T. Soga
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
T. Soga has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
T. Jimbo
Dept. of Environ. Technol. & Urban Planning, Nagoya Inst. of Technol., Japan
21 shared publicationsM. Umeno
16 shared publicationsK. Baskar
Research Center for Micro-Structure Devices, NIT, Japan
4 shared publications- Mohamad Rusop
Nagoya Institute of Technology
4 shared publications T. Egawa
Research Center for Micro-Structure Devices, Nagoya Institute of Technology, Gokiso-cho, Showa-ku, Nagoya 466, Japan
4 shared publications- Yasuhiko Hayashi
Graduate School of Natural Science and Technology, Okayama University, Okayama, Japan
3 shared publications
Latest Publications
- Open Access
- 30 March 2008
- Published by Korean Carbon Society in Carbon Letters
- Vol. 9 (1) , 17-22
Laser Ablated Carbon Thin Film from Carbon Nanotubes and Their Property Studies
- 30 March 2008
- Published by Korean Carbon Society in Carbon Letters
- Vol. 9 (1) , 17-22
Open AccessLaser Ablated Carbon Thin Film from Carbon Nanotubes and Their Property Studies
- 23 April 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 343-347
Properties of p-C:B films using graphite target and fabrication of p-C:B/n-Si heterojunction solar cells
This paper reports on the successful deposition of boron (B)-doped p-type amorphous carbon (p-C:B) films, and fabrication of p-C:B/n-Si by pulsed laser deposition (PLD) using graphite target. The cells performances have been given in the dark I-V rectifying curve and I-V working curve under illumination when exposed to AM 1.5 illumination condition (100 mW/cm/sup 2/, 25/spl deg/C). The open circuit voltage (V/sub oc/) and short circuit current density (J/sub sc/) for p-C:B/n-Si are observed to vary from 230 to 250 mV. The p-C:B/n-Si cell fabricated using the target with the amount of B by 3 weight percentages (Bwt%) shows highest energy conversion efficiency, /spl eta/=0.20% and fill factor, FF=45%. The quantum efficiency (QE) of the p-C:B/n-Si cells are observed to improve with Bwt%.
- 23 April 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 343-347
Properties of p-C:B films using graphite target and fabrication of p-C:B/n-Si heterojunction solar cells
This paper reports on the successful deposition of boron (B)-doped p-type amorphous carbon (p-C:B) films, and fabrication of p-C:B/n-Si by pulsed laser deposition (PLD) using graphite target. The cells performances have been given in the dark I-V rectifying curve and I-V working curve under illumination when exposed to AM 1.5 illumination condition (100 mW/cm/sup 2/, 25/spl deg/C). The open circuit voltage (V/sub oc/) and short circuit current density (J/sub sc/) for p-C:B/n-Si are observed to vary from 230 to 250 mV. The p-C:B/n-Si cell fabricated using the target with the amount of B by 3 weight percentages (Bwt%) shows highest energy conversion efficiency, /spl eta/=0.20% and fill factor, FF=45%. The quantum efficiency (QE) of the p-C:B/n-Si cells are observed to improve with Bwt%.
- 23 April 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 338-342
Studies on the a-C:B films prepared by PLD using camphoric carbon target
The boron (B) doped amorphous carbon (a-C:B) films have been grown by pulsed laser deposition (PLD) using camphoric carbon target at room temperature. The deposited films have been investigated using standard measurement techniques and the effects of B percentages by weight in the target (Bwt%) are discussed. The variation of structural properties, optical gap (E/sub g/) and electrical resistivity (/spl rho/) are related to successful doping of B for low content of B in the amorphous carbon (a-C) films as the structural and E/sub g/ remain almost unchanged, and the /spl rho/ decreased till for the film deposited at 10 Bwt%. Since both the E/sub g/ and /spl rho/ are decreased sharply with higher Bwt%, this phenomenon can be related due to the graphitization.
