BZBei-Jing Zhong

Bei-Jing Zhong

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Bei-Jing Zhong has a total of 19 co-authors. Here are the top co-authors by number of shared publications:

  • Fan Yang

    School of Aerospace, Tsinghua University, Beijing, P.R. China; Shenhua Fujian Energy Corporation Limited, Fuzhou, Fujian, P.R. China

    3 shared publications
  • Zheng Dong

    3 shared publications
  • Dong Zheng

    Southwest Jiaotong Univ, Sch Mech Engn, Chengdu 610031, Sichuan, Peoples R China

    2 shared publications
  • Hui-Sheng Peng

    School of Aerospace Engineering, Tsinghua University, Beijing, People’s Republic of China

    2 shared publications
  • Qing-Tao Yang

    Key Laboratory for Thermal Science and Power Engineering of Ministry of Education, Department of Engineering Mechanics , Tsinghua University , Beijing , P.R. China ; China Aerodynamics Research and Development Center , Mianyang , P.R. China

    2 shared publications
  • Tong Yao

    Tsinghua Univ, Dept Thermal Engn, Ctr Combust Energy, Key Lab Thermal Sci & Power Engn,Minist Educ, Beijing 100084, Peoples R China

    2 shared publications

Latest Publications

  • The Experimental and Kinetic Study on Ignition Characteristics of n-Butane/Oxygen-Enriched Air Mixtures in a Heated Meso-Channel

    by Bei-Jing Zhong, Fang Xin

    Oxygen-enriched combustion is expected to be introduced into small scale to improve the characteristics of micro- or meso-scale combustion. To fully understand the advantages of oxygen-enriched combustion, the ignition characteristics of n-butane/oxygen-enriched air mixtures are studied by the experimental and numerical methods in a heated quartz tube with an inner diameter of 5 mm. The experimental results show that the oxygen enrichment level, equivalence ratio, and flow rate have an important influence on the ignition temperature of the mixed gas in the tube. The ignition temperature decreases with the increasing oxygen enrichment and is strongly affected by oxygen concentration at higher equivalence ratio and lower oxygen enrichment level. In the meanwhile, higher equivalence ratio and lower flow velocity also significantly reduce the ignition temperature in the experimental cases. Furthermore, the increase in the oxygen enrichment level significantly enhances the effect of the equivalence ratio on the ignition temperature while higher flow velocity slightly weakens the effect. The numerical results show that oxygen enrichment is beneficial to the production of OH radicals in pre-ignition period and significantly promotes the oxydehydrogenation reactions of intermediates.


  • Effect of Molecular Structure on Laminar Flame Speeds of Three C5 Alkenes

    by Bei-Jing Zhong, Zhao-Mei Zeng

    The laminar flame speeds of 1-pentene and 2-methyl-2-butene are measured in our previous studies. In order to study the effect of molecular structure on the combustion characteristics of C5 alkenes, the laminar flame speeds of 2-pentene/air mixtures were measured in a constant volume combustion bomb in the different conditions (T0 = 450 K, p = 0.1/0.3 MPa, and φ = 0.6–1.6). Experimental results for the three fuels show that 1-pentene has the largest laminar flame speeds, and 2-methyl-2-butene has the lowest one. Further, a high-temperature chemical mechanism for C5 alkenes was developed to analyze the differences in laminar flame speeds between the three fuels and to explore the effects of molecular structure on the combustion characteristics of the three C5 alkenes. The chemical mechanism was verified by the experimental results of laminar flame speeds and can well predict the combustion characteristics of these three C5 alkenes over a wide range of conditions. The effects of molecular structure on laminar flame speed were analyzed by the chemical kinetic model from three aspects: bond dissociation energies, reaction pathways, and sensitivity analyses. Results show that the chemical kinetic characteristics of linear 1-pentene and 2-pentene are similar to each other, while the chemical kinetic characteristics of branched 2-methyl-2-butene differ greatly from them.


  • Experimental Study on the Combustion of Thermally Cracked Endothermic Hydrocarbon Fuel

    by Bei-Jing Zhong, Hui-Sheng Peng

    The combustion of pyrolysis products of endothermic hydrocarbon fuel was studied experimentally to demonstrate the variation in the combustion characteristics after regenerative cooling. The experimental results show that the pyrolysis liquid produced from different cracking conditions have similar combustion characteristics to the original fuel. The different pyrolysis gases show very similar combustion characteristics even under very different conversion rates. Therefore, no remarkable differences in the combustion characteristics were found in the practical pyrolysis products (mixtures of pyrolysis liquid and pyrolysis gas), and the differences between their combustion characteristics remain essentially the same with changes in the cracking pressure and mass flow rate once the inlet and outlet temperature are settled. An analysis also shows that the liquid phase of the pyrolysis product has a greater effect on the combustion characteristics of practical pyrolysis products than the gaseous phase, but the discrepancy between their relative effects is insensitive to the combustion pressure.


