Ahmed B. Shuraim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ahmed B. Shuraim has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Ahmed Kamal El-Sayed
Department of Civil Engineering, College of Engineering, King Saud University, Riyadh 12372, Saudi Arabia
5 shared publications Abdulaziz I. Al-Negheimish
Professor, Center of Excellence for Concrete Research and Testing, Dept. of Civil Engineering, King Saud Univ., P.O. Box 800, Riyadh, Kingdom of Saudi Arabia 11421
3 shared publications- Abdulrahman M. Alhozaimy
Department of Civil Engineering, College of Engineering, King Saud University, Riyadh 12372, Saudi Arabia
3 shared publications - Abdulaziz I. Al-Negheimish
Center of Excellence for Concrete Research and Testing, Department of Civil Engineering, College of Engineering, King Saud University, P.O. Box 800, Riyadh 11421, Saudi Arabia
2 shared publications Abdulrahman M. Alhozaimy
King Saud University, Saudi Arabia
2 shared publications- Rajeh A. Al-Zaid
King Saud University, Saudi Arabia
2 shared publications
Latest Publications
- 1 December 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 28 (12)
Coupled Effect of Coarse Aggregate Type and Silica Fume on Creep Coefficients of High-Strength Concrete
Standard concrete creep prediction models are essential for structural design; however, it would be unrealistic to expect accurate prediction results without calibration and validations through experimental studies involving local materials and conditions. This paper reports on the long-term creep of high-strength concrete based on experimental work of six independent concrete mixtures involving three types of aggregate, where three mixtures of them incorporated 10% silica fume. Creep testing was conducted with consideration of standard guidelines for loading and strain measurements for up to 2.5 years. Creep coefficients computed from measured strains indicated a substantial influence of the silica fume and aggregate types. The study found that two of the examined models were capable of producing reasonable predictions of the creep for concretes without silica fume. On the other hand, the a current industry model showed reasonable prediction of the creep of concretes with silica fume while undere...
- 1 December 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 28 (12)
Coupled Effect of Coarse Aggregate Type and Silica Fume on Creep Coefficients of High-Strength Concrete
Standard concrete creep prediction models are essential for structural design; however, it would be unrealistic to expect accurate prediction results without calibration and validations through experimental studies involving local materials and conditions. This paper reports on the long-term creep of high-strength concrete based on experimental work of six independent concrete mixtures involving three types of aggregate, where three mixtures of them incorporated 10% silica fume. Creep testing was conducted with consideration of standard guidelines for loading and strain measurements for up to 2.5 years. Creep coefficients computed from measured strains indicated a substantial influence of the silica fume and aggregate types. The study found that two of the examined models were capable of producing reasonable predictions of the creep for concretes without silica fume. On the other hand, the a current industry model showed reasonable prediction of the creep of concretes with silica fume while undere...
- 1 April 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Composites for Construction
- Vol. 20 (2)
Efficiency of CFRP Strengthening in Controlling the Deflection of RC Beams in a Redundant Structural System
One-way reinforced concrete joist floor with wide shallow beams (WSBs) are used widely in building construction throughout the Middle East. Situations arise when it is desirable to strengthen a specific member or a group of members in a floor to reduce their deflections. Extensive work has been made on the strengthening of isolated members using fiber-reinforced polymers (FRP) for providing much needed data on the member performance and characteristics where the ultimate goal is to apply these findings to actual complex existing structures. Judging by studies on individual isolated members strengthened with FRP, a substantial improvement in deflection control is expected. However, this cannot be directly applied to members in redundant structural systems before confirming that experimentally. This paper presents the results of an investigation on the effectiveness of carbon FRP (CFRP) external strengthening for the purpose of reducing deflection of WSBs as part of joist floor of a prototype reinforced concrete building with highly redundant structural system. The results indicated that using CFRP strengthening did not show much improvement in controlling the deflection of the beams. The experimental work was also complemented with theoretical explanation of the expected effectiveness in terms of parallel spring analogy. Further, a nonlinear finite element analysis for the floor system was conducted. The results of that analysis were in good agreement with the experimental findings.
