Sune Larsson
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Sune Larsson has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Thomas W. Bauer
Department of Pathology and Laboratory Medicine, Hospital for Special Surgery, New York, NY
2 shared publications A.B. Lennon
1 shared publication- B. M. Wroblewski
The John Charnley Research Institute, Wrightington Hospital, Hall Lane, Appley Bridge, Wigan, Lancashire, WN6 9EP, UK,
1 shared publication B.H. van Duren
Nuffield Orthopaedic Centre, Windmill Road, Headington, Oxford OX3 7LD, UK
1 shared publication- Blanca Vázquez
Institute of Polymer Science and Technology, ICTP-CSIC, C/Juan de la Cierva 3, 28006 Madrid, Spain
1 shared publication C. Ohtsuki
1 shared publication
Latest Publications
- 1 June 2011
- Published by Wolters Kluwer Health in Journal of Orthopaedic Trauma
- Vol. 25 (Supplement) , S90-S94
Periarticular Fractures Around the Hip and Knee: Fix or Replace?
The number of periarticular fragility fractures around the hip and knee is increasing. If surgical treatment is indicated, open reduction and internal fixation or replacement can often be viable options. In contrast to secondary replacement, the use of replacement in the acute stage might be advantageous because early rehabilitation and weightbearing can be initiated. This article describes the current literature related to internal fixation or primary replacement in periarticular fractures around the hip and knee.
- 1 June 2011
- Published by Wolters Kluwer Health in Journal of Orthopaedic Trauma
- Vol. 25 (Supplement) , S90-S94
Periarticular Fractures Around the Hip and Knee: Fix or Replace?
The number of periarticular fragility fractures around the hip and knee is increasing. If surgical treatment is indicated, open reduction and internal fixation or replacement can often be viable options. In contrast to secondary replacement, the use of replacement in the acute stage might be advantageous because early rehabilitation and weightbearing can be initiated. This article describes the current literature related to internal fixation or primary replacement in periarticular fractures around the hip and knee.
- 1 March 2010
- Published by Wolters Kluwer Health in Journal of Orthopaedic Trauma
- Vol. 24 (Supplement) , S41-S45
Calcium Phosphates: What Is the Evidence?
A number of different calcium phosphate compounds such as calcium phosphate cements and solid beta-tricalcium phosphate products have been introduced during the last decade. The chemical composition mimics the mineral phase of bone and as a result of this likeness, the materials seem to be remodeled as for normal bone through a cell-mediated process that involves osteoclastic activity. This is a major difference when compared with, for instance, calcium sulphate compounds that after implantation dissolve irrespective of the new bone formation rate. Calcium phosphates are highly biocompatible and in addition, they act as synthetic osteoconductive scaffolds after implantation in bone. When placed adjacent to bone, osteoid is formed directly on the surface of the calcium phosphate with no soft tissue interposed. Remodeling is slow and incomplete, but by adding more and larger pores, like in ultraporous beta-tricalcium phosphate, complete or nearly complete resorption can be achieved. The indications explored so far include filling of metaphyseal fracture voids or bone cysts, a volume expander in conjunction with inductive products, and as a carrier for various growth factors and antibiotics. Calcium phosphate compounds such as calcium phosphate cement and beta-tricalcium phosphate will most certainly be part of the future armamentarium when dealing with fracture treatment. It is reasonable to believe that we have so far only seen the beginning when it comes to clinical applications.
- 1 March 2010
- Published by Wolters Kluwer Health in Journal of Orthopaedic Trauma
- Vol. 24 (Supplement) , S41-S45
Calcium Phosphates: What Is the Evidence?
A number of different calcium phosphate compounds such as calcium phosphate cements and solid beta-tricalcium phosphate products have been introduced during the last decade. The chemical composition mimics the mineral phase of bone and as a result of this likeness, the materials seem to be remodeled as for normal bone through a cell-mediated process that involves osteoclastic activity. This is a major difference when compared with, for instance, calcium sulphate compounds that after implantation dissolve irrespective of the new bone formation rate. Calcium phosphates are highly biocompatible and in addition, they act as synthetic osteoconductive scaffolds after implantation in bone. When placed adjacent to bone, osteoid is formed directly on the surface of the calcium phosphate with no soft tissue interposed. Remodeling is slow and incomplete, but by adding more and larger pores, like in ultraporous beta-tricalcium phosphate, complete or nearly complete resorption can be achieved. The indications explored so far include filling of metaphyseal fracture voids or bone cysts, a volume expander in conjunction with inductive products, and as a carrier for various growth factors and antibiotics. Calcium phosphate compounds such as calcium phosphate cement and beta-tricalcium phosphate will most certainly be part of the future armamentarium when dealing with fracture treatment. It is reasonable to believe that we have so far only seen the beginning when it comes to clinical applications.
