TSTor P. Schultz

Tor P. Schultz

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Tor P. Schultz has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Relative fungal efficacy results from the soil block test with a long incubation period of three commercial copper wood preservatives

    by Tor P. Schultz, Darrel D. Nicholas

    Development of new wood preservative systems is a lengthy and expensive endeavor. This study examined soil block experiments with a longer incubation time than typical to make the test harsher, using commercial particulate copper azole (PCA), soluble copper azole (CA-C), and soluble alkaline copper quaternary (ACQ-D) systems. Both the CA-C and PCA systems performed poorly compared to ACQ-D with two copper tolerant fungi, even at retentions well above the specified ground-contact residential level, i.e., Use Category 4A (UC4A). With the one copper sensitive fungus examined, PCA and ACQ-D prevented decay at about half the UC4A retention. To compare these laboratory efficacy results, data from an outdoor accelerated post test with a copper tolerant fungus gave efficacies of ACQ > CA-C >> PCA, with PCA having significantly more decay than the two soluble copper systems. Further confirmation was obtained from recently published E7 stake data conducted at a site with extensive copper tolerant fungi, which suggested that ACQ performed better than PCA and CA-B after about 3 years of exposure in agreement with the harsh soil block results with the two copper-tolerant fungi. Conversely, results from four other sites without a history of extensive copper tolerant fungi are interpreted that all three systems generally performed adequately, which is compatible with the soil block test with the one copper sensitive fungus examined.


  • A proposed accelerated field stake test for rapid assessment of wood preservative systems

    by Tor P. Schultz, Darrel D. Nicholas

    A ground-contact field test which would yield faster deterioration data when testing new wood preservative systems would be useful. This paper reports on an accelerated field test concept where wood samples are treated with a proposed preservative and a reference system with known efficacy, with the treated samples installed next to ground-contact wood feeder stakes that are already infected with wood decay fungi. This method was employed to compare decay efficacies of wood treated with four copper systems commonly available in the US. Two preliminary short-term studies show that this test method can provide differentiation between preservatives systems after only a short exposure period.


  • Effect of different soils and pH amendments on brown-rot decay activity in a soil block test

    by Nathan S. Little, Tor P. Schultz, Darrel D. Nicholas

    The soil block test is the most widely employed laboratory method for determination of biocide efficacy in North America. However, surprisingly little is known about the effect of different soil properties and soil amendments on fungal decay. Four soils with different textures and chemical properties were obtained and characterized. These soils, with and without pH amendments, were submitted to one soil block decay study using untreated southern pine wood and two brown-rot fungi. A second study examined the effect of adding water-soluble calcium chloride to soils, or directly to wood, on brown-rot decay. Based on the results of the first study with a limited number of soils, changes in the specified properties of the soil are suggested. Generally, fungal decay was reduced by raising the soil pH for acidic soils by hydrated lime as specified in the standards, or by adding water-soluble acidic calcium chloride to basic soils.


  • Termite-resistant heartwood. Effect of antioxidants on termite feeding deterrence and mortality

    by Nathan S. Little, Tor P. Schultz, Darrel D. Nicholas

    Biocides currently employed to prevent termite damage face environmental and toxicity concerns. We recently proposed that heartwood which is naturally resistant to termites might be due to the extractives having both toxicity and antioxidant properties and we reported that the artificial and benign antioxidant butylated hydroxytoluene (BHT) had termite feeding deterrence and toxicity properties. Here, we investigate other antioxidants, both natural and synthetic, and analogs which lack antioxidant properties, on Reticulitermes flavipes Kollar. Laboratory no-choice tests according to AWPA Standard E1 were performed. Antioxidants that are benign to humans had feeding deterrence and mortality properties to R. flavipes. Conversely, the non-antioxidant analogs, with the exception of the heterocyclic flavanone which was previously shown to be active against decay fungi, had little effect on R. flavipes. We conclude that R. flavipes avoids wood which contain high levels of antioxidants, such as heartwood with phenolic extractives.


