Dominique Thiaudiere
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Dominique Thiaudiere has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Damien Faurie
LSPM–CNRS, UPR3407, Université Sorbonne Paris Nord , 99 Avenue Jean–Baptiste Clément
3 shared publications - Eric Le Bourhis
Institut P’, CNRS - Université de Poitiers – ENSMA - UPR 3346, SP2MI-Téléport 2-Bd Marie et Pierre Curie, B.P. 30179, 86962 Futuroscope-Chasseneuil Cedex, France
3 shared publications - Philippe Goudeau
Université de Poitiers
3 shared publications - Pierre Olivier Renault
Institut Pprime, CNRS - Université de Poitiers - ENSMA 2 , Bd Marie et Pierre Curie, Futuroscope Cedex 86962
3 shared publications G. Geandier
2 shared publicationsA Zozulya
1 shared publication
Latest Publications
- Open Access
- 1 January 2018
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 25 (1) , 204-213
Fast X-ray reflectivity measurements using an X-ray pixel area detector at the DiffAbs beamline, Synchrotron SOLEIL
This paper describes a method for rapid measurements of the specular X-ray reflectivity signal using an area detector and a monochromatic, well collimated X-ray beam (divergence below 0.01°), combined with a continuous data acquisition mode during the angular movements of the sample and detector. In addition to the total integrated (and background-corrected) reflectivity signal, this approach yields a three-dimensional mapping of the reciprocal space in the vicinity of its origin. Grazing-incidence small-angle scattering signals are recorded simultaneously. Measurements up to high momentum transfer values (close to 0.1 nm−1, also depending on the X-ray beam energy) can be performed in total time ranges as short as 10 s. The measurement time can be reduced by up to 100 times as compared with the classical method using monochromatic X-ray beams, a point detector and rocking scans (integrated reflectivity signal).
- 1 January 2018
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 25 (1) , 204-213
Open AccessFast X-ray reflectivity measurements using an X-ray pixel area detector at the DiffAbs beamline, Synchrotron SOLEIL
This paper describes a method for rapid measurements of the specular X-ray reflectivity signal using an area detector and a monochromatic, well collimated X-ray beam (divergence below 0.01°), combined with a continuous data acquisition mode during the angular movements of the sample and detector. In addition to the total integrated (and background-corrected) reflectivity signal, this approach yields a three-dimensional mapping of the reciprocal space in the vicinity of its origin. Grazing-incidence small-angle scattering signals are recorded simultaneously. Measurements up to high momentum transfer values (close to 0.1 nm−1, also depending on the X-ray beam energy) can be performed in total time ranges as short as 10 s. The measurement time can be reduced by up to 100 times as compared with the classical method using monochromatic X-ray beams, a point detector and rocking scans (integrated reflectivity signal).
- Open Access
- 1 August 2014
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 996, 878-883
Time-Resolved X-Ray Stress Analysis in Multilayered Thin Films during Continuous Loading: Use of 2D Remote Detection
Synchrotron X-ray diffraction is a powerful tool to analyse the mechanical behavior of multiphase materials due to its selectivity. Simultaneous stress analysis of both phases of a W/Cu thin multilayer has been performed during a continuous biaxial loading on DiffAbs beamline at SOLEIL synchrotron (France). The use of a 2D detector with a large sample-detector distance is shown to give relatively accurate applied stress analysis even if only a small part of the usual ψ range of the sin2ψ method is considered. The results show the failure of the thin film multilayer while the W components are still under a strong compressive stress state of-3 GPa. It is concluded that the mechanical behavior is in fact mainly governed by the residual stress state.
- 1 August 2014
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 996, 878-883
Open AccessTime-Resolved X-Ray Stress Analysis in Multilayered Thin Films during Continuous Loading: Use of 2D Remote Detection
Synchrotron X-ray diffraction is a powerful tool to analyse the mechanical behavior of multiphase materials due to its selectivity. Simultaneous stress analysis of both phases of a W/Cu thin multilayer has been performed during a continuous biaxial loading on DiffAbs beamline at SOLEIL synchrotron (France). The use of a 2D detector with a large sample-detector distance is shown to give relatively accurate applied stress analysis even if only a small part of the usual ψ range of the sin2ψ method is considered. The results show the failure of the thin film multilayer while the W components are still under a strong compressive stress state of-3 GPa. It is concluded that the mechanical behavior is in fact mainly governed by the residual stress state.
- 1 July 2014
- Published by Elsevier in Applied Surface Science
- Vol. 306, 70-74
Mastering the biaxial stress state in nanometric thin films on flexible substrates
- 1 July 2014
- Published by Elsevier in Applied Surface Science
- Vol. 306, 70-74
Mastering the biaxial stress state in nanometric thin films on flexible substrates
- 9 September 2011
- Published by Taylor & Francis
- p. 353-358
In-situ synchrotron X-ray diffraction study of strain-induced crystallization of natural rubber during fatigue tests
- 9 September 2011
- Published by Taylor & Francis
- p. 353-358
In-situ synchrotron X-ray diffraction study of strain-induced crystallization of natural rubber during fatigue tests
- 25 November 2010
- Published by Elsevier in Surface and Coatings Technology
- Vol. 205 (5) , 1420-1425
Controlled biaxial deformation of nanostructured W/Cu thin films studied by X-ray diffraction
- 25 November 2010
- Published by Elsevier in Surface and Coatings Technology
- Vol. 205 (5) , 1420-1425
Controlled biaxial deformation of nanostructured W/Cu thin films studied by X-ray diffraction