Dong-Young Lee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Dong-Young Lee has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- I. S. Lee
Department of Radiology, Seoul National University Bundang Hospital, Seongnam-si, Korea
1 shared publication - Ji-Young Kim
Department of Electronics Engineering, Chungnam National University, Daejeon, Korea. Tel : +82-42-821-8914
1 shared publication - Joon Lyou
Chungnam National University
1 shared publication - Jung-Taek Kim
ICT Division, Korea Atomic Energy Research Institute, Daejeon 34057, Korea
1 shared publication - Jung-Woon Lee
Korea Atomic Energy Research Institute PO BOX 105, Yuseong, Daejeon South Korea +82-42-868-8322
1 shared publication - Kyung Youn Kim
Electronic Engineering Department and the Faculty of Applied Energy Systems Engineering, Department of Electronic Engineering, Jeju National University, Jeju, South Korea
1 shared publication
Latest Publications
- 1 January 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 4345-4349
Reliability Analysis of Safety Grade Programmable Logic Controller
This paper focuses on the random hardware failures necessary for the safety assessment of the reactor protection system (RPS). A prediction method of the hardware failure rate for safety assessment is suggested, and applied to the safety grade programmable logic controller (PLC) to identify design weak points from a safety point of view
- 1 January 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 4345-4349
Reliability Analysis of Safety Grade Programmable Logic Controller
This paper focuses on the random hardware failures necessary for the safety assessment of the reactor protection system (RPS). A prediction method of the hardware failure rate for safety assessment is suggested, and applied to the safety grade programmable logic controller (PLC) to identify design weak points from a safety point of view
- 18 September 2003
- Published by Hindawi Limited in International Journal of Intelligent Systems
- Vol. 18 (10) , 1087-1100
Model-based fault detection and isolation method using ART2 neural network
This article presents a model‐based fault diagnosis method to detect and isolate faults in the robot arm control system. The proposed algorithm is composed functionally of three main parts: parameter estimation, fault detection, and isolation. When a change in the system occurs, the errors between the system output and the estimated output cross a predetermined threshold, and once a fault in the system is detected, the estimated parameters are transferred to the fault classifier by the adaptive resonance theory 2 neural network (ART2 NN) with uneven vigilance parameters for fault isolation. The simulation results show the effectiveness of the proposed ART2 NN–based fault diagnosis method.
- 18 September 2003
- Published by Hindawi Limited in International Journal of Intelligent Systems
- Vol. 18 (10) , 1087-1100
Model-based fault detection and isolation method using ART2 neural network
This article presents a model‐based fault diagnosis method to detect and isolate faults in the robot arm control system. The proposed algorithm is composed functionally of three main parts: parameter estimation, fault detection, and isolation. When a change in the system occurs, the errors between the system output and the estimated output cross a predetermined threshold, and once a fault in the system is detected, the estimated parameters are transferred to the fault classifier by the adaptive resonance theory 2 neural network (ART2 NN) with uneven vigilance parameters for fault isolation. The simulation results show the effectiveness of the proposed ART2 NN–based fault diagnosis method.