Prabhas Kumar Yadav
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Prabhas Kumar Yadav has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Peter Dietrich
Helmholtz Centre for Environmental Research Leipzig Germany
3 shared publications Christian Müller
Technische Universität Dresden
1 shared publication- Falk Händel
Technische Universität Dresden
1 shared publication R. Liedl
Institute for Groundwater Management Technische Universität Dresden Dresden Germany
1 shared publication- Rudolf Liedl
Technische Universität Dresden, Institute for Groundwater Management, Dresden, Germany
1 shared publication - Rudolf Liedl
Technische Universität Dresden
1 shared publication
Latest Publications
- 7 May 2013
- Published by Springer Nature in Environmental Earth Sciences
- Vol. 71 (2) , 959-964
Influence of source thickness on steady-state plume length
- 7 May 2013
- Published by Springer Nature in Environmental Earth Sciences
- Vol. 71 (2) , 959-964
Influence of source thickness on steady-state plume length
- 20 October 2012
- Published by Springer Nature in Grundwasser
- Vol. 18 (1) , 47-53
NAFLA – Ein Simulationswerkzeug zur analytischen Abschätzung von Schadstofffahnenlängen
- 20 October 2012
- Published by Springer Nature in Grundwasser
- Vol. 18 (1) , 47-53
NAFLA – Ein Simulationswerkzeug zur analytischen Abschätzung von Schadstofffahnenlängen
- 31 August 2011
- Published by American Geophysical Union (AGU) in Water Resources Research
- Vol. 47 (8)
Length of 3‐D mixing‐controlled plumes for a fully penetrating contaminant source with finite width
An analytical 3‐D model is developed to estimate steady state plume lengths in contaminated aquifers for the case of an instantaneous bimolecular reaction. The developed model generalizes the previous vertically‐oriented 2‐D model of Liedl et al. (2005) by considering a source that has finite width (2W) and is extended over the entire depth (M) of the aquifer. It is shown that the model of Liedl et al. (2005) overestimates steady state plume lengths if the source width is below a certain maximum relevant source width (2Wrel). Results also suggest that the ratio of the bulk transverse dispersivities in the horizontal and vertical directions is critical in defining the size of the plume, and that the maximum plume length is observed when 2W and M are approximately equal for any ratio above 10.
- 31 August 2011
- Published by American Geophysical Union (AGU) in Water Resources Research
- Vol. 47 (8)
Length of 3‐D mixing‐controlled plumes for a fully penetrating contaminant source with finite width
An analytical 3‐D model is developed to estimate steady state plume lengths in contaminated aquifers for the case of an instantaneous bimolecular reaction. The developed model generalizes the previous vertically‐oriented 2‐D model of Liedl et al. (2005) by considering a source that has finite width (2W) and is extended over the entire depth (M) of the aquifer. It is shown that the model of Liedl et al. (2005) overestimates steady state plume lengths if the source width is below a certain maximum relevant source width (2Wrel). Results also suggest that the ratio of the bulk transverse dispersivities in the horizontal and vertical directions is critical in defining the size of the plume, and that the maximum plume length is observed when 2W and M are approximately equal for any ratio above 10.