- 1 January 2008
- Published by Elsevier
Contributor contact details
- Open Access
- 1 June 2006
- Published by SAGE Publications in Scandinavian Journal of Surgery
- Vol. 95 (2) , 111-118
Cement Augmentation in Fracture Treatment
Surgical treatment of fractures close to joints, especially in osteoporotic patients, is often associated with problems to obtain adequate strength of the bone-implant construct as well as sufficient purchase for screws in the weak bone. One way to address this increasing problem is through the development of new metal implants specifically designed for fixation of fractures in osteopenic bone. An alternative strategy is to develop methods for augmentation of the weak bone that surrounds the metal implant. In most instances augmentation is achieved by using injectable cement to reinforce the bone. Conventional PMMA provides good strength but due to several drawbacks it has never gained general acceptance for fracture augmentation. More recently several injectable cements based on calcium-phosphate, calcium-sulphate or bioglass has been developed for augmentation of fractures in the extremities as well as for vertebral compressive fractures in the spine. On the basis of biomechanical studies and the clinical experience so far, cement augmentation will enable faster rehabilitation, as the strength of the cement makes it possible to allow full weight-bearing earlier than conventional metal implants alone. More clinical studies are needed in order to refine the surgical technique, develop cement types aimed for fracture treatment and define the most appropriate indications and limitations of augmentation for fracture repair. The purpose of this article is to review the possible use of augmentation as a technique in the treatment of fractures in the extremities as well as in the spine.
- 1 June 2006
- Published by SAGE Publications in Scandinavian Journal of Surgery
- Vol. 95 (2) , 111-118
Open AccessCement Augmentation in Fracture Treatment
Surgical treatment of fractures close to joints, especially in osteoporotic patients, is often associated with problems to obtain adequate strength of the bone-implant construct as well as sufficient purchase for screws in the weak bone. One way to address this increasing problem is through the development of new metal implants specifically designed for fixation of fractures in osteopenic bone. An alternative strategy is to develop methods for augmentation of the weak bone that surrounds the metal implant. In most instances augmentation is achieved by using injectable cement to reinforce the bone. Conventional PMMA provides good strength but due to several drawbacks it has never gained general acceptance for fracture augmentation. More recently several injectable cements based on calcium-phosphate, calcium-sulphate or bioglass has been developed for augmentation of fractures in the extremities as well as for vertebral compressive fractures in the spine. On the basis of biomechanical studies and the clinical experience so far, cement augmentation will enable faster rehabilitation, as the strength of the cement makes it possible to allow full weight-bearing earlier than conventional metal implants alone. More clinical studies are needed in order to refine the surgical technique, develop cement types aimed for fracture treatment and define the most appropriate indications and limitations of augmentation for fracture repair. The purpose of this article is to review the possible use of augmentation as a technique in the treatment of fractures in the extremities as well as in the spine.
- Open Access
- 1 June 2002
- Published by SAGE Publications in Scandinavian Journal of Surgery
- Vol. 91 (2) , 140-146
Treatment of Osteoporotic Fractures
Fractures are the most common problem associated with osteoporosis and despite advances in prevention and treatment of osteoporosis the number of fractures continue to increase. Along with the three classic locations hip, spine and wrist, there are several other fractures that commonly are related to osteoporosis. The weak bone makes it difficult to achieve a stable bone-implant construct and general weakness of the patient often prevents reduction of load on the injured extremity during healing. The main treatment goal should be preservation of function even at the expense of restoration of exact anatomy. By development of dynamic load-sharing implants and less invasive techniques the results following fixation of osteoporotic fractures has improved. A new strategy has also been to develop materials that will enhance the strength of the cancellous bone that surrounds the metal implant. By using bioactive cement in conjunction with metal implants improved strength has been shown in internally fixed metaphyseal fractures. Encouraging results have also been reported after cement injection into compressed vertebral fractures, so called vertebroplasty. The specific demands involved in the treatment of osteoporotic fractures calls for specific solutions. Apart from augmentation of the cancellous bone and development of new load-sharing devices, endoprosthetic replacement with specially designed fracture prosthesis has become more frequent.
