N. S. Saxena
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
N. S. Saxena has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
K. Singh
Department of Physics , Banaras Hindu University , Varanasi, UP, India
4 shared publicationsS. Thomas
School of Chemical Science, M. G. University, Kottayam 686560, Kerala, India
3 shared publicationsKedar Singh
Condensed Matter Physics Laboratory, Department of Physics, University of Rajasthan, Jaipur, 302004, India
2 shared publicationsM. S. Sreekala
Rubber Research Institute of India, Kottyam 686009, Kerala, India
2 shared publicationsR. Mangal
Condensed Matter Physics Laboratory, Dungar College, Bikaner‐334001
2 shared publicationsT. P. Sharma
University of Rajasthan
2 shared publications
Latest Publications
- 1 April 2011
- Published by Taylor & Francis in Radiation Effects and Defects in Solids
- Vol. 166 (4) , 251-257
Effect of high energetic ionic irradiation in thermally activated crystallization of Co 66 Si 15 B 14 Fe 4 Ni 1 metallic glass: observation of the MN rule
This paper reports the Meyer–Neldel relation between the pre-exponential factor and the activation energy of non-isothermal crystallization of Co66Si15B14Fe4Ni1 metallic glass. A differential scanning calorimeter is employed to study the change in the above two kinetic parameters of the crystallization due to ionic irradiation at three different fluences with high-energy heavy ions (Ni11+ of 150 MeV).
- 1 April 2011
- Published by Taylor & Francis in Radiation Effects and Defects in Solids
- Vol. 166 (4) , 251-257
Effect of high energetic ionic irradiation in thermally activated crystallization of Co 66 Si 15 B 14 Fe 4 Ni 1 metallic glass: observation of the MN rule
This paper reports the Meyer–Neldel relation between the pre-exponential factor and the activation energy of non-isothermal crystallization of Co66Si15B14Fe4Ni1 metallic glass. A differential scanning calorimeter is employed to study the change in the above two kinetic parameters of the crystallization due to ionic irradiation at three different fluences with high-energy heavy ions (Ni11+ of 150 MeV).
- 12 July 2010
- Published by AIP Publishing
- Vol. 1249 (1) , 103
Comparative Study of Thermomechanical Properties of Indigenous Blended Clay and Clay of Ukraine
This paper investigates the particle size distribution, chemical composition, fired modulus of rupture (MOR), and apparent porosity of blended clay utilizing clays available in Bikaner region and comparison with a imported Ukrainian clay. The blended clay B2 presents good white buff fired colour, higher fired modulus of rupture, and low porosity. The blend is suitable for Traditional Indian ceramic industries and a substitute of Ukrainian clay in India.
- 12 July 2010
- Published by AIP Publishing
- Vol. 1249 (1) , 103
Comparative Study of Thermomechanical Properties of Indigenous Blended Clay and Clay of Ukraine
This paper investigates the particle size distribution, chemical composition, fired modulus of rupture (MOR), and apparent porosity of blended clay utilizing clays available in Bikaner region and comparison with a imported Ukrainian clay. The blended clay B2 presents good white buff fired colour, higher fired modulus of rupture, and low porosity. The blend is suitable for Traditional Indian ceramic industries and a substitute of Ukrainian clay in India.
- 1 November 2008
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 403 (21-22) , 3928-3931
Comparative analysis of thermal crystallization in Cu50Ti50 and Cu50Zr50 metallic glasses
- 1 November 2008
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 403 (21-22) , 3928-3931
Comparative analysis of thermal crystallization in Cu50Ti50 and Cu50Zr50 metallic glasses
- 1 January 2005
- Published by Springer Nature in Journal of Materials Science
- Vol. 40 (2) , 523-524
Effective thermal conductivity and effective thermal diffusivity of Se100 ? xZnx chalcogenide system
- 1 January 2005
- Published by Springer Nature in Journal of Materials Science
- Vol. 40 (2) , 523-524
Effective thermal conductivity and effective thermal diffusivity of Se100 ? xZnx chalcogenide system
- 5 August 2003
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 90 (2) , 430-435
Measurement of thermal properties of polyaniline/metal from room temperature to 170°C
- 5 August 2003
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 90 (2) , 430-435
Measurement of thermal properties of polyaniline/metal from room temperature to 170°C
- 15 July 2003
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 89 (13) , 3458-3463
Temperature dependence of the thermal conductivity and thermal diffusivity of treated oil‐palm‐fiber‐reinforced phenolformaldehyde composites
The effective thermal conductivity (λe) and effective thermal diffusivity (χe) of oil‐palm‐fiber‐reinforced treated composites were measured simultaneously with the transient plane source technique from 50 to 110°C. The fibers of the composites were treated with sodium hydroxide alkali, silanol, and acetic acid. The experimental results for the different treated composites showed that there were variations in λe and χe over this temperature range. However, the maximum values of λe and χe were observed at 90°C, in the vicinity of the glass‐transition temperatures of these composites. An effort was also made to predict the temperature dependence of λe and χe through the development of an empirical model. The theoretically predicted values of λe and χe for these composites were in excellent agreement with the experimental results over the entire range of investigated temperatures. Sudden increases in λe and χe in the glass‐transition region of these composites were indicative of the fact that the crosslinking density decreased and was at a minimum at the temperature at which λe and χe showed their maxima. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 3458–3463, 2003
