Masoud Montazeri Namin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Masoud Montazeri Namin has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Asghar Bohluly2 shared publications
- Ahmad Tahershamsi
Amirkabir University of Technology (Tehran Polytechnic)
1 shared publication - Andre Stephan Henry Prevot
Paul Scherrer Institute
1 shared publication - Ehsan Fadaei-Kermani
Department of Civil Engineering, Faculty of Engineering, Shahid Bahonar University of Kerman, Kerman, Iran
1 shared publication - Farhad Bahmanpouri1 shared publication
Farhang Behrangi
1 shared publication
Latest Publications
- 13 October 2021
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (11) , 16233-16249
Temporal variations, regional contribution, and cluster analyses of ozone and NOx in a middle eastern megacity during summertime over 2017–2019
Particulate matter is usually regarded as the dominant pollutant in Tehran megacity in Iran. However, the number of ozone exceedance days significantly increased in recent years. This study analyzes simultaneous measurements of O3 and NOx (NO+NO2) concentrations to improve our understanding of ozone evolution during the summers of 2017 to 2019. The k-means clustering technique was used to select five representative air quality monitoring sites in Tehran to capture O3 and NOx concentrations’ variability. The findings show that all of the investigated sites failed to meet the ozone non-attainment criterion. The ozone weekend effect is seen in the study of weekday/weekend differences in 2017 and 2018, but not in 2019, which can be due to the shift in the ozone production regime. The summer mean variation analysis can also be used to deduce this regime change. In 2017, the O3 and NO2 summer mean variations suggest a holdback in the NO2 upward trend and a reversal in the O3 downward trend that had been in place since 2012. Air mass back trajectory clustering reveals that east and north-east air mass clusters have the most significant impact on Tehran’s O3 pollution and the highest regional contribution to OX. The study of OX against NOx shows that the regional contribution to OX increased from 2017 to 2018 and then decreased in 2019; however, the local contribution is the opposite. The diurnal analysis of the regional and local contributions to OX indicated that OX in Tehran might be primarily affected by pollutants from a short distance. The findings reveal critical changes in the behavior of O3 in recent years, indicating that decision-makers in Tehran should reconsider air pollution control measures.
- 13 October 2021
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (11) , 16233-16249
Temporal variations, regional contribution, and cluster analyses of ozone and NOx in a middle eastern megacity during summertime over 2017–2019
Particulate matter is usually regarded as the dominant pollutant in Tehran megacity in Iran. However, the number of ozone exceedance days significantly increased in recent years. This study analyzes simultaneous measurements of O3 and NOx (NO+NO2) concentrations to improve our understanding of ozone evolution during the summers of 2017 to 2019. The k-means clustering technique was used to select five representative air quality monitoring sites in Tehran to capture O3 and NOx concentrations’ variability. The findings show that all of the investigated sites failed to meet the ozone non-attainment criterion. The ozone weekend effect is seen in the study of weekday/weekend differences in 2017 and 2018, but not in 2019, which can be due to the shift in the ozone production regime. The summer mean variation analysis can also be used to deduce this regime change. In 2017, the O3 and NO2 summer mean variations suggest a holdback in the NO2 upward trend and a reversal in the O3 downward trend that had been in place since 2012. Air mass back trajectory clustering reveals that east and north-east air mass clusters have the most significant impact on Tehran’s O3 pollution and the highest regional contribution to OX. The study of OX against NOx shows that the regional contribution to OX increased from 2017 to 2018 and then decreased in 2019; however, the local contribution is the opposite. The diurnal analysis of the regional and local contributions to OX indicated that OX in Tehran might be primarily affected by pollutants from a short distance. The findings reveal critical changes in the behavior of O3 in recent years, indicating that decision-makers in Tehran should reconsider air pollution control measures.
