Eric J. Goethals
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Eric J. Goethals has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Marjorie F. Dubreuil
Department of Organic Chemistry, Polymer Division, University of Ghent, Ghent, Belgium
2 shared publicationsWouter G. Reyntjens
Department of Organic Chemistry, Polymer Chemistry Division , Ghent University , Gent, Belgium
2 shared publicationsBeatrice Verdonck
Department of Organic Chemistry, Polymer Division, Ghent University, Krijgslaan 281, S4, 9000 Ghent, Belgium; Fax 00 32 (0)9 264 49 72
1 shared publication- Filip Eduard Du Prez
Polymer Chemistry Research Group, Centre of Macromolecular Chemistry (CMaC), Department of Organic and Macromolecular Chemistry, Faculty of Sciences, Ghent University, Ghent, Belgium
1 shared publication Laura E. Jonckheere
Department of Organic Chemistry, Polymer Chemistry Division, Ghent University, Krijgslaan 281 (S4‐bis), 9000 Gent, Belgium; Fax: +32 (0) 9 2644972
1 shared publicationLaura Jonckheere
Department of Organic Chemistry, Polymer Chemistry Division , Ghent University , Gent, Belgium
1 shared publication
Latest Publications
- 27 January 2003
- Published by Wiley in Polymer International
- Vol. 52 (2) , 191-197
Segmented polymer networks containing amino‐dendrimers
Polymer networks in which poly(propylene imine) dendrimers (Astramol™) are connected to each other by linear polytetrahydrofuran (polyTHF) segments, were prepared by two methods. The first method was a one‐step procedure in which bifunctionally living polyTHF, obtained by initiation of the THF polymerization with trifluoromethane sulfonic anhydride (triflic anhydride), was reacted with an amino‐dendrimer. This reaction was very fast but did not allow formation of the end products. The second method was a two‐step procedure. In a first step, living polyTHF, prepared with acryloyloxybutyl triflate as initiator, was grafted on an amino‐dendrimer, to form a star‐like, acrylate‐terminated polyTHF multi‐macromonomer with the dendrimer as core. In a second step, networks were obtained by Michael addition between the acrylate end‐groups and unreacted amino‐groups of the dendrimer. This cross‐linking reaction occurred spontaneously upon heating of the solution of the multi‐macromonomer with gelation times varying from a few minutes to a few hours, depending on the temperature and the composition of the prepolymers. With this method it was possible to prepare networks in the form of coatings or films.© 2003 Society of Chemical Industry
- 27 January 2003
- Published by Wiley in Polymer International
- Vol. 52 (2) , 191-197
Segmented polymer networks containing amino‐dendrimers
Polymer networks in which poly(propylene imine) dendrimers (Astramol™) are connected to each other by linear polytetrahydrofuran (polyTHF) segments, were prepared by two methods. The first method was a one‐step procedure in which bifunctionally living polyTHF, obtained by initiation of the THF polymerization with trifluoromethane sulfonic anhydride (triflic anhydride), was reacted with an amino‐dendrimer. This reaction was very fast but did not allow formation of the end products. The second method was a two‐step procedure. In a first step, living polyTHF, prepared with acryloyloxybutyl triflate as initiator, was grafted on an amino‐dendrimer, to form a star‐like, acrylate‐terminated polyTHF multi‐macromonomer with the dendrimer as core. In a second step, networks were obtained by Michael addition between the acrylate end‐groups and unreacted amino‐groups of the dendrimer. This cross‐linking reaction occurred spontaneously upon heating of the solution of the multi‐macromonomer with gelation times varying from a few minutes to a few hours, depending on the temperature and the composition of the prepolymers. With this method it was possible to prepare networks in the form of coatings or films.© 2003 Society of Chemical Industry
- 3 January 2003
- Published by Taylor & Francis in Journal of Macromolecular Science, Part A
- Vol. 40 (1) , 1-10
Thermotropic Networks Based on Poly(Methyl Vinyl Ether)
Segmented polymer networks consisting of poly(methyl vinyl ether) (PMVE) and a second polymer were synthesized by copolymerization of PMVE-α,ω-bis-methacrylate with a hydrophilic vinyl monomer (hydroxyethyl methacrylate, HEMA) or a hydrophobic vinyl monomer (styrene, St or butyl acrylate, BA). Such networks, swollen to equilibrium in water, show thermotropic properties in the case of the PMVE-PSt and PMVE-PBA systems due to the lower critical solution temperature (LCST) properties of the PMVE segments. The PMVE-PHEMA networks showed an inverse thermotropic behavior, i.e., the swollen networks are turbid at lower temperature and become transparent at higher temperature. The PMVE-PSt networks containing a small fraction of PSt are the best materials for thermotropic properties because the swelling is limited to a few percent which results in materials free of cracks after repeated heating–cooling (with corresponding de-swelling–swelling) processes.
