Jean W. Lee
Jean W. Lee has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Dale Miles
Pharmacyclics, Inc, Sunnyvale, CA 94085-4521, USA
1 shared publicationDawna Dressler
1 shared publicationIhor Bekersky
1 shared publicationJohn Fiene
MDS Pharma Services
1 shared publicationLori I. Hatcher
MDS Pharma Services
1 shared publicationMark Stiles
MDS Pharma Services
1 shared publication
Latest Publications
- 1 September 2003
- Published by Springer Nature in AAPS PharmSci
- Vol. 5 (3) , 1-16
Quantitation of motexafin lutetium in human plasma by liquid chromatography-tandem mass spectrometry and inductively coupled plasma-atomic emission spectroscopy
Liquid chromatography-tandem mass spectrometry (LC-MS/MS) and inductively coupled plasma-atomic emission spectroscopy (ICP-AES) methods were developed and validated for the evaluation of motexafin lutetium (MLu, lutetium texaphyrin, PCI-0123) pharmacokinetics in human plasma. The LC-MS/MS method was specific for MLu, whereas the ICP-AES method measured total elemental lutetium. Both methods were fast, simple, precise, and accurate. For the LC-MS/MS method, a closely related analogue (PCI-0353) was used as the internal standard (IS). MLu and the IS were extracted from plasma by protein precipitation and injected onto and LC-MS/MS system configured with a C18 column and an electrospray interface. The lower limit of quantitation was 0.05 μg MLu mL−1, with a signal-to-noise ratio of 15∶1. The response was linear from 0.05 to 5.0 μg MLu mL−1. For the ICP-AES method, indium was used as the IS. The sample was digested with nitric acid, diluted, filtered, and then injected onto the ICP-AES system. Two standard curve ranges were validated to meet the expected range of sample concentrations: 0.5 to 50, and 0.1 to 10 μg Lu mL−1. The LC-MS/MS and ICP-AES methods were validated to establish accuracy, precision, analyte stability, and assay robustness. Interday precision and accuracy of quality control samples were ≤6.3% coefficient of variation (CV) and within 2.2% relative error (RE) for the LC-MS/MS method, and ≤8.7% CV and within 4.9% RE for the ICP-AES method. Plasma samples from a subset of patients in a clinical study were analyzed using both methods. For a representative patient, over 90% of the elemental lutetium in plasma could be ascribed to intact MLu at early time points. This percentage decreased to 59% at 48 hours after dosing, suggesting that some degradation and/or metabolism of the drug may have occurred.
- 1 September 2003
- Published by Springer Nature in AAPS PharmSci
- Vol. 5 (3) , 1-16
Quantitation of motexafin lutetium in human plasma by liquid chromatography-tandem mass spectrometry and inductively coupled plasma-atomic emission spectroscopy
Liquid chromatography-tandem mass spectrometry (LC-MS/MS) and inductively coupled plasma-atomic emission spectroscopy (ICP-AES) methods were developed and validated for the evaluation of motexafin lutetium (MLu, lutetium texaphyrin, PCI-0123) pharmacokinetics in human plasma. The LC-MS/MS method was specific for MLu, whereas the ICP-AES method measured total elemental lutetium. Both methods were fast, simple, precise, and accurate. For the LC-MS/MS method, a closely related analogue (PCI-0353) was used as the internal standard (IS). MLu and the IS were extracted from plasma by protein precipitation and injected onto and LC-MS/MS system configured with a C18 column and an electrospray interface. The lower limit of quantitation was 0.05 μg MLu mL−1, with a signal-to-noise ratio of 15∶1. The response was linear from 0.05 to 5.0 μg MLu mL−1. For the ICP-AES method, indium was used as the IS. The sample was digested with nitric acid, diluted, filtered, and then injected onto the ICP-AES system. Two standard curve ranges were validated to meet the expected range of sample concentrations: 0.5 to 50, and 0.1 to 10 μg Lu mL−1. The LC-MS/MS and ICP-AES methods were validated to establish accuracy, precision, analyte stability, and assay robustness. Interday precision and accuracy of quality control samples were ≤6.3% coefficient of variation (CV) and within 2.2% relative error (RE) for the LC-MS/MS method, and ≤8.7% CV and within 4.9% RE for the ICP-AES method. Plasma samples from a subset of patients in a clinical study were analyzed using both methods. For a representative patient, over 90% of the elemental lutetium in plasma could be ascribed to intact MLu at early time points. This percentage decreased to 59% at 48 hours after dosing, suggesting that some degradation and/or metabolism of the drug may have occurred.