  • Biocide Retention Variation and Gradients in Commercially Treated 4 by 4s

    by T. P. Schultz, Darrel D. Nicholas

    Biocide retentions for copper-based wood preservatives used for residential ground-contact applications are established through field stake tests using small research stakes cut from selected sapwood and then treated in laboratory cylinders. The results from the relatively short-term field tests are then used to specify retentions for commercially treated timbers that have a range of densities and heartwood content. More than 120 4 by 4s that had been commercially treated with four copper-based systems readily available were purchased, with the posts carefully selected for good biocide penetration and a wide outer sapwood band, and analyzed for biocide retentions. Also, biocide gradients from five soluble copper and three particulate copper commercially treated 4 by 4s, all having the same labeled retention, were determined. All four systems gave a range of analyzed retentions, with some fraction of the timbers of each preservative system having a relatively low biocide level. In contrast to previous reports, the biocide gradient for wood treated with a soluble copper formulation was less steep than in wood treated with a particulate copper system.

  • Effect of Polyvinyl Alcohol on Copper Leaching from Treated Wood

    by P. Vasishth, D. D. Nicholas, W. P. Henry, T. P. Schultz

    The new copper-based preservative systems leach a relatively high level of copper and, thus, generate some environmental concerns. Polyvinyl alcohol (PVOH) is known to complex with copper(II) and is water soluble. The effect of co-addition of fully hydrolyzed PVOH on the leaching of copper from wood treated with three different copper salts was examined. Southern pine sapwood wafers were treated with copper sulfate, copper acetate, and ammoniacal copper carbonate, all with 1 percent elemental copper in the waterborne solution, with and without 2 percent PVOH. The wafers were then dried and water leached for 2 weeks. PVOH co-addition greatly reduced the copper leached from wood treated with alkaline ammoniacal copper carbonate but not from wood treated with a slightly acidic solution of copper acetate or highly acidic copper sulfate.

  • Water Repellency and Dimensional Stability of Southern Pine Decking Treated with Waterborne Resin Acids

    by Joseph Dahlen, Darrel D. Nicholas, Tor P. Schultz

    Many residential consumers prefer that wood used in above‐ground exterior applications be protected by environmentally benign biocide systems and have good dimensional stability. To help achieve these two properties we are employing resin acids, a by‐product from the kraft pulping of pines, in a waterborne formulation. In an extremely harsh above‐ground exterior exposure, two sets of decking boards treated with the resin acid system had water repellent properties that were still effective after up to two years of exposure. The increased water repellency reduced the moisture gain following summer rainstorms by about one‐third compared to untreated matched samples, and this was sufficient to significantly reduce splitting by about half and cupping by one‐third. A wide variation in moisture gain following rain was observed for the untreated sapwood flatsawn decking, with the moisture gain positively and significantly correlated to the extent of checking. The optimal use of resin acids may be to provide some limited dimensional stability and, in combination with antioxidants and organic biocide(s), as a benign wood preservative system.


  • Developing environmentally benign and effective organic wood preservatives by understanding the biocidal and non-biocidal properties of extractives in naturally durable heartwood

    by Nursen Binbuga, Christopher Ruhs, Julia K. Hasty, William P. Henry, Tor P. Schultz

    Wood products for exterior residential applications have long been protected with metallic preservatives. However, environmental and disposal concerns and governmental regulations have resulted in a growing trend to employ organic systems based on relatively benign and expensive agrochemicals. To develop organic preservatives that have increased efficacy and lower cost, various groups are studying the biocidal and non-biocidal properties of extractives present in naturally durable heartwoods. In this study, we determined the fungicidal, free radical scavenger/antioxidant, metal chelation and Fe3+ reducing properties of some flavones and flavonoid analogs and chromones. The results support our earlier hypothesis that the abiotic antioxidant, Fe3+ reduction and subsequent metal complexation properties, in combination with the extractives’ fungicidal properties, all have a role in natural durability. Consequently, it may be possible to employ non-biocidal additive(s) with the above abiotic properties to enhance the efficacy of the relatively expensive organic agrochemicals used to protect wood.


  • A brief review of the past, present and future of wood preservation

    by Tor P Schultz, Darrel D Nicholas, Alan F Preston

    Wood products used in exterior applications must be protected against biodeterioration by decay fungi, insects such as termites, and other organisms. Traditionally, wood products for residential or industrial applications have been protected by treatment with chromated copper arsenate (CCA) or older inexpensive organic biocides, but environmental and disposal concerns and governmental regulations have resulted in a rapid and dramatic worldwide shift to copper‐based systems. The current development trend is towards employing totally organic biocides based on relatively benign and expensive agrochemicals, with continuing research directed towards developing non‐biocidal methods to protect wood. Copyright © 2007 Society of Chemical Industry