Roger M. Jarvis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Roger M. Jarvis has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
Royston Goodacre
University of Manchester, Manchester Interdisciplinary Biocentre
6 shared publications- Ewan William Blanch
School of Science RMIT University Melbourne Victoria Australia
2 shared publications - Paul O' Brien
School of Chemistry
2 shared publications - Alexander P. Golovanov
Department of Chemistry, School of Natural Sciences, Faculty of Science and Engineering, The University of Manchester, Manchester M13 9PL, United Kingdom
1 shared publication - Arunkumar Panneerselvam
Department of Food Packaging Technology, CSIR-Central Food Technological Research Institute, Mysuru, 570020, India
1 shared publication - David Broadhurst
Edith Cowan University
1 shared publication
Latest Publications
- 4 May 2010
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 397 (5) , 1893-1901
Multiobjective evolutionary optimisation for surface-enhanced Raman scattering
In most optimisation experiments, a single parameter is first optimised before a second and then third one are subsequently modified to give the best result. By contrast, we believe that simultaneous multiobjective optimisation is more powerful; therefore, an optimisation of the experimental conditions for the colloidal SERS detection of l-cysteine was carried out. Six aggregating agents and three different colloids (citrate, borohydride and hydroxylamine reduced silver) were tested over a wide range of concentrations for the enhancement and the reproducibility of the spectra produced. The optimisation was carried out using two methods, a full factorial design (FF, a standard method from the experimental design literature) and, for the first time, a multiobjective evolutionary algorithm (MOEA), a method more usually applied to optimisation problems in computer science. Simulation results suggest that the evolutionary approach significantly out-performs random sampling. Real experiments applying the evolutionary method to the SERS optimisation problem led to a 32% improvement in enhancement and reproducibility compared with the FF method, using far fewer evaluations.
- 4 May 2010
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 397 (5) , 1893-1901
Multiobjective evolutionary optimisation for surface-enhanced Raman scattering
In most optimisation experiments, a single parameter is first optimised before a second and then third one are subsequently modified to give the best result. By contrast, we believe that simultaneous multiobjective optimisation is more powerful; therefore, an optimisation of the experimental conditions for the colloidal SERS detection of l-cysteine was carried out. Six aggregating agents and three different colloids (citrate, borohydride and hydroxylamine reduced silver) were tested over a wide range of concentrations for the enhancement and the reproducibility of the spectra produced. The optimisation was carried out using two methods, a full factorial design (FF, a standard method from the experimental design literature) and, for the first time, a multiobjective evolutionary algorithm (MOEA), a method more usually applied to optimisation problems in computer science. Simulation results suggest that the evolutionary approach significantly out-performs random sampling. Real experiments applying the evolutionary method to the SERS optimisation problem led to a 32% improvement in enhancement and reproducibility compared with the FF method, using far fewer evaluations.
- 29 July 2008
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 80 (17) , 6741-6746
Surface-Enhanced Raman Scattering from Intracellular and Extracellular Bacterial Locations
While surface-enhanced Raman scattering (SERS) can increase the Raman cross-section by 4−6 orders of magnitude, for SERS to be effective it is necessary for the analyte to be either chemically bonded or within close proximity to the metal surface used. Therefore most studies investigating the biochemical constituents of microorganisms have introduced an external supply of gold or silver nanoparticles. As a consequence, the study of bacteria by SERS has to date been focused almost exclusively on the extracellular analysis of the Gram-negative outer cell membrane. Bacterial cells typically measure as little as 0.5 by 1 μm, and it is difficult to introduce a nanometer sized colloidal metal particle into this tiny environment. However, dissimilatory metal-reducing bacteria, including Shewanella and Geobacter species, can reduce a wide range of high valence metal ions, often within the cell, and for Ag(I) and Au(III) this can result in the formation of colloidal zero-valent particles. Here we report, for the first time, SERS of the bacterium Geobacter sulfurreducens facilitated by colloidal gold particles precipitated within the cell. In addition, we show SERS from the same organism following reduction of ionic silver, which results in colloidal silver depositions on the cell surface.
