Hai Ping Yin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Hai Ping Yin has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Fabienne Anfosso-Lédée
Laboratoire Central des Ponts et Chaussées, BP 4129, 44341 Bouguenais Cedex, France
3 shared publications - Julien Cesbron
Université d'Evry - Val d'Essonne, Laboratoire de Mécanique d'Evry, EA3332, 40, rue du Pelvoux, 91 020 Evry Cedex, France
3 shared publications - Denis Duhamel
ENPC, UR Navier, 6 et 8 Avenue Blaise Pascal, Cité Descartes, Champs sur Marne, 77455 Marne la Vallée, France
2 shared publications D Duhamel
LAMI, ENPC, LCPC, Institut Navier, Ecole Nationale des Ponts et chaussées, 6 et 8 Avenue Blaise Pascal, Cité Descartes, Champs-sur-Marne, 77455 Marne-La-Vallée Cedex 2, France
1 shared publicationDonatien Le Houedec
Ecole Centrale de Nantes, GeM, 1 rue de la Noe, BP 92101, 44321 Nantes Cedex 3, France
1 shared publicationHong Hai Nguyen
ENPC, UR Navier, 6 et 8 Avenue Blaise Pascal, Cité Descartes, Champs sur Marne, 77455 Marne la Vallée, France
1 shared publication
Latest Publications
- 1 May 2008
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 123 (5_Suppleme) , 3389
Experimental study of dynamical contact forces for tyre/road noise application
This paper deals with the experimental study of tyre/road contact forces in rolling conditions for tyre/road noise investigation. In situ measurements of contact forces and CPX noise levels were carried out for a slick tyre rolling on six different road surfaces at rolling speeds between 30 km/h and 50 km/h. Contact stresses were measured at a sampling frequency around 10000 Hz using a single array of digital pressure sensitive cells both in the transverse and in the longitudinal directions. The contact areas obtained during rolling were smaller than the one measured in statics. This could be due to an influence of the viscoelastic behavior of the rubber of the tyre tread during rolling. Additionally the global energy of the longitudinal contact forces at different speeds were in the same order for the six road surfaces, while their spectrums at different speeds were quite different. This may be explained by a spectral influence of the vibration of the tyre during rolling. Finally, the levels of longitudinal contact forces and CPX noise measured at 30 km/h were correlated. A high positive correlation was found around 800 Hz, which frequency could be directly linked to the road texture.
- 1 May 2008
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 123 (5_Suppleme) , 3389
Experimental study of dynamical contact forces for tyre/road noise application
This paper deals with the experimental study of tyre/road contact forces in rolling conditions for tyre/road noise investigation. In situ measurements of contact forces and CPX noise levels were carried out for a slick tyre rolling on six different road surfaces at rolling speeds between 30 km/h and 50 km/h. Contact stresses were measured at a sampling frequency around 10000 Hz using a single array of digital pressure sensitive cells both in the transverse and in the longitudinal directions. The contact areas obtained during rolling were smaller than the one measured in statics. This could be due to an influence of the viscoelastic behavior of the rubber of the tyre tread during rolling. Additionally the global energy of the longitudinal contact forces at different speeds were in the same order for the six road surfaces, while their spectrums at different speeds were quite different. This may be explained by a spectral influence of the vibration of the tyre during rolling. Finally, the levels of longitudinal contact forces and CPX noise measured at 30 km/h were correlated. A high positive correlation was found around 800 Hz, which frequency could be directly linked to the road texture.
- 1 May 2008
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 123 (5_Suppleme) , 3868
Dependence of the contact area on the velocity of a rolling tire
It is known that the eigenfrequencies of a rolling tire depend on the velocity of rotation. We distinguish two causes for the stiffness increase: the frequency dependence of the complex modulus of the materials and the geometrical stiffness. The real part of the Young's modulus is monotonic according to the frequency. It contributes for an important part to the stiffening. The geometrical stiffness also increases with the rotational velocity. A consequence of these effects is the modification of the size of the contact area for different velocities of a rolling tire. Here we first present experimental results estimating the size of the contact area for a tire in statics and for different rolling velocities. Differences of 20% can be observed. Then the viscoelastic behaviours of the tire materials are presented and experimental results showing the frequency dependence of the complex modulus of the tire constitutive materials are given. Then finite element computations are presented with a real distribution of materials in the tire section and the size of the contact area is estimated and compared to experimental measurements. These results could improve the modelling of tire road interaction for tire noise predictions.
- 1 May 2008
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 123 (5_Suppleme) , 3868
Dependence of the contact area on the velocity of a rolling tire
It is known that the eigenfrequencies of a rolling tire depend on the velocity of rotation. We distinguish two causes for the stiffness increase: the frequency dependence of the complex modulus of the materials and the geometrical stiffness. The real part of the Young's modulus is monotonic according to the frequency. It contributes for an important part to the stiffening. The geometrical stiffness also increases with the rotational velocity. A consequence of these effects is the modification of the size of the contact area for different velocities of a rolling tire. Here we first present experimental results estimating the size of the contact area for a tire in statics and for different rolling velocities. Differences of 20% can be observed. Then the viscoelastic behaviours of the tire materials are presented and experimental results showing the frequency dependence of the complex modulus of the tire constitutive materials are given. Then finite element computations are presented with a real distribution of materials in the tire section and the size of the contact area is estimated and compared to experimental measurements. These results could improve the modelling of tire road interaction for tire noise predictions.
- 30 November 2004
- Published by Elsevier in Mechanical Systems and Signal Processing
- Vol. 18 (6) , 1497-1503
Substraction technique and finite difference formulas for modal parameter estimation
- 30 November 2004
- Published by Elsevier in Mechanical Systems and Signal Processing
- Vol. 18 (6) , 1497-1503
Substraction technique and finite difference formulas for modal parameter estimation