Suresh C. Ameta
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Suresh C. Ameta has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Narendra Pal Singh Chauhan
Department of Chemistry, Faculty of Science Bhupal Nobles' University Udaipur Rajasthan India
2 shared publications - Pinki Bala Punjabi
Department of Chemistry, University College of Science, Mohanlal Sukhadia University, Udaipur-313001, Rajasthan, India
2 shared publications A. Kumar
University College of Science, M.L. Sukhadia University
1 shared publication- Abhijit Adhikary
Elastomers Customer Support Centre (ECSC), Reliance Industries Limited, PO- Petrochemicals, Vadodara, India
1 shared publication Anil Kumar
Photochemistry and Solar Energy Laboratory, Department of Chemistry, University College of Science, M. L. Sukhadia University, Udaipur 313001, India
1 shared publication- Bharatraj Singh Rathore
Department of Chemistry, Vidya Bhawan Rural Institute, Udaipur 313011, Rajasthan, India
1 shared publication
Latest Publications
- 19 May 2023
- Published by Springer Nature in Polymer Bulletin
- Vol. 81 (3) , 2365-2384
To explore extension of emulsion styrene butadiene rubber with modified vegetable oils
- 19 May 2023
- Published by Springer Nature in Polymer Bulletin
- Vol. 81 (3) , 2365-2384
To explore extension of emulsion styrene butadiene rubber with modified vegetable oils
- Open Access
Synthesis and Characterization of Ch-PANI-Fe2O3 Nanocomposite and Its Water Remediation Applications
Using the batch adsorption technique, an eco-friendly polymer composite made of chitosan, polyaniline, and iron (III) oxide was developed for removal of dye contamination from wastewater. Ultraviolet-visible spectroscopy (UV-Vis), Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), X-ray diffraction (XRD), transmission electron microscopy (TEM), EDX (energy dispersive X-ray analysis), and thermogravimetric-derived thermogravimetric (TG-DTG) techniques were used to characterize the sample. According to EDX, the Ch-PANI-Fe2O3 hybrid composite has the following weight ratios: C 34.25%, N 0.48%, O 50.51%, and Fe 3.08%. The nanocomposite’s surface was rough with pleats, which was evident from the SEM and TEM images. This surface structure likely contributed to the nanocomposite’s higher dye adsorption rate (91.5%). According to SEM analysis, the proportion of Fe2O3 nanoparticles to the chitosan–polyaniline composite changed the hybrids’ morphology from granular to an irregular, globular-like structure, which was supported by EDX. The results demonstrated that this polymer matrix (chitosan-PANI-Fe2O3) nanocomposite can be employed as an adsorbent for the effective removal of methyl orange dye, as well as for the removal of dye contamination from wastewater with reusability.
Open AccessSynthesis and Characterization of Ch-PANI-Fe2O3 Nanocomposite and Its Water Remediation Applications
Using the batch adsorption technique, an eco-friendly polymer composite made of chitosan, polyaniline, and iron (III) oxide was developed for removal of dye contamination from wastewater. Ultraviolet-visible spectroscopy (UV-Vis), Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), X-ray diffraction (XRD), transmission electron microscopy (TEM), EDX (energy dispersive X-ray analysis), and thermogravimetric-derived thermogravimetric (TG-DTG) techniques were used to characterize the sample. According to EDX, the Ch-PANI-Fe2O3 hybrid composite has the following weight ratios: C 34.25%, N 0.48%, O 50.51%, and Fe 3.08%. The nanocomposite’s surface was rough with pleats, which was evident from the SEM and TEM images. This surface structure likely contributed to the nanocomposite’s higher dye adsorption rate (91.5%). According to SEM analysis, the proportion of Fe2O3 nanoparticles to the chitosan–polyaniline composite changed the hybrids’ morphology from granular to an irregular, globular-like structure, which was supported by EDX. The results demonstrated that this polymer matrix (chitosan-PANI-Fe2O3) nanocomposite can be employed as an adsorbent for the effective removal of methyl orange dye, as well as for the removal of dye contamination from wastewater with reusability.
