Nikolay N. Brandt
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Nikolay N. Brandt has a total of 82 co-authors. Here are the top co-authors by number of shared publications:
A. Yu. Chikishev
Lomonosov Moscow State University, Moscow, Russia
6 shared publicationsAndrey Yu. Chikishev
Lomonosov Moscow State University
5 shared publications- Irina A. Balakhnina
Faculty of Physics, Lomonosov Moscow State University, 1/2, Leninskie Gory, Moscow 119991, Russia
5 shared publications A.YU. Chikishev
3 shared publications- A. Yu. Chikishev
Faculty of Physics, Lomonosov Moscow State University, Moscow, Russian Federation
2 shared publications - Alexander Pavlovich Shkurinov
Department of Physics Lomonosov Moscow State University Moscow Russia
2 shared publications
Latest Publications
- 29 October 2026
- Published by Springer Nature in Journal of Applied Spectroscopy
- p. 1-7
Raman Spectroscopy of Hematite in the Paint Layer of a Model Fresco Before and After Heating
- 29 October 2026
- Published by Springer Nature in Journal of Applied Spectroscopy
- p. 1-7
Raman Spectroscopy of Hematite in the Paint Layer of a Model Fresco Before and After Heating
- 2 January 2025
- Published by Wiley in Journal of Raman Spectroscopy
- Vol. 56 (9) , 801-807
Raman Microspectroscopy of Hair Cuticle With Polarized Excitation: Problem of Protein Secondary and Tertiary Structure
Raman spectra of human hair cuticle measured in two experimental configurations with linearly polarized radiation focused on the lateral surface of the hair and on its cross section are compared. The bands at ~150, 220–230, 900, 935, 1321, 1338, and 1652 cm −1 are found to be polarization‐sensitive and assigned to the skeletal vibrations of α ‐helices of hair keratins. However, different Raman spectra depending on the relative direction of signal collection can be obtained under identical polarization conditions for excitation. Several markers of the secondary structure of keratins (in particular, ~150, 935, and 1338 cm −1 ) may also be sensitive to the changes in the tertiary structure.
- 2 January 2025
- Published by Wiley in Journal of Raman Spectroscopy
- Vol. 56 (9) , 801-807
Raman Microspectroscopy of Hair Cuticle With Polarized Excitation: Problem of Protein Secondary and Tertiary Structure
Raman spectra of human hair cuticle measured in two experimental configurations with linearly polarized radiation focused on the lateral surface of the hair and on its cross section are compared. The bands at ~150, 220–230, 900, 935, 1321, 1338, and 1652 cm −1 are found to be polarization‐sensitive and assigned to the skeletal vibrations of α ‐helices of hair keratins. However, different Raman spectra depending on the relative direction of signal collection can be obtained under identical polarization conditions for excitation. Several markers of the secondary structure of keratins (in particular, ~150, 935, and 1338 cm −1 ) may also be sensitive to the changes in the tertiary structure.
- 13 October 2024
- Published by Wiley in Journal of Biophotonics
- Vol. 18 (12) , e202400265
Raman Microspectroscopy of Hair: Low‐Frequency Markers of Protein Secondary Structure
Low‐frequency intervals that can be used to study the secondary structure of proteins are determined. Compared are Raman spectra of keratins from unpigmented human hair, measured in two experimental configurations: with excitation radiation coaxial with the hair and perpendicular to it. Based on the polarization sensitivity, the bands peaked at 150 and 221 cm −1 are assigned to vibrations of α‐helical structures. The comparison of Raman spectra of hair fragments with different contents of secondary structure elements shows that the vibrations of β‐structure are manifested in a spectral interval of 270–340 cm −1 . The results obtained for a particular object (hair keratin) can be used in the study of the secondary structure of proteins.
- 13 October 2024
- Published by Wiley in Journal of Biophotonics
- Vol. 18 (12) , e202400265
Raman Microspectroscopy of Hair: Low‐Frequency Markers of Protein Secondary Structure
Low‐frequency intervals that can be used to study the secondary structure of proteins are determined. Compared are Raman spectra of keratins from unpigmented human hair, measured in two experimental configurations: with excitation radiation coaxial with the hair and perpendicular to it. Based on the polarization sensitivity, the bands peaked at 150 and 221 cm −1 are assigned to vibrations of α‐helical structures. The comparison of Raman spectra of hair fragments with different contents of secondary structure elements shows that the vibrations of β‐structure are manifested in a spectral interval of 270–340 cm −1 . The results obtained for a particular object (hair keratin) can be used in the study of the secondary structure of proteins.
