Maciej Radosz
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Maciej Radosz has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Youqing Shen
Zhejiang University
9 shared publications Xudong Hu
Soft Materials Laboratory, Department of Chemical and Petroleum Engineering, University of Wyoming, Laramie, WY 82071, USA
4 shared publicationsS. V. B. Janardhan Garikipati
University of Wyoming
3 shared publicationsGui‐Bing Zhao
Dept. of Chemical and Petroleum Engineering, University of Wyoming, Laramie, WY 82071
2 shared publicationsJimmy W. Mays
2 shared publications- Kunlun Hong
Center for Nanophase Materials Sciences Oak Ridge National Laboratory Oak Ridge TN USA
2 shared publications
Latest Publications
- 24 May 2012
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 45 (11) , 4809-4817
Multilayered Nanoparticles for Controlled Release of Paclitaxel Formed by Near-Critical Micellization of Triblock Copolymers
- 24 May 2012
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 45 (11) , 4809-4817
Multilayered Nanoparticles for Controlled Release of Paclitaxel Formed by Near-Critical Micellization of Triblock Copolymers
- Open Access
- 1 September 2011
- Published by Defense Technical Information Center (DTIC)
Breast Cancer-Targeted Nuclear Drug Delivery Overcoming Drug Resistance for Breast Cancer Chemotherapy
Cell membrane-associated and intracellular drug resistance mechanisms are the major cause of breast cancer treatment failure. The aim of this proposal is to develop nuclear localizing nanoparticles to delivery DNA-toxins breast cancer cell nuclei to effectively overcoming the drug resistance. We finished the task 1 - To synthesize and optimize folic-acid- or LHRHfunctionalized charge reversal nanoparticles. The cationic polymer PEI and its block copolymer with degradable PCL were synthesized. The cationic PEI block amines were converted to acid labile amides to obtain the PCL-PEI/amide block copolymer. This polymer was used to fabricate the nanoparticles. The ideal nanoparticles with optimal sizes and acid-triggered negative-to-positive charge reversal properties were fabricated and characterized carefully. These nanoparticles will be characterized in vitro and in vivo.
- 1 September 2011
- Published by Defense Technical Information Center (DTIC)
Open AccessBreast Cancer-Targeted Nuclear Drug Delivery Overcoming Drug Resistance for Breast Cancer Chemotherapy
Cell membrane-associated and intracellular drug resistance mechanisms are the major cause of breast cancer treatment failure. The aim of this proposal is to develop nuclear localizing nanoparticles to delivery DNA-toxins breast cancer cell nuclei to effectively overcoming the drug resistance. We finished the task 1 - To synthesize and optimize folic-acid- or LHRHfunctionalized charge reversal nanoparticles. The cationic polymer PEI and its block copolymer with degradable PCL were synthesized. The cationic PEI block amines were converted to acid labile amides to obtain the PCL-PEI/amide block copolymer. This polymer was used to fabricate the nanoparticles. The ideal nanoparticles with optimal sizes and acid-triggered negative-to-positive charge reversal properties were fabricated and characterized carefully. These nanoparticles will be characterized in vitro and in vivo.
- 18 July 2011
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 45 (16) , 7068-7074
CO2-Filling Capacity and Selectivity of Carbon Nanopores: Synthesis, Texture, and Pore-Size Distribution from Quenched-Solid Density Functional Theory (QSDFT)
Porous carbons synthesized by KOH activation of petroleum coke can have high surface areas, over 3000 m2/g, and high CO2 sorption capacity, over 15 wt % at 1 bar. This makes them attractive sorbents for carbon capture from combustion flue gas. Quenched solid density functional theory (QSDFT) analysis of high-resolution nitrogen-sorption data for such materials leads to the conclusion that it is the pores smaller than 1 nm in diameter that fill with high-density CO2 at atmospheric pressure. Upon increasing pressure, larger and larger pores are filled, up to about 4 nm at 10 bar. An ideal CO2/N2 selectivity of such carbon materials tends to decrease substantially upon increasing pressure, for example, from about 8–10 at 1 bar to about 4–5 at 10 bar. All in all, this work confirms the robust CO2-filling properties of porous carbon sorbents, their low-pressure selectivity advantages, and points to the critical role of <1 nm pores that can be controlled with activation conditions.
