Tim J. Wooster
Research Subjects
Tim J. Wooster has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Douglas R. MacFarlane
School of Chemistry, Monash University, Clayton 3800, Victoria, Australia
3 shared publications Simmi Abrol
Materials Laboratory – Robert BOSCH Australia Pty Ltd, Cnr Center & McNaughton Roads, Clayton, Victoria 3168, Australia
3 shared publicationsMary Ann Augustin
2 shared publicationsJeffrey M. Hey
Materials Laboratory, Robert BOSCH Australia Pty Ltd, Cnr Center & McNaughton Roads, Clayton, Victoria 3168, Australia
1 shared publication- Matt Golding
School of Food and Advanced Technology, Massey University, Palmerston North, New Zealand
1 shared publication Peerasak Sanguansri
Food Science Australia (CSIRO), Werribee, Victoria 3030, Australia
1 shared publication
Latest Publications
- Top Cited Papers
- 14 October 2008
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 24 (22) , 12758-12765
Impact of Oil Type on Nanoemulsion Formation and Ostwald Ripening Stability
The formation of stable transparent nanoemulsions poses two challenges: the ability to initially create an emulsion where the entire droplet size distribution is below 80 nm, and the subsequent stabilization of this emulsion against Ostwald ripening. The physical properties of the oil phase and the nature of the surfactant layer were found to have a considerable impact on nanoemulsion formation and stabilization. Nanoemulsions made with high viscosity oils, such as long chain triglycerides (LCT), were considerably larger (D = 120 nm) than nanoemulsions prepared with low viscosity oils such as hexadecane (D = 80 nm). The optimization of surfactant architecture, and differential viscosity ηD/ηC, has led to the formation of remarkably small nanoemulsions. With average sizes below 40 nm they are some of the smallest homogenized emulsions ever reported. What is more remarkable is that LCT nanoemulsions do not undergo Ostwald ripening and are physically stable for over 3 months. Ostwald ripening is prevented by the large molar volume of long chain triglyceride oils, which makes them insoluble in water thus providing a kinetic barrier to Ostwald ripening. Examination of the Ostwald ripening of mixed oil nanoemulsions found that the entropy gain associated with oil demixing provided a thermodynamic barrier to Ostwald ripening. Not only are the nanoemulsions created in this work some of the smallest reported, but they are also thermodynamically stable to Ostwald ripening when at least 50% of the oil phase is an insoluble triglyceride.
- 14 October 2008
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 24 (22) , 12758-12765
Top Cited PapersImpact of Oil Type on Nanoemulsion Formation and Ostwald Ripening Stability
The formation of stable transparent nanoemulsions poses two challenges: the ability to initially create an emulsion where the entire droplet size distribution is below 80 nm, and the subsequent stabilization of this emulsion against Ostwald ripening. The physical properties of the oil phase and the nature of the surfactant layer were found to have a considerable impact on nanoemulsion formation and stabilization. Nanoemulsions made with high viscosity oils, such as long chain triglycerides (LCT), were considerably larger (D = 120 nm) than nanoemulsions prepared with low viscosity oils such as hexadecane (D = 80 nm). The optimization of surfactant architecture, and differential viscosity ηD/ηC, has led to the formation of remarkably small nanoemulsions. With average sizes below 40 nm they are some of the smallest homogenized emulsions ever reported. What is more remarkable is that LCT nanoemulsions do not undergo Ostwald ripening and are physically stable for over 3 months. Ostwald ripening is prevented by the large molar volume of long chain triglyceride oils, which makes them insoluble in water thus providing a kinetic barrier to Ostwald ripening. Examination of the Ostwald ripening of mixed oil nanoemulsions found that the entropy gain associated with oil demixing provided a thermodynamic barrier to Ostwald ripening. Not only are the nanoemulsions created in this work some of the smallest reported, but they are also thermodynamically stable to Ostwald ripening when at least 50% of the oil phase is an insoluble triglyceride.
- 1 September 2007
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 313 (2) , 665-675
The emulsion flocculation stability of protein–carbohydrate diblock copolymers
- 1 September 2007
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 313 (2) , 665-675
The emulsion flocculation stability of protein–carbohydrate diblock copolymers
- 1 November 2006
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 303 (2) , 564-572
β-Lactoglobulin–dextran Maillard conjugates: Their effect on interfacial thickness and emulsion stability
- 1 November 2006
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 303 (2) , 564-572
β-Lactoglobulin–dextran Maillard conjugates: Their effect on interfacial thickness and emulsion stability
- 28 September 2005
- Published by Wiley in Macromolecular Materials and Engineering
- Vol. 290 (10) , 961-969
Polymeric Toughening of Particle Filled Cyanate Ester Composites
Summary: The present study examines the effect of polymeric tougheners on the performance of silica filled cyanate ester composites. The polymeric tougheners used have been shown to enhance cyanate ester tougheners in binary toughener/matrix systems. Tougheners that were able to form a favourable phase‐separated morphology resulted in the greatest increase in crack resistance. The addition of these tougheners resulted in minimal loss of strength, and a slight decrease in modulus. Importantly the viscosity of the compounded systems was low enough for them to be readily processable. Whilst conserving most secondary properties, toughener addition did result in a slight increase in composite hydrolytic degradation. This issue was linked to the additive/ additive compounding processes. Removal of this extra moisture should eliminate this concern, permitting the used of these composites in electronic applications. Effect of ETBN content on the crack resistance of particle filled cyanate ester composites and SEM image of 15 matrix wt.‐% ETBN. magnified image Effect of ETBN content on the crack resistance of particle filled cyanate ester composites and SEM image of 15 matrix wt.‐% ETBN.
- 28 September 2005
- Published by Wiley in Macromolecular Materials and Engineering
- Vol. 290 (10) , 961-969
Polymeric Toughening of Particle Filled Cyanate Ester Composites
Summary: The present study examines the effect of polymeric tougheners on the performance of silica filled cyanate ester composites. The polymeric tougheners used have been shown to enhance cyanate ester tougheners in binary toughener/matrix systems. Tougheners that were able to form a favourable phase‐separated morphology resulted in the greatest increase in crack resistance. The addition of these tougheners resulted in minimal loss of strength, and a slight decrease in modulus. Importantly the viscosity of the compounded systems was low enough for them to be readily processable. Whilst conserving most secondary properties, toughener addition did result in a slight increase in composite hydrolytic degradation. This issue was linked to the additive/ additive compounding processes. Removal of this extra moisture should eliminate this concern, permitting the used of these composites in electronic applications. Effect of ETBN content on the crack resistance of particle filled cyanate ester composites and SEM image of 15 matrix wt.‐% ETBN. magnified image Effect of ETBN content on the crack resistance of particle filled cyanate ester composites and SEM image of 15 matrix wt.‐% ETBN.
- 14 September 2005
- Published by Wiley in Journal of Polymer Science Part A: Polymer Chemistry
- Vol. 43 (21) , 5072-5082
The synthesis of novel aliphatic bis(acenaphthelene) reactive monomers
- 14 September 2005
- Published by Wiley in Journal of Polymer Science Part A: Polymer Chemistry
- Vol. 43 (21) , 5072-5082
The synthesis of novel aliphatic bis(acenaphthelene) reactive monomers