Akos Nemcsics
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Akos Nemcsics has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
P. Turmezei
Institute of Microelectronics and Technology
2 shared publicationsAndrea Stemmann
1 shared publicationEniko Horvath
Research Institute for Technical Physics and Materials Science, P.O.B. 49 H-1525, Hungary
1 shared publication- Ferenc Riesz
Hungarian Academy of Sciences
1 shared publication Imre Mojzes
Department of Electronics Technology, Technical Univerity of Budapest, H-1521 Budapest, Hungary
1 shared publicationJ. Betko
Institute of Electrical Engineering, Dúbravská cesta 9, Slovak Academy of Sciences, 84239 Bratislava, Slovakia
1 shared publication
Latest Publications
- 1 May 2011
- Published by Elsevier in Microelectronics Reliability
- Vol. 51 (5) , 927-930
Facetting of the self-assembled droplet epitaxial GaAs quantum dot
- 1 May 2011
- Published by Elsevier in Microelectronics Reliability
- Vol. 51 (5) , 927-930
Facetting of the self-assembled droplet epitaxial GaAs quantum dot
- 1 October 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 215-218
Some remarks to the nanowires grown on Ill-V substrate
In the present work nanowires are investigated, which were prepared with the help of encapsulated metal induced growth method on GaAs and InP substrate. As our former investigations show, we can receive nanowires with substrate-like composition in the case of InP. In the case of GaAs substrate the situation is entirely different, while the growth technology in both cases was the same. The difference between the nanoproducts in the cases of different substrates originate in the reactivity of the components, which is explained in the following considerations. Furthermore we have observed that the diameter of the nanowires depends on the electron energy of the irradiation. If the electron beam was 5 kV and 20 kV, the diameter lasting increases and decreases, respectively. This effect can be explained by the change of the nanowires structure influenced by the electron beam.
- 1 October 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 215-218
Some remarks to the nanowires grown on Ill-V substrate
In the present work nanowires are investigated, which were prepared with the help of encapsulated metal induced growth method on GaAs and InP substrate. As our former investigations show, we can receive nanowires with substrate-like composition in the case of InP. In the case of GaAs substrate the situation is entirely different, while the growth technology in both cases was the same. The difference between the nanoproducts in the cases of different substrates originate in the reactivity of the components, which is explained in the following considerations. Furthermore we have observed that the diameter of the nanowires depends on the electron energy of the irradiation. If the electron beam was 5 kV and 20 kV, the diameter lasting increases and decreases, respectively. This effect can be explained by the change of the nanowires structure influenced by the electron beam.
- 1 January 2006
- Published by Pleiades Publishing Ltd in Inorganic Materials
- Vol. 42 (1) , 3-6
Studies on the RF sputtered amorphous SiGe thin films
In this study, rf sputtered hydrogenated amorphous silicon-germanium thin films deposited at room temperature have been investigated by spectroscopic ellipsometry and Rutherford backscattering. Technological parameters were determined for good layer quality of amorphous material. The layer thicknesses were first evaluated from the Rutherford backscattering and spectroscopic ellipsometry measurements, then measured directly by step-profiler, and compared to each other. The inherence of technological parameters and composition of the layers is discussed.
- 1 January 2006
- Published by Pleiades Publishing Ltd in Inorganic Materials
- Vol. 42 (1) , 3-6
Studies on the RF sputtered amorphous SiGe thin films
In this study, rf sputtered hydrogenated amorphous silicon-germanium thin films deposited at room temperature have been investigated by spectroscopic ellipsometry and Rutherford backscattering. Technological parameters were determined for good layer quality of amorphous material. The layer thicknesses were first evaluated from the Rutherford backscattering and spectroscopic ellipsometry measurements, then measured directly by step-profiler, and compared to each other. The inherence of technological parameters and composition of the layers is discussed.