- 23 July 2021
- Published by Springer Nature in Iranian Journal of Science and Technology, Transactions of Civil Engineering
- Vol. 46 (2) , 1515-1525
2-D Dam-Break Flow Modeling Based on Weighted Average Flux Method
- 23 July 2021
- Published by Springer Nature in Iranian Journal of Science and Technology, Transactions of Civil Engineering
- Vol. 46 (2) , 1515-1525
2-D Dam-Break Flow Modeling Based on Weighted Average Flux Method
- 16 November 2018
- Published by Elsevier in Journal of Hydrology
- Vol. 568, 479-491
A 3D unstructured triangular numerical algorithm for simultaneous effects of fluid density variation and water table gradient in saturated porous media
- 16 November 2018
- Published by Elsevier in Journal of Hydrology
- Vol. 568, 479-491
A 3D unstructured triangular numerical algorithm for simultaneous effects of fluid density variation and water table gradient in saturated porous media
- 8 May 2018
- Published by Emerald Publishing in Engineering Computations
- Vol. 35 (3) , 1161-1182
FGA-MMF method for the simulation of two-phase flows
Purpose: This paper aims to present a novel numerical technique for solving the incompressible multiphase mixture model. Design/methodology/approach: The multiphase mixture model contains a set of momentum and continuity equations for the mixture phase, a second phase continuity equation and the algebraic equation for the relative velocity. For solving continuity equation for the second phase and advection term of momentum, an improved approach fine grid advection-multiphase mixture flow (FGA-MMF) is developed. In the FGA-MMF method, the continuity equation for the second phase is solved with higher-order schemes in a two times finer grid. To solve the advection term of the momentum equation, the advection fluxes of the volume fraction in the continuity equation for the second phase are used. Findings: This approach has been used in various tests to simulate unsteady flow problems. Comparison between numerical results and experimental data demonstrates a satisfactory performance. Numerical examples show that this approach increases the accuracy and stability of the solution and decreases non-monotonic results. Research limitations/implications: The solver for the multi-phase mixture model can only be adopted to solve the incompressible fluid flow. Originality/value: The paper developed an innovative solution (FGA-MMF) to find multi-phase flow field value in the multi-phase mixture model. Advantages of the FGA-MMF technique are the ability to accurately determine the phases interpenetrating, decreasing the numerical diffusion of the interface and preventing instability and non-monotonicity in solution of large density variation problems.
- 8 May 2018
- Published by Emerald Publishing in Engineering Computations
- Vol. 35 (3) , 1161-1182
FGA-MMF method for the simulation of two-phase flows
Purpose: This paper aims to present a novel numerical technique for solving the incompressible multiphase mixture model. Design/methodology/approach: The multiphase mixture model contains a set of momentum and continuity equations for the mixture phase, a second phase continuity equation and the algebraic equation for the relative velocity. For solving continuity equation for the second phase and advection term of momentum, an improved approach fine grid advection-multiphase mixture flow (FGA-MMF) is developed. In the FGA-MMF method, the continuity equation for the second phase is solved with higher-order schemes in a two times finer grid. To solve the advection term of the momentum equation, the advection fluxes of the volume fraction in the continuity equation for the second phase are used. Findings: This approach has been used in various tests to simulate unsteady flow problems. Comparison between numerical results and experimental data demonstrates a satisfactory performance. Numerical examples show that this approach increases the accuracy and stability of the solution and decreases non-monotonic results. Research limitations/implications: The solver for the multi-phase mixture model can only be adopted to solve the incompressible fluid flow. Originality/value: The paper developed an innovative solution (FGA-MMF) to find multi-phase flow field value in the multi-phase mixture model. Advantages of the FGA-MMF technique are the ability to accurately determine the phases interpenetrating, decreasing the numerical diffusion of the interface and preventing instability and non-monotonicity in solution of large density variation problems.
- 1 January 2017
- Published by Inderscience Publishers in Progress in Computational Fluid Dynamics, An International Journal
- Vol. 1 (1)
A new approach to solve mixture Multi-phase Flow model using Time Splitting Projection Method
International publishers of academic, scientific and professional journals since 1979.
- 1 January 2017
- Published by Inderscience Publishers in Progress in Computational Fluid Dynamics, An International Journal
- Vol. 1 (1)
A new approach to solve mixture Multi-phase Flow model using Time Splitting Projection Method
International publishers of academic, scientific and professional journals since 1979.
- 7 April 2012
- Published by Elsevier in Journal of Hydrology
- Vol. 444-445, 10-21
A time splitting algorithm for numerical solution of Richard’s equation
- 7 April 2012
- Published by Elsevier in Journal of Hydrology
- Vol. 444-445, 10-21
A time splitting algorithm for numerical solution of Richard’s equation
- 26 September 2011
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 49 (5) , 685-688
Numerical modelling of supercritical flow in rectangular chute bends
A two-dimensional numerical model predicting supercritical flow in open channels has been developed using the finite volume method. The shallow-water equations are solved by the total variation diminishing weighted average flux method. Then the model is applied to a wide range of supercritical flow tests in rectangular chute bends and the results are compared with available experimental data. The results indicate that the model predicts the flow profile well for the channel bend with a width to channel curvature ratio of 0.04 and the present model has limitations for the other tests which have a higher ratio.
- 26 September 2011
- Published by Taylor & Francis in Journal of Hydraulic Research
- Vol. 49 (5) , 685-688
Numerical modelling of supercritical flow in rectangular chute bends
A two-dimensional numerical model predicting supercritical flow in open channels has been developed using the finite volume method. The shallow-water equations are solved by the total variation diminishing weighted average flux method. Then the model is applied to a wide range of supercritical flow tests in rectangular chute bends and the results are compared with available experimental data. The results indicate that the model predicts the flow profile well for the channel bend with a width to channel curvature ratio of 0.04 and the present model has limitations for the other tests which have a higher ratio.