Evor L. Hines
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Evor L. Hines has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Mark Stephen Leeson
School of Engineering, University of Warwick, Coventry, United Kingdom
5 shared publications - Julian William Gardner
Microsensors and Bioelectronics Laboratory, School of Engineering, University of Warwick, Coventry CV4 7AL, UK
3 shared publications D. D. Iliescu
2 shared publicationsM. Bhuyan
Tezpur University
2 shared publications- Pascal Boilot
Division of Electrical and Electronic Engineering, School of Engineering, University of Warwick, Coventry, CV4 7AL, United Kingdom
2 shared publications D. Daciana Iliescu
School of Engineering, Warwick University, Coventry CV4 7AL, United Kingdom
1 shared publication
Latest Publications
- 30 June 2013
- Published by AICIT in INTERNATIONAL JOURNAL ON Advances in Information Sciences and Service Sciences
- Vol. 5 (11) , 1-9
Urban Vehicular Network Performance Optimization
- 30 June 2013
- Published by AICIT in INTERNATIONAL JOURNAL ON Advances in Information Sciences and Service Sciences
- Vol. 5 (11) , 1-9
Urban Vehicular Network Performance Optimization
- 20 April 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 16 (6) , 874-877
Performance Analysis of Spectrum Sensing with Multiple Status Changes in Primary User Traffic
In this letter, the impact of primary user traffic with multiple status changes on the spectrum sensing performance is analyzed. Closed-form expressions for the probabilities of false alarm and detection are derived. Numerical results show that the multiple status changes of the primary user cause considerable degradation in the sensing performance. This degradation depends on the number of changes, the primary user traffic model, the primary user traffic intensity and the signal-to-noise ratio of the received signal. Numerical results also show that the amount of degradation decreases when the number of changes increases, and converges to a minimum sensing performance due to the limited sensing period and primary holding time.
- 20 April 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 16 (6) , 874-877
Performance Analysis of Spectrum Sensing with Multiple Status Changes in Primary User Traffic
In this letter, the impact of primary user traffic with multiple status changes on the spectrum sensing performance is analyzed. Closed-form expressions for the probabilities of false alarm and detection are derived. Numerical results show that the multiple status changes of the primary user cause considerable degradation in the sensing performance. This degradation depends on the number of changes, the primary user traffic model, the primary user traffic intensity and the signal-to-noise ratio of the received signal. Numerical results also show that the amount of degradation decreases when the number of changes increases, and converges to a minimum sensing performance due to the limited sensing period and primary holding time.
- Open Access
- 30 March 2009
- Published by National Institute of Telecommunications in Journal of Telecommunications and Information Technology
- No. 1,p. 63-67
Fault Tolerant Dense Wavelength Division Multiplexing Optical Transport Networks
Design of fault tolerant dense wavelength division multiplexing (DWDM) backbones is a major issue for service provision in the presence of failures. The problem is an NP-hard problem. This paper presents a genetic algorithm based approach for designing fault tolerant DWDM optical networks in the presence of a single link failure. The working and spare lightpaths are encoded into variable length chromosomes. Then the best lightpaths are found by use of a fitness function and these are assigned the minimum number of wavelengths according to the problem constraints using first-fit (FF) algorithm. The proposed approach has been evaluated for dedicated path protection architecture. The results, obtained from the ARPA2 test bench network, show that the method is well suited to tackling this complex and multi-constraint problem.
- 30 March 2009
- Published by National Institute of Telecommunications in Journal of Telecommunications and Information Technology
- No. 1,p. 63-67
Open AccessFault Tolerant Dense Wavelength Division Multiplexing Optical Transport Networks
Design of fault tolerant dense wavelength division multiplexing (DWDM) backbones is a major issue for service provision in the presence of failures. The problem is an NP-hard problem. This paper presents a genetic algorithm based approach for designing fault tolerant DWDM optical networks in the presence of a single link failure. The working and spare lightpaths are encoded into variable length chromosomes. Then the best lightpaths are found by use of a fitness function and these are assigned the minimum number of wavelengths according to the problem constraints using first-fit (FF) algorithm. The proposed approach has been evaluated for dedicated path protection architecture. The results, obtained from the ARPA2 test bench network, show that the method is well suited to tackling this complex and multi-constraint problem.