- 1 June 2002
- Published by SAGE Publications in Scandinavian Journal of Surgery
- Vol. 91 (2) , 140-146
Open AccessTreatment of Osteoporotic Fractures
Fractures are the most common problem associated with osteoporosis and despite advances in prevention and treatment of osteoporosis the number of fractures continue to increase. Along with the three classic locations hip, spine and wrist, there are several other fractures that commonly are related to osteoporosis. The weak bone makes it difficult to achieve a stable bone-implant construct and general weakness of the patient often prevents reduction of load on the injured extremity during healing. The main treatment goal should be preservation of function even at the expense of restoration of exact anatomy. By development of dynamic load-sharing implants and less invasive techniques the results following fixation of osteoporotic fractures has improved. A new strategy has also been to develop materials that will enhance the strength of the cancellous bone that surrounds the metal implant. By using bioactive cement in conjunction with metal implants improved strength has been shown in internally fixed metaphyseal fractures. Encouraging results have also been reported after cement injection into compressed vertebral fractures, so called vertebroplasty. The specific demands involved in the treatment of osteoporotic fractures calls for specific solutions. Apart from augmentation of the cancellous bone and development of new load-sharing devices, endoprosthetic replacement with specially designed fracture prosthesis has become more frequent.
- 1 February 2002
- Published by Wolters Kluwer Health in Clinical Orthopaedics and Related Research
- Vol. 395 (395) , 23-32
Use of Injectable Calcium Phosphate Cement for Fracture Fixation: A Review
Injectable osteoconductive calcium phosphate cements have been introduced as an adjunct to internal fixation for treating selected fractures. These cements harden without producing much heat, develop compressive strength, and are remodeled slowly in vivo. The main purpose of the cement is to fill voids in metaphyseal bone, thereby reducing the need for bone graft, but cements also may improve the holding strength around metal devices in osteoporotic bone. Several bioactive cements are being developed. One of these cements, Skeletal Repair System, is available in Europe and has been approved by the United States Food and Drug Administration for use in selected distal radius fractures. Cadaveric studies have shown that using Skeletal Repair System cement with conventional metal fixation in certain fractures of the distal radius, tibial plateau, proximal femur, and calcaneus can produce better stability, stiffness, and strength than metal fixation alone. Early clinical results have shown reduced time to full weightbearing when cement has been used for augmentation of tibial plateau and calcaneal fractures, more rapid gain of strength and range of motion when used in distal radius fractures, and improved stability in certain hip fractures. Bioactive cements in general also may prove useful in vertebroplasty.
- 1 February 2002
- Published by Wolters Kluwer Health in Clinical Orthopaedics and Related Research
- Vol. 395 (395) , 23-32
Use of Injectable Calcium Phosphate Cement for Fracture Fixation: A Review
Injectable osteoconductive calcium phosphate cements have been introduced as an adjunct to internal fixation for treating selected fractures. These cements harden without producing much heat, develop compressive strength, and are remodeled slowly in vivo. The main purpose of the cement is to fill voids in metaphyseal bone, thereby reducing the need for bone graft, but cements also may improve the holding strength around metal devices in osteoporotic bone. Several bioactive cements are being developed. One of these cements, Skeletal Repair System, is available in Europe and has been approved by the United States Food and Drug Administration for use in selected distal radius fractures. Cadaveric studies have shown that using Skeletal Repair System cement with conventional metal fixation in certain fractures of the distal radius, tibial plateau, proximal femur, and calcaneus can produce better stability, stiffness, and strength than metal fixation alone. Early clinical results have shown reduced time to full weightbearing when cement has been used for augmentation of tibial plateau and calcaneal fractures, more rapid gain of strength and range of motion when used in distal radius fractures, and improved stability in certain hip fractures. Bioactive cements in general also may prove useful in vertebroplasty.