors increase with the decrease of corner angle from 90 to 60°, before levelling out around 60°. Nusselt numbers and friction factors also increase with the Reynolds number, and the slopes of their representative curves increase above a critical value of the Reynolds number because of the onset of time‐periodic flow oscillations. Copyright © 2004 John Wiley & Sons, Ltd.
- 3 June 2003
- Published by Wiley in International Journal for Numerical Methods in Engineering
- Vol. 57 (12) , 1755-1773
Numerical simulation of convective heat and mass transfer in banks of tubes
This paper studies convective heat and mass transfer in laminar flows of humid air through banks of tubes. The flow structure on the airside is spatially periodic, with fully developed conditions prevailing after a short distance from the inlet section. In numerical simulations, periodicities in the velocity, temperature and mass concentration fields are taken into account to reduce the computational domain, both in the entrance region and in the fully developed region. The approach followed is completely general, even if the finite element method is used in the discretization process. In the application section, velocity, temperature and mass concentration fields are computed for a bank of tubes in a staggered arrangement. Quantitative results are also obtained for apparent friction factors, Nusselt numbers, Sherwood numbers and ratios between Colburn factors for heat and mass transfer. Copyright © 2003 John Wiley & Sons, Ltd.
- 3 June 2003
- Published by Wiley in International Journal for Numerical Methods in Engineering
- Vol. 57 (12) , 1755-1773
Numerical simulation of convective heat and mass transfer in banks of tubes
This paper studies convective heat and mass transfer in laminar flows of humid air through banks of tubes. The flow structure on the airside is spatially periodic, with fully developed conditions prevailing after a short distance from the inlet section. In numerical simulations, periodicities in the velocity, temperature and mass concentration fields are taken into account to reduce the computational domain, both in the entrance region and in the fully developed region. The approach followed is completely general, even if the finite element method is used in the discretization process. In the application section, velocity, temperature and mass concentration fields are computed for a bank of tubes in a staggered arrangement. Quantitative results are also obtained for apparent friction factors, Nusselt numbers, Sherwood numbers and ratios between Colburn factors for heat and mass transfer. Copyright © 2003 John Wiley & Sons, Ltd.
- 1 March 1997
- Published by Taylor & Francis in Numerical Heat Transfer, Part B: Fundamentals
- Vol. 31 (2) , 217-234
OPEN BOUNDARY CONDITIONS FOR THE STREAMFUNCTION -VORTICITY FORMULATION OF UNSTEADY LAMINAR CONVECTION
The streamfunction-vorticity formulation is used to analyze unsteady laminar-convection problems in two-dimensional incompressible flows. The Bubnov-Galerkin finite-element method and a sequential procedure are employed to discretize and solve the governing differential equations. Very accurate results are obtained by employing “advective derivative conditions” at the outflow for all the variables involved. The boundary conditions for the streamfUnction at internal walls are imposed during the assembly process, and the vorticity at inflow and wall boundaries is evaluated in the framework of the stream/unction equation. The accuracy of the approach is demonstrated by the solution of two well-known benchmark problems concerning forced convection over a circular cylinder in cross flow and mixed convection in a plane channel heated from below.
- 1 March 1997
- Published by Taylor & Francis in Numerical Heat Transfer, Part B: Fundamentals
- Vol. 31 (2) , 217-234
OPEN BOUNDARY CONDITIONS FOR THE STREAMFUNCTION -VORTICITY FORMULATION OF UNSTEADY LAMINAR CONVECTION
The streamfunction-vorticity formulation is used to analyze unsteady laminar-convection problems in two-dimensional incompressible flows. The Bubnov-Galerkin finite-element method and a sequential procedure are employed to discretize and solve the governing differential equations. Very accurate results are obtained by employing “advective derivative conditions” at the outflow for all the variables involved. The boundary conditions for the streamfUnction at internal walls are imposed during the assembly process, and the vorticity at inflow and wall boundaries is evaluated in the framework of the stream/unction equation. The accuracy of the approach is demonstrated by the solution of two well-known benchmark problems concerning forced convection over a circular cylinder in cross flow and mixed convection in a plane channel heated from below.