WLWalter Lauriks

Walter Lauriks

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Walter Lauriks has a total of 62 co-authors. Here are the top co-authors by number of shared publications:

  • C. Glorieux

    Laboratorium voor Akoestiek en Thermische Fysica, Katholieke Universiteit Leuven, Celestijnenlaan 200D, B-3001 Leuven, Belgium

    4 shared publications
  • Jan Thoen

    Laboratorium voor Akoestiek en Thermische Fysica, Departement Natuurkunde en Sterrenkunde, Katholieke Universiteit Leuven, Celestijnenlaan 200D, B-3001 Leuven, Belgium

    4 shared publications
  • Claude Depollier

    Laboratoire d’Acoustique de l’Universit’e du Maine, Universit e du Maine, Maine, France

    3 shared publications
  • K. Van de Rostyne

    Laboratorium voor Akoestiek en Thermische Fysica, Katholieke Universiteit Leuven, Celestijnenlaan 200D, B-3001 Leuven, Belgium

    3 shared publications
  • Mouna Naas

    Laboratoire d'Acoustique de l'Université du Maine, Avenue Olivier Messiaen, 72085 Le Mans, France

    3 shared publications
  • Naima Sebaa

    Laboratoire d'Acoustique de l'Université du Maine, Avenue Olivier Messiaen, 72085 Le Mans, France

    3 shared publications

Latest Publications

  • Prediction of sound reflection by corrugated porous surfaces

    by J.-F. Allard, O. Dazel, G. Gautier, J.-P. Groby, W. Lauriks

    The coupled mode (CM) and finite-element methods (FEMs) are developed and used to predict the acoustic reflection coefficient of a semi-infinite porous medium with closely spaced two-dimensional (2D) periodical corrugations. These methods are also applied to predict the reflection coefficient of a periodic array of porous corrugations installed on an acoustically rigid surface. It is shown that the predictions by the both methods agree closely. The reflection coefficient and Brewster angle of total refraction for the corrugated semi-infinite medium predicted with these methods are compared against that predicted by the Biot/Tolstoy/Howe/Twersky and extended Twersky models. A similar analysis is carried out for porous corrugations set on a rigid backing. The behavior of the reflection coefficient and the pole in the expression for the reflection coefficient located close to grazing incidence is studied.


  • The use of virtual acoustics in the evaluation and development of binaural hearing aid algorithms

    by Monika Rychtarikova, Tim Van Den Bogaert, Gerrit Vermeir, Koen Eneman, Walter Lauriks, Marc Moonen, Jan Wouters

    The development of noise reduction algorithms for hearing aids (HA) is not longer only related to the improvement of signal to noise ratio, but also to the quality of hearing, e.g., binaural aspects of hearing. This is very important for the recognition of the localization of sound sources but also for an improved speech intelligibility in noisy situations due to spatial release from masking effects. New design and signal processing algorithms for binaural HA's need to be tested and validated in different acoustical scenarios. As it is too laborious and time consuming to perform sufficient numbers of perceptual evaluations in different rooms with different acoustical parameters, advanced acoustic modeling of different virtual acoustical environments might be needed. Virtual acoustics in our research relates to the convolution of the measured or simulated binaural signals (head related transfer functions ‐ HRTF's) with the impulse response generated from a computermodel of a room (using ODEON®software) to simulate binauralsounds. This study investigates the usage of virtual acoustics in the framework of developing algorithms for binaural hearing aids. It evaluates and quantifies the fidelity of binaural signals generated by commercially available virtual acoustics software with respect to the localization of sound and speech intelligibility in different acoustical scenarios.

  • Excess ultrasonic attenuation due to inhomogeneities in porous media

    by Mouna Naas, Naima Sebaa, Zine Fellah, Mohamed Fellah, Walter Lauriks, Claude Depollier

    While Biot's theory seems well adapted to model the acoustical waves propagation in cancellous bone, some of its predictions do not agree with the experimental results. The excess of attenuation of the fast wave is one of these discrepancies. In this paper we propose a modified Biot's model which takes into account the fluctuations of the physical parameters and their correlations. As a result of this model, we show that this excess of attenuation is due to several processes: i) classical Biot's attenuation, ii) scattering leading to the extension of the wave path, iii) mode conversion. Some comparison between experimental results and numerical simulations are proposed.


  • Simulation of ultrasound wave propagation through trabecular bone samples with and without bone marrow

    by Liesbet Goossens, Jef Vanderoost, Siegfried Jaecques, Steven Boonen, Jan D'HOoge, Walter Lauriks, Georges Van Der Perre

    For the clinical assessment of osteoporosis, ultrasound has been proposed as an alternative or supplement to the Dual-Energy X-ray Absorptiometry technique. However the interaction of ultrasound waves with (trabecular) bone remains relatively poorly understood. The aim of the present study was to improve the understanding of this interaction by simulating ultrasound wave propagation in fifteen trabecular bone samples from the human lumbar spine, using μCT based Finite Elements Modelling. The model included only the solid bone, without the bone marrow. Two structural parameters were calculated: the bone volume fraction (BV/TV) and the structural (apparent) elastic modulus (Es), and the ultrasound parameter Speed Of Sound (SOS). At 1 MHz, correlations between SOS and the parameters BV/TV and Es were rather weak but the results can be explained from the specific features of the trabecular structure and the intrinsic material elastic modulus Ei. The correlation found between the simulated SOS values and those calculated from the simple bar equation was poor when the three directions are considered separately. However at lower frequencies (50-300 kHz), this correlation significantly improved. Currently we investigate the correlations between SOS and the structural parameters when the bone marrow is included in the FE model.