- 24 April 2012
- Published by Taylor & Francis in International Journal of Polymeric Materials and Polymeric Biomaterials
- Vol. 61 (14) , 1102-1114
Synthesis, Characterization, and Antimicrobial Properties of p-Chloroacetophenone Oxime-Based Furan Resins
A copolymer resin, p-chloroacetophenone oxime-furfuraldehyde (CAOFU), and a terpolymer resin, p-chloroacetophenone oxime-formaldehyde-benzoic acid (CAOFUBA), were synthesized in the presence of hydrochloric acid as catalyst. The structures of copolymer and terpolymer were established by FT-IR and 1H NMR techniques. Molecular weight and polydispersity index were determined by gel permeation chromatography. The thermal stability was evaluated by thermogravimetric analyses (TGA). Softening temperatures (Ts) of these polymers were obtained from differential scanning calorimetry (DSC). All the synthesized polymers have shown reasonably good antimicrobial activities.
- 24 April 2012
- Published by Taylor & Francis in International Journal of Polymeric Materials and Polymeric Biomaterials
- Vol. 61 (14) , 1102-1114
Synthesis, Characterization, and Antimicrobial Properties of p-Chloroacetophenone Oxime-Based Furan Resins
A copolymer resin, p-chloroacetophenone oxime-furfuraldehyde (CAOFU), and a terpolymer resin, p-chloroacetophenone oxime-formaldehyde-benzoic acid (CAOFUBA), were synthesized in the presence of hydrochloric acid as catalyst. The structures of copolymer and terpolymer were established by FT-IR and 1H NMR techniques. Molecular weight and polydispersity index were determined by gel permeation chromatography. The thermal stability was evaluated by thermogravimetric analyses (TGA). Softening temperatures (Ts) of these polymers were obtained from differential scanning calorimetry (DSC). All the synthesized polymers have shown reasonably good antimicrobial activities.
- 1 June 2008
- Published by Springer Nature in Journal of the Iranian Chemical Society
- Vol. 5 (2) , 346-351
Oxidation of fast green FCF by the solar photo-Fenton process
- 1 June 2008
- Published by Springer Nature in Journal of the Iranian Chemical Society
- Vol. 5 (2) , 346-351
Oxidation of fast green FCF by the solar photo-Fenton process
- 1 January 2008
- Published by Institute of Organic Chemistry & Biochemistry in Collection of Czechoslovak Chemical Communications
- Vol. 73 (5) , 679-689
A Novel Route for Waste Water Treatment: Photo-Assisted Fenton Degradation of Naphthol Green B
- 1 January 2008
- Published by Institute of Organic Chemistry & Biochemistry in Collection of Czechoslovak Chemical Communications
- Vol. 73 (5) , 679-689
A Novel Route for Waste Water Treatment: Photo-Assisted Fenton Degradation of Naphthol Green B
- 24 December 2007
- Published by Taylor & Francis in Phosphorus, Sulfur, and Silicon and the Related Elements
- Vol. 183 (1) , 105-114
Microwave Assisted Synthesis of Some Pyridine Derivatives Containing Mercaptotriazole and Thiazolidinone as a New Class of Antimicrobial Agents
A fast and facile procedure for the synthesis of pyridomercaptotriazole 4a–e and pyridothiazolidinone 5a–e is being reported starting from dihydropyridine 1a–e . Subsequent oxidation with nitrating mixture (HNO 3 /H 2 SO 4 ) produced the anticipated 2,6-dimethylpyridine derivatives 2a–e , which were subsequently condensed with thiosemicarbazide in ethanol to produce the key intermediate 2,2′-[4-(4-substituted phenyl)- 2,6-dimethylpyridine-3,5-diyl]dicarbonyldihydrazine carbothioamides 3a–e . In the final step pyridomercaptotriazole derivatives 4a–e were synthesized by treating 3a–e in alkaline media. In parallel pyridothiazolidinone derivatives 5a–e were obtained by the reaction of 3a–e with ClCH 2 COOH/CH 3 COONa. All the reactions were carried out on microwave irradiation in good yield with short time. The structures of all the compounds have been confirmed on the basis of their analytical, IR, 1 H NMR, and Mass spectral data (Table I and Table II). The potent antimicrobial effects of the synthesized compounds were also investigated.