- 15 June 2008
- Published by Elsevier in Optics Communications
- Vol. 281 (12) , 3245-3253
Fuzzy control of optical PPM–CDMA with M-ary orthogonal signaling
- 15 June 2008
- Published by Elsevier in Optics Communications
- Vol. 281 (12) , 3245-3253
Fuzzy control of optical PPM–CDMA with M-ary orthogonal signaling
- 20 December 2007
- Published by Springer Nature in Sensing and Instrumentation for Food Quality and Safety
- Vol. 2 (1) , 7-14
Neural network based electronic nose for classification of tea aroma
- 20 December 2007
- Published by Springer Nature in Sensing and Instrumentation for Food Quality and Safety
- Vol. 2 (1) , 7-14
Neural network based electronic nose for classification of tea aroma
- 16 July 2007
- Published by Hindawi Limited in International Journal of RF and Microwave Computer-Aided Engineering
- Vol. 17 (5) , 493-504
Phase compensating dielectric lens design with genetic programming
This article illustrates a microwave dielectric lens design using genetic programming (GP), which, to the best knowledge of the authors, is the first time GP has been applied to design a microwave dielectric lens. A phase-compensating single layer lens and a quarter-wave phase-compensating multilayer dielectric lens, which uses four types of materials and a zoned structure, was designed using GP. The dielectric lens shape was designed using GP strategy, with a random initial shape, to compensate for the phase error of the multilayer dielectric lens and to achieve the required performance. Standard GP (SGP) and hierarchical fair competition genetic programming (HFC-GP) was applied to obtain the solution. The results show that this novel method of microwave lens shape design using GP is both accurate and stable. In addition, the simulation results of using high frequency simulation software (HFSS) are illustrated and compared. © 2007 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2007.
- 16 July 2007
- Published by Hindawi Limited in International Journal of RF and Microwave Computer-Aided Engineering
- Vol. 17 (5) , 493-504
Phase compensating dielectric lens design with genetic programming
This article illustrates a microwave dielectric lens design using genetic programming (GP), which, to the best knowledge of the authors, is the first time GP has been applied to design a microwave dielectric lens. A phase-compensating single layer lens and a quarter-wave phase-compensating multilayer dielectric lens, which uses four types of materials and a zoned structure, was designed using GP. The dielectric lens shape was designed using GP strategy, with a random initial shape, to compensate for the phase error of the multilayer dielectric lens and to achieve the required performance. Standard GP (SGP) and hierarchical fair competition genetic programming (HFC-GP) was applied to obtain the solution. The results show that this novel method of microwave lens shape design using GP is both accurate and stable. In addition, the simulation results of using high frequency simulation software (HFSS) are illustrated and compared. © 2007 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2007.
- 2 March 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Determination of tea quality by using a neural network based electronic nose
In these paper we have used a metal oxide sensor based electronic nose (EN) to analyse five tea samples with different qualities, namely, drier month, drier month again over fired, well fermented normal fired in oven, well fermented over fired in oven, and under fermented normal fired in oven. The flavour of team is determined mainly by its taste and smell, which generated by hundreds of volatile organic compounds (VOCs) and non-volatile organic compounds present in tea. These VOCs are present in different ratios and determine the quality of the tea. For example Assamica (Sri Lanka and Assam tea) and Assamica Sinesis (Dajeeling and Japanese tea) are two different species of tea giving different flavour notes. Tea flavour is traditionally measured through the use of a combination of conventional analytical instrumentation and human organoleptic profiling panels. These methods are expensive in terms of time and labour and also inaccurate because of lack of either sensitivity or quantitative information. In this paper an investigation has been made to determine the flavours of different tea samples using an EN and to explore the possibility of replacing existing analytical and profiling panel methods. The technique uses as array of 4 metal oxide sensors (MOS), each of, which has an electrical resistance that has partial sensitivity to the headspace of tea. The signals from the sensor array are then conditioned by suitable interface circuitry. The data were processed using principal component analysis (PCA), fuzzy C means algorithm (FCM). We also explored the use of self-organizing map (SOM) method along with a radial basis function network (RBF) and a probabilistic neural network (PNN) classifier. Using FCM and SOM feature extraction techniques along with RBF neural network we achieved 100% correct classification for the five different tea samples with different qualities. These results prove that our EN is capable of discriminating between the flavours of teas manufactured under different processing conditions, viz. over-fermented, over-fired, under fermented etc.
