Zhe Chuan Feng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Zhe Chuan Feng has a total of 182 co-authors. Here are the top co-authors by number of shared publications:
S. J. Chua
Institute of Materials Research & Engineering, 3 Research Link, Singapore 117602
6 shared publicationsI. Ferguson
3) Electrical and Computer Engineering, Georgia Institute of Technology, Atlanta, Georgia 30332
5 shared publicationsJ. J. Song
Center for Laser and Photonics Research and Department of Physics, Oklahoma State University, Stillwater, Oklahoma 74078
3 shared publicationsM. Schurman
EMCORE Corporation, 394 Elizobeth Avenue, Somerest, New Jersey 08873
3 shared publicationsR. A. Stall
EMCORE Corporation, 394 Elizobeth Avenue, Somerest, New Jersey 08873
3 shared publications- W. Shan
Materials Sciences Division, Lawrence Berkeley National Laboratory, Berkeley, California 94720, USA
3 shared publications
Latest Publications
- 1 February 2013
- Published by Elsevier in Thin Solid Films
- Vol. 529, 269-274
Optical and structural studies of dual wavelength InGaN/GaN tunnel-injection light emitting diodes grown by metalorganic chemical vapor deposition
- 1 February 2013
- Published by Elsevier in Thin Solid Films
- Vol. 529, 269-274
Optical and structural studies of dual wavelength InGaN/GaN tunnel-injection light emitting diodes grown by metalorganic chemical vapor deposition
- 1 February 2009
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 105 (3) , 036102
Raman scattering study on anisotropic property of wurtzite GaN
The phonon anisotropy property of the GaN wurtzite crystal is studied using angular dependent Raman spectroscopy both theoretically and experimentally. The polarized Raman scattering spectra were recorded from the cross section of c-axis oriented GaN films as a function of the angle between the incident laser polarization direction and the film normal direction in three different configurations. The Raman intensity of A1(TO) showed a sinusoidal dependence on the rotating angle, as also did the E1(TO) mode, while the E2 mode has a quite different behavior. The theoretical analysis takes into account the susceptibility contribution and the phase differential of different vibrating elements.
- 1 February 2009
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 105 (3) , 036102
Raman scattering study on anisotropic property of wurtzite GaN
The phonon anisotropy property of the GaN wurtzite crystal is studied using angular dependent Raman spectroscopy both theoretically and experimentally. The polarized Raman scattering spectra were recorded from the cross section of c-axis oriented GaN films as a function of the angle between the incident laser polarization direction and the film normal direction in three different configurations. The Raman intensity of A1(TO) showed a sinusoidal dependence on the rotating angle, as also did the E1(TO) mode, while the E2 mode has a quite different behavior. The theoretical analysis takes into account the susceptibility contribution and the phase differential of different vibrating elements.
- 13 July 2007
- Published by Elsevier in Thin Solid Films
- Vol. 516 (16) , 5571-5576
Metal organic chemical vapor deposition and investigation of ZnO thin films grown on sapphire
- 13 July 2007
- Published by Elsevier in Thin Solid Films
- Vol. 516 (16) , 5571-5576
Metal organic chemical vapor deposition and investigation of ZnO thin films grown on sapphire
- 1 November 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 981-984
Synchrotron Radiation X-ray Diffraction and X-ray Photoelectron Spectroscopy Investigation on Si-based Structures for Sub-Micron Si-IC Applications
Synchrotron radiation X-ray diffraction and X-ray photoelectron spectroscopy techniques have been employed for the investigation on Si-based layer structures for sub-micron Si-IC Applications. The high energy synchrotron radiation light sources have produced plenty of X-ray lines with high index diffraction and strong X-ray photoelectron emissions. The useful information will increase our understanding of these materials which are applied extensively to the semiconductor industry.
- 1 November 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 981-984
Synchrotron Radiation X-ray Diffraction and X-ray Photoelectron Spectroscopy Investigation on Si-based Structures for Sub-Micron Si-IC Applications
Synchrotron radiation X-ray diffraction and X-ray photoelectron spectroscopy techniques have been employed for the investigation on Si-based layer structures for sub-micron Si-IC Applications. The high energy synchrotron radiation light sources have produced plenty of X-ray lines with high index diffraction and strong X-ray photoelectron emissions. The useful information will increase our understanding of these materials which are applied extensively to the semiconductor industry.