- 24 December 2007
- Published by Taylor & Francis in Phosphorus, Sulfur, and Silicon and the Related Elements
- Vol. 183 (1) , 105-114
Microwave Assisted Synthesis of Some Pyridine Derivatives Containing Mercaptotriazole and Thiazolidinone as a New Class of Antimicrobial Agents
A fast and facile procedure for the synthesis of pyridomercaptotriazole 4a–e and pyridothiazolidinone 5a–e is being reported starting from dihydropyridine 1a–e . Subsequent oxidation with nitrating mixture (HNO 3 /H 2 SO 4 ) produced the anticipated 2,6-dimethylpyridine derivatives 2a–e , which were subsequently condensed with thiosemicarbazide in ethanol to produce the key intermediate 2,2′-[4-(4-substituted phenyl)- 2,6-dimethylpyridine-3,5-diyl]dicarbonyldihydrazine carbothioamides 3a–e . In the final step pyridomercaptotriazole derivatives 4a–e were synthesized by treating 3a–e in alkaline media. In parallel pyridothiazolidinone derivatives 5a–e were obtained by the reaction of 3a–e with ClCH 2 COOH/CH 3 COONa. All the reactions were carried out on microwave irradiation in good yield with short time. The structures of all the compounds have been confirmed on the basis of their analytical, IR, 1 H NMR, and Mass spectral data (Table I and Table II). The potent antimicrobial effects of the synthesized compounds were also investigated.
- 1 January 2006
- Published by Taylor & Francis in Toxicological & Environmental Chemistry
- Vol. 88 (1) , 35-44
Effect of transition metal ions on photocatalytic activity of ZnO in bleaching of some dyes
The photocatalytic bleaching of some dyes (erythrosin-B, fast green FCF and eosin Y) was carried in the presence of semiconducting zinc oxide and was observed spectrophotometrically. The effects of various operating variables like pH, concentration of dyes, amount of semiconductor and light intensity on the efficiency of the reaction were also observed. Attempts have been made to study the effect of the addition of other metal ions (Fe2+, Ni2+, Ag+, Cu2+, Co2+, V2+ and Mn2+). All the added metal ions increase the reaction rate to some extent. It was also observed that Fe2+ is most effective in photobleaching of erythrosin-B, whereas V2+ is more effective in the cases of fast green FCF and eosin Y. A tentative mechanism has been proposed.
- 1 January 2006
- Published by Taylor & Francis in Toxicological & Environmental Chemistry
- Vol. 88 (1) , 35-44
Effect of transition metal ions on photocatalytic activity of ZnO in bleaching of some dyes
The photocatalytic bleaching of some dyes (erythrosin-B, fast green FCF and eosin Y) was carried in the presence of semiconducting zinc oxide and was observed spectrophotometrically. The effects of various operating variables like pH, concentration of dyes, amount of semiconductor and light intensity on the efficiency of the reaction were also observed. Attempts have been made to study the effect of the addition of other metal ions (Fe2+, Ni2+, Ag+, Cu2+, Co2+, V2+ and Mn2+). All the added metal ions increase the reaction rate to some extent. It was also observed that Fe2+ is most effective in photobleaching of erythrosin-B, whereas V2+ is more effective in the cases of fast green FCF and eosin Y. A tentative mechanism has been proposed.