- 23 April 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 338-342
Studies on the a-C:B films prepared by PLD using camphoric carbon target
The boron (B) doped amorphous carbon (a-C:B) films have been grown by pulsed laser deposition (PLD) using camphoric carbon target at room temperature. The deposited films have been investigated using standard measurement techniques and the effects of B percentages by weight in the target (Bwt%) are discussed. The variation of structural properties, optical gap (E/sub g/) and electrical resistivity (/spl rho/) are related to successful doping of B for low content of B in the amorphous carbon (a-C) films as the structural and E/sub g/ remain almost unchanged, and the /spl rho/ decreased till for the film deposited at 10 Bwt%. Since both the E/sub g/ and /spl rho/ are decreased sharply with higher Bwt%, this phenomenon can be related due to the graphitization.
- 1 January 2004
- Published by Springer Nature in MRS Proceedings
- Vol. 836
1MeV electron irradiation effects of GaAs/Si solar cells
- 1 January 2004
- Published by Springer Nature in MRS Proceedings
- Vol. 836
1MeV electron irradiation effects of GaAs/Si solar cells
- 23 September 2003
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 80 (3) , 383-389
Fabrication of a solid-state cell using vitamin C as sensitizer
- 23 September 2003
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 80 (3) , 383-389
Fabrication of a solid-state cell using vitamin C as sensitizer
- 27 May 2003
- Published by AIP Publishing in Applied Physics Letters
- Vol. 82 (22) , 3892-3894
GaAs film on Si substrate transplanted from GaAs/Ge structure by direct bonding
A process to transplant GaAs film from a Ge substrate to Si substrate using a direct bonding method is proposed. The scanning electron microscopy picture shows that the GaAs film is uniformly transplanted from Ge to Si. The high-resolution transmission electron microscopy image shows that GaAs is connected to Si by the covalent bonds. The stress of the bonded GaAs on Si is compared with GaAs/GaAs and heteroepitaxially grown GaAs/Ge(before bonding) by a 4.2 K photoluminescence method. The difference in the residual stress between the bonded GaAs/Si sample and GaAs/Si grown by two-step growth is explained by a thermal stress relaxation mechanism during the cooling process.
- 27 May 2003
- Published by AIP Publishing in Applied Physics Letters
- Vol. 82 (22) , 3892-3894
GaAs film on Si substrate transplanted from GaAs/Ge structure by direct bonding
A process to transplant GaAs film from a Ge substrate to Si substrate using a direct bonding method is proposed. The scanning electron microscopy picture shows that the GaAs film is uniformly transplanted from Ge to Si. The high-resolution transmission electron microscopy image shows that GaAs is connected to Si by the covalent bonds. The stress of the bonded GaAs on Si is compared with GaAs/GaAs and heteroepitaxially grown GaAs/Ge(before bonding) by a 4.2 K photoluminescence method. The difference in the residual stress between the bonded GaAs/Si sample and GaAs/Si grown by two-step growth is explained by a thermal stress relaxation mechanism during the cooling process.
- 23 December 2002
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 93 (1) , 101-105
Optical properties of nanocrystalline diamond films by prism coupling technique
Measurement of optical properties such as the refractive index and thickness of nanocrystalline or smooth diamond films is carried out by the prism coupling technique. The films observed to be absorbing for a standard operating wavelength of 633 nm and higher wavelengths, i.e., 830 and 1300 nm, were used to obtain sharp guided modes and the refractive index and thickness of the films could be measured independently with high accuracy. The index of the nanocrystalline diamond films was found to be homogeneous within the films with negligible changes observed at the film–substrate interface. Information on absorption was also obtained from the half width of the guided modes and was correlated to the graphitic concentration of the films measured by Raman spectroscopy. The thickness measured by the prism coupling technique was found to be in agreement with the thickness measured by cross-sectional transmission electron microscopy. The overall results indicate that the prism coupling technique can be very useful for rapid, easy accurate measurement of the refractive index and thickness of smooth diamond films.
