Bimal K. Kad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bimal K. Kad has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Ming Dao
Department of Materials Science and Engineering, Massachusetts Institute of Technology, Cambridge, USA
3 shared publications Robert J. Asaro
Department of Applied Mechanics and Engineering Sciences, 0411 , University of California , San Diego, La Jolla, California, 92093, USA
3 shared publications- Brian Maddox
Lawrence Livermore National Laboratory, Livermore, California 94550, USA
1 shared publication - Bruce A. Remington
Lawrence Livermore National Laboratory 5 , Livermore, California 94550, USA
1 shared publication - Hyesook Park
Department of Preventive Medicine, College of Medicine, Ewha Womans University, Seoul, Republic of Korea
1 shared publication Joe A Horton
Oak Ridge National Laboratory, Oak Ridge, TN 37831-6115, USA
1 shared publication
Latest Publications
- Open Access
- 1 January 2012
- Published by AIP Publishing in AIP Conference Proceedings
- p. 1391-1394
Laser compression of monocrystalline tantalum
Monocrystalline tantalum with orientations [100] and [111] was subjected to laser driven compression at laser energies of 350 to 685 J, generating shock amplitudes varying from 15 to 100 GPa. The laser beam, with a beam spot diameter of ~1 mm, created a crater of significant depth (~ 80 to ~ 200 μm). Twins were observed just below the crater surface (~ 42 μm) by back-scattered SEM. Transmission electron microscopy (TEM) revealed profuse mechanical twinning within a distance from the energy deposition surface of ~ 1.5 mm at 684 J compression power, corresponding to an approximate pressure of 35 GPa. The decay of the pulse through the specimens was accompanied by an attendant decrease in the density of shock-generated dislocations. Microhardness measurements were conducted on the recovered samples. The experimentally measured dislocation densities and threshold stress for twinning are compared with predictions using analyses based on the constitutive response and the similarities and differences are discussed in terms of the mechanisms of defect generation.
- 1 January 2012
- Published by AIP Publishing in AIP Conference Proceedings
- p. 1391-1394
Open AccessLaser compression of monocrystalline tantalum
Monocrystalline tantalum with orientations [100] and [111] was subjected to laser driven compression at laser energies of 350 to 685 J, generating shock amplitudes varying from 15 to 100 GPa. The laser beam, with a beam spot diameter of ~1 mm, created a crater of significant depth (~ 80 to ~ 200 μm). Twins were observed just below the crater surface (~ 42 μm) by back-scattered SEM. Transmission electron microscopy (TEM) revealed profuse mechanical twinning within a distance from the energy deposition surface of ~ 1.5 mm at 684 J compression power, corresponding to an approximate pressure of 35 GPa. The decay of the pulse through the specimens was accompanied by an attendant decrease in the density of shock-generated dislocations. Microhardness measurements were conducted on the recovered samples. The experimentally measured dislocation densities and threshold stress for twinning are compared with predictions using analyses based on the constitutive response and the similarities and differences are discussed in terms of the mechanisms of defect generation.
- 1 December 1997
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 239-240, 118-125
Discrepancies between microscopic (TEM) and macroscopic (texture) observations in high temperature deformation of FeAl and Fe3Al-based alloys
- 1 December 1997
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 239-240, 118-125
Discrepancies between microscopic (TEM) and macroscopic (texture) observations in high temperature deformation of FeAl and Fe3Al-based alloys
- 1 February 1997
- Published by Taylor & Francis in Philosophical Magazine A
- Vol. 75 (2) , 443-459
Mechanism of intense shear failure in Ni3Al single crystals
Localized shear bands, with minute misorientations off the slip plane, cause sharp failures in Ni3Al single crystals that fail after elongation exceeding 70–80% in room-temperature tensile tests. An explanation for intense slip plane shear failure, consistent with prior experimental observations, is proposed. Prior electron microscopy evidence obtained by Horton, Baker and Yoo of decreasing antiphase-boundary energy in highly deformed slip bands is employed to suggest a highly localized order-disorder transition. This shear-strain-induced slip-plane disordering provides the essential mechanism to lower the work-hardening rate to zero or negative values. A decreasing work-hardening rate sustains persistent shear localization, ultimately leading to failure. This mechanism is suggested to be applicable to other ordered crystals.
- 1 February 1997
- Published by Taylor & Francis in Philosophical Magazine A
- Vol. 75 (2) , 443-459
Mechanism of intense shear failure in Ni3Al single crystals
Localized shear bands, with minute misorientations off the slip plane, cause sharp failures in Ni3Al single crystals that fail after elongation exceeding 70–80% in room-temperature tensile tests. An explanation for intense slip plane shear failure, consistent with prior experimental observations, is proposed. Prior electron microscopy evidence obtained by Horton, Baker and Yoo of decreasing antiphase-boundary energy in highly deformed slip bands is employed to suggest a highly localized order-disorder transition. This shear-strain-induced slip-plane disordering provides the essential mechanism to lower the work-hardening rate to zero or negative values. A decreasing work-hardening rate sustains persistent shear localization, ultimately leading to failure. This mechanism is suggested to be applicable to other ordered crystals.
- 1 January 1996
- Published by Springer Nature in MRS Proceedings
- Vol. 434
Micromechanics of Deformation and Fracture in Low Symmetry Layered Materials
- 1 January 1996
- Published by Springer Nature in MRS Proceedings
- Vol. 434
Micromechanics of Deformation and Fracture in Low Symmetry Layered Materials
- 1 January 1994
- Published by Springer Nature in MRS Proceedings
- Vol. 364
Deformation and Failure Modes Under Compressive Loading in Lamellar Tial
- 1 January 1994
- Published by Springer Nature in MRS Proceedings
- Vol. 364
Deformation and Failure Modes Under Compressive Loading in Lamellar Tial