- 1 January 2003
- Published by Springer Nature in Clinical Pharmacokinetics
- Vol. 42 (12) , 997-1022
Biomarkers, Validation and Pharmacokinetic-Pharmacodynamic Modelling
Four elements are crucial to successful pharmacokinetic-pharmacodynamic (PK/PD) modelling and simulation for efficient and effective rational drug development: (i) mechanism-based biomarker selection and correlation to clinical endpoints; (ii) quantification of drug and/or metabolites in biological fluids under good laboratory practices (GLP); (iii) GLP-like biomarker method validation and measurements and; (iv) mechanism-based PK/PD modelling and validation. Biomarkers can provide great predictive value in early drug development if they reflect the mechanism of action for the intervention even if they do not become surrogate endpoints. PK/PD modelling and simulation can play a critical role in this process. Data from genomic and proteomics differentiating healthy versus disease states lead to biomarker discovery and identification. Multiple genes control complex diseases via hosts of gene products in biometabolic pathways and cell/organ signal transduction. Pilot exploratory studies should be conducted to identify pivotal biomarkers to be used for predictive clinical assessment of disease progression and the effect of drug intervention. Most biomarkers are endogenous macromolecules, which could be measured in biological fluids. Many exist in heterogeneous forms with varying activity and immunoreactivity, posting challenges for bioanalysis. Reliable and selective assays could be validated under a GLP-like environment for quantitative methods. While the need for consistent reference standards and quality control monitoring during sample analysis for biomarker assays are similar to that of drug molecules, many biomarkers have special requirements for sample collection that demand a wellcoordinated team management. Bioanalytical methods should be validated to meet study objectives at various drug development stages, and possess adequate performance to quantify biochemical responses specific to the target disease progression and drug intervention. Protocol design to produce sufficient data for PK/PD modelling would be more complex than that of PK. Knowledge of mechanism from discovery and preclinical studies are helpful for planning clinical study designs in cascade, sequential, crossover or replicate mode. The appropriate combination of biomarker identification and selection, bioanalytical methods development and validation for drugs and biomarkers, and mechanism-based PK/PD models for fitting data and predicting future clinical endpoints/outcomes provide powerful insights and guidance for effective and efficient rational drug development, toward safe and efficacious medicine for individual patients.
- 1 January 2003
- Published by Springer Nature in Clinical Pharmacokinetics
- Vol. 42 (12) , 997-1022
Biomarkers, Validation and Pharmacokinetic-Pharmacodynamic Modelling
Four elements are crucial to successful pharmacokinetic-pharmacodynamic (PK/PD) modelling and simulation for efficient and effective rational drug development: (i) mechanism-based biomarker selection and correlation to clinical endpoints; (ii) quantification of drug and/or metabolites in biological fluids under good laboratory practices (GLP); (iii) GLP-like biomarker method validation and measurements and; (iv) mechanism-based PK/PD modelling and validation. Biomarkers can provide great predictive value in early drug development if they reflect the mechanism of action for the intervention even if they do not become surrogate endpoints. PK/PD modelling and simulation can play a critical role in this process. Data from genomic and proteomics differentiating healthy versus disease states lead to biomarker discovery and identification. Multiple genes control complex diseases via hosts of gene products in biometabolic pathways and cell/organ signal transduction. Pilot exploratory studies should be conducted to identify pivotal biomarkers to be used for predictive clinical assessment of disease progression and the effect of drug intervention. Most biomarkers are endogenous macromolecules, which could be measured in biological fluids. Many exist in heterogeneous forms with varying activity and immunoreactivity, posting challenges for bioanalysis. Reliable and selective assays could be validated under a GLP-like environment for quantitative methods. While the need for consistent reference standards and quality control monitoring during sample analysis for biomarker assays are similar to that of drug molecules, many biomarkers have special requirements for sample collection that demand a wellcoordinated team management. Bioanalytical methods should be validated to meet study objectives at various drug development stages, and possess adequate performance to quantify biochemical responses specific to the target disease progression and drug intervention. Protocol design to produce sufficient data for PK/PD modelling would be more complex than that of PK. Knowledge of mechanism from discovery and preclinical studies are helpful for planning clinical study designs in cascade, sequential, crossover or replicate mode. The appropriate combination of biomarker identification and selection, bioanalytical methods development and validation for drugs and biomarkers, and mechanism-based PK/PD models for fitting data and predicting future clinical endpoints/outcomes provide powerful insights and guidance for effective and efficient rational drug development, toward safe and efficacious medicine for individual patients.