- 2 March 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Determination of tea quality by using a neural network based electronic nose
In these paper we have used a metal oxide sensor based electronic nose (EN) to analyse five tea samples with different qualities, namely, drier month, drier month again over fired, well fermented normal fired in oven, well fermented over fired in oven, and under fermented normal fired in oven. The flavour of team is determined mainly by its taste and smell, which generated by hundreds of volatile organic compounds (VOCs) and non-volatile organic compounds present in tea. These VOCs are present in different ratios and determine the quality of the tea. For example Assamica (Sri Lanka and Assam tea) and Assamica Sinesis (Dajeeling and Japanese tea) are two different species of tea giving different flavour notes. Tea flavour is traditionally measured through the use of a combination of conventional analytical instrumentation and human organoleptic profiling panels. These methods are expensive in terms of time and labour and also inaccurate because of lack of either sensitivity or quantitative information. In this paper an investigation has been made to determine the flavours of different tea samples using an EN and to explore the possibility of replacing existing analytical and profiling panel methods. The technique uses as array of 4 metal oxide sensors (MOS), each of, which has an electrical resistance that has partial sensitivity to the headspace of tea. The signals from the sensor array are then conditioned by suitable interface circuitry. The data were processed using principal component analysis (PCA), fuzzy C means algorithm (FCM). We also explored the use of self-organizing map (SOM) method along with a radial basis function network (RBF) and a probabilistic neural network (PNN) classifier. Using FCM and SOM feature extraction techniques along with RBF neural network we achieved 100% correct classification for the five different tea samples with different qualities. These results prove that our EN is capable of discriminating between the flavours of teas manufactured under different processing conditions, viz. over-fermented, over-fired, under fermented etc.
- Open Access
- 16 October 2002
- Published by Springer Nature in BioMedical Engineering OnLine
- Vol. 1 (1) , 4
Bacteria classification using Cyranose 320 electronic nose
An electronic nose (e-nose), the Cyrano Sciences' Cyranose 320, comprising an array of thirty-two polymer carbon black composite sensors has been used to identify six species of bacteria responsible for eye infections when present at a range of concentrations in saline solutions. Readings were taken from the headspace of the samples by manually introducing the portable e-nose system into a sterile glass containing a fixed volume of bacteria in suspension. Gathered data were a very complex mixture of different chemical compounds. Linear Principal Component Analysis (PCA) method was able to classify four classes of bacteria out of six classes though in reality other two classes were not better evident from PCA analysis and we got 74% classification accuracy from PCA. An innovative data clustering approach was investigated for these bacteria data by combining the 3-dimensional scatter plot, Fuzzy C Means (FCM) and Self Organizing Map (SOM) network. Using these three data clustering algorithms simultaneously better 'classification' of six eye bacteria classes were represented. Then three supervised classifiers, namely Multi Layer Perceptron (MLP), Probabilistic Neural network (PNN) and Radial basis function network (RBF), were used to classify the six bacteria classes. A [6 x 1] SOM network gave 96% accuracy for bacteria classification which was best accuracy. A comparative evaluation of the classifiers was conducted for this application. The best results suggest that we are able to predict six classes of bacteria with up to 98% accuracy with the application of the RBF network. This type of bacteria data analysis and feature extraction is very difficult. But we can conclude that this combined use of three nonlinear methods can solve the feature extraction problem with very complex data and enhance the performance of Cyranose 320.
- 16 October 2002
- Published by Springer Nature in BioMedical Engineering OnLine
- Vol. 1 (1) , 4
Open AccessBacteria classification using Cyranose 320 electronic nose
An electronic nose (e-nose), the Cyrano Sciences' Cyranose 320, comprising an array of thirty-two polymer carbon black composite sensors has been used to identify six species of bacteria responsible for eye infections when present at a range of concentrations in saline solutions. Readings were taken from the headspace of the samples by manually introducing the portable e-nose system into a sterile glass containing a fixed volume of bacteria in suspension. Gathered data were a very complex mixture of different chemical compounds. Linear Principal Component Analysis (PCA) method was able to classify four classes of bacteria out of six classes though in reality other two classes were not better evident from PCA analysis and we got 74% classification accuracy from PCA. An innovative data clustering approach was investigated for these bacteria data by combining the 3-dimensional scatter plot, Fuzzy C Means (FCM) and Self Organizing Map (SOM) network. Using these three data clustering algorithms simultaneously better 'classification' of six eye bacteria classes were represented. Then three supervised classifiers, namely Multi Layer Perceptron (MLP), Probabilistic Neural network (PNN) and Radial basis function network (RBF), were used to classify the six bacteria classes. A [6 x 1] SOM network gave 96% accuracy for bacteria classification which was best accuracy. A comparative evaluation of the classifiers was conducted for this application. The best results suggest that we are able to predict six classes of bacteria with up to 98% accuracy with the application of the RBF network. This type of bacteria data analysis and feature extraction is very difficult. But we can conclude that this combined use of three nonlinear methods can solve the feature extraction problem with very complex data and enhance the performance of Cyranose 320.
- 1 November 2000
- Published by Wiley in Sensors Update
- Vol. 8 (1) , 73-94
Knowledge Extraction from Electronic Nose Data Sets Using Hybrid Neuro-fuzzy Systems
- 1 November 2000
- Published by Wiley in Sensors Update
- Vol. 8 (1) , 73-94
Knowledge Extraction from Electronic Nose Data Sets Using Hybrid Neuro-fuzzy Systems