Glenn R. Heppler
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Glenn R. Heppler has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Eihab Muhammed Abdel-Rahman
University of Waterloo
7 shared publications - Shahrzad Towfighian
State University of New York at Binghamton
5 shared publications - Seyed Amir Mousavi Lajimi
Faculty of Engineering Department of Systems Design Engineering University of Waterloo 200 University Avenue West Waterloo N2L 3G1 Ontario Canada
3 shared publications A. Seleim
University of Waterloo, Waterloo, ON, Canada
1 shared publication- Abdulrahman Seleim
University of Windsor
1 shared publication - Ayman Alneamy
Department of Mechanical Engineering, College of Engineering and Computer Sciences, Jazan University, Jazan, Saudi Arabia
1 shared publication
Latest Publications
- 16 July 2021
- Published by ASME International in ASME Letters in Dynamic Systems and Control
- Vol. 2 (1)
Derivation and Experimental Validation of the Equations of Motion of Magnetic Pendulums
A series of coaxial magnetic pendulums is studied as a simple physical surrogate for more general nonlinearly coupled almost-identical resonators that arise in quantum communications and the dynamics of social networks. The equations of motion for a series of coaxial magnetic pendulums are derived, and the solution is compared to experimental results. The equilibrium points and their stability are also determined.
- 16 July 2021
- Published by ASME International in ASME Letters in Dynamic Systems and Control
- Vol. 2 (1)
Derivation and Experimental Validation of the Equations of Motion of Magnetic Pendulums
A series of coaxial magnetic pendulums is studied as a simple physical surrogate for more general nonlinearly coupled almost-identical resonators that arise in quantum communications and the dynamics of social networks. The equations of motion for a series of coaxial magnetic pendulums are derived, and the solution is compared to experimental results. The equilibrium points and their stability are also determined.
- Open Access
Nonlinear Parameter Identification of a Resonant Electrostatic MEMS Actuator
We experimentally investigate the primary superharmonic of order two and subharmonic of order one-half resonances of an electrostatic MEMS actuator under direct excitation. We identify the parameters of a one degree of freedom (1-DOF) generalized Duffing oscillator model representing it. The experiments were conducted in soft vacuum to reduce squeeze-film damping, and the actuator response was measured optically using a laser vibrometer. The predictions of the identified model were found to be in close agreement with the experimental results. We also identified the noise spectral density of process (actuation voltage) and measurement noise.
Open AccessNonlinear Parameter Identification of a Resonant Electrostatic MEMS Actuator
We experimentally investigate the primary superharmonic of order two and subharmonic of order one-half resonances of an electrostatic MEMS actuator under direct excitation. We identify the parameters of a one degree of freedom (1-DOF) generalized Duffing oscillator model representing it. The experiments were conducted in soft vacuum to reduce squeeze-film damping, and the actuator response was measured optically using a laser vibrometer. The predictions of the identified model were found to be in close agreement with the experimental results. We also identified the noise spectral density of process (actuation voltage) and measurement noise.
- 17 February 2016
- Published by Springer Nature in Acta Mechanica
- Vol. 227 (5) , 1469-1491
Theory of micropolar gyroelastic continua
- 17 February 2016
- Published by Springer Nature in Acta Mechanica
- Vol. 227 (5) , 1469-1491
Theory of micropolar gyroelastic continua
- Open Access
Eigenvalues of an axially loaded cantilever beam with an eccentric end rigid body
An analytical form of the characteristic equation for a vertically mounted cantilever beam with an end rigid body is obtained and solved for the eigenvalues of the structure. The effect of the weight of the structure is taken into consideration by estimating the load as a function of the length of the beam. The mass, rotary inertia and eccentricity of the end rigid body are demonstrated to considerably affect the eigenvalues of the structure.
Open AccessEigenvalues of an axially loaded cantilever beam with an eccentric end rigid body
An analytical form of the characteristic equation for a vertically mounted cantilever beam with an end rigid body is obtained and solved for the eigenvalues of the structure. The effect of the weight of the structure is taken into consideration by estimating the load as a function of the length of the beam. The mass, rotary inertia and eccentricity of the end rigid body are demonstrated to considerably affect the eigenvalues of the structure.
- 1 March 2013
- Published by Canadian Science Publishing in Transactions of the Canadian Society for Mechanical Engineering
- Vol. 37 (1) , 89-110
FREE VIBRATION AND BUCKLING OF CANTILEVER BEAMS UNDER LINEARLY VARYING AXIAL LOAD CARRYING AN ECCENTRIC END RIGID BODY
Natural frequencies of a clamped axially loaded beam carrying an eccentric end rigid body are computed. A linearly varying non-follower axial force representing the beam’s own weight is taken into consideration. An analytical form of the frequency equation of the structure is obtained and solved numerically. The parameters associated with the end rigid body, the mass, the rotary inertia and the eccentricity, are shown to considerably affect the natural frequencies of the structure. The modified orthogonality conditions of the system are presented. A closed-form of the frequency equation for a beam under constant axial load carrying an eccentric end rigid body is obtained and results are compared with the distributed load case. Based on the exact and approximate computations of the critical buckling load a recommendation is made on the method of including the effect of distributed load for practical purposes.