- 29 July 2008
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 80 (17) , 6741-6746
Surface-Enhanced Raman Scattering from Intracellular and Extracellular Bacterial Locations
While surface-enhanced Raman scattering (SERS) can increase the Raman cross-section by 4−6 orders of magnitude, for SERS to be effective it is necessary for the analyte to be either chemically bonded or within close proximity to the metal surface used. Therefore most studies investigating the biochemical constituents of microorganisms have introduced an external supply of gold or silver nanoparticles. As a consequence, the study of bacteria by SERS has to date been focused almost exclusively on the extracellular analysis of the Gram-negative outer cell membrane. Bacterial cells typically measure as little as 0.5 by 1 μm, and it is difficult to introduce a nanometer sized colloidal metal particle into this tiny environment. However, dissimilatory metal-reducing bacteria, including Shewanella and Geobacter species, can reduce a wide range of high valence metal ions, often within the cell, and for Ag(I) and Au(III) this can result in the formation of colloidal zero-valent particles. Here we report, for the first time, SERS of the bacterium Geobacter sulfurreducens facilitated by colloidal gold particles precipitated within the cell. In addition, we show SERS from the same organism following reduction of ionic silver, which results in colloidal silver depositions on the cell surface.
- 25 July 2008
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 133 (10) , 1449-1452
Towards quantitatively reproducible substrates for SERS
There is a need for a method to facilitate the development of novel, reproducible colloidal surface-enhanced Raman scattering (SERS) substrates to encourage the use of SERS in applied studies. In this study we show for the first time that by using suitably designed SERS experiments in conjunction with multivariate analysis of variance (MANOVA), an objective assessment of colloidal SERS reproducibility can be made. This is demonstrated with the analyte cresyl violet, but could be extended to any analyte of interest for which reproducible SERS data are needed.
- 25 July 2008
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 133 (10) , 1449-1452
Towards quantitatively reproducible substrates for SERS
There is a need for a method to facilitate the development of novel, reproducible colloidal surface-enhanced Raman scattering (SERS) substrates to encourage the use of SERS in applied studies. In this study we show for the first time that by using suitably designed SERS experiments in conjunction with multivariate analysis of variance (MANOVA), an objective assessment of colloidal SERS reproducibility can be made. This is demonstrated with the analyte cresyl violet, but could be extended to any analyte of interest for which reproducible SERS data are needed.
- 26 March 2008
- Published by Royal Society of Chemistry (RSC) in Chemical Society Reviews
- Vol. 37 (5) , 931-936
Characterisation and identification of bacteria using SERS
Within microbiology Raman spectroscopy is considered as a very important whole-organism fingerprinting technique, which is used to characterise, discriminate and identify microorganisms and assess how they respond to abiotic or biotic stress. Enhancing the sensitivity of Raman spectroscopy is very beneficial for the rapid analysis of bacteria (and indeed biological systems in general), where the ultimate goal is to achieve this without the need for lengthy cell culture. Bypassing this step would provide significant benefits in many areas such as medical, environmental and industrial microbiology, microbial systems biology, biological warfare countermeasures and bioprocess monitoring. In this tutorial review we will report on the advances made in bacterial studies, a relatively new and exciting application area for SERS.
- 26 March 2008
- Published by Royal Society of Chemistry (RSC) in Chemical Society Reviews
- Vol. 37 (5) , 931-936
Characterisation and identification of bacteria using SERS
Within microbiology Raman spectroscopy is considered as a very important whole-organism fingerprinting technique, which is used to characterise, discriminate and identify microorganisms and assess how they respond to abiotic or biotic stress. Enhancing the sensitivity of Raman spectroscopy is very beneficial for the rapid analysis of bacteria (and indeed biological systems in general), where the ultimate goal is to achieve this without the need for lengthy cell culture. Bypassing this step would provide significant benefits in many areas such as medical, environmental and industrial microbiology, microbial systems biology, biological warfare countermeasures and bioprocess monitoring. In this tutorial review we will report on the advances made in bacterial studies, a relatively new and exciting application area for SERS.