- 18 July 2011
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 45 (16) , 7068-7074
CO2-Filling Capacity and Selectivity of Carbon Nanopores: Synthesis, Texture, and Pore-Size Distribution from Quenched-Solid Density Functional Theory (QSDFT)
Porous carbons synthesized by KOH activation of petroleum coke can have high surface areas, over 3000 m2/g, and high CO2 sorption capacity, over 15 wt % at 1 bar. This makes them attractive sorbents for carbon capture from combustion flue gas. Quenched solid density functional theory (QSDFT) analysis of high-resolution nitrogen-sorption data for such materials leads to the conclusion that it is the pores smaller than 1 nm in diameter that fill with high-density CO2 at atmospheric pressure. Upon increasing pressure, larger and larger pores are filled, up to about 4 nm at 10 bar. An ideal CO2/N2 selectivity of such carbon materials tends to decrease substantially upon increasing pressure, for example, from about 8–10 at 1 bar to about 4–5 at 10 bar. All in all, this work confirms the robust CO2-filling properties of porous carbon sorbents, their low-pressure selectivity advantages, and points to the critical role of <1 nm pores that can be controlled with activation conditions.
- 25 May 2011
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 115 (24) , 11951-11956
Near-Critical Fluid Micellization for High and Efficient Drug Loading: Encapsulation of Paclitaxel into PEG-b-PCL Micelles
- 25 May 2011
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 115 (24) , 11951-11956
Near-Critical Fluid Micellization for High and Efficient Drug Loading: Encapsulation of Paclitaxel into PEG-b-PCL Micelles
- 27 October 2009
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 113 (46) , 15156-15161
Deuteration Impact on Micellization Pressure and Cloud Pressure of Polystyrene-block-polybutadiene and Polystyrene-block-polyisoprene in Compressible Propane
The deuterated homopolymers and their corresponding polystyrene-block-polybutadiene and polystyrene-block-polyisoprene copolymers require lower cloud pressures than their hydrogenous analogues to dissolve in a compressible alkane solvent, such as propane. For symmetric diblocks, deuteration reduces the micellization pressure. By contrast, for asymmetric diblocks with a long diene block relative to the styrene block, deuteration can increase the micellization pressure. All in all, however, the deuteration effects, while measurable, do not qualitatively change the principal diblock properties in compressible propane solutions, such as pressure-induced micelle decomposition, micelle formation and micelle size, and their temperature dependence. Therefore, isotope labeling should be a useful approach to neutron-scattering characterization for styrene-diene block copolymers in compressible alkane systems.
- 27 October 2009
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 113 (46) , 15156-15161
Deuteration Impact on Micellization Pressure and Cloud Pressure of Polystyrene-block-polybutadiene and Polystyrene-block-polyisoprene in Compressible Propane
The deuterated homopolymers and their corresponding polystyrene-block-polybutadiene and polystyrene-block-polyisoprene copolymers require lower cloud pressures than their hydrogenous analogues to dissolve in a compressible alkane solvent, such as propane. For symmetric diblocks, deuteration reduces the micellization pressure. By contrast, for asymmetric diblocks with a long diene block relative to the styrene block, deuteration can increase the micellization pressure. All in all, however, the deuteration effects, while measurable, do not qualitatively change the principal diblock properties in compressible propane solutions, such as pressure-induced micelle decomposition, micelle formation and micelle size, and their temperature dependence. Therefore, isotope labeling should be a useful approach to neutron-scattering characterization for styrene-diene block copolymers in compressible alkane systems.
- 1 November 2008
- Published by Office of Scientific and Technical Information (OSTI)
Novel Sorption/Desorption Process for Carbon Dioxide Capture (Feasibility Study)
Western Research Institute and the University of Wyoming Enhanced Oil Recovery Institute have tested a novel approach to carbon dioxide capture in power plants and industrial operations. This approach is expected to provide considerable cost savings, in terms of regeneration of the sorbent. It is proposed that low molecular weight, low volatility liquid fluorocarbons be utilized to absorb CO{sub 2} due to their unusual affinity for the gas. The energy savings would be realized by cooling the fluorocarbon liquids below their melting point where the CO{sub 2} would be released even at elevated pressure. Thus, the expense of heating currently used sorbents, saturated with CO{sub 2}, under low pressure conditions and then having to compress the released gas would not be realized. However, these fluorinated materials have been shown to be poor carbon dioxide absorbers under conditions currently required for carbon capture. The project was terminated.