- 1 April 2016
- Published by American Society of Civil Engineers (ASCE) in Journal of Composites for Construction
- Vol. 20 (2)
Efficiency of CFRP Strengthening in Controlling the Deflection of RC Beams in a Redundant Structural System
One-way reinforced concrete joist floor with wide shallow beams (WSBs) are used widely in building construction throughout the Middle East. Situations arise when it is desirable to strengthen a specific member or a group of members in a floor to reduce their deflections. Extensive work has been made on the strengthening of isolated members using fiber-reinforced polymers (FRP) for providing much needed data on the member performance and characteristics where the ultimate goal is to apply these findings to actual complex existing structures. Judging by studies on individual isolated members strengthened with FRP, a substantial improvement in deflection control is expected. However, this cannot be directly applied to members in redundant structural systems before confirming that experimentally. This paper presents the results of an investigation on the effectiveness of carbon FRP (CFRP) external strengthening for the purpose of reducing deflection of WSBs as part of joist floor of a prototype reinforced concrete building with highly redundant structural system. The results indicated that using CFRP strengthening did not show much improvement in controlling the deflection of the beams. The experimental work was also complemented with theoretical explanation of the expected effectiveness in terms of parallel spring analogy. Further, a nonlinear finite element analysis for the floor system was conducted. The results of that analysis were in good agreement with the experimental findings.
- 28 April 2015
- Published by Springer Nature in Materials and Structures
- Vol. 49 (5) , 1871-1882
Size effect on shear resistance of high strength concrete deep beams
- 28 April 2015
- Published by Springer Nature in Materials and Structures
- Vol. 49 (5) , 1871-1882
Size effect on shear resistance of high strength concrete deep beams
- Open Access
- 1 November 2014
- Published by FapUNIFESP (SciELO) in Latin American Journal of Solids and Structures
- Vol. 11 (6) , 946-965
Strengthening of structurally damaged wide shallow RC beams using externally bonded CFRP plates
Reinforced concrete wide shallow beams (WSBs) are commonly used in the joist flooring systems. The structural behavior of WSBs strengthened with carbon fiber reinforced polymer (CFRP) reinforcement was studied on isolated beams and as part of full-scale building. The effect of structural damage on the performance of WSBs flexurally strengthened with CFRP plates was investigated and presented in this paper. Eight full-scale WSBs were tested under four-point bending up to failure. Seven beams were strengthened with CFRP plates bonded to the soffit of the beams and one beam was unstrengthened serving as control. Prior to strengthening, the beams were subjected to different levels of damaging by preloading to 30-95% of the beams' flexural capacity. One beam was fully damaged by preloading to failure and repaired before strengthening by replacing the crushed concrete. The data showed that the pre-damaged strengthened beams exhibited ultimate capacities up to 8% lower than those of the undamaged strengthened beams. However, the load carrying capacities of pre-damaged strengthened beams were more than those predicted by ACI 440 design guide, fib Bulletin 14, and JSCE design recommendations. Both fib Bulletin 14 and JSCE design recommendations gave very conservative predictions with average ratios of experimental to predicted ultimate capacity of 2.02 and 2.35, respectively. More accurate predictions were obtained by ACI 440 design guide as the corresponding ratio was 1.24. These results indicate that strong confidence and reliability can be placed in applying CFRP strengthening to structurally damaged WSBs.
- 1 November 2014
- Published by FapUNIFESP (SciELO) in Latin American Journal of Solids and Structures
- Vol. 11 (6) , 946-965
Open AccessStrengthening of structurally damaged wide shallow RC beams using externally bonded CFRP plates
Reinforced concrete wide shallow beams (WSBs) are commonly used in the joist flooring systems. The structural behavior of WSBs strengthened with carbon fiber reinforced polymer (CFRP) reinforcement was studied on isolated beams and as part of full-scale building. The effect of structural damage on the performance of WSBs flexurally strengthened with CFRP plates was investigated and presented in this paper. Eight full-scale WSBs were tested under four-point bending up to failure. Seven beams were strengthened with CFRP plates bonded to the soffit of the beams and one beam was unstrengthened serving as control. Prior to strengthening, the beams were subjected to different levels of damaging by preloading to 30-95% of the beams' flexural capacity. One beam was fully damaged by preloading to failure and repaired before strengthening by replacing the crushed concrete. The data showed that the pre-damaged strengthened beams exhibited ultimate capacities up to 8% lower than those of the undamaged strengthened beams. However, the load carrying capacities of pre-damaged strengthened beams were more than those predicted by ACI 440 design guide, fib Bulletin 14, and JSCE design recommendations. Both fib Bulletin 14 and JSCE design recommendations gave very conservative predictions with average ratios of experimental to predicted ultimate capacity of 2.02 and 2.35, respectively. More accurate predictions were obtained by ACI 440 design guide as the corresponding ratio was 1.24. These results indicate that strong confidence and reliability can be placed in applying CFRP strengthening to structurally damaged WSBs.