- 15 July 2003
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 89 (13) , 3458-3463
Temperature dependence of the thermal conductivity and thermal diffusivity of treated oil‐palm‐fiber‐reinforced phenolformaldehyde composites
The effective thermal conductivity (λe) and effective thermal diffusivity (χe) of oil‐palm‐fiber‐reinforced treated composites were measured simultaneously with the transient plane source technique from 50 to 110°C. The fibers of the composites were treated with sodium hydroxide alkali, silanol, and acetic acid. The experimental results for the different treated composites showed that there were variations in λe and χe over this temperature range. However, the maximum values of λe and χe were observed at 90°C, in the vicinity of the glass‐transition temperatures of these composites. An effort was also made to predict the temperature dependence of λe and χe through the development of an empirical model. The theoretically predicted values of λe and χe for these composites were in excellent agreement with the experimental results over the entire range of investigated temperatures. Sudden increases in λe and χe in the glass‐transition region of these composites were indicative of the fact that the crosslinking density decreased and was at a minimum at the temperature at which λe and χe showed their maxima. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 3458–3463, 2003
- 23 May 2003
- Published by Elsevier in Acta Materialia
- Vol. 51 (9) , 2569-2576
Temperature dependence of effective thermal conductivity and effective thermal diffusivity of Ni-Zn ferrites
- 23 May 2003
- Published by Elsevier in Acta Materialia
- Vol. 51 (9) , 2569-2576
Temperature dependence of effective thermal conductivity and effective thermal diffusivity of Ni-Zn ferrites
- 23 May 2003
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 89 (6) , 1708-1714
Temperature dependence of effective thermal conductivity and thermal diffusivity of treated and untreated polymer composites
Thermal properties, such as thermal conductivity, thermal diffusivity, and specific heat, of treated and untreated oil palm fiber–reinforced PF composites were measured simultaneously at room temperature and normal pressure using the transient plane source (TPS) technique. An increase in thermal conductivity was observed in the fiber‐treated and resin‐treated composites. Surface modifications of fibers by prealkali, potassium permanganate, and peroxide treatments increased the fiber–matrix adhesion by increasing porosity and pore size of the fiber surfaces. The increase in crosslinking enhanced the thermal conductivity of a composite of resin treated with peroxide compared to other composites. Also an attempt was made to explain the temperature dependence of thermal conductivity and thermal diffusivity of amorphous polymer samples using the same technique. It was observed that at the glass‐transition peak of the polymer, thermal conductivity and diffusivity were maximum. Below and above this temperature their values decreased. This has been explained on the basis of predominant scattering processes. An empirical relationship was established for the theoretical prediction of thermal conductivity and diffusivity. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 1708–1714, 2003
- 23 May 2003
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 89 (6) , 1708-1714
Temperature dependence of effective thermal conductivity and thermal diffusivity of treated and untreated polymer composites
Thermal properties, such as thermal conductivity, thermal diffusivity, and specific heat, of treated and untreated oil palm fiber–reinforced PF composites were measured simultaneously at room temperature and normal pressure using the transient plane source (TPS) technique. An increase in thermal conductivity was observed in the fiber‐treated and resin‐treated composites. Surface modifications of fibers by prealkali, potassium permanganate, and peroxide treatments increased the fiber–matrix adhesion by increasing porosity and pore size of the fiber surfaces. The increase in crosslinking enhanced the thermal conductivity of a composite of resin treated with peroxide compared to other composites. Also an attempt was made to explain the temperature dependence of thermal conductivity and thermal diffusivity of amorphous polymer samples using the same technique. It was observed that at the glass‐transition peak of the polymer, thermal conductivity and diffusivity were maximum. Below and above this temperature their values decreased. This has been explained on the basis of predominant scattering processes. An empirical relationship was established for the theoretical prediction of thermal conductivity and diffusivity. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 1708–1714, 2003
- 20 January 2003
- Published by Wiley in Physica Status Solidi (a)
- Vol. 195 (2) , 305-310
Calorimetric studies in Se75Te25xSnx chalcogenide glasses
- 20 January 2003
- Published by Wiley in Physica Status Solidi (a)
- Vol. 195 (2) , 305-310
Calorimetric studies in Se75Te25xSnx chalcogenide glasses
- 1 January 2002
- Published by Wiley in Physica Status Solidi (a)
- Vol. 189 (1) , 197-202
Simultaneous Measurements of Thermal Conductivity and Diffusivity of Se85-xTe15Sbx (x = 2, 4, 6, 8, and 10) Chalcogenide Glasses at Room Temperature
- 1 January 2002
- Published by Wiley in Physica Status Solidi (a)
- Vol. 189 (1) , 197-202
Simultaneous Measurements of Thermal Conductivity and Diffusivity of Se85-xTe15Sbx (x = 2, 4, 6, 8, and 10) Chalcogenide Glasses at Room Temperature