  • Measurement of the tortuosity and the viscous characteristic length of human cancellous bone via transmitted waves

    by Naima Sebaa, Laurens Boeckx, Zine Fellah, Mouna Naas, Tom L. Goossens, Steven Boonen, Georges Van Der Perre, Philippe Leclaire, Claude Depollier, Walter Lauriks

    For a few years several authors have proposed the model of Biot to describe the ultrasonicwave propagation in cancellous bone. One drawback of this model is the number of parameters which it needs. Two significant parameters to describe the geometry of the trabeculae are tortuosity and viscous characteristics length. In this communication, we propose two methods to measure these parameters. The first method consists in estimating these two parameters by inversion from the transmission coefficient. In the second method, we get the tortuosity from direct measurement using the focused transducers. The scan of a layer of cancellous bone shows a good correlation between direct measurements and the results of the inversion.

  • Acoustic waves propagation along mechanically free surface of unconsolidated granular porous media

    by Xavier Jacob, Vladislav Aleshin, Vincent Tournat, Philippe Leclaire, Walter Lauriks, Vitali Gusev

    Unconsolidated granular materials exhibit strong dependence of elastic properties on pressure due to high sensitivity of the intergrain contacts to magnitude of loading. As a consequence the gravity field makes these granular assemblages highly elastically inhomogeneous particularly near mechanically free surface.Theoretical and experimental investigations conducted recently have demonstrated that multiple waveguidesurface acoustic modes propagate along the free surface of the solid‐state skeleton in the disordered air‐saturated granular packings. These modes are localized near the surface. In ordered granular packing the acoustic waves can travel along the surface inside the horizontal channels, which are localized beneath the surface. The waves of different frequencies are travelling at different depths. The anisotropy of these inhomogeneous granular phononic crystals has an important influence of the existence of the waveguide modes. The experiments with acoustic waves traveling in the vicinity of a free surface provide fundamental information on the mechanical behaviour of unconsolidated granular media at very low pressures in the vicinity of the jamming transition. The perspectives of this research could be related to the analysis of the role which could be played in the considered phenomena by the acoustic waves predominantly travelling in these granular porous assemblages through the fluid‐saturated pores.

  • Film thickness determination by laser ultrasonics

    by Michaël Lemaire, Frédéric Jenot, Mohammadi Ouaftouh, Wei Jiang Xu, Marc Duquennoy, Mohamed Ourak, Renaud Côte, Robbe Salenbien, Bart Sarens, Walter Lauriks, et al.

    The thickness of films deposited on substrates is crucial for their thermal, electrical, optical behaviour. These properties are essential in thin film applications, especially in the field of microelectronics. In this study, we are interested in thickness determination of silver and gold films deposited by evaporation on a silicon substrate by using an ultrasonic non‐destructive technique. In particular, the well‐known laser ultrasonic technique is used to generate and detect the surface acoustic waves. Results obtained by two complementary methods allowing a non‐contact measurement in a large bandwidth (from 5 MHz to 200 MHz) are presented, and the dispersion of the Rayleigh wave propagation velocity is analyzed to determine the film thickness.


  • Flow resistivity profile inversion for a porous medium

    by Claude Depollier, Naima Sebaa, Mouna Naas, Bernard R. Castagnede, Zine Fellah, Walter Lauriks

    Predictions for the low frequency sound waves propagation in a porous medium needs the knowledge of the flow specific resistance of the medium. We present a scheme for the flow resistivity profile inversion for a layered medium. In the framework of the fluid equivalent model a closed‐form relation of the resistivity profile with the Fourier transform of the reflection is derived. It provide a straightforward way to perform the reconstruction of the profile. The result show a strong correlation between the flow resistivity profile and the reflection coefficient in this model. Some numerical simulations are given as examples of the applicability of this scheme.

  • Prediction of the sound field above a patchwork of absorbing materials

    by R. Lanoye, G. Vermeir, W. Lauriks, F. Sgard, W. Desmet

    The aim of this paper is to investigate the acoustic performance of sound absorbing materials through a numerical wave based prediction technique. The final goal of this work is to get insight into the acoustic behavior of a combination of sound absorbing patches. In order to address a wide frequency range, a model based on the Trefftz approach is adopted. In this approach, the dynamic field variables are expressed in terms of global wave function expansions that satisfy the governing dynamic equations exactly. Therefore, approximation errors are associated only with the boundary conditions of the considered problem. This results in a computationally efficient technique. The main advantage of this method is the fact that the sound absorbing patches do not have to be locally reacting. In this article, the wave based method is described and experimentally validated for the case of normal incidence sound absorption identification in a standing wave tube. Afterwards, the method is applied to simulate some interesting setups of absorbing materials.