- 1 November 2005
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 39 (11) , 1352-1355
Some aspects of the RHEED behavior of low-temperature GaAs growth
The reflection high-energy electron diffraction (RHEED) behavior manifested during MBE growth on a GaAs(001) surface under low-temperature (LT) growth conditions is examined in this study. RHEED and its intensity oscillations during LT GaAs growth exhibit some particular behavior. The intensity, phase, and decay of the oscillations depend on the beam equivalent pressure (BEP) ratio and substrate temperature, etc. Here, the intensity dependence of RHEED behavior on the BEP ratio, substrate temperature, and excess of As content in the layer are examined. The change in the decay constant of the RHEED oscillations is also discussed.
- 1 November 2005
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 39 (11) , 1352-1355
Some aspects of the RHEED behavior of low-temperature GaAs growth
The reflection high-energy electron diffraction (RHEED) behavior manifested during MBE growth on a GaAs(001) surface under low-temperature (LT) growth conditions is examined in this study. RHEED and its intensity oscillations during LT GaAs growth exhibit some particular behavior. The intensity, phase, and decay of the oscillations depend on the beam equivalent pressure (BEP) ratio and substrate temperature, etc. Here, the intensity dependence of RHEED behavior on the BEP ratio, substrate temperature, and excess of As content in the layer are examined. The change in the decay constant of the RHEED oscillations is also discussed.
- 1 September 2005
- Published by Springer Nature in Instruments and Experimental Techniques
- Vol. 48 (5) , 679-682
Remark to the Intensity Measurement of RHEED
- 1 September 2005
- Published by Springer Nature in Instruments and Experimental Techniques
- Vol. 48 (5) , 679-682
Remark to the Intensity Measurement of RHEED
- 1 June 2003
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 37 (6) , 632-635
Defect profiling in semiconductor layers by the electrochemical method
Special based equipment for selective electrochemical etching is presented which is appropriate for in situ observation of the defect structure. The operation of the setup is demonstrated on InGaAs/GaAs (001) heteroepitaxial systems in which the epitaxial layer thickness is above the critical layer thickness. Through incremental layer removal, the depth profile of the dislocation density is mapped. The measured defect density is inversely proportional to the layer thickness and corresponds to the theoretical model.
- 1 June 2003
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 37 (6) , 632-635
Defect profiling in semiconductor layers by the electrochemical method
Special based equipment for selective electrochemical etching is presented which is appropriate for in situ observation of the defect structure. The operation of the setup is demonstrated on InGaAs/GaAs (001) heteroepitaxial systems in which the epitaxial layer thickness is above the critical layer thickness. Through incremental layer removal, the depth profile of the dislocation density is mapped. The measured defect density is inversely proportional to the layer thickness and corresponds to the theoretical model.
- 5 February 2003
- Published by Wiley in physica status solidi (c)
- No. 3,p. 857-861
Fabrication of a‐SiGe structure by rf sputtering for solar cell purposes
- 5 February 2003
- Published by Wiley in physica status solidi (c)
- No. 3,p. 857-861
Fabrication of a‐SiGe structure by rf sputtering for solar cell purposes
- 5 February 2003
- Published by Wiley in physica status solidi (c)
- No. 3,p. 967-969
Modelling of Cd 4 GeSe 6 –electrolyte junction for solar cell purposes
- 5 February 2003
- Published by Wiley in physica status solidi (c)
- No. 3,p. 967-969
Modelling of Cd 4 GeSe 6 –electrolyte junction for solar cell purposes
- 1 October 2001
- Published by Wiley in Crystal Research and Technology
- Vol. 36 (8-10) , 1011-1017
Influence of Lattice Mismatch and Growth Rate on the Decay of RHEED Oscillation in the Case of InGaAs/GaAs Growth
- 1 October 2001
- Published by Wiley in Crystal Research and Technology
- Vol. 36 (8-10) , 1011-1017
Influence of Lattice Mismatch and Growth Rate on the Decay of RHEED Oscillation in the Case of InGaAs/GaAs Growth