- 23 December 2002
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 93 (1) , 101-105
Optical properties of nanocrystalline diamond films by prism coupling technique
Measurement of optical properties such as the refractive index and thickness of nanocrystalline or smooth diamond films is carried out by the prism coupling technique. The films observed to be absorbing for a standard operating wavelength of 633 nm and higher wavelengths, i.e., 830 and 1300 nm, were used to obtain sharp guided modes and the refractive index and thickness of the films could be measured independently with high accuracy. The index of the nanocrystalline diamond films was found to be homogeneous within the films with negligible changes observed at the film–substrate interface. Information on absorption was also obtained from the half width of the guided modes and was correlated to the graphitic concentration of the films measured by Raman spectroscopy. The thickness measured by the prism coupling technique was found to be in agreement with the thickness measured by cross-sectional transmission electron microscopy. The overall results indicate that the prism coupling technique can be very useful for rapid, easy accurate measurement of the refractive index and thickness of smooth diamond films.
- 30 June 2002
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 166 (1) , 142-147
Charge Generation in a Dye-Sensitized Solid-State Cell under Different Modes of Illumination
- 30 June 2002
- Published by Elsevier in Journal of Solid State Chemistry
- Vol. 166 (1) , 142-147
Charge Generation in a Dye-Sensitized Solid-State Cell under Different Modes of Illumination
- 30 May 2002
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 91 (12) , 9752-9756
Role of cyclic process in the initial stage of diamond deposition during bias enhanced nucleation
The initial nucleation of diamond film on a Si substrate, deposited by a three-step growth process together with a cycle bias enhanced nucleation (BEN) plasma etching technique in a microwave plasma enhanced chemical vapor deposition system has been investigated by atomic force microscopy, Raman spectroscopy and x-ray photoelectron spectroscopy. The surface morphology and the uniformity of {100}-oriented textured grains at the BEN step were found to be greatly increased by applying the cyclic process with some optimal plasma etching time during the BEN stage.- 30 May 2002
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 91 (12) , 9752-9756
Role of cyclic process in the initial stage of diamond deposition during bias enhanced nucleation
The initial nucleation of diamond film on a Si substrate, deposited by a three-step growth process together with a cycle bias enhanced nucleation (BEN) plasma etching technique in a microwave plasma enhanced chemical vapor deposition system has been investigated by atomic force microscopy, Raman spectroscopy and x-ray photoelectron spectroscopy. The surface morphology and the uniformity of {100}-oriented textured grains at the BEN step were found to be greatly increased by applying the cyclic process with some optimal plasma etching time during the BEN stage.- 1 January 2002
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 388 (1) , 95-101
Influence Of Deposition Parameters On The Structural, Optical And Electrical Properties Of Amorphous Carbon And Amorphous Carbon Nitride Films Grown By Pulsed Laser Deposition Using Camphoric Carbon Target
The role of laser fluence (LF) and target to substrate distance (TSD) on the surface morphology, deposition rate, composition, structural, optical and electrical properties of amorphous carbon (a-C) and amorphous carbon nitride (a-CN x ) films deposited by Xe-Cl excimer pulsed laser deposition is reported. At fixed TSD, the surface roughness, particle density and deposition rate increase, whereas the particle size decreases with higher LF. When the LF is fixed, TSD decreases resulting in an increase in the irregular small particle size, particle density, surfaces roughness and deposition rate. We found that the amorphous structure of a-C and a-CN x films is strongly dependent on the LF and TSD. The a-CN x films with high deposition rate have relatively high nitrogen content and high electrical resistivity.
- 1 January 2002
- Published by Taylor & Francis in Molecular Crystals and Liquid Crystals
- Vol. 388 (1) , 95-101
Influence Of Deposition Parameters On The Structural, Optical And Electrical Properties Of Amorphous Carbon And Amorphous Carbon Nitride Films Grown By Pulsed Laser Deposition Using Camphoric Carbon Target
The role of laser fluence (LF) and target to substrate distance (TSD) on the surface morphology, deposition rate, composition, structural, optical and electrical properties of amorphous carbon (a-C) and amorphous carbon nitride (a-CN x ) films deposited by Xe-Cl excimer pulsed laser deposition is reported. At fixed TSD, the surface roughness, particle density and deposition rate increase, whereas the particle size decreases with higher LF. When the LF is fixed, TSD decreases resulting in an increase in the irregular small particle size, particle density, surfaces roughness and deposition rate. We found that the amorphous structure of a-C and a-CN x films is strongly dependent on the LF and TSD. The a-CN x films with high deposition rate have relatively high nitrogen content and high electrical resistivity.