Perrine Batude
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Perrine Batude has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Laurent Brunet
CEA-LETI, Universit Grenoble Alpes, Grenoble, France
2 shared publications - Alexandre Ayres
STMicroelectronics, 38926 Crolles, France
1 shared publication - Arnaud Peizerat
Commissariat à l’Energie Atomique et aux Energies Alternatives—Laboratoire d′Electronique des Technologies de l′Information (CEA—LETI), University Grenoble Alpes, 38054 Grenoble, France
1 shared publication Bertrand Borot
STMicroelectronics, 38926 Crolles, France
1 shared publicationC. Le Royer
CEA-LETI-Minatec, 17 Rue des Martyrs 38054 Grenoble, France
1 shared publication- Christoforos Theodorou
French National Centre for Scientific Research (CNRS), Centre for Radiofrequencies, Optic and Micro-nanoelectronics (CROMA), University of Grenoble Alpes, University of Savoie Mont-Blanc Grenoble INP, 38000 Grenoble, France
1 shared publication
Latest Publications
- 10 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (4) , 627-633
Total-Ionizing-Dose Effects on 3-D Sequentially Integrated FDSOI Ring Oscillators
Total-ionizing-dose responses are investigated for fully-depleted silicon-on-insulator (FDSOI) ring oscillators (RO), in three-dimensional (3D) architectures. Operational frequencies decrease after irradiation in these devices due primarily to threshold voltage shifts and transconductance degradation due to interface-trap buildup in the pull-up p MOSFETs. 3D sequentially-integrated FDSOI ROs fabricated in the bottom layer of the 3D structure show the most significant frequency degradation. AC-bias irradiation leads to greater shifts than static-bias irradiation in these devices due to enhanced interface-trap buildup. Circuit simulations reinforce the relative importance of transconductance degradation in pull-up p MOSFETs to the TID response of these ROs.
- 10 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 70 (4) , 627-633
Total-Ionizing-Dose Effects on 3-D Sequentially Integrated FDSOI Ring Oscillators
Total-ionizing-dose responses are investigated for fully-depleted silicon-on-insulator (FDSOI) ring oscillators (RO), in three-dimensional (3D) architectures. Operational frequencies decrease after irradiation in these devices due primarily to threshold voltage shifts and transconductance degradation due to interface-trap buildup in the pull-up p MOSFETs. 3D sequentially-integrated FDSOI ROs fabricated in the bottom layer of the 3D structure show the most significant frequency degradation. AC-bias irradiation leads to greater shifts than static-bias irradiation in these devices due to enhanced interface-trap buildup. Circuit simulations reinforce the relative importance of transconductance degradation in pull-up p MOSFETs to the TID response of these ROs.
- Open Access
- 28 February 2022
- Published by MDPI AG in Technologies
- Vol. 10 (2) , 38
Parasitic Coupling in 3D Sequential Integration: The Example of a Two-Layer 3D Pixel
In this paper, we present a thorough analysis of parasitic coupling effects between different electrodes for a 3D Sequential Integration circuit example comprising stacked devices. More specifically, this study is performed for a Back-Side Illuminated, 4T–APS, 3D Sequential Integration pixel with both its photodiode and Transfer Gate at the bottom tier and the other parts of the circuit on the top tier. The effects of voltage bias and 3D inter-tier contacts are studied by using TCAD simulations. Coupling-induced electrical parameter variations are compared against variations due to temperature change, revealing that these two effects can cause similar levels of readout error for the top-tier readout circuit. On the bright side, we also demonstrate that in the case of a rolling shutter pixel readout, the coupling effect becomes nearly negligible. Therefore, we estimate that the presence of an inter-tier ground plane, normally used for electrical isolation, is not strictly mandatory for Monolithic 3D pixels.
- 28 February 2022
- Published by MDPI AG in Technologies
- Vol. 10 (2) , 38
Open AccessParasitic Coupling in 3D Sequential Integration: The Example of a Two-Layer 3D Pixel
In this paper, we present a thorough analysis of parasitic coupling effects between different electrodes for a 3D Sequential Integration circuit example comprising stacked devices. More specifically, this study is performed for a Back-Side Illuminated, 4T–APS, 3D Sequential Integration pixel with both its photodiode and Transfer Gate at the bottom tier and the other parts of the circuit on the top tier. The effects of voltage bias and 3D inter-tier contacts are studied by using TCAD simulations. Coupling-induced electrical parameter variations are compared against variations due to temperature change, revealing that these two effects can cause similar levels of readout error for the top-tier readout circuit. On the bright side, we also demonstrate that in the case of a rolling shutter pixel readout, the coupling effect becomes nearly negligible. Therefore, we estimate that the presence of an inter-tier ground plane, normally used for electrical isolation, is not strictly mandatory for Monolithic 3D pixels.
- 20 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (1) , 633-640
Variance Analysis in 3-D Integration: A Statistically Unified Model With Distance Correlations
Variability is a challenge for future scaling as process dimensions reduce. The emerging 3-D sequential stacking technology is more than Moore's scaling alternative. The 3-D design flow requires the partitioning of the netlist between the tiers. This paper presents the variability analysis of circuits partitioned into different levels. A comparison among local and global variations effects on ring oscillators (ROs) and SRAM is demonstrated. The across-chip variations and correlation range are shown as a critical point for the 3-D very large-scale integrated circuits, where the local variability is dominant. The correlations between devices due to the distances or the allocation into different tiers are directly taken into account in the SPICE model due to a statically unified model applied to 3-D circuits based on Monte Carlo simulations. Design wise, the 3-D integration can further decrease the circuit variability as shown in RO output frequency and SRAM static noise margin.
- 20 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 66 (1) , 633-640
Variance Analysis in 3-D Integration: A Statistically Unified Model With Distance Correlations
Variability is a challenge for future scaling as process dimensions reduce. The emerging 3-D sequential stacking technology is more than Moore's scaling alternative. The 3-D design flow requires the partitioning of the netlist between the tiers. This paper presents the variability analysis of circuits partitioned into different levels. A comparison among local and global variations effects on ring oscillators (ROs) and SRAM is demonstrated. The across-chip variations and correlation range are shown as a critical point for the 3-D very large-scale integrated circuits, where the local variability is dominant. The correlations between devices due to the distances or the allocation into different tiers are directly taken into account in the SPICE model due to a statically unified model applied to 3-D circuits based on Monte Carlo simulations. Design wise, the 3-D integration can further decrease the circuit variability as shown in RO output frequency and SRAM static noise margin.
- 31 October 2007
- Published by Elsevier in Microelectronic Engineering
- Vol. 84 (9-10) , 2320-2323
In-depth investigation of the mechanisms impacting C-V/G-V characteristics of Ge/GeON/HfO2/TiN stacks by electrical modeling
- 31 October 2007
- Published by Elsevier in Microelectronic Engineering
- Vol. 84 (9-10) , 2320-2323
In-depth investigation of the mechanisms impacting C-V/G-V characteristics of Ge/GeON/HfO2/TiN stacks by electrical modeling