- 7 August 2007
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 132 (10) , 1053-1060
Quantification of casein phosphorylation with conformational interpretation using Raman spectroscopy
Raman spectroscopy is emerging as a powerful method for obtaining both quantitative and qualitative information from biological samples. One very interesting area of research, for which the technique has rarely been used, is the detection, quantification and structural analysis of post-translational modifications (PTMs) on proteins. Since Raman spectra can be used to address both of these questions simultaneously, we have developed near infrared Raman spectroscopy with appropriate chemometric approaches (partial least squares regression) to quantify low concentration (4 µM) mixtures of phosphorylated and dephosphorylated bovine αs-casein. In addition, we have used these data in conjunction with Raman optical activity (ROA) spectra and NMR to assess the structural changes that occur upon phosphorylation.
- 7 August 2007
- Published by Royal Society of Chemistry (RSC) in The Analyst
- Vol. 132 (10) , 1053-1060
Quantification of casein phosphorylation with conformational interpretation using Raman spectroscopy
Raman spectroscopy is emerging as a powerful method for obtaining both quantitative and qualitative information from biological samples. One very interesting area of research, for which the technique has rarely been used, is the detection, quantification and structural analysis of post-translational modifications (PTMs) on proteins. Since Raman spectra can be used to address both of these questions simultaneously, we have developed near infrared Raman spectroscopy with appropriate chemometric approaches (partial least squares regression) to quantify low concentration (4 µM) mixtures of phosphorylated and dephosphorylated bovine αs-casein. In addition, we have used these data in conjunction with Raman optical activity (ROA) spectra and NMR to assess the structural changes that occur upon phosphorylation.
- Open Access
- 31 July 2006
- Published by Oxford University Press (OUP) in Bioinformatics
- Vol. 22 (20) , 2565-2566
PYCHEM: a multivariate analysis package for python
Summary: We have implemented a multivariate statistical analysis toolbox, with an optional standalone graphical user interface (GUI), using the Python scripting language. This is a free and open source project that addresses the need for a multivariate analysis toolbox in Python. Although the functionality provided does not cover the full range of multivariate tools that are available, it has a broad complement of methods that are widely used in the biological sciences. In contrast to tools like MATLAB, PyChem 2.0.0 is easily accessible and free, allows for rapid extension using a range of Python modules and is part of the growing amount of complementary and interoperable scientific software in Python based upon SciPy. One of the attractions of PyChem is that it is an open source project and so there is an opportunity, through collaboration, to increase the scope of the software and to continually evolve a user-friendly platform that has applicability across a wide range of analytical and post-genomic disciplines. Availability: Contact: Roger.Jarvis@manchester.ac.uk or admin@pychem.org.uk Supplementary information: Further information is available from the project home page at whilst details of data generation are available at
- 31 July 2006
- Published by Oxford University Press (OUP) in Bioinformatics
- Vol. 22 (20) , 2565-2566
Open AccessPYCHEM: a multivariate analysis package for python
Summary: We have implemented a multivariate statistical analysis toolbox, with an optional standalone graphical user interface (GUI), using the Python scripting language. This is a free and open source project that addresses the need for a multivariate analysis toolbox in Python. Although the functionality provided does not cover the full range of multivariate tools that are available, it has a broad complement of methods that are widely used in the biological sciences. In contrast to tools like MATLAB, PyChem 2.0.0 is easily accessible and free, allows for rapid extension using a range of Python modules and is part of the growing amount of complementary and interoperable scientific software in Python based upon SciPy. One of the attractions of PyChem is that it is an open source project and so there is an opportunity, through collaboration, to increase the scope of the software and to continually evolve a user-friendly platform that has applicability across a wide range of analytical and post-genomic disciplines. Availability: Contact: Roger.Jarvis@manchester.ac.uk or admin@pychem.org.uk Supplementary information: Further information is available from the project home page at whilst details of data generation are available at