- 3 January 2003
- Published by Taylor & Francis in Journal of Macromolecular Science, Part A
- Vol. 40 (1) , 1-10
Thermotropic Networks Based on Poly(Methyl Vinyl Ether)
Segmented polymer networks consisting of poly(methyl vinyl ether) (PMVE) and a second polymer were synthesized by copolymerization of PMVE-α,ω-bis-methacrylate with a hydrophilic vinyl monomer (hydroxyethyl methacrylate, HEMA) or a hydrophobic vinyl monomer (styrene, St or butyl acrylate, BA). Such networks, swollen to equilibrium in water, show thermotropic properties in the case of the PMVE-PSt and PMVE-PBA systems due to the lower critical solution temperature (LCST) properties of the PMVE segments. The PMVE-PHEMA networks showed an inverse thermotropic behavior, i.e., the swollen networks are turbid at lower temperature and become transparent at higher temperature. The PMVE-PSt networks containing a small fraction of PSt are the best materials for thermotropic properties because the swelling is limited to a few percent which results in materials free of cracks after repeated heating–cooling (with corresponding de-swelling–swelling) processes.
- Open Access
- 1 December 2002
- Published by Walter de Gruyter GmbH in e-Polymers
- Vol. 2 (1) , 596-604
‘Living’ cationic copolymerization of isobutyl vinyl ether with methyl vinyl ether: copolymerization parameters and properties of the copolymers
The copolymerization of isobutyl vinyl ether (IBVE) with methyl vinyl ether (MVE), initiated by the system 1,1-diethoxyethane/trimethylsilyl iodide/zinc iodide and conducted at 0°C in toluene, was found to be ‘living’ just as the homopolymerizations of these monomers. Monomer reactivity ratios are r IBVE = 1.08 and r MVE = 0.43. The lower critical solution temperature of polyMVE in water, situated around 37°C, was lowered to 10°C (for a 0.25 wt.-% solution) when 6 mol-% of IBVE units were introduced in copolymers of molar mass 3000 - 7000 g/mol. At higher IBVE contents, the polymers are insoluble in water at all temperatures.
- 1 December 2002
- Published by Walter de Gruyter GmbH in e-Polymers
- Vol. 2 (1) , 596-604
Open Access‘Living’ cationic copolymerization of isobutyl vinyl ether with methyl vinyl ether: copolymerization parameters and properties of the copolymers
The copolymerization of isobutyl vinyl ether (IBVE) with methyl vinyl ether (MVE), initiated by the system 1,1-diethoxyethane/trimethylsilyl iodide/zinc iodide and conducted at 0°C in toluene, was found to be ‘living’ just as the homopolymerizations of these monomers. Monomer reactivity ratios are r IBVE = 1.08 and r MVE = 0.43. The lower critical solution temperature of polyMVE in water, situated around 37°C, was lowered to 10°C (for a 0.25 wt.-% solution) when 6 mol-% of IBVE units were introduced in copolymers of molar mass 3000 - 7000 g/mol. At higher IBVE contents, the polymers are insoluble in water at all temperatures.
- 1 March 2002
- Published by Wiley in Macromolecular Rapid Communications
- Vol. 23 (4) , 282-285
Thermo-Responsive Solid-Phase Extraction Using Poly(methyl vinyl ether)-Containing Segmented Polymer Networks
- 1 March 2002
- Published by Wiley in Macromolecular Rapid Communications
- Vol. 23 (4) , 282-285
Thermo-Responsive Solid-Phase Extraction Using Poly(methyl vinyl ether)-Containing Segmented Polymer Networks
- Open Access
- 1 December 2001
- Published by Walter de Gruyter GmbH in e-Polymers
- Vol. 1 (1) , 159-169
Grafting of living poly(tetrahydrofuran) onto aminodendrimers
Hybrid polymers consisting of poly(propyleneimine) dendrimers (Astramol TM ) and linear poly(tetrahydrofuran) (polyTHF) were obtained by grafting living cationic polyTHF onto the dendrimer. By varying the mole ratio of polyTHF to dendrimer, either modified dendrimers, containing only a few linear polymer chains, or ‘superstar’ polymers, i.e. dendrimers containing a large number of polyTHF chains, were obtained. The average number of grafted chains per dendrimer unit, the grafting degree, could be estimated by means of 1 H NMR spectroscopy. For polyTHF with molar mass of 2000 g/mol or lower, all primary amino functions of the dendrimers up to the 5 th generation (32 primary amino functions) could be grafted. For polyTHF with molar mass of 4000 g/mol, the maximum grafting degree was lower than the number of primary amino groups available and decreased with increasing dendrimer generation.