  • The pressure dependence of laminar flame speed of 2-methyl-2-butene/air flames in the 0.1–1.0 MPa range

    by Bei-Jing Zhong, Zhao-Mei Zeng, Hui-Sheng Peng

    Laminar flame speeds of 2-methyl-2-butene/air mixtures were measured in a constant volume combustion bomb at T0 = 450 K, p = 0.1–1.0 MPa, and φ = 0.5–1.6. The dependence of laminar flame speed on pressure is described by an empirical formula , where the power exponent β is summarized as a function of equivalence ratios (φ). The maximum β at stoichiometric ratio indicates that the effect of pressure on flame is greater around the stoichiometric ratio and weaker at deviations from the stoichiometric ratio. Furthermore, analysis by chemical kinetic mechanism shows that elevated pressure is more sensitive to the reactions associated with the H and OH radicals and affects their concentration variation, and ultimately the laminar flame speed of 2-methyl-2-butene/air mixtures.


  • Open Access

    Compact Chemical Mechanism for Autoignition and Combustion of Methylcyclohexane under Engine Relevant Conditions

    by Tong Yao, Bei-Jing Zhong, Kai Hong Luo

    A compact chemical kinetic mechanism for autoignition and combustion of methylcyclohexane (MCH) was developed and validated for a wide range of conditions, especially for low temperatures and high pressures that are most relevant to real engines. The mechanism was constructed in steps. An improved C5-C7 submechanism (26 species and 90 reactions) was first developed to describe fuel-cracking to form smaller fragments under high temperatures. Five modules of the C5-C7 submechanism were considered separately, and the rate constants were carefully estimated. A semiglobal low-temperature submechanism was developed to improve prediction of the negative temperature coefficient behaviors, which contained 4 species and 11 reactions. Isomers of intermediate radicals and fast reactions were lumped to obtain the minimal low-temperature submechanism. Combined with a simplified C0-C4 kernel (40 species and 276 reactions), the final mechanism consists of 70 species and 377 reactions. Validations of the newly developed mechanism were performed using amounts of experimental data, including ignition delays in shock tubes and rapid compression machines, under a wide range of temperatures (650–2000 K), pressures (1–50 atm), and equivalence ratios (0.5–2.0), and OH concentration histories in high pressure shock tubes. Furthermore, experimental data of species concentrations and flame speeds in laminar premixed flames were also used for validation. The present mechanism showed good accuracy in predicting ignition and combustion properties over a range of parameters. Simulations using other detailed MCH mechanisms were also carried out for comparison.


  • Effect of Catalyst Length and Hydrogen Addition on the Combustion Characteristics ofn-Butane in a Catalytic Swiss-Roll Combustor

    by Bei-Jing Zhong, Ya-Wei Yu, Fan Yang

    The effect of catalyst length and hydrogen addition on the combustion characteristics of n-butane in a catalytic Swiss-roll combustor was studied experimentally. The results show that the 4.5-mm ceramic with Pt catalyst slightly outperforms the 3.0- and 6.0-mm ceramics. However, changing only the catalyst length does not expand the lower flammable limits to lean fuel. Further experiments on the combustor with the 4.5-mm ceramic show that the addition of hydrogen to flammable mixtures can expand the lower flammable limits of such mixtures to lower than 0.5. Analyses on exhaust gas and stable combustion temperature indicate that hydrogen supplies heat through complete combustion and enhances the n-butane conversion ratio. A high amount of hydrogen is favorable for flammable range expansion. Moreover, a higher amount of hydrogen can further reduce the lower limits.


  • Chemical Kinetic Mechanism of a Three-Component Fuel Composed of Iso-octane/n-Heptane/Ethanol

    by Bei-Jing Zhong, Dong Zheng

    A chemical kinetic mechanism for a three-component fuel composed of iso-octane/n-heptane/ethanol has been developed. The mechanism consists of 51 species and 204 elementary reactions. Two elementary reactions that significantly affect laminar flame speed are subjected to sensitivity analysis. The validated results show that the predictions using the present mechanism are in good agreement with the experimental ignition delay time and laminar flame speed. Both the chemical reaction and the transportation process are accurately reproduced by the simulation using the present model in iso-octane/air premixed flames and in n-heptane/air counterflow partially premixed flames. The chemical kinetic mechanism is applicable to multidimensional computational fluid dynamics simulations of the combustion of gasoline surrogates or the cocombustion of primary reference fuels (PRF) with ethanol because of its smaller number of species and fewer reactions.