- 26 August 2024
- Published by Taylor & Francis in Studies in Conservation
- Vol. 70 (5) , 375-385
Comparison of Color Changes in Paints Based on Ultramarine and Zinc White Resulting from Storage and Thermally Induced Aging
- 26 August 2024
- Published by Taylor & Francis in Studies in Conservation
- Vol. 70 (5) , 375-385
Comparison of Color Changes in Paints Based on Ultramarine and Zinc White Resulting from Storage and Thermally Induced Aging
- 1 July 2024
- Published by Elsevier in Dyes and Pigments
- Vol. 229
Color trajectories of natural pigments for model fresco samples under heating
- 1 July 2024
- Published by Elsevier in Dyes and Pigments
- Vol. 229
Color trajectories of natural pigments for model fresco samples under heating
- Open Access
- 22 May 2023
- Published by TIRAZH Publishing House in Actual problems in dentistry
- Vol. 19 (1) , 126-132
QUANTITATIVE ASSESSMENT OF DENTAL PROSTHETIC FLUORESCENCE
Subject. Ceramics based on zirconia can fluoresce through the additional application of fluorescent glazes, fluorescent dyes, as well. To date, there are no methods for assessing the fluorescence of dental materials used in prosthetics. The aim –– Development of a method for quantitative determination of the fluorescence intensity of dental prosthetic materials. Methodology. The study was conducted in the laboratory of the Faculty of Physics of Moscow State University. Fluorescence was excited by an ultraviolet lamp. The fluorescence spectra of the samples were measured using the Ocean Optics fiber optic spectrofluorometer. Ceramic billets made of zirconia "Ziceram T" A2 of domestic production without and with the staining of fluorescent glaze "Ivocolor fluo", as well as natural teeth were used as samples for patients. Results. Samples of domestic zirconia acquire fluorescent properties after applying and sintering the fluorescent glaze. The varied number of layers of the applied glaze explains why the fluorescence intensity increases. The authors compare the fluorescence spectra of two natural teeth with the spectra of zirconia samples with two and three layers of glaze. The spectra coincide well with each other in pairs. A fluorescence spectrum that is similar to one of the natural tooth samples can thus be achieved by varying the number of glaze layers. Conclusions. The analysis of the fluorescence spectra of samples of zirconia from domestic production after application and sintering of fluorescent glaze shows a similar fluorescence spectrum to samples of natural teeth.
- 22 May 2023
- Published by TIRAZH Publishing House in Actual problems in dentistry
- Vol. 19 (1) , 126-132
Open AccessQUANTITATIVE ASSESSMENT OF DENTAL PROSTHETIC FLUORESCENCE
Subject. Ceramics based on zirconia can fluoresce through the additional application of fluorescent glazes, fluorescent dyes, as well. To date, there are no methods for assessing the fluorescence of dental materials used in prosthetics. The aim –– Development of a method for quantitative determination of the fluorescence intensity of dental prosthetic materials. Methodology. The study was conducted in the laboratory of the Faculty of Physics of Moscow State University. Fluorescence was excited by an ultraviolet lamp. The fluorescence spectra of the samples were measured using the Ocean Optics fiber optic spectrofluorometer. Ceramic billets made of zirconia "Ziceram T" A2 of domestic production without and with the staining of fluorescent glaze "Ivocolor fluo", as well as natural teeth were used as samples for patients. Results. Samples of domestic zirconia acquire fluorescent properties after applying and sintering the fluorescent glaze. The varied number of layers of the applied glaze explains why the fluorescence intensity increases. The authors compare the fluorescence spectra of two natural teeth with the spectra of zirconia samples with two and three layers of glaze. The spectra coincide well with each other in pairs. A fluorescence spectrum that is similar to one of the natural tooth samples can thus be achieved by varying the number of glaze layers. Conclusions. The analysis of the fluorescence spectra of samples of zirconia from domestic production after application and sintering of fluorescent glaze shows a similar fluorescence spectrum to samples of natural teeth.
- 8 April 2023
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 55 (6) , 1-10
Microsampling of Veliky Novgorod frescoes using laser ablation
- 8 April 2023
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 55 (6) , 1-10
Microsampling of Veliky Novgorod frescoes using laser ablation
- 1 June 2021
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 136 (6) , 1-9
Raman microspectroscopy of fresco fragments from the Annunciation Church at Gorodishche at Veliky Novgorod
- 1 June 2021
- Published by Springer Nature in The European Physical Journal Plus
- Vol. 136 (6) , 1-9
Raman microspectroscopy of fresco fragments from the Annunciation Church at Gorodishche at Veliky Novgorod
- 1 November 2018
- Published by Allerton Press in Moscow University Physics Bulletin
- Vol. 73 (6) , 644-650
Time Variations in the FTIR Spectra of Liquids Measured in the ATR Configuration
Attenuated total reflection (ATR) is often employed in the measurements of FTIR spectra. Such a configuration is convenient for experiments with liquid samples, since pressing them to the...
- 1 November 2018
- Published by Allerton Press in Moscow University Physics Bulletin
- Vol. 73 (6) , 644-650
Time Variations in the FTIR Spectra of Liquids Measured in the ATR Configuration
Attenuated total reflection (ATR) is often employed in the measurements of FTIR spectra. Such a configuration is convenient for experiments with liquid samples, since pressing them to the...