Peter G. Pickup
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Peter G. Pickup has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
Mark C. Lefebvre
Department of Chemistry, Memorial University of Newfoundland, St. John's, Newfoundland, Canada A1B 3X7
2 shared publicationsZhigang Qi
H‐Power Corp., Belleville, New Jersey, United States America
2 shared publications- E. Bradley Easton
Ontario Tech University
1 shared publication Guangchun Li
Department of Chemistry, Memorial University of Newfoundland, St. John's, Newfoundland, Canada
1 shared publicationJohn Halfyard
Department of Chemistry Memorial University of Newfoundland St. John's A1B 3X7 Newfoundland Canada
1 shared publicationNengyou Jia
Metallic Power, Carlsbad, California, United States America
1 shared publication
Latest Publications
- 24 February 2000
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 2 (6) , 1255-1260
Ion transport in poly(3,4-ethylenedioxythiophene)–poly(styrene-4-sulfonate) composites
The ion transport properties and electrochemistry of both chemically prepared and electrochemically prepared poly(3,4-ethylenedioxythiophene)–poly(styrene-4-sulfonate) composites have been investigated by cyclic voltammetry and impedance spectroscopy in a variety of electrolyte solutions. The polymers exhibited facile electrochemistry, fast ion transport, and good electrochemical stability. The ionic conductivities of the polymers are strongly dependent on the concentration and conductivity of the electrolyte solution used. At low electrolyte concentrations, the ionic conductivities of these polymers also show some potential dependence. Ion transport in chemically prepared layers was found to be much faster than in electrochemically prepared films. The high ionic conductivities of the polymers are shown to be due to their very porous structure and electrolytes in pores.
- 24 February 2000
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 2 (6) , 1255-1260
Ion transport in poly(3,4-ethylenedioxythiophene)–poly(styrene-4-sulfonate) composites
The ion transport properties and electrochemistry of both chemically prepared and electrochemically prepared poly(3,4-ethylenedioxythiophene)–poly(styrene-4-sulfonate) composites have been investigated by cyclic voltammetry and impedance spectroscopy in a variety of electrolyte solutions. The polymers exhibited facile electrochemistry, fast ion transport, and good electrochemical stability. The ionic conductivities of the polymers are strongly dependent on the concentration and conductivity of the electrolyte solution used. At low electrolyte concentrations, the ionic conductivities of these polymers also show some potential dependence. Ion transport in chemically prepared layers was found to be much faster than in electrochemically prepared films. The high ionic conductivities of the polymers are shown to be due to their very porous structure and electrolytes in pores.
- Open Access
- 1 January 1999
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 3 (12) , 529-531
Modification of Nafion Proton Exchange Membranes to Reduce Methanol Crossover in PEM Fuel Cells
Commercial sulfonated fluorocarbon membranes (Nafion) have been impregnated with poly(1‐methylpyrrole) by in situ polymerization. This can lead to a decrease of more than 90% in the permeability of the membranes to methanol, although the ionic resistance of such heavily loaded membranes becomes too high for high power fuel cells. At lower poly(1‐methylpyrrole) loadings, a decrease in methanol permeability by as much as 50% can be realized without a significant increase in ionic resistance. Such modified membranes can provide comparable performances to the original membranes in hydrogen fuel cells. ©2000 The Electrochemical Society
- 1 January 1999
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 3 (12) , 529-531
Open AccessModification of Nafion Proton Exchange Membranes to Reduce Methanol Crossover in PEM Fuel Cells
Commercial sulfonated fluorocarbon membranes (Nafion) have been impregnated with poly(1‐methylpyrrole) by in situ polymerization. This can lead to a decrease of more than 90% in the permeability of the membranes to methanol, although the ionic resistance of such heavily loaded membranes becomes too high for high power fuel cells. At lower poly(1‐methylpyrrole) loadings, a decrease in methanol permeability by as much as 50% can be realized without a significant increase in ionic resistance. Such modified membranes can provide comparable performances to the original membranes in hydrogen fuel cells. ©2000 The Electrochemical Society
- 1 January 1999
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 3 (8) , 359-361
Chemically Modified Gas Diffusion Electrodes Probing Electrochemical Activity in Proton Exchange Membrane Fuel Cells