- 1 November 2008
- Published by Office of Scientific and Technical Information (OSTI)
Novel Sorption/Desorption Process for Carbon Dioxide Capture (Feasibility Study)
Western Research Institute and the University of Wyoming Enhanced Oil Recovery Institute have tested a novel approach to carbon dioxide capture in power plants and industrial operations. This approach is expected to provide considerable cost savings, in terms of regeneration of the sorbent. It is proposed that low molecular weight, low volatility liquid fluorocarbons be utilized to absorb CO{sub 2} due to their unusual affinity for the gas. The energy savings would be realized by cooling the fluorocarbon liquids below their melting point where the CO{sub 2} would be released even at elevated pressure. Thus, the expense of heating currently used sorbents, saturated with CO{sub 2}, under low pressure conditions and then having to compress the released gas would not be realized. However, these fluorinated materials have been shown to be poor carbon dioxide absorbers under conditions currently required for carbon capture. The project was terminated.
- 1 August 2007
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 256 (1-2) , 75-80
Magnetic suspension balance study of carbon dioxide solubility in ammonium-based polymerized ionic liquids: Poly(p-vinylbenzyltrimethyl ammonium tetrafluoroborate) and poly([2-(methacryloyloxy)ethyl] trimethyl ammonium tetrafluoroborate)
- 1 August 2007
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 256 (1-2) , 75-80
Magnetic suspension balance study of carbon dioxide solubility in ammonium-based polymerized ionic liquids: Poly(p-vinylbenzyltrimethyl ammonium tetrafluoroborate) and poly([2-(methacryloyloxy)ethyl] trimethyl ammonium tetrafluoroborate)
- 1 August 2005
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 25 (4) , 351-370
Laser-Induced Fluorescence (LIF) Probe for In-situ Nitric Oxide Concentration Measurement in a Non-thermal Pulsed Corona Discharge Plasma Reactor
- 1 August 2005
- Published by Springer Nature in Plasma Chemistry and Plasma Processing
- Vol. 25 (4) , 351-370
Laser-Induced Fluorescence (LIF) Probe for In-situ Nitric Oxide Concentration Measurement in a Non-thermal Pulsed Corona Discharge Plasma Reactor
- 4 April 2005
- Published by Wiley in AIChE Journal
- Vol. 51 (6) , 1813-1821
Effect of reactor configuration on nitric oxide conversion in nitrogen plasma
The configuration of a nonthermal plasma reactor strongly affects the rate of electron collision reactions. Experiments involving the decomposition of NO in N2 were performed in a reactor in which the number of parallel reactor tubes varied from 1 to 10 at a constant pressure of 147.6 kPa and ambient temperature. A previously developed lumped model of the reactions accurately predicted the effects of varying the initial concentrations of NO (from 240 ppm to 593 ppm) and gas residence time (from 1.93 to 7.42 s). With an increasing number of parallel reactor tubes, the rate of electron collision reactions decreases because the energy input per unit reactor volume at unit time decreases, while the energy consumption per molecule of NO converted to N2 and O2 decreases due to electrical and geometric effects associated with the decreasing peak width of the discharge voltage pulses and increasing reactor capacitance. Therefore, increasing the number of parallel reactor tubes provides a viable scale‐up method for constructing more efficient pulsed corona discharge reactors. © 2005 American Institute of Chemical Engineers AIChE J, 2005
- 4 April 2005
- Published by Wiley in AIChE Journal
- Vol. 51 (6) , 1813-1821
Effect of reactor configuration on nitric oxide conversion in nitrogen plasma
The configuration of a nonthermal plasma reactor strongly affects the rate of electron collision reactions. Experiments involving the decomposition of NO in N2 were performed in a reactor in which the number of parallel reactor tubes varied from 1 to 10 at a constant pressure of 147.6 kPa and ambient temperature. A previously developed lumped model of the reactions accurately predicted the effects of varying the initial concentrations of NO (from 240 ppm to 593 ppm) and gas residence time (from 1.93 to 7.42 s). With an increasing number of parallel reactor tubes, the rate of electron collision reactions decreases because the energy input per unit reactor volume at unit time decreases, while the energy consumption per molecule of NO converted to N2 and O2 decreases due to electrical and geometric effects associated with the decreasing peak width of the discharge voltage pulses and increasing reactor capacitance. Therefore, increasing the number of parallel reactor tubes provides a viable scale‐up method for constructing more efficient pulsed corona discharge reactors. © 2005 American Institute of Chemical Engineers AIChE J, 2005