Marzena Smol
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Marzena Smol has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Maria Włodarczyk-Makuła
Faculty of Infrastructure and Environment, Częstochowa University of Technology, 69 Dabrowskiego Str., 42-201 Częstochowa, Poland
2 shared publications - Dariusz Włóka
Institute of Environmental Engineering, Czestochowa University of Technology, Częstochowa, Poland
1 shared publication - Jolanta Bohdziewicz
Institute of Water and Wastewater Engineering, Silesian Technical University, Gliwice, Poland
1 shared publication Karolina Mielczarek
Institute of Environmental Engineering, Czestochowa University of Technology, Częstochowa, Poland
1 shared publicationMaria Włodarczyk-Makuła
1 shared publication
Latest Publications
- Open Access
- 10 December 2014
- Published by University of Zielona Góra, Poland in Civil and Environmental Engineering Reports
- Vol. 13 (2) , 87-96
Adsorption of Polycyclic Aromatic Hydrocarbons (PAHS) from Aqueous Solutions on Different Sorbents
This paper presents the results of the possibility and effectiveness of PAHs removal from a model aqueous solution, during the sorption on the selected sorbents. Six PAHs (naphthalene, acenaphthylene, acenaphthene, fluorene, phenanthrene, anthracene) listed by EPA for the analysis in the environmental samples were determined. Model aqueous solution was prepared with RESTEK 610 mix PAHs standard. After the sorption process, decrease in the concentration of individual hydrocarbons was observed. The removal percentage was dependent on the type of sorbent (quartz sand, mineral sorbent, activated carbon). The highest efficiency (98.1%) was observed for activated carbon.. The results shows that the sorption processes can be used in aqueous solutions treatment procedures
- 10 December 2014
- Published by University of Zielona Góra, Poland in Civil and Environmental Engineering Reports
- Vol. 13 (2) , 87-96
Open AccessAdsorption of Polycyclic Aromatic Hydrocarbons (PAHS) from Aqueous Solutions on Different Sorbents
This paper presents the results of the possibility and effectiveness of PAHs removal from a model aqueous solution, during the sorption on the selected sorbents. Six PAHs (naphthalene, acenaphthylene, acenaphthene, fluorene, phenanthrene, anthracene) listed by EPA for the analysis in the environmental samples were determined. Model aqueous solution was prepared with RESTEK 610 mix PAHs standard. After the sorption process, decrease in the concentration of individual hydrocarbons was observed. The removal percentage was dependent on the type of sorbent (quartz sand, mineral sorbent, activated carbon). The highest efficiency (98.1%) was observed for activated carbon.. The results shows that the sorption processes can be used in aqueous solutions treatment procedures
- Open Access
- 18 February 2014
- Published by Elsevier in Desalination and Water Treatment
- Vol. 52 (19-21) , 3889-3897
Comparison of the retention of selected PAHs from municipal landfill leachate by RO and UF processes
The aim of the conducted research was to compare the changes in the retention of polycyclic aromatic hydrocarbons (PAHs) during membrane filtration (ultrafiltration—UF and reverse osmosis—RO). In the study, municipal landfill leachate was used. In the first stage of testing, leachates were filtrated on the sand bed (prefiltration). After prefiltration, they were directed to the membrane module for main filtration. The ultrafiltration process was carried out at the transmembrane pressure of 0.1–0.2 MPa. The membrane separation process was based on a capillary membrane type ZW-10. The transmembrane pressure of the reverse osmosis stood at 2 MPa and for this process one nylon membrane (ADF) was used. The prepared samples of the municipal landfill leachates were subjected to extraction with applying 2-propanol. Extracts were cleared on octadecyl C18 columns, and then concentrated in the nitrogen stream. High-performance liquid chromatography HPLC with fluorescence detection (model HPLC THERMO) was used for qualitative and quantitative analysis of PAHs. During the process, a decrease in the concentrations of most tested hydrocarbons was observed. The initial concentrations of PAHs in the municipal landfill leachates were in the range 17.5–30.4 mg / L. The efficiency of the removal of hydrocarbons grouped according to a number of rings was in the range of 48 (for naphthalene) to 73% (for 6-ring of PAHs) in ultrafiltration technique. However, the greater efficiency retention of PAHs was obtained for RO. The average value of the retention coefficient for RO was equal to 71% (for individual hydrocarbons were in the range of 19–100%).