Two examples of chemically modified gas diffusion electrodes are presented to demonstrate the value of electrode functionalization methods in the study of fuel cells. In one example, has been added to the ionomer binder in the active layer of the electrode to measure the fraction of this ionomer that participates in ion transport within the layer. A lower fraction of the complex was electrochemically active in the cathode of an operating fuel cell, compared to a similar electrode that was in contact with an aqueous sulfuric acid solution. The difference is attributed to poor hydration of the fuel cell electrode. In a second example, a complex has been covalently attached to a carbon‐black fuel cell catalyst support to allow measurement of the fraction of the carbon surface that is in both electronic and ionic contact with the current collector and membrane. respectively. ©2000 The Electrochemical Society
- 1 January 1999
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 3 (8) , 359-361
Chemically Modified Gas Diffusion Electrodes Probing Electrochemical Activity in Proton Exchange Membrane Fuel Cells
Two examples of chemically modified gas diffusion electrodes are presented to demonstrate the value of electrode functionalization methods in the study of fuel cells. In one example, has been added to the ionomer binder in the active layer of the electrode to measure the fraction of this ionomer that participates in ion transport within the layer. A lower fraction of the complex was electrochemically active in the cathode of an operating fuel cell, compared to a similar electrode that was in contact with an aqueous sulfuric acid solution. The difference is attributed to poor hydration of the fuel cell electrode. In a second example, a complex has been covalently attached to a carbon‐black fuel cell catalyst support to allow measurement of the fraction of the carbon surface that is in both electronic and ionic contact with the current collector and membrane. respectively. ©2000 The Electrochemical Society
- 1 January 1999
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 2 (6) , 259-261
Characterization of Ionic Conductivity Profiles within Proton Exchange Membrane Fuel Cell Gas Diffusion Electrodes by Impedance Spectroscopy
Experimental impedance data recorded for operating cathodes in proton exchange membrane fuel cells have been interpreted with the aid of a finite transmission‐line model in which the ionic conductivity of the catalyst layer decreases with distance from the membrane. By purging the cathode compartment of the cell with nitrogen during measurements, the impedance response becomes dominated by charging of the catalyst's double layer through the layer's ionic resistance. Fitting of simulated data to the experimental data provides a profile of the variation of the catalyst layer's ionic conductivity with distance from the membrane. The power of this approach is demonstrated by comparing data for electrodes with and without impregnated ionomer (Nafion). The Nafion‐containing electrode is shown to have a much higher ionic conductivity, and, consequently, has a larger active catalyst area and provides better fuel cell performance. Furthermore, its ionic conductivity decreases with distance from the membrane, consistent with the nonuniform Nafion impregnation expected with the immersion method used. ©1999 The Electrochemical Society
- 1 January 1999
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 2 (6) , 259-261
Characterization of Ionic Conductivity Profiles within Proton Exchange Membrane Fuel Cell Gas Diffusion Electrodes by Impedance Spectroscopy
Experimental impedance data recorded for operating cathodes in proton exchange membrane fuel cells have been interpreted with the aid of a finite transmission‐line model in which the ionic conductivity of the catalyst layer decreases with distance from the membrane. By purging the cathode compartment of the cell with nitrogen during measurements, the impedance response becomes dominated by charging of the catalyst's double layer through the layer's ionic resistance. Fitting of simulated data to the experimental data provides a profile of the variation of the catalyst layer's ionic conductivity with distance from the membrane. The power of this approach is demonstrated by comparing data for electrodes with and without impregnated ionomer (Nafion). The Nafion‐containing electrode is shown to have a much higher ionic conductivity, and, consequently, has a larger active catalyst area and provides better fuel cell performance. Furthermore, its ionic conductivity decreases with distance from the membrane, consistent with the nonuniform Nafion impregnation expected with the immersion method used. ©1999 The Electrochemical Society
- 14 April 1998
- Published by Elsevier in Electrochimica Acta
- Vol. 43 (9) , 1005-1012
Ion transport competition in ionomer filmsloaded with Fe(CN)3−/4−6
- 14 April 1998
- Published by Elsevier in Electrochimica Acta
- Vol. 43 (9) , 1005-1012
Ion transport competition in ionomer filmsloaded with Fe(CN)3−/4−6