- 1 March 2013
- Published by Canadian Science Publishing in Transactions of the Canadian Society for Mechanical Engineering
- Vol. 37 (1) , 89-110
FREE VIBRATION AND BUCKLING OF CANTILEVER BEAMS UNDER LINEARLY VARYING AXIAL LOAD CARRYING AN ECCENTRIC END RIGID BODY
Natural frequencies of a clamped axially loaded beam carrying an eccentric end rigid body are computed. A linearly varying non-follower axial force representing the beam’s own weight is taken into consideration. An analytical form of the frequency equation of the structure is obtained and solved numerically. The parameters associated with the end rigid body, the mass, the rotary inertia and the eccentricity, are shown to considerably affect the natural frequencies of the structure. The modified orthogonality conditions of the system are presented. A closed-form of the frequency equation for a beam under constant axial load carrying an eccentric end rigid body is obtained and results are compared with the distributed load case. Based on the exact and approximate computations of the critical buckling load a recommendation is made on the method of including the effect of distributed load for practical purposes.
- 4 June 2012
- Published by Elsevier in Journal of Sound and Vibration
- Vol. 331 (12) , 2964-2968
Comments on “Natural frequencies of a uniform cantilever with a tip mass slender in the axial direction”
- 4 June 2012
- Published by Elsevier in Journal of Sound and Vibration
- Vol. 331 (12) , 2964-2968
Comments on “Natural frequencies of a uniform cantilever with a tip mass slender in the axial direction”
- 24 December 2011
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 69 (1-2) , 615-633
Dynamics of a close-loop controlled MEMS resonator
- 24 December 2011
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 69 (1-2) , 615-633
Dynamics of a close-loop controlled MEMS resonator
- 22 December 2011
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 69 (1-2) , 565-575
Low-voltage closed loop MEMS actuators
- 22 December 2011
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 69 (1-2) , 565-575
Low-voltage closed loop MEMS actuators
- 27 September 2010
- Published by ASME International in Journal of Computational and Nonlinear Dynamics
- Vol. 6 (1) , 011001
Analysis of a Chaotic Electrostatic Micro-Oscillator
The closed-loop dynamics of a chaotic electrostatic microbeam actuator are presented. The actuator was found to be an asymmetric two-well potential system with two distinct chaotic attractors: one of which occurs predominantly in the lower well and a second that visits a lower-well orbit and a two-well orbit. Bifurcation diagrams obtained by sweeping the ac voltage amplitudes and frequency are presented. Period doubling, reverse period doubling, and the one-well chaos through period doubling are observed in amplitude sweep. In frequency sweep, period doubling, one-well, and two-well chaos, superharmonic resonances and on and off chaotic oscillations are found.
- 27 September 2010
- Published by ASME International in Journal of Computational and Nonlinear Dynamics
- Vol. 6 (1) , 011001
Analysis of a Chaotic Electrostatic Micro-Oscillator
The closed-loop dynamics of a chaotic electrostatic microbeam actuator are presented. The actuator was found to be an asymmetric two-well potential system with two distinct chaotic attractors: one of which occurs predominantly in the lower well and a second that visits a lower-well orbit and a two-well orbit. Bifurcation diagrams obtained by sweeping the ac voltage amplitudes and frequency are presented. Period doubling, reverse period doubling, and the one-well chaos through period doubling are observed in amplitude sweep. In frequency sweep, period doubling, one-well, and two-well chaos, superharmonic resonances and on and off chaotic oscillations are found.
- 1 January 2010
- Published by ASME International
- p. 631-638
Experimental Validation for an Extended-Stability Electrostatic Actuator
A voltage regulator is developed to extend the operation range of a electrostatic actuator using a displacement feedback. The feedback actuator system can be used for continuous position tracking of step, ramp, or harmonic voltage signals. The electrostatic actuator is composed of a micro-cantilever beam electrode above a fixed electrode. The voltage difference between the two electrodes is regulated by the controller to maintain the balance between mechanical and electrostatic forces at large beam deflections, thereby increasing the actuation range. Simulated closed loop system responses with experimentally identified parameters are presented and show the actuation can reach up to 85% of the gap in the static response with an input voltage of less than 12 V. Experimental results show that the controller properly functions and prevents the beam from experiencing pull-in. A close agreement is found between the simulated and measured closed loop model dynamic responses.
- 1 January 2010
- Published by ASME International
- p. 631-638
Experimental Validation for an Extended-Stability Electrostatic Actuator
A voltage regulator is developed to extend the operation range of a electrostatic actuator using a displacement feedback. The feedback actuator system can be used for continuous position tracking of step, ramp, or harmonic voltage signals. The electrostatic actuator is composed of a micro-cantilever beam electrode above a fixed electrode. The voltage difference between the two electrodes is regulated by the controller to maintain the balance between mechanical and electrostatic forces at large beam deflections, thereby increasing the actuation range. Simulated closed loop system responses with experimentally identified parameters are presented and show the actuation can reach up to 85% of the gap in the static response with an input voltage of less than 12 V. Experimental results show that the controller properly functions and prevents the beam from experiencing pull-in. A close agreement is found between the simulated and measured closed loop model dynamic responses.