- 18 February 2014
- Published by Elsevier in Desalination and Water Treatment
- Vol. 52 (19-21) , 3889-3897
Open AccessComparison of the retention of selected PAHs from municipal landfill leachate by RO and UF processes
The aim of the conducted research was to compare the changes in the retention of polycyclic aromatic hydrocarbons (PAHs) during membrane filtration (ultrafiltration—UF and reverse osmosis—RO). In the study, municipal landfill leachate was used. In the first stage of testing, leachates were filtrated on the sand bed (prefiltration). After prefiltration, they were directed to the membrane module for main filtration. The ultrafiltration process was carried out at the transmembrane pressure of 0.1–0.2 MPa. The membrane separation process was based on a capillary membrane type ZW-10. The transmembrane pressure of the reverse osmosis stood at 2 MPa and for this process one nylon membrane (ADF) was used. The prepared samples of the municipal landfill leachates were subjected to extraction with applying 2-propanol. Extracts were cleared on octadecyl C18 columns, and then concentrated in the nitrogen stream. High-performance liquid chromatography HPLC with fluorescence detection (model HPLC THERMO) was used for qualitative and quantitative analysis of PAHs. During the process, a decrease in the concentrations of most tested hydrocarbons was observed. The initial concentrations of PAHs in the municipal landfill leachates were in the range 17.5–30.4 mg / L. The efficiency of the removal of hydrocarbons grouped according to a number of rings was in the range of 48 (for naphthalene) to 73% (for 6-ring of PAHs) in ultrafiltration technique. However, the greater efficiency retention of PAHs was obtained for RO. The average value of the retention coefficient for RO was equal to 71% (for individual hydrocarbons were in the range of 19–100%).
- Open Access
- 1 December 2012
- Published by Polish Academy of Sciences Chancellery in Archives of Environmental Protection
- Vol. 38 (4) , 49-58
Effectiveness in the Removal of Polycyclic Aromatic Hydrocarbons From Industrial Wastewater by Ultrafiltration Technique
The paper presents the results of studies on the changes in the PAHs concentration during pre-filtration and ultrafiltration (UF) processes. In the study, biologically treated wastewater (after denitrification and nitrification processes), discharged from the biological treatment plant and used in coke plant, was used. A gas chromatography-mass spectrometry (GC-MS) was used in order to qualify and quantify the PAHs. Sixteen PAHs listed by EPA were determined. The wastewater samples were collected three fold and initially characterized for the concentration of nitrate nitrogen, ammonium nitrogen, COD, TOC and pH. In the first step, wastewater was filtrated on the sand bed. Total concentration of 16 PAHs in the treated wastewater before initial filtration was in the range of 44.8‒53.5 mg/L. During the process the decrease in the concentration of the most studied hydrocarbons was observed. Concentration of PAHs after initial filtration ranged from 21.9 to 38.3 μg/L. After the initial filtration process the wastewater flew to the ultrafiltration module and then was separated on the membrane (type ZW-10). The total concentration of 16 PAHs in the process of ultrafiltration was in the range of 8.9‒19.3 mg/L. The efficiency of removal of PAHs from coke wastewater in the process of ultrafiltration equaled 66.6%. Taking into account the initial filtration, the total degree of removal of PAHs reached 85%. The obtained results indicate the possibility of using the ultrafiltration process with the initial filtration as additional process in the coke wastewater treatment.
- 1 December 2012
- Published by Polish Academy of Sciences Chancellery in Archives of Environmental Protection
- Vol. 38 (4) , 49-58
Open AccessEffectiveness in the Removal of Polycyclic Aromatic Hydrocarbons From Industrial Wastewater by Ultrafiltration Technique
The paper presents the results of studies on the changes in the PAHs concentration during pre-filtration and ultrafiltration (UF) processes. In the study, biologically treated wastewater (after denitrification and nitrification processes), discharged from the biological treatment plant and used in coke plant, was used. A gas chromatography-mass spectrometry (GC-MS) was used in order to qualify and quantify the PAHs. Sixteen PAHs listed by EPA were determined. The wastewater samples were collected three fold and initially characterized for the concentration of nitrate nitrogen, ammonium nitrogen, COD, TOC and pH. In the first step, wastewater was filtrated on the sand bed. Total concentration of 16 PAHs in the treated wastewater before initial filtration was in the range of 44.8‒53.5 mg/L. During the process the decrease in the concentration of the most studied hydrocarbons was observed. Concentration of PAHs after initial filtration ranged from 21.9 to 38.3 μg/L. After the initial filtration process the wastewater flew to the ultrafiltration module and then was separated on the membrane (type ZW-10). The total concentration of 16 PAHs in the process of ultrafiltration was in the range of 8.9‒19.3 mg/L. The efficiency of removal of PAHs from coke wastewater in the process of ultrafiltration equaled 66.6%. Taking into account the initial filtration, the total degree of removal of PAHs reached 85%. The obtained results indicate the possibility of using the ultrafiltration process with the initial filtration as additional process in the coke wastewater treatment.