Alan Naughton
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Alan Naughton has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- Giuseppe Talli
Huawei Heisenberg Research Center (Munich), Munich, Germany
3 shared publications - Paul D. Townsend
University College Cork
3 shared publications - Cleitus Antony
University College Cork
2 shared publications A. Borghesani
CIP Technologies Adastral Park, Martlesham Heath Ipswich IP5 3RE United Kingdom
1 shared publication- Aude Martin
Thales Research and Technology (TRT), Campus Polytechnique, Palaiseau, France
1 shared publication C.P. Lai
Photonics Systems Group Tyndall National Institute and University College Cork Cork Ireland
1 shared publication
Latest Publications
- Top Cited PapersOpen Access
- 28 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 36 (19) , 4640-4645
Photonic Integrated Circuit-Based FMCW Coherent LiDAR
We present the demonstration of an integrated Frequency Modulated Continuous Wave LiDAR on a silicon platform. The waveform calibration, the scanning system and the balanced detectors are implemented on chip. Detection and ranging of a moving hard target at up to 60 m with less than 5 mW of output power is demonstrated here.
- 28 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 36 (19) , 4640-4645
Top Cited PapersOpen AccessPhotonic Integrated Circuit-Based FMCW Coherent LiDAR
We present the demonstration of an integrated Frequency Modulated Continuous Wave LiDAR on a silicon platform. The waveform calibration, the scanning system and the balanced detectors are implemented on chip. Detection and ranging of a moving hard target at up to 60 m with less than 5 mW of output power is demonstrated here.
- Open Access
- 1 April 2016
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 52 (8) , 637-639
Demonstration of multi‐channel 80 Gbit/s integrated transmitter and receiver for wavelength‐division multiplexing passive optical network and fronthauling applications
The performance evaluation of a multi‐channel transmitter that employs an arrayed reflective electroabsorption modulator‐based photonic integrated circuit and a low‐power driver array in conjunction with a multi‐channel receiver incorporating a pin photodiode array and integrated arrayed waveguide grating is reported. Due to their small footprint, low power consumption and potential low cost, these devices are attractive solutions for future mobile fronthaul and next generation optical access networks. A BER performance of −9 at 10.3 Gbit/s per channel is achieved over 25 km of standard single mode fibre. The transmitter/receiver combination can achieve an aggregate bit rate of 82.4 Gbit/s when eight channels are active.
- 1 April 2016
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 52 (8) , 637-639
Open AccessDemonstration of multi‐channel 80 Gbit/s integrated transmitter and receiver for wavelength‐division multiplexing passive optical network and fronthauling applications
The performance evaluation of a multi‐channel transmitter that employs an arrayed reflective electroabsorption modulator‐based photonic integrated circuit and a low‐power driver array in conjunction with a multi‐channel receiver incorporating a pin photodiode array and integrated arrayed waveguide grating is reported. Due to their small footprint, low power consumption and potential low cost, these devices are attractive solutions for future mobile fronthaul and next generation optical access networks. A BER performance of −9 at 10.3 Gbit/s per channel is achieved over 25 km of standard single mode fibre. The transmitter/receiver combination can achieve an aggregate bit rate of 82.4 Gbit/s when eight channels are active.
- 11 September 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 32 (22) , 4386-4392
Design Optimization of R-EAM-SOA for Long-Reach Carrier-Distributed Passive Optical Networks
Reflective electro-absorption modulators (R-EAMs) monolithically integrated with semiconductor optical amplifiers (SOAs) have strong potential as upstream transmitter in carrier-distributed long-reach passive optical networks (PONs). In these devices, the SOA provides the gain necessary to overcome the high loss of the PON power splitters, while the EAM allows the high speed and low chirp modulation required for long-reach PONs. It has previously been shown that purposely adding internal loss between the R-EAM and SOA compresses the burst-to-burst dynamic range on the upstream channels of the PON and that the SOA gain and the internal loss value between the SOA and the reflective surface are the key parameters which control this behavior. Dynamic range compression is an essential feature for carrier-distributed PONs, since both the carrier and the modulated signal experience the differential loss travelling through the optical distribution network of the PON. Other features of these modulators, which are also critical for the PON operation such as the output power and the patterning distortion, are also dependent on the SOA gain and internal loss value. In this paper, we demonstrate that careful design of the SOA gain and internal loss can provide an optimum balance between dynamic range compression, output power, and patterning distortion reduction. We model the R-EAM-SOA device in a network whose differential access loss is 15 dB. The dynamic range at the burst-mode receiver, using the optimized R-EAM-SOA, is found to be ~12 dB, well within the capabilities of current burst-mode receiver designs. The optimum SOA gain is 24 dB, and the device has an internal loss in the range of 21 to 24 dB.
- 11 September 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 32 (22) , 4386-4392
Design Optimization of R-EAM-SOA for Long-Reach Carrier-Distributed Passive Optical Networks
Reflective electro-absorption modulators (R-EAMs) monolithically integrated with semiconductor optical amplifiers (SOAs) have strong potential as upstream transmitter in carrier-distributed long-reach passive optical networks (PONs). In these devices, the SOA provides the gain necessary to overcome the high loss of the PON power splitters, while the EAM allows the high speed and low chirp modulation required for long-reach PONs. It has previously been shown that purposely adding internal loss between the R-EAM and SOA compresses the burst-to-burst dynamic range on the upstream channels of the PON and that the SOA gain and the internal loss value between the SOA and the reflective surface are the key parameters which control this behavior. Dynamic range compression is an essential feature for carrier-distributed PONs, since both the carrier and the modulated signal experience the differential loss travelling through the optical distribution network of the PON. Other features of these modulators, which are also critical for the PON operation such as the output power and the patterning distortion, are also dependent on the SOA gain and internal loss value. In this paper, we demonstrate that careful design of the SOA gain and internal loss can provide an optimum balance between dynamic range compression, output power, and patterning distortion reduction. We model the R-EAM-SOA device in a network whose differential access loss is 15 dB. The dynamic range at the burst-mode receiver, using the optimized R-EAM-SOA, is found to be ~12 dB, well within the capabilities of current burst-mode receiver designs. The optimum SOA gain is 24 dB, and the device has an internal loss in the range of 21 to 24 dB.
- 6 December 2011
- Published by Optica Publishing Group in Optics Express
- Vol. 19 (26) , B722-B727
Optimisation of SOA-REAMs for Hybrid DWDM-TDMA PON Applications
Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.
- 6 December 2011
- Published by Optica Publishing Group in Optics Express
- Vol. 19 (26) , B722-B727
Optimisation of SOA-REAMs for Hybrid DWDM-TDMA PON Applications
Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.