- 1 December 2001
- Published by Walter de Gruyter GmbH in e-Polymers
- Vol. 1 (1) , 159-169
Open AccessGrafting of living poly(tetrahydrofuran) onto aminodendrimers
Hybrid polymers consisting of poly(propyleneimine) dendrimers (Astramol TM ) and linear poly(tetrahydrofuran) (polyTHF) were obtained by grafting living cationic polyTHF onto the dendrimer. By varying the mole ratio of polyTHF to dendrimer, either modified dendrimers, containing only a few linear polymer chains, or ‘superstar’ polymers, i.e. dendrimers containing a large number of polyTHF chains, were obtained. The average number of grafted chains per dendrimer unit, the grafting degree, could be estimated by means of 1 H NMR spectroscopy. For polyTHF with molar mass of 2000 g/mol or lower, all primary amino functions of the dendrimers up to the 5 th generation (32 primary amino functions) could be grafted. For polyTHF with molar mass of 4000 g/mol, the maximum grafting degree was lower than the number of primary amino groups available and decreased with increasing dendrimer generation.
- 1 January 2001
- Published by Taylor & Francis in Designed Monomers and Polymers
- Vol. 4 (2) , 195-201
Controlled cationic polymerization of methyl vinyl ether with a semi-continuous process
A semi-continuous process for the controlled cationic polymerization of methyl vinyl ether (MVE) was developed. The initiating system was a combination of 1,1-diethoxyethane (DEE), trimethyl silyl iodide (TMSI), and ZnI2 as activator. The optimal reaction conditions were a reaction temperature of-5 °C in toluene, an initiator to activator ratio of 5 to 1, and a monomer feed rate of 0.86 mol/h. With these reaction conditions, poly(methyl vinyl ethers) (PMVEs) with molecular weights up to 7500 could be prepared in quantities up to 30 g with narrow molecular weight distributions (MWD<1.2) and still possessing active chain ends which can be end-capped with a nucleophilic terminator.
- 1 January 2001
- Published by Taylor & Francis in Designed Monomers and Polymers
- Vol. 4 (2) , 195-201
Controlled cationic polymerization of methyl vinyl ether with a semi-continuous process
A semi-continuous process for the controlled cationic polymerization of methyl vinyl ether (MVE) was developed. The initiating system was a combination of 1,1-diethoxyethane (DEE), trimethyl silyl iodide (TMSI), and ZnI2 as activator. The optimal reaction conditions were a reaction temperature of-5 °C in toluene, an initiator to activator ratio of 5 to 1, and a monomer feed rate of 0.86 mol/h. With these reaction conditions, poly(methyl vinyl ethers) (PMVEs) with molecular weights up to 7500 could be prepared in quantities up to 30 g with narrow molecular weight distributions (MWD<1.2) and still possessing active chain ends which can be end-capped with a nucleophilic terminator.
- 1 October 2000
- Published by Wiley in Macromolecular Symposia
- Vol. 161 (1) , 135-140
star- andcomb-polytetrahydrofuran multimacromonomers: synthesis and network formation
- 1 October 2000
- Published by Wiley in Macromolecular Symposia
- Vol. 161 (1) , 135-140
star- andcomb-polytetrahydrofuran multimacromonomers: synthesis and network formation
- 1 July 1999
- Published by Wiley in Macromolecular Rapid Communications
- Vol. 20 (7) , 383-386
Influence of the alkyl group of triflate esters on their initiation ability for the cationic ring-opening polymerization of tetrahydrofuran
- 1 July 1999
- Published by Wiley in Macromolecular Rapid Communications
- Vol. 20 (7) , 383-386
Influence of the alkyl group of triflate esters on their initiation ability for the cationic ring-opening polymerization of tetrahydrofuran