- 30 October 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 227-230
Structural and Optical Investigation of Copper Nanoparticle and Microfiber Produced by Using Carbon Nanotube as Templates
Copper nanoparticles and microfibers have been prepared by solid state reaction using carbon nanotube (CNT) as template. Their structural and optical properties were investigated by scanning and transmission electron microscopy, Raman scattering and X-ray diffraction (XRD). With the variation of the ratio of Cu to CNT, interesting Raman spectral shifts and intensity variation are observed, and a broad photoluminescence background is arisen. XRD revealed the contraction of the Cu lattice constant in the formation of nanoparticles and microfibers.
- 30 October 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 227-230
Structural and Optical Investigation of Copper Nanoparticle and Microfiber Produced by Using Carbon Nanotube as Templates
Copper nanoparticles and microfibers have been prepared by solid state reaction using carbon nanotube (CNT) as template. Their structural and optical properties were investigated by scanning and transmission electron microscopy, Raman scattering and X-ray diffraction (XRD). With the variation of the ratio of Cu to CNT, interesting Raman spectral shifts and intensity variation are observed, and a broad photoluminescence background is arisen. XRD revealed the contraction of the Cu lattice constant in the formation of nanoparticles and microfibers.
- 24 February 2006
- Published by Elsevier in Surface and Coatings Technology
- Vol. 200 (10) , 3245-3249
Luminescent characteristics of InGaAsP/InP multiple quantum well structures by impurity-free vacancy disordering
- 24 February 2006
- Published by Elsevier in Surface and Coatings Technology
- Vol. 200 (10) , 3245-3249
Luminescent characteristics of InGaAsP/InP multiple quantum well structures by impurity-free vacancy disordering
- 24 February 2006
- Published by Elsevier in Surface and Coatings Technology
- Vol. 200 (10) , 3103
The 3rd Asian Conference on Chemical Vapor Deposition (3rd Asian-CVD), Taipei, Taiwan, November 12–14, 2004
- 24 February 2006
- Published by Elsevier in Surface and Coatings Technology
- Vol. 200 (10) , 3103
The 3rd Asian Conference on Chemical Vapor Deposition (3rd Asian-CVD), Taipei, Taiwan, November 12–14, 2004
- 25 January 2006
- Published by Elsevier in Journal of Crystal Growth
- Vol. 287 (2) , 354-358
Study of carrier localization in InGaN/GaN quantum well blue-light-emitting diode structures
- 25 January 2006
- Published by Elsevier in Journal of Crystal Growth
- Vol. 287 (2) , 354-358
Study of carrier localization in InGaN/GaN quantum well blue-light-emitting diode structures
- 1 January 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 227-230
Structural and Optical Investigation of Copper Nanoparticle and Microfiber Produced by Using Carbon Nanotube as Templates
Copper nanoparticles and microfibers have been prepared by solid state reaction using carbon nanotube (CNT) as template. Their structural and optical properties were investigated by scanning and transmission electron microscopy, Raman scattering and X-ray diffraction (XRD). With the variation of the ratio of Cu to CNT, interesting Raman spectral shifts and intensity variation are observed, and a broad photoluminescence background is arisen. XRD revealed the contraction of the Cu lattice constant in the formation of nanoparticles and microfibers.
- 1 January 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 227-230
Structural and Optical Investigation of Copper Nanoparticle and Microfiber Produced by Using Carbon Nanotube as Templates
Copper nanoparticles and microfibers have been prepared by solid state reaction using carbon nanotube (CNT) as template. Their structural and optical properties were investigated by scanning and transmission electron microscopy, Raman scattering and X-ray diffraction (XRD). With the variation of the ratio of Cu to CNT, interesting Raman spectral shifts and intensity variation are observed, and a broad photoluminescence background is arisen. XRD revealed the contraction of the Cu lattice constant in the formation of nanoparticles and microfibers.
- 11 August 2005
- Published by Elsevier in Thin Solid Films
- Vol. 498 (1) , 1
The 3rd Asian Conference on Chemical Vapor Deposition (3rd Asian-CVD), Taipei, Taiwan, November 12–14, 2004
- 11 August 2005
- Published by Elsevier in Thin Solid Films
- Vol. 498 (1) , 1
The 3rd Asian Conference on Chemical Vapor Deposition (3rd Asian-CVD), Taipei, Taiwan, November 12–14, 2004