- 1 June 2001
- Published by Wolters Kluwer Health in Therapeutic Drug Monitoring
- Vol. 23 (3) , 268-276
Quantitation of Free and Total Amphotericin B in Human Biologic Matrices by a Liquid Chromatography Tandem Mass Spectrometric Method
Amphotericin B remains the standard of care for the treatment of invasive and disseminated fungal infections. Various lipid-based formulations of amphotericin B have been developed to improve its therapeutic index by decreasing toxicity. Previous bioanalytic methods using microbial inhibition or high-pressure liquid chromatography quantified total amphotericin B (free, plasma protein-bound, and lipid-complexed). Sensitivity of this method with a low limit of quantitation of 0.05 μg/mL was inadequate to determine free (unbound) amphotericin B. A sensitive LC/MS/MS method was developed to determine the total amphotericin B value in human plasma and other biologic matrices and the free amphotericin B concentration in plasma. For determination of total plasma amphotericin B concentrations, the sample was diluted and injected onto the LC/MS/MS. For total amphotericin B in other matrices and free amphotericin B in plasma, solid-phase extraction was used. Natamycin served as an internal standard. A PE Sciex API 3000 (Sciex; Concord, Ontario, Canada) was used to assess free amphotericin B in plasma ultrafiltrate determination and an API 3+ for the other matrices, with electrospray interfaced to a C18 analytic column. The low limit of quantitation was 1 ng/mL for ultrafiltrate. For total amphotericin B, the low limits were 2 μg/mL for plasma, 0.05 μg/mL for urine, and 0.4 μg/mL for fecal homogenate. The methods were validated to show the standard range linearity, sensitivity, selectivity, accuracy, precision, and stability of amphotericin B in the matrices tested.
- 1 June 2001
- Published by Wolters Kluwer Health in Therapeutic Drug Monitoring
- Vol. 23 (3) , 268-276
Quantitation of Free and Total Amphotericin B in Human Biologic Matrices by a Liquid Chromatography Tandem Mass Spectrometric Method
Amphotericin B remains the standard of care for the treatment of invasive and disseminated fungal infections. Various lipid-based formulations of amphotericin B have been developed to improve its therapeutic index by decreasing toxicity. Previous bioanalytic methods using microbial inhibition or high-pressure liquid chromatography quantified total amphotericin B (free, plasma protein-bound, and lipid-complexed). Sensitivity of this method with a low limit of quantitation of 0.05 μg/mL was inadequate to determine free (unbound) amphotericin B. A sensitive LC/MS/MS method was developed to determine the total amphotericin B value in human plasma and other biologic matrices and the free amphotericin B concentration in plasma. For determination of total plasma amphotericin B concentrations, the sample was diluted and injected onto the LC/MS/MS. For total amphotericin B in other matrices and free amphotericin B in plasma, solid-phase extraction was used. Natamycin served as an internal standard. A PE Sciex API 3000 (Sciex; Concord, Ontario, Canada) was used to assess free amphotericin B in plasma ultrafiltrate determination and an API 3+ for the other matrices, with electrospray interfaced to a C18 analytic column. The low limit of quantitation was 1 ng/mL for ultrafiltrate. For total amphotericin B, the low limits were 2 μg/mL for plasma, 0.05 μg/mL for urine, and 0.4 μg/mL for fecal homogenate. The methods were validated to show the standard range linearity, sensitivity, selectivity, accuracy, precision, and stability of amphotericin B in the matrices tested.