- 1 January 2014
- Published by Elsevier in Construction and Building Materials
- Vol. 51, 473-483
Long-term behavior of wide shallow RC beams strengthened with externally bonded CFRP plates
- 1 January 2014
- Published by Elsevier in Construction and Building Materials
- Vol. 51, 473-483
Long-term behavior of wide shallow RC beams strengthened with externally bonded CFRP plates
- Open Access
- 1 January 2014
- Published by FapUNIFESP (SciELO) in Latin American Journal of Solids and Structures
- Vol. 11 (1) , 93-112
A novel approach for evaluating the concrete shear strength in reinforced concrete beams
- 1 January 2014
- Published by FapUNIFESP (SciELO) in Latin American Journal of Solids and Structures
- Vol. 11 (1) , 93-112
Open AccessA novel approach for evaluating the concrete shear strength in reinforced concrete beams
- Open Access
- 1 January 2013
- Published by Springer Nature in Journal of King Saud University – Engineering Sciences
- Vol. 25 (1) , 65-74
Behavior and shear design provisions of reinforced concrete D-region beams
- 1 January 2013
- Published by Springer Nature in Journal of King Saud University – Engineering Sciences
- Vol. 25 (1) , 65-74
Open AccessBehavior and shear design provisions of reinforced concrete D-region beams
- 1 August 2012
- Published by American Society of Civil Engineers (ASCE) in Journal of Composites for Construction
- Vol. 16 (4) , 418-429
Behavior of Wide Shallow RC Beams Strengthened with CFRP Reinforcement
One-way reinforced concrete joist floors with wide shallow beams (WSBs) are used widely in building construction throughout the Middle East. The short- and long-term behavior of WSBs externally strengthened with carbon fiber-reinforced polymer (CFRP) reinforcement was studied on isolated beams and as part of full-scale building. This paper presents the results of the experimental investigation on the flexural performance of isolated WSBs externally strengthened with CFRP reinforcement. A total of six full-scale beams were constructed and tested to failure. The test variables were the amount, type, configuration, and the elastic modulus of CFRP reinforcement. The test results were presented in terms of deflections, ultimate capacities and modes of failure, crack width development, and strains in reinforcement and concrete. The test results showed significant improvement in the flexural performance of the strengthened beams with respect to flexural capacity, flexural stiffness, and crack width. All ...
- 1 August 2012
- Published by American Society of Civil Engineers (ASCE) in Journal of Composites for Construction
- Vol. 16 (4) , 418-429
Behavior of Wide Shallow RC Beams Strengthened with CFRP Reinforcement
One-way reinforced concrete joist floors with wide shallow beams (WSBs) are used widely in building construction throughout the Middle East. The short- and long-term behavior of WSBs externally strengthened with carbon fiber-reinforced polymer (CFRP) reinforcement was studied on isolated beams and as part of full-scale building. This paper presents the results of the experimental investigation on the flexural performance of isolated WSBs externally strengthened with CFRP reinforcement. A total of six full-scale beams were constructed and tested to failure. The test variables were the amount, type, configuration, and the elastic modulus of CFRP reinforcement. The test results were presented in terms of deflections, ultimate capacities and modes of failure, crack width development, and strains in reinforcement and concrete. The test results showed significant improvement in the flexural performance of the strengthened beams with respect to flexural capacity, flexural stiffness, and crack width. All ...
- Open Access
- 1 April 2012
- Published by FapUNIFESP (SciELO) in Latin American Journal of Solids and Structures
- Vol. 9 (2) , 1-19
Numerical forensic model for the diagnosis of a full-scale RC floor
- 1 April 2012
- Published by FapUNIFESP (SciELO) in Latin American Journal of Solids and Structures
- Vol. 9 (2) , 1-19
Open AccessNumerical forensic model for the